MATERIAL SAFETY DATA SHEET
SECTION 1 - PRODUCT AND COMPANY IDENTIFICATION
PRODUCT NAME: 3101 SOLVENT BLEND
GENERAL USE: Cleaning solvent
PRODUCT DESCRIPTION: Colorless flammable liquid
NSN: 6850-01-469-1109 (55-gal), 6850-01-468-8855 (5-gal), 6850-01-481-1299 (1-gal)
MANUFACTURER'S NAME DATE PREPARED: November 2, 2006
Page 1 of 4
Dysol Inc. (formerly Dynamold Solvents, Inc.) SUPERSEDES: September 1, 2006
ADDRESS (NUMBER, STREET, P.O. BOX) TELEPHONE NUMBER FOR INFORMATION
2901 Shamrock Avenue (817) 335-1826
MATERIAL SAFETY DATA SHEET COUNTRY EMERGENCY TELEPHONE NUMBER
Fort Worth, TX 76107 USA CHEM ?TEL (800) 255-3924 Outside USA (813) 248-0585
DISTRIBUTOR'S NAME
ADDRESS (NUMBER, STREET, P.O. BOX) TELEPHONE NUMBER FOR INFORMATION
(CITY, STATE AND ZIP CODE) COUNTRY EMERGENCY TELEPHONE NUMBER
SECTION 2 - HAZARDOUS INGREDIENTS
OSHA PEL ACGIH TWA
% SARA RQ
HAZARDOUS COMPONENTS CAS # TITLE III LBS
(by weight) PPM MG/M3 PPM MG/M3
Methyl ethyl ketone (a,b,c) 78-93-3 50 200 590 200 Yes 5000
Acetone (a,b) 67-64-1 50 1000 2400 500 5000
(a,c) See Section 15
(b) Indicates that the Resource Conservation and Recovery Act (RCRA) has determined the waste for this chemical is listed as hazardous and must be handled
according to regulations in 40 CFR 260-281.
SECTION 3 - HAZARDS IDENTIFICATION
EMERGENCY OVERVIEW
Colorless highly flammable liquid, hazardous vapors. Can cause serious or fatal complications if swallowed. Can cause eye and skin irritation
upon contact. Inhalation of vapors can cause anesthetic effect leading to death in poorly ventilated areas.
POTENTIAL HEALTH EFFECTS
INHALATION: High concentrations are irritating to the respiratory tract; may cause headache, dizziness, nausea, vomiting and malaise.
SKIN: Brief contact may cause slight irritation; prolonged contact may cause moderate reddening, swelling and possible necrosis.
EYES: Contact causes severe irritation and pain associated with redness and swelling of the conjunctiva.
INGESTION: Moderately toxic; may cause headache, dizziness, diarrhea and general weakness; large doses may result in red blood cell
hemolysis.
CARCINOGENICITY No No No
NTP? IARC MONOGRAPHS? OSHA REGULATED?
MATERIAL SAFETY DATA SHEET
PRODUCT NAME: 3101 SOLVENT BLEND
Page 2 of 4
November 2, 2006
SECTION 4 - FIRST AID MEASURES
INHALATION: Remove affected person to fresh air; provide oxygen if breathing is difficult; if affected person is not breathing, administer CPR
and seek emergency medical attention.
SKIN: Remove contaminated clothing; wash affected area with soap and water; launder contaminated clothing before reuse; if irritation
persists, seek medical attention.
EYES: Check for and remove contact lenses. Flush eyes with clear running water for 15 minutes while holding eyelids open; if irritation
persists, seek medical attention.
INGESTION: Give two glasses of water for dilution; Induce vomiting by sticking fingers down throat; never give anything by mouth to an
unconscious person; seek medical attention.
SECTION 5 - FIRE FIGHTING MEASURES
FLAMMABLE LIMITS LEL: 2.6% UEL: 12.8%
FLASH POINT (METHOD USED)
AUTOIGNITION TEMPERATURE: NFPA CLASS:
869?F (465?C)
-2?F ( -18.9?C ) TCC IB
GENERAL HAZARDS: Product is flammable. Products of combustion include compounds of carbon, hydrogen and oxygen, including carbon
monoxide.
EXTINGUISHING MEDIA
Carbon dioxide, water, water fog, dry chemical, chemical foam.
FIRE FIGHTING PROCEDURES
Self - contained respiratory equipment; cool containers to prevent pressure buildup and possible explosion when exposed to extreme heat.
Caution - material is flammable!
UNUSUAL FIRE AND EXPLOSION HAZARDS
Closed containers can explode due to buildup of pressure when exposed to extreme heat. Vapors may cause a flash fire or ignite
explosively. Vapors may travel a considerable distance to a source of ignition and flash back.
