MATERIAL SAFETY DATA SHEET
Wynn's Professional Products
Silicone Lubricant ?Aerosol
WYNN'S EMERGENCY TELEPHONE NUMBER:
A division of Illinois Tool Works Inc. Chemtrec (800) 424-9300
1151 West Fifth Street INFORMATION TELEPHONE NUMBER:
Azusa, California 91702 Wynn's (626) 334-0231
PRODUCT IDENTIFICATION
PRODUCT NAME EFFECTIVE DATE PRODUCT CODE
Wynn's Professional Products Silicone Lubricant 11-09-05 52630, 52633
- Aerosol
CHEMICAL NAME CAS NUMBER
N/A N/A
HAZARDOUS INGREDIENTS
COMMON CHEMICAL OSHA ACGIH
CAS NO.
NAME NAME PEL TLV-TWA
N-Hexane Hexane 110-54-3 500 50 ppm
Acetone 2 Propanone 67-64-1 1000 500 ppm
Liquefied Petroleum
Liquefied Petroleum Gas 68476-86-8 1000 1000 ppm
Gas
Petroleum Distillate Distillates, Petroleum, 64742-47-8 5mg/m 5mg/m
as mist3 as mist3
Hydrotreated Light
Contains no other ingredients now known to be hazardous as defined by OSHA 29CFR 1910.1000(z) and 29CFR
1910.1200.
PHYSICAL DATA
These data are approximate or typical values and should not be used as precise specifications. Unless otherwise
noted values are at 20癈(68癋) and 760 mmHg (1 atm).
癈)
1.75癋 to 159癋 N/D癋(
Boiling Point/Range Freeze/Melt Point
(-17?to 71癈)
0.7 33
Vapor Pressure (PSIG)
Specific Gravity (H20=1) @ 15.6癈
4.0 Nil
Vapor Density (Air =1) Solubility in Water (%)
60% >1
Evaporation Rate (Butyl Acetate =
% Volatiles by Volume
1)
(CARB)
N/A N/A
pH (as is) pH (dilute) @ %
Clear liquid Solvent
Appearance Odor
N/D - Not Determined N/A - Not Applicable
< = Less Than > = Greater Than
Wynn's Professional Products
Silicone Lubricant - Aerosol
WC 52630, 52633 - MSDS
11-09-05
FIRE AND EXPLOSION HAZARD DATA
Pensky-Martens ASTM D-93
-40癋(-40癈)
Flash Point Method
Flammable or Explosive Limits (Approximate percent by volume in air)
Lower (LEL) N/D Upper (UEL) N/D
Hazard Class Identification
Flammability Hazard Code
4 0 - Least
(insignificant)
1 - Slight
Health Reactivity
2 0 2 - Moderate
3 - High
Other
--- 4 - Extreme
Extinguishing Media
Carbon dioxide, dry chemicals, water fog.
Special Fire Fighting Procedures
Use water to cool fire exposed containers. Fire fighters wear a suit contained breathing apparatus.
Unusual Fire and Explosion Hazards
Aerosol cans may rupture when exposed to heat.
REACTIVITY DATA
Stability
Stable.
Conditions to Avoid
Avoid spraying around open flame. Avoid high temperature sources.
Materials to Avoid
Strong Oxidizers.
Hazardous Decomposition or Combustion Products
Thermal decomposition will produce oxides of carbon, and silicone dioxide.
Page 2
Wynn's Professional Products
Silicone Lubricant - Aerosol
WC 52630, 52633 - MSDS
11-09-05
Hazardous Polymerization (conditions)
Will not occur.
HEALTH HAZARDS/ROUTES OF ENTRY
Signs, Symptoms and Effects of Overexposure
Ingestion (swallowing) Harmful if swallowed. Can cause vomiting, dizziness, headaches, loss of coordination.
Irritant to skin. Can cause defatting of skin, redness, dryness, cracking of skin.
