1
MM-0210
MATERIAL SAFETY DATA SHEET
I. IDENTIFICATION .
MANUFACTURED BY: Diamond Vogel Paint REVISED: 09/18/2009
1020 Albany Place SE PRINTED: 09/25/2009
Orange City, IA 51041
General Information:
24 Hour Emergency Telephone Mon-Fri 8 AM - 5 PM
CHEMTREC 1-800-424-9300 712-737-4993
TRADE NAME: V-Cote 111 Epoxy W/R Cure (Part B)
MFG. PRODUCT NUMBER: MM-0210
II. HAZARDOUS INGREDIENTS .
CAS #68410-23-1 Polyamide resin WT %: 20-50
ACGIH TLV: ACGIH STEL:
OSHA PEL: OSHA CEILING: OSHA PEAK:
VAPOR PRESSURE: LEL%:
CAS #85-68-7 Butyl benzyl phthalate WT %: 20-50
ACGIH TLV: ACGIH STEL:
OSHA PEL: OSHA CEILING: OSHA PEAK:
VAPOR PRESSURE: LEL%:
CAS #9046-10-0 Polyoxypropylenediamine WT %: 5-20
ACGIH TLV: NE ACGIH STEL: NE
OSHA PEL: NE OSHA CEILING: NE OSHA PEAK: NE
VAPOR PRESSURE: 1 mmHg@212F LEL%: 0.7
Trade Secret WT %: 1-5
ACGIH TLV: n.e. ACGIH STEL: n.e.
OSHA PEL: n.e. OSHA CEILING: n.e. OSHA PEAK: n.e.
VAPOR PRESSURE: 0.01 mmHg21c LEL%:
CAS #112-24-3 Triethylenetetramine WT %: 1-5 Footnote: (1,2)
ACGIH TLV: N.E ACGIH STEL: N.E.
OSHA PEL: N.E. OSHA CEILING: N.E. OSHA PEAK: N.E.
VAPOR PRESSURE: .01mmHg 68F LEL%:
WARNING MESSAGES:
(1) Reports have associated repeated and prolonged occupational overexposure to solvents
with permanent brain and nervous system damage. Intentional misuse by deliberately
concentrating and inhaling the contents may be harmful or fatal. Chronic exposure may
cause damage to the central nervous system, respiratory system, lung, eye, skin, liver,
gastrointestinal tract, spleen, kidneys, and blood.
(2) The above material is being studied and evaluated, by various government agencies and
independent research groups, for its health effects on humans.
(3) See Section IX for reportable Hazardous Air Pollutants.
III. PHYSICAL DATA .
BOILING RANGE: 266-513?F
EVAPORATION RATE: * slower than ether *
PERCENT VOLATILE BY VOLUME: 0.00% WEIGHT PER GALLON: 8.67 LBS
2
MM-0210
VAPOR DENSITY: * heavier than air *
ACTUAL VOC (lb/gal): 0.00
EPA VOC (lb/gal): 0.00 EPA VOC (g/L): 0.00
IV. FIRE AND EXPLOSION HAZARD DATA .
FLASH POINT: 121?C 250?F LEL: Refer to Section II
FLAMMABILITY CLASSIFICATION: CLASS IIIB
HAZARD CLASSIFICATION: *Combustible Liquid* CORROSIVE
EXTINGUISHING MEDIA: Use water spray, dry chemical, foam, or Carbon
Dioxide. Use water spray to cool fire-exposed
containers.
UNUSUAL FIRE AND EXPLOSION HAZARD: Keep away from heat, sparks, and flame.
May generate toxic or irritating combustion products.
May generate carbon monoxide or toxic nitrogen gases.
SPECIAL FIRE FIGHTING PROCEDURES:
In case of fire and/or explosion do not breathe fumes. Use
water spray to reduce vapors. If water pollution occurs,
notify appropriate authorities. Wear NIOSH approved
self-contained breathing apparatus with independent air
supply. Keep containers cool with water spray. Avoid skin
contact.
V. HEALTH HAZARD DATA .
THRESHOLD LIMIT VALUE: See Section II.
EFFECTS OF OVEREXPOSURE:
CORROSIVE
ACUTE: Eye contact- Severe irritant, chemical burn possible,
possible tissue damage.
Skin contact- Severe irritant, corrosion to tissue, possible
skin burns.
Inhalation- Moderate to severe irritant.
Ingestion- Severe irritation, possible gastrointestinal tract.
CHRONIC: Slightly toxic with repeated inhalation or ingestion.
