SAF-T-LOK Material Safety Data Sheet
International Corporation DRY FILM MOLY LUBE
Issue Date: 1/19/09
SECTION I - PRODUCT AND COMPANY INFORMATION
Product Name: DMA-12 DRY FILM MOLY LUBE
Product Type: Lubricant
85856
Part Numbers:
Hazard Rating: Health: 2 Fire: 3 Reactivity: 1
Company Identification: SAF-T-LOK International Corporation
300 EISENHOWER LANE NORTH
LOMBARD, IL 60148
Contact: Helen Sherry
Telephone/ Fax: (630) 495-2001
Emergency Phone (24 Hour): (703) 527-3887
Chemtrec (24 Hour): (800) 424-9300
Preparer: Ind. Hygiene Department
Internet: www.saftlok.com
Product Class: Mixture
DOT Hazard Class: Aerosols
Shipping Name: Flammable Gas
SECTION II - INGREDIENT AND HAZARD INFORMATION
Components CAS# OSHA PEL ACGIH TLV Percent
Acetone 67-64-1 750 ppm 750 ppm 42
*Methyl-ethyl ketone 78-93-3 200 ppm 200 ppm 20
Isopropyl alcohol 67-63-0 400 ppm 400 ppm 10
Molybdenum disulfide 1317-33-5 10 mg/m 10 mg/m3 2
Propane 74-98-6 1000 ppm Asphyxiant 12
Butane 106-97-8800 ppm 800 ppm 11
*Indicates toxic chemical subject to the reporting requirements of section 313 of Title III and of 40 DFR 372.
SECTION III - HAZARD IDENTIFICATION AND EMERGENCY OVERVIEW
EMERGENCY OVERVIEW
Physical appearance: Aerosol HMIS
Health: 2
Flammability: 3
Reactivity: 1
Personal Protection: B
WARNING; MAY CAUSE: EYE IRRITATION
SKIN IRRITATION
RESPIRATORY TRACT IRRITATION
MAY IRRITATE EXISTING ALLERGIC SKIN CONDITIONS
Relative routes of entry: Skin, Inhalation, Eyes
Skin Contact: Usually no effect, however, as with any chemical, prolonged, excessive, or repeated exposure
may cause mild to moderate skin irritation, exhibited by redness, drying and cracking of unprotected skin.
Page 1 of 3 Product: DMA-12
Eye Contact: May irritate with slight pain and redness.
Respiratory/ Inhalation: Dizziness, Headache, Nausea, Fatigue, Drowsiness, Impaired co-ordination
Ingestion: Amounts transferred to mouth by fingers, etc, during normal operation should not cause injury.
Medical conditions generally aggravated by exposure: Liver and Kidney disease, Anemia, Coronary disease
SECTION IV ?FIRST AID INSTRUCTIONS
Skin Contact: Remove contaminated clothing. Wash affected area with soap and rinse with plenty of water.
Get medical attention if symptoms occur. Wash clothing before reuse.
Eye Contact: Flush with water for at least 15 minutes holding eyelid open. Get medical attention if
symptoms persist.
Respiratory / Inhalation: Remove to fresh air, if symptoms develop get medical attention.
Ingestion: Do not induce vomiting. Obtain medical attention if symptoms develop.
SECTION V ?FIRE FIGHTING INSTRUCTIONS
Flash Point: -156癋 (Estimate.)
Unusual Fire and Explosion Hazards: Closed containers may explode from internal pressure build-up
When exposed to extreme heat and discharge contents.
Flammable Limits: LEL: 1.8, UEL: 13
Extinguishing Media: Carbon Dioxide, Foam, Dry Chemicals, Water fog
Fire Fighting Procedures: Air mask, goggles, and procedures for fighting chemical fires
SECTION VI -ACCIDENTAL RELEASE MEASURES
Special Precautions: Avoid breathing vapors. Ventilate area. Remove all sources
Of ignition.
Environmental precautions: Prevent material from entering floor drains, sewers, or
any bodies of water.
Clean up methods: Clean up area with absorbent material.
Store in a closed container until disposal.
SECTION VII - HANDLING AND STORAGE
Handling: Avoid contact with eyes, skin, and clothing. Avoid
breathing vapors. Wash hands thoroughly at mealtime
and end of shift.
Storage: Store in a cool location (60-90癋) in a well ventilated
area away from sources of heat. Do not puncture or
Incinerate (burn) cans. Do not stick pin, nail or any other
Sharp object into opening on top of can. Do not spray in
Eyes.
Personal Protection: Wear personal protective equipment as outlined in
Section VIII of this MSDS.
SECTION VIII ?EXPOSURE CONTROLS AND PERSONAL PROTECTION
Respiratory Protection: No respiratory protection required under normal use, but
normal good ventilation is recommended. Forced ventilation
may be required if concentrations exceed normal use
exposure.
Page 2 of 3 Product: DMA-12
Skin Protection: Use impermeable gloves (neoprene, butyl rubber,
natural rubber), as necessary to avoid skin contact, as
well as proper clothing or plastic apron. Wash hands
before eating, drinking, or using restroom.
Eye Protection: None under normal use, however, use of safety glasses with
Splash guards or full face shield is recommended.
Eye Washes: Eye wash stations should be located within 100 feet or
10 second walk of the work area.
SECTION IX - PHYSICAL AND CHEMICAL PROPERTIES
Physical state: Aerosol
Boiling Point: -44癋 ?177癋
Specific Gravity: 0.73
Vapor Density (Air = 1): N/A
Vapor Pressure (mm Hg.): N/A
pH: N/A
Melting Point: N/A
Evaporation Rate: N/A
Solubility in Water: Slight to Moderate
SECTION X 璖TABILITY AND REACTIVITY
Stability: Stable
Hazardous Polymerization: Will not occur.
Hazardous decomposition byproducts: May produce fumes when heated to decomposition. Fumes
May contain carbon monoxide
Incompatibility: Strong Oxidizing agents
SECTION XI ?TOXICOLOGICAL INFORMATION
Carcinogen Status
NTP Carcinogen: No IARC Monographs: No OSHA Regulated: No
SECTION XII ?ECOLOGICAL DATA
Water Hazard: No
SECTION XIII ?DISPOSAL CONSIDERATIONS
Recommended method of disposal: Dispose of according to Federal, State and local regulations.
SECTION XIV ?SHIPPING AND TRANSPORTATION INFORMATION
U.S. Department of Transportation Ground (49 CFR)
Proper Shipping Name: Aerosol
Hazard Class or Division: Flammable Gas
Identification Number: UN 1950
SECTION XV ?REGULATORY INFORMATION
See Section II
SECTION XVI ?OTHER INFORMATION
Revision date: 03-07-07
DISCLAIMER: The information on this material safety data sheet represents our current data and best
opinion as to the proper use in handling of this product under normal conditions. Any use of the product
which is not in conformance with this data sheet or which involves using the product in combination with any
other product or any other process is the responsibility of the user. SAF-T-LOK International Corporation
specifically disclaims all warranties, express or implied, including warranties of merchantability and fitness
for a particular purpose, arising from sale or use of SAF-T-LOK International Corporation products.
Page 3 of 3 Product: DMA-12
|