69 Waione Street
Issue Date 11/10/07
Petone, New Zealand
Page 1 of 3 PO Box 38 079, Petone
Tel 0-4-568 8046
Replaces 18/04/01
Fax 0-4-568 8043
MATERIAL SAFETY DATA SHEET (MSDS)
IDENTIFICATION
PRODUCT: 5 MINUTE EPOXY ADHESIVE
PART A OF A TWO PART UNIT
Not classified
Chemical Mercaptan - Terminated Polymer UN No
(mixture)
Family
Not classified
Hazard Class
Proper
Not Applicable
Subsidiary Risk
Shipping
Name
2Y
Hazchem Code
Part A of a two part epoxy resin adhesive
Use
Not classified
Poisons Schedule
Specific Gravity 1.14
Slight odour ; ammonia like
Odour
Not determined
Boiling Insoluble
Solubility
Point 癈 in Water
Melting Point 癈 Not applicable Flash Point 癈 >150
Not determined
Vapour
Pressure
Autoignition Not established.
Not determined.
Flammability Temperature 癈
Limits
INGREDIENTS: Content CAS. No
-TRIS(DIMETHYLAMINOMETHYL)PHENOL HIGH 90-72-2
Content: High >60%, Medium 10 to 60%, Low 1 to 10%, Very Low <1% RND: Registered Not Disclosed
MSDS: 5 Minute Epoxy Adhesive 11/10/07
Part A of a two part unit Page 2 of 3
HEALTH HAZARD INFORMATION
HEALTH EFFECTS
Swallowed
Moderately toxic.
Eye
Strong irritant.
Skin
Strong irritant. Can be slightly absorbed through skin. Repeated or prolonged skin contact can
cause sensitisation.
Inhaled
High concentration of vapour can be harmful in enclosed spaces.
FIRST AID
Swallowed
If swallowed do NOT induce vomiting. Give a glass of water. Contact a doctor or National
Poisons Information Centre.
Eye
Hold eyes open, flood with water for at least 15 minutes and see a doctor.
Skin
Remove contaminated clothing and wash skin thoroughly.
Inhaled
Remove to fresh air. If breathing has ceased give artificial respiration and seek medical advice.
The National Poisons Information Centre
(03) 479 1200 during work hours
DUNEDIN (03) 474 7000 if Urgent
PRECAUTIONS FOR USE
EXPOSURE LIMITS (Dept of Labour Workplace Exposure Standards 1994)
(TLV = Threshold Value Limit, TWA = Time-Weighted Average, STEL = Short-Term Exposure Limit)
Major component has an acute oral LD50 (rat) of 2000mg/kg.
VENTILATION
Use in well ventilated areas.
Page 3 of 3
MSDS: 5 Minute Epoxy Adhesive
Part A of a two part unit 11/10/07
PERSONAL PROTECTION
Respiratory protection not required under normal conditions of use. Wear PVC or rubber gloves to
avoid skin contamination. Safety glasses should be worn.
FLAMMABILITY
Product is not flammable at normal temperatures of use.
SAFE HANDLING INFORMATION
STORAGE AND TRANSPORT
Material is a corrosive substance and should be stored and transported according to the relevant
Dangerous Goods and Toxic Substances regulations.
Store in original unopened containers in a cool area.
SPILLS AND DISPOSAL
Isolate spill and soak up with inert absorbent material such as clay or sand. Collect and seal into drums
for disposal. Ensure adequate ventilation during the clean up process. Dispose of according to Local
Government regulations.
FIRE/EXPLOSION HAZARD
Product is not flammable at normal temperatures.
EXTINGUISHING MEDIA
Foam, dry chemical, carbon dioxide.
SPECIAL FIRE FIGHTING PROCEDURES
Wear self contained breathing apparatus.
DANGEROUS DECOMPOSITION PRODUCTS
Oxides of nitrogen, carbon dioxide, carbon monoxide, hydrocarbons may be evolved during
combustion.
OTHER INFORMATION
Ensure that you obtain the latest MSDS's for any associated materials from Fosroc.
CONTACT POINT: The Technical Manager, phone (04) 568-8046 (business hours)
In emergency, or after hours, contact a doctor or the National Poisons Centre.
This MSDS was prepared following the recommended N.Z. Dept.of Health format. Data
IMPORTANT NOTE:
quoted is typical for the product, but does not constitute a specification; and is based on the most accurate information
available to Fosroc Ltd. at the time of writing. All information contained herein is given in good faith, but is subject
to change without notice, and no warranty expressed or implied is made as to its accuracy.