Causes burns to exposed tissue.
MEDICAL CONDITIONS GENERALLY AGGRAVATED BY EXPOSURE:
Eye disease, Skin disorders and Allergies
PRIMARY ROUTE(S) OF ENTRY: Ingestion, Skin Absorption, Inhalation
3
MM-0210
EMERGENCY AND FIRST AID PROCEDURES:
EYE CONTACT- Hold eyelids apart and immediately flush eyes
with plenty of water for at least 15 minutes. Call a
Physician.
SKIN CONTACT- Remove product and immediately flush affected area
with water for at least 15 minutes. Call a physician.
Except in the most minor, superficial and localized burns,
cover the affected area with a sterile dressing or clean
sheeting and transport for medical care. DO NOT APPLY
GREASES OR OINTMENTS. Control shock if present.
INHALATION- Move patient to fresh air. If breathing has stopped
or is labored give mouth-to-mouth respiration. Supplemental
oxygen may be indicated. Prevent aspiration of vomit. Turn
victim's head to the side. Assure mucus does not obstruct
airway. Call a physician.
INGESTION- In the event of ingestion, administer 3-4 glasses of
milk or water. DO NOT INDUCE VOMITING. Obtain medical care
and hospital treatment immediately. Note to physician: This
product is highly injurious to all tissues, similar to that
of ammonia or ammonia gas. Chemical pneumonitis, pulmonary
edema, laryngeal edema and delayed scarring of the airway or
other affected tissues may occur following exposure. There
is no specific treatment. Clinical management is based on
supportive treatment, which is similar to that for thermal
burns.
VI. REACTIVITY DATA .
STABILITY: *stable* HAZARDOUS POLYMERIZATION: *will not occur*
INCOMPATIBILITY:
Oxidizing agents, cleaning solutions, such as chromerge (sulfonic
acid/dichromate) and aqua regia. A reaction accompanied by large
heat release occurs when the product is mixed with acids. Heat
generated may be sufficient to cause vigorous boiling creating a
hazard due to splashing or splattering of hot material. CAUTION!
N-Nitrosamines, many of which are known to be potent carcinogens,
may be formed when the product comes in contact with nitrous acid,
nitrites or atmospheres with high nitrous oxide concentrations.
HAZARDOUS DECOMPOSITION PRODUCTS: Fire, burning and welding may
generate carbon monoxide, carbon dioxide,
ammonia. Nitrogen oxides in a fire.
Nitrogen oxide can react with water vapors
to form corrosive nitric acid. Combustion
of product under oxygen starved conditions
can be expected to produce numerous toxic
products including: nitriles, cyanic acid,
isocyanates, cyanogens, nitrosamines,
amides, carbamates. Irritating and toxic
fumes at elevated temperatures.
4
MM-0210
CONDITIONS TO AVOID: Avoid acid contamination and skin contact.
Keep containers tightly closed. No smoking
or eating in handling area.
VII. SPILL OR LEAK PROCEDURES .
STEPS TO BE TAKEN IN CASE MATERIAL IS RELEASED OR SPILLED:
Remove all sources of ignition (flames, hot surfaces and
electrical, static or frictional sparks). Avoid breathing
vapors. Ventilate area. Use non-sparking tools. Remove with
inert absorbant.
WASTE DISPOSAL METHOD: Dispose of in accordance with local, state, and
federal regulations.
VIII. SPECIAL PROTECTION INFORMATION .
RESPIRATORY PROTECTION: In confined areas of poor ventilation, use chemical
cartridge respirator or self-contained breathing
apparatus.
VENTILATION: Provide general dilution or local exhaust ventilation in
volume and pattern to keep TLV and LEL of most hazardous
ingredient in Section II, below acceptable limit.
PROTECTIVE GLOVES: Impermeable gloves to prevent skin contact.
EYE PROTECTION:
Splash proof eye goggles. In emergency situations, use eye
goggles with a full face shield.
OTHER PROTECTIVE EQUIPMENT: Protective clothing such as coveralls or lab
coats must be worn.
HYGIENIC PRACTICES: See Section V
IX. SPECIAL PRECAUTIONS .
PRECAUTIONS TO BE TAKEN IN HANDLING AND STORING: Do not store near heat,
sparks, flame, strong oxidizing agents or strong acids
OTHER PRECAUTIONS: Eye wash station and safety shower
should be available
This product contains no reportable Hazardous Air Pollutants.
_____________________________________________________________________________
|