Skin Contact
Irritant to eyes. Direct contact with the liquid causes stinging, tearing, blurred vision, pain.
Eye Contact
Inhalation (breathing) Anesthetic effect. May cause irritation to the upper respiratory tract.
Other Effects of Prolonged/Repeated Overexposure
This material contains a trace amount of chemical that has been identified as a
carcinogen by NTP, IARC or OSHA. Vapors in a confined area in high concentrations
are anesthetic. Overexposure may result in light headiness, dizziness, nausea. Chronic
Effect: Prolonged and repeated over-exposure to solvents may result in permanent brain
and nervous system damage. May cause kidney and liver damage. This product
contains chemicals known to the State of California to cause cancer and birth defects or
other reproductive harm.
EMERGENCY AND FIRST AID PROCEDURES
Ingestion (swallowing) Call a physician immediately. DO NOT give anything by mouth to induce vomiting.
Wash with soap and water. Remove contaminated clothes.
Skin Contact
Flush with water for 15 minutes. If irritation persists, call a physician immediately.
Eye Contact
Inhalation (breathing) Remove person to fresh air to avoid further inhalation.
NOTE TO PHYSICIANS: Exposure to high concentrations of this
Comments
material (e.g. enclosed areas) may be associated with cardiac arrhythmias.
SPILL OR RELEASE CONTROL PROCEDURES
Steps to be taken in case material is released or spilled
Eliminate all ignition sources. Ventilate area & restrict entry. Wear protective equipment. Remove with inert
absorbent.
Waste Disposal Method
Do not incinerate. Dispose of in accordance with Federal, State and Local regulations.
Page 3
Wynn's Professional Products
Silicone Lubricant - Aerosol
WC 52630, 52633 - MSDS
11-09-05
EPA Reportable Quantity (RQ), 40CFR302 (CERCLA104)
N/A
EPA Toxic Chemical Release Reporting, 40CFR372(SARA313)
Chemical CAS NO. % in Product
Hexane 110-54-3 10-30
HANDLING AND STORAGE
Handling and Storage Precautions
DANGER: Extremely flammable. Harmful if inhaled. Avoid breathing of vapors, spray mist. Avoid skin and eye
contact. KEEP AWAY from heat, sparks, open flame. Wear respiratory protection equipment.
Other Precautions
DO NOT PUNCTURE.
DO NOT INCINERATE.
KEEP OUT OF REACH OF CHILDREN.
PERSONAL PROTECTION - EXPOSURE CONTROL
Ventilation
Provide explosion proof exhaust in confined areas to maintain exposure levels below TLV limits.
Respiratory Protection
Normal use, none required.
Eye Protection
Safety glasses.
Protective Gloves
Impervious gloves.
Other Protective Clothing or Equipment
None.
Work/Hygienic Practices
Personal cleanliness is always appropriate. Frequent washing minimizes chances of inadvertent exposure.
Page 4
Wynn's Professional Products
Silicone Lubricant - Aerosol
WC 52630, 52633 - MSDS
11-09-05
TRANSPORTATION INFORMATION
Department of Transportation (DOT) Classification
Flammable Liquid Corrosive
Flammable Solid Non-Flammable Gas
XXX Flammable Gas Not Hazardous by DOT
Combustible Liquid Other:
DOT Proper Shipping Name
Aerosols, flammable.
(Consumer Commodity, ORM-D may be used for ground transportation within the USA.)
DOT ID Number
UN 1950
DOCUMENTATION
Product Code No.: 52630, 52633 Issue Date: 11-09-05
Previous Code No.: 52630, 52633 Prior Date: 03-04-05
This information is, to the best of our knowledge and belief, accurate and reliable as of the date compiled. However, no
representation, warranty or guarantee is made as to its accuracy, reliability or completeness. It is the user's responsibility
to satisfy himself as to the suitability and completeness of such information for his own particular use.
Page 5
|