====================I. PRODUCT IDENTIFICATION==========================
Trade Name: Roberts Capitol 029 Flammable Pad Cement
Chemical names, common names: Synthetic Rubber/resin in a solvent blend
Manufactured by: Roberts Capitol, Inc.
Address: 300 Cross Plains Blvd.
Dalton, GA 30721
Emergency Phone: 800-424-9300 (Chemtrec)
Business Phone: 706-277-5294 Date revised: 04/27/09
By: M. King
HMIS Rating: H = 2 F=3 R=0
====================II. HAZARDOUS INGREDIENTS==========================
CAS No. % by wt. PEL TLV
Hexane ((n-hexane) 110-54-3 44 500 ppm 50 ppm
Solvent Naphtha
(Petroleum),Light
Aliphatic 64742-89-8 24 500 ppm 300 ppm
Reportable hazardous chemicals for SARA TITLE III Section 311, 312, 313:
Hexane
===================III. PHYSICAL PROPERTIES ============================
Vapor Density (Air=1): 3.0 Boiling Point: 149癋
Solubility in Water: NA Specific gravity: 0.77
Vapor Pressure (mmHg at 20癈): not determined.
Appearance & odor: Amber colored liquid with solvent odor.
Percent Volatile: 68% by weight
VOC calculated (Coating): 542 grams/liter
===================IV. FIRE AND EXPLOSION==============================
Flash point, Pensky-Martens C.C: ?篎
Auto-Ignition Temperature, F: 450
Flammable limits in air, Volume %: Lower: 1 Upper: 8
Fire Extinguishing Materials:
_X__Carbon Dioxide _____Other:
__X__Foam __X__Dry Chemical
Special Fire fighting Procedures: Wear self-contained breathing
apparatus. Use water spray to cool containers only.
Unusual Fire and Explosion Hazards: Do not expose to open flame, sparks
or extreme heat. Turn off all pilot lights.
MSDS --
Page 2
HAZARDOUS DECOMPOSITION PRODUCTS: May form toxic materials: carbon
dioxide and carbon monoxide, various hydrocarbons, etc.
======================= V. HEALTH HAZARD INFORMATION ==================
EFFECTS OF EXPOSURE: Eyes: Can cause irritation, redness, tearing,
blurred vision. Skin: Prolonged or repeated contact can cause moderate
irritation, defatting, and dermatitis. Breathing: Excessive inhalation
of vapors can cause nasal and respiratory irritation, dizziness,
weakness, fatigue, nausea, headache, possible unconsciousness, and even
asphyxiation. Swallowing: Can cause gastrointestinal irritation, nausea,
vomiting, and diarrhea. Do not eat or drink in areas where solvents are
stored or used.
FIRST AID: Eyes: Flush with water for 15 minutes, lifting eyelids
occasionally. Obtain medical attention. Skin: Remove contaminated
clothing. Wash skin thoroughly with soap and water. Obtain medical
attention if irritation persists. Inhalation: Remove person to
fresh air. Obtain immediate medical attention. Ingestion: Do not
induce vomiting. Obtain immediate medical attention.USE ONLY WELL
VENTILATED AREAS.
------------------------------------------------------------------------
SUSPECTED CANCER AGENT?
NO:_X__
YES: _____ Federal OSHA _____NTP _____IARC _____Cal/OSHA
-------------------------------------------------------------------------
MEDICAL CONDITIONS AGGRAVATED BY EXPOSURE: None Known
===========================VI. REACTIVITY DATA==========================
Stability: __X____ Stable _____ Unstable
Conditions to Avoid: Protect from freezing.
Incompatibility (Materials to Avoid): Oxidizing materials
Hazardous Decomposition Products (including combustion products):
Oxides of carbon, water and organic compounds of unknown
structure.
Hazardous Polymerization: Does not occur
Conditions to Avoid: Open flame, extreme heat.
-2-
MSDS
Page 3
===================VII. SPECIAL HANDLING INFORMATION===================
VENTILATION: Adequate ventilation is essential to prevent vapor
buildup. Open all available windows and entrances to insure good
ventilation. Provide sufficient mechanical (general and/or local
exhaust) ventilation to maintain exposure below TLV. RESPIRATOR
PROTECTION: Adequate ventilation is normally sufficient. If TLV of the
product or any component is exceeded or eyes begin to water or dizziness
or headaches are experienced, increase fresh air supply, wear an NIOSH
approved respirator, or leave the area. Engineering or administrative
controls should be implemented to reduce exposure. PROTECTIVE GLOVES:
Wear protective gloves to prevent skin contact. EYE PROTECTION: Wear
glasses or protective goggles to avoid splashes.
OTHER PROTECTIVE EQUIPMENT: None required. WASH HANDS THOROUGHLY WITH
SOAP AND WATER
===============VIII. SPILL, LEAK, AND DISPOSAL PROCEDURES=============
STEPS TO BE TAKEN IN CASE MATERIAL IS RELEASED OR SPILLED: Absorb liquid
on paper, vermiculite, floor absorbent, or other absorbent material and
transfer to hood. Allow volatile portion to evaporate in hood. Allow
sufficient time for vapors to completely clear hood duct work.
Note: Dispose of all wastes in accordance with Federal, State and Local
regulations.
===================IX. Storage & Handling DATA========================
Other Handling and Storage requirements: Protect against physical damage.
Store in a cool, dry place (50F - 90F). Keep away from excessive
heat. Protect from freezing. Shake before using.
======================X. Regulatory Information ======================
Hazardous Waste 40CFR261: NO(dry adhesive) Hazardous Waste Number:
Hazardous Substance Superfund: NO RQ(lbs):
All components are in TSCA inventory.
Disposal Considerations
Whatever cannot be saved for recovery or recycling should be handled as hazardous waste
and sent to a RCRA approved incinerator or disposed in a RCRA approved waste facility.
Processing, use or contamination of this product may change the waste management
options. State and local disposal regulations may differ from federal disposal
regulations. Dispose of container and unused contents in accordance with federal, state
and local requirements.
-3-
MSDS
Page 4
=============================XI.SHIPPING DATA========================
D.O.T. Proper Shipping Name (49CFR172.101-102): Adhesives.
Hazardous Substance (49CFR CERCLA list): No. RQ: N/A
D.O.T. Hazard Classification (49CFR 172.101-102):
Primary: Class 3 Secondary: PG II.
D.O.T. Labels Required (49CFR172.101-102): Flammable.
D.O.T. Placards Required (CFR172.504): Flammable.
Poison Constituent (49CFR172.203(K)): None.
Bill of Lading Description: Adhesives, NOS (Hexane, Solvent Naptha)
UN/NA Code: 1133.
Roberts Capitol, Inc. believes the data set forth herein are accurate as
of the date hereof, and makes no warranty with respect thereto
and expressly disclaims all liability for reliance thereon. Such
data are offered solely for your consideration, investigation and
verification.
-4-
|