BoatCraft Pacific
MATERIAL SAFETY DATA SHEET
SECTION 1. PRODUCT IDENTIFICATION
Trade name CONTRACTOR'S EPOXY
Chemical Name & Synonyms Epoxy resin / amine hardener two component kit
Manufacturer BoatCraft Pacific Pty. Ltd.
22 Babdoyle St
Loganholme, Queensland 4129
Australia
Emergency Contact Telephone 07 3806 1944, (ah) 07 3299 1468
UN No. None allocated Hazchem N/A
DG Class None allocated Poisons Schedule 5
CAS No. Mixture Pkge Grp III
Intended usage A general purpose epoxy adhesive packaged as
two separate components
Classified as hazardous according to the criteria of Worksafe Australia
SECTION 2. INGREDIENTS
Epoxy resin CAS No. 25068-38-6 60 ?65 %
Aliphatic amine adducts CAS No. 26950-63-0 25 - 30 %
Triethylenetetramine CAS No. 112-24-3 < 10%
SECTION 3. PHYSICAL & EXPOSURE DATA
Physical data
Appearance / odour Viscous liquids, low amine odour
Boiling range High - N/A
Flash Point 195 deg C
Specific gravity 1.12
Vapour pressure Low at 20 deg C
Vapour density (air = 1) > 1 at 20 deg C
Volatile component (% vol) 0%
pH 11 - 13
Solubility with water Insoluble
Explosive limits N/A
Product Exposure Limits
TLV TWA epoxy resin No value assigned by NHMRC
TLV TWA amidoamine No value assigned by NHMRC
TLV TWA triethylenetetramine No value assigned by NHMRC
BoatCraft Pacific Pty. Ltd. A.C.N. 057-731-174
22 Babdoyle St., Loganholme, Queensland 4129
Tel (+61) 07 3806 1944 Fax (+61) 07 3209 7711
Email: info@boatcraft.com.au
BoatCraft Pacific
Toxicity and Irritation Data
LD(50) for ingestion (rat) ?epoxy resin 5 gm/kg
LD(50) for ingestion (rat) ?amines 3.5 gm/kg
SECTION 4. HEALTH HAZARD
Symptoms of Exposure: Acute and Chronic Effects
Ingestion:
Strong burning sensation, possible vomiting. Can result in irritation of the gastrointestinal tract and
mucous membranes. Considered as an unlikely route of entry in commercial/industrial environments.
Eye contact:
The amine hardener component may be severely irritating to the eyes and may burn eye tissue. High
concentrations of vapour may cause irritation.
Skin contact:
Liquid may be irritating to the skin and may be capable of causing allergic skin reactions. Repeated or
prolonged contact may lead to dermatitic effects and may cause sensitisation in some individuals.
Inhalation:
The vapour is mildly irritating to the mucous membranes and respiratory tract. The vapour pressure from
these products is very low at ambient temperatures and is unlikely to cause exposure from normal
handling. Frequent or prolonged exposure can cause respiratory irritation and may cause sensitisation in
some individuals. Overexposure symptoms include headache, swelling and congestion of the eyes and
sinuses.
Systemic and other effects:
The ingredients may cause adverse effects including sensitisation. Symptoms include itching rash and
respiratory congestion.
Emergency & First Aid Procedures
Ingestion:
DO NOT INDUCE VOMITING. If conscious give water or milk to rinse out mouth and drink. Provide
liquid slowly but as much as casualty will drink. Transport to hospital or doctor without delay. Activated
charcoal may be helpful.
Eye contact:
Immediately hold the eyes open and irrigate eyes with running water for at least 15 minutes. Ensure
irrigation under eyelids by occasionally lifting the upper and lower lids. Transport to doctor or hospital
without delay. Removal of contact lenses after an eye injury should only be undertaken by skilled
personnel.
Skin contact:
Immediately remove all contaminated clothing including footwear. Wash affected areas thoroughly with
detergent hand cleaner and rinse with plenty of water. Seek medical attention in event of irritation.
BoatCraft Pacific Pty. Ltd. A.C.N. 057-731-174
22 Babdoyle St., Loganholme, Queensland 4129
Tel (+61) 07 3806 1944 Fax (+61) 07 3209 7711
Email: info@boatcraft.com.au
BoatCraft Pacific
Inhalation:
Remove to fresh air, lie patient down, keep warm and rested. If breathing is shallow or has stopped,
ensure clear airway and apply resuscitation. Administer oxygen. Transport to hospital or doctor.
Notes to physician: Treat symptomatically.
SECTION 5. PERSONAL PROTECTION & HANDLING
Protective Equipment
Eyes: Goggles or face shield
Hands/feet: Rubber gloves, full overalls, safety shoes
Respiratory: Ensure adequate ventilation. Wear organic vapour respirator or self
contained breathing apparatus in enclosed areas.
Remove and wash all contaminated clothing and equipment.
Handling Procedures
Handle in well ventilated area. Always observe conditions of good industrial hygiene and safe working
practice.
SECTION 6. FIRE & EXPLOSION
Stability
Stable for minimum 2 years at room temperature. Excess heating over long periods will degrade
ingredients. .
Flammability
Products will support combustion if heated but will not spontaneously ignite or explode.
Hazardous Decomposition Products
On burning will emit toxic fumes of oxides of nitrogen, carbon monoxide and carbon dioxide.
Hazardous Polymerisation
Will not occur in absence of contact with reactive elements or unless the separately packed components
are mixed in large quantities. This will cause irreversible polymerization with considerable heat build-up.
Incompatibility
Avoid contact with water, strong acids, alkalis, oxidising materials.
Fire Fighting
Toxic fumes will be evolved when this material is involved in a fire. Fire fighters must wear full protective
clothing and self contained breathing apparatus.
Extinguishing Media
Foam, carbon dioxide, dry chemical powder.
BoatCraft Pacific Pty. Ltd. A.C.N. 057-731-174
22 Babdoyle St., Loganholme, Queensland 4129
Tel (+61) 07 3806 1944 Fax (+61) 07 3209 7711
Email: info@boatcraft.com.au
BoatCraft Pacific
SECTION 7. STORAGE & TRANSPORT
DG Class Non hazardous
Packaging Group & Label III
Suitable Containers Pre-packaged
Storage Procedures Containers will develop pressure at high
temperatures. Store at room temperature under
cover in accordance with AS1940 and State Poisons
Acts.
Transport Not regulated for transport under UN and local
regulations.
SECTION 8. SPILLS & DISPOSAL
Minor spill Absorb into waste cloth or other suitable absorbent. Avoid
contact with skin or eyes.
Major spill Contain with sand or earth, absorb with suitable absorbent, collect
and seal in properly labelled drums for disposal. Prevent run-off
into drains or waterways.
Disposal Suitable for incineration by approved agent or bury in approved
landfill according to local regulations.
SECTION 9. AUTHORISATION
Name: B.H. McConkey
Title Technical Director
Issue Date September 11, 2002
BoatCraft Pacific Pty. Ltd. A.C.N. 057-731-174
22 Babdoyle St., Loganholme, Queensland 4129
Tel (+61) 07 3806 1944 Fax (+61) 07 3209 7711
Email: info@boatcraft.com.au
|