HAZARDOUS COMBUSTION PRODUCTS
Smoke, fumes or vapors, oxides of carbon.
SECTION 6 - ACCIDENTAL RELEASE MEASURES
STEPS TO BE TAKEN IN CASE MATERIAL IS RELEASED OR SPILLED: CAUTION - FLAMMABLE - Evacuate and ventilate area; confine
and absorb into absorbent; place material into approved containers for disposal; for spills in excess of allowable limits (RQ) notify the National
Response Center (800) 424 - 8802; refer to CERCLA 40 CFR 302 and SARA Title III, Section 313 40 CFR 372 for detailed instructions
concerning reporting requirements. Do not discharge into lakes, ponds, streams or public waters.
SECTION 7 - HANDLING AND STORAGE
PRECAUTIONS TO BE TAKEN IN HANDLING AND STORAGE: Keep container closed when not in use; protect containers from abuse;
protect from extreme temperatures. CAUTION - FLAMMABLE - keep away from all sources of ignition. "Empty" containers may contain
residue which may form explosive vapors. Do not weld or cut near empty container that has not been professionally reconditioned. Use non-
sparking tools when opening and closing containers. Maintain well ventilated work areas to minimize exposure when handling this material.
SECTION 8 - EXPOSURE CONTROLS / PERSONAL PROTECTION
ENGINEERING CONTROLS
The use of local exhaust ventilation is recommended to control emissions near the source. Provide mechanical ventilation of confined spaces.
Use explosion-proof ventilation equipment.
PERSONAL PROTECTION:
RESPIRATORY PROTECTION: None required while threshold limits are kept below maximum allowable concentrations; if TWA exceeds
limits, NIOSH approved respirator must be worn. Refer to 29 CFR 1910.134 or European Standard EN 149 for complete regulations.
PROTECTIVE GLOVES: Neoprene, butyl or nitrile rubber gloves with cuffs.
EYE PROTECTION: Chemical splash goggles. Refer to 29 CFR 1910.133 or European Standard EN166.
OTHER PROTECTIVE CLOTHING OR EQUIPMENT: Safety eyewash station nearby.
WORK / HYGIENIC PRACTICES: Practice safe workplace habits. Minimize body contact with this, as well as all chemicals in general.
MATERIAL SAFETY DATA SHEET
PRODUCT NAME: 3101 SOLVENT BLEND
Page 3 of 4
November 2, 2006
SECTION 9 - PHYSICAL AND CHEMICAL PROPERTIES
VAPOR PRESSURE VAPOR DENSITY (AIR = 1)
185 mm Hg @ 20?C 2.8
SPECIFIC GRAVITY (WATER = 1) EVAPORATION RATE (Water = 1)
0.799 5
SOLUBILITY IN WATER FREEZING POINT
Complete Not determined
pH APPEARANCE AND ODOR
Not applicable Colorless liquid, characteristic ketone odor
BOILING POINT PHYSICAL STATE
132?F ( 56?C ) Liquid
VISCOSITY VOLATILE ORGANIC COMPOUNDS (Total VOC's)
13 cps @ 25?C 6.7 lbs / gal (799 gms / liter)
SECTION 10 - STABILITY AND REACTIVITY
CONDITIONS TO AVOID: Extreme temperatures, open flames, sparks.
STABILITY UNSTABLE:
STABLE: XXX
INCOMPATIBILITY (MATERIALS TO AVOID): Strong oxidizers, strong acids.
HAZARDOUS DECOMPOSITION OR BYPRODUCTS: Decomposition will not occur if handled and stored properly. In case of a fire, oxides
of carbon, hydrocarbons, fumes or vapors, and smoke may be produced.
CONDITIONS TO AVOID: None
HAZARDOUS POLYMERIZATION MAY OCCUR:
WILL NOT OCCUR: XXX
SECTION 11 - TOXICOLOGICAL INFORMATION
LD50 of Ingredient LC50 of Ingredient
Hazardous Ingredients CAS # (Specify Species and Route) (Specify Species)
3400 mg / kg 8000 ppm / 8H
Methyl ethyl ketone (a,b,c) 78-93-3
Oral - rat Inhalation - rat
9750 mg / kg 16,000 ppm / 4H
Acetone (a,b) 67-64-1
Oral - rat Inhalation - rat
SECTION 12 - ECOLOGICAL INFORMATION
No data are available on the adverse effects of this material on the environment. Neither COD nor BOD data are available. Based on the
chemical composition of this product it is assumed that the mixture can be treated in an acclimatized biological waste treatment plant system
in limited quantities. However, such treatment should be evaluated and approved for each specific biological system. None of the ingredients
in this mixture are classified as a Marine Pollutant.
SECTION 13 - DISPOSAL CONSIDERATIONS
WASTE DISPOSAL METHOD: Dispose of in accordance with Local, State, and Federal Regulations. This product may produce hazardous
vapors in a closed disposal container creating a dangerous environment. Refer to "40 CFR Protection of Environment Parts 260 - 299" for
complete waste disposal regulations. Consult your local, state, or Federal Environmental Protection Agency before disposing of any
chemicals. Do not flush to sanitary sewer or waterway.
SECTION 14 - TRANSPORT INFORMATION
PROPER SHIPPING NAME: Paint related material
DOT HAZARD CLASS / Pack Group: 3 / II
REFERENCE: 49 CFR 173.150, .173, .242
UN / NA IDENTIFICATION NUMBER: UN 1263 HAZARD SYMBOLS: F
LABEL: FLAMMABLE LIQUID Hazard Identification Number (HIN): 33
Note: Transportation information provided is for reference only. Client is urged to consult CFR 49 parts 100 - 177, IMDG, IATA, EC, United
Nations TDG, and WHMIS (Canada) TDG information manuals for detailed regulations and exceptions covering specific container sizes,
packaging materials and methods of shipping.
MATERIAL SAFETY DATA SHEET
PRODUCT NAME: 3101 SOLVENT BLEND
Page 4 of 4
November 2, 2006
SECTION 15 - REGULATORY INFORMATION
TSCA (Toxic Substance Control Act)
All components of this product are listed on the U.S. Toxic Substances Control Act Chemical Inventory (TSCA Inventory) or are exempted
from listing because a Low Volume Exemption has been granted in accordance with 40 CFR 723.50.
SARA TITLE III (Superfund Amendments and Reauthorization Act)
311/312 Hazard Categories
Fire hazard, Immediate health
313 Reportable Ingredients:
(a) Indicates a toxic chemical subject to annual reporting requirements of Section 313 of the Emergency Planning and Community Right-To-
Know Act of 1986 and of 40 CFR 372.
CERCLA (Comprehensive Response Compensation and Liability Act)
(c) The Comprehensive Environmental Response, Compensation, and Liability Act (CERCLA) has notification requirements for releases or
spills to the environment of the Reportable Quantity (RQ for this mixture > 24,000 lbs) or greater amounts, according to 40 CFR 302.
California Prop 65, Safe Drinking Water and Toxic Enforcement Act of 1986
There are no chemicals present known to the state of California to cause cancer or reproductive toxicity.
CPR (Canadian Controlled Products Regulations)
This product has been classified in accordance with the hazard criteria of the Controlled Products Regulations and the MSDS contains all
the information required by the Controlled Products Regulations. WHMIS Classification: B2, D2B
IDL (Canadian Ingredient Disclosure List)
Components of this product identified by CAS number and listed on the Canadian Ingredient Disclosure List are shown in Section 2.
DSL / NDSL (Canadian Domestic Substances List / Non-Domestic Substances List)
Components of this product identified by CAS number are listed on the DSL or NDSL, or are otherwise in compliance with the New
Substances Notification (NSN) regulations. Only ingredients classified as "hazardous" are listed in Section 2 unless otherwise indicated.
SECTION 16 - OTHER INFORMATION
Specific toxicity tests have not been conducted on this product. Our hazard evaluation is based on Information from similar products, the
ingredients, technical literature, and/or professional experience.
HMIS HAZARD RATINGS * = Chronic Health Hazard 2 = MODERATE
HEALTH 1
0 = INSIGNIFICANT 3 = HIGH
FLAMMABILITY 3
1 = SLIGHT 4 = EXTREME
PHYSICAL HAZARD 0
PERSONAL PROTECTIVE EQUIPMENT Safety Glasses, Gloves
B
REVISION SUMMARY:
This MSDS has been revised in the following Format update
sections:
MSDS Prepared by: Comprehensive Data Base, Inc.
P.O. Box 5604
Lakeland, FL 33807 USA
(863) 644 - 3298 www.compdatabase.com
The information contained herein is believed to be accurate but is not warranted to be so. Data and calculations are based on information furnished by
the manufacturer of the product and manufacturers of the components of the product. Users are advised to confirm in advance of need that
information is current, applicable and suited to the circumstances of use. Vendor assumes no responsibility for injury to vendee or third persons
proximately caused by the material if reasonable safety procedures are not adhered to as stipulated in the data sheet. Furthermore, vendor assumes
no responsibility for injury caused by abnormal use of this material even if reasonable safety procedures are followed. Any questions regarding this
product should be directed to the manufacturer of the product as described in Section 1.
|