MATERIAL SAFETY DATA SHEET
"ASEP-332" SELF ETCHING PRIMER Page: 1
PRODUCT NAME: SELF ETCHING PRIMER HMIS CODES: H F R P
PRODUCT CODE: ASEP-332 3*3 0 H
================== SECTION I - MANUFACTURER IDENTIFICATION
MANUFACTURED FOR Alsa Corporation
2640 East 37th Street
ADDRESS
Vernon, CA 90058
EMERGENCY PHONE 800-535-5053 / 352-323-3500 DATE PRINTED : 2/11/2005
INFORMATION PHONE (323)581-5200 PREPARER NAME: MSDS Coordinator
========== SECTION II - HAZARDOUS INGREDIENTS/SARA III INFORMATION
VAPOR PRESSURE WEIGHT
REPORTABLE COMPONENTS
CAS NUMBER mm Hg @ TEMP PERCENT
ETHYL ALCOHOL
64-17-5 44.25 68 F 53.66
OSHA PEL: 1000 ppm TWA OR 1900 mg/m3 TWA
ACGIH TLV: 1000 ppm TWA OR 1880 mg/m3 TWA
NIOSH: 1000 ppm TWA OR 1900 mg/m3 TWA
NIOSH: 3300 ppm IDLH
1-methoxy-2-propanol acetate
108-65-6 3.68 68 F 0%-10%
ISOBUTYL ALCOHOL
78-83-1 7.1 68 F 6.69
ACGIH TWA: 152 mg/m3
ACGIH TWA: 50 ppm TLV
OSHA TWA: 150 mg/m3
OSHA TWA: 50 ppm VPEL
* TOLUENE
108-88-3 22 68 F 6.66
ACGIH TLV: 150 ppm STEL (SKIN)
ACGIH TLV: 50 ppm TWA (SKIN)
OSHA VPEL: 150 ppm STEL OSHA
VPEL: 100 ppm TWA
* XYLENES
1330-20-7 5.10 68F 4.26
ACGIH TWA 100 ppm
ACGIH STEL 150 ppm
OSHA TWA 100 ppm
OSHA STEL 150 ppm
* METHYL ALCOHOL
67-56-1 30.3 77 F 2.37
OSHA VPEL TWA: 200.000 ppm SKIN
OSHA VPEL STEL: 250.000 ppm SKIN
ACGIH TLV TWA: 200.000 ppm SKIN
ACGIH TLV STEL: 250.000 ppm SKIN
* {N090, N982} ZINC CHROMATE
13530-65-9 N/A N/A 2.2321
ACGIH TLV: .05 mg/m3 Cr
OSHA PEL: .10 mg/m3 CrO3
108-10-1 16 68 F 1.02
* METHYL ISOBUTYL KETONE
OSHA TWA 50.000 ppm OSHA
STEL 75.000 ppm ACGIH TWA
50.000 ppm ACGIH STEL 75.000
100-41-4 5.1 68 F .75
ppm ETHYL BENZENE
OSHA PEL: 100 ppm TWA
ACGIH TVL: 100 ppm TWA
phenol
5 ppm TWA (SKIN) 108-95-2 0.4 68F .4908
OSHA PEL:
5 ppm TWA (SKIN)
ACGIH TLV
123-72-8 88.5 20 C .01
BUTYRALDEHYDE
50-00-0 N/A N/A .0098
FORMALDEHYDE
OSHA PEL: 0.7 5 ppm TWA
OSHA PEL: 2.00 ppm STEL
MA T E R I A L SAFETY DATA SHEET
"ASEP-332" SELF ETCHING PRIMER Page: 2
OSHA PEL: 0.5 ppm TWA ACTION LEVEL
ACGIH TLV: 0.3 ppm CEILING
* Indicates toxic chemical(s) subject to the reporting requirements of section 313 of Title III and of 40 CFR 372.
N/A
=============== SECTION III - PHYSICAL/CHEMICAL CHARACTERISTICS ============
BOILING RANGE: 147 F - 360 F SPECIFIC GRAVITY (H2O=1): .87
VAPOR DENSITY: Heavier than air EVAPORATION RATE: Slower than ether
V.O.C. grams/liter: 740.97 V.O.C. lbs/gl: 6.18
SOLUBILITY IN WATER: Insoluble SOLIDS BY VOLUME 9.266
APPEARANCE AND ODOR: Opaque liquid with an organic solvent odor.
=============== SECTION IV - FIRE AND EXPLOSION HAZARD DATA
FLASH POINT: 10.4 F METHOD USED: TAGCC
FLAMMABLE LIMITS IN AIR BY VOLUME- LOWER: 1.0 UPPER: 36.0
EXTINGUISHING MEDIA: Foam, Carbon Dioxide, Dry Chemical, Water Fog
SPECIAL FIREFIGHTING PROCEDURES
Full protective equipment, including self contained breathing apparatus, is recommended. Water from fog nozzles may be
used to cool closed containers to prevent pressure build up.
UNUSUAL FIRE AND EXPLOSION HAZARDS
When heated above flashpoint, emits flammable vapors which, when mixed with air, can burn or become explosive. Fine
mists or sprays may be flammable below the flash point.
=============== SECTION V - REACTIVITY DATA
STABILITY: Stable
CONDITIONS TO AVOID
Avoid all sources of ignition
INCOMPATIBILITY (MATERIALS TO AVOID)
Strong oxidi zing materials
HAZARDOUS DECOMPOSITION OR BYPRODUCTS
May produce hazardous fumes when heated to decomposition. Fumes may contain Carbon Monoxide and Carbon Dioxide.
HAZARDOUS POLYMERIZATION: Will not occur
==================== SECTION VI - HEALTH HAZARD DATA =======================
INHALATION HEALTH RISKS AND SYMPTOMS OF EXPOSURE
May cause nose and throat irritation. Repeated and prolonged exposure to organic solvents may lead to permanent brain
and nervous system damage. Eye watering, headaches, nausea, dizziness, and loss of coordination are signs that solvent
levels are too high.
Individuals with breathing problems must not be exposed to this product. If affected by inhalation, remove to fresh air.
If breathing difficulty persists, consult a physician.
SKIN AND EYE CONTACT HEALTH RISKS AND SYMPTOMS OF EXPOSURE
May cause irritation or burning of the eyes. Repeated and prolonged skin contact may cause skin irritation or
dermatitis. In case of eye contact, immediately flush eyes with plenty of water for at least 15 minutes; call a
physician. In case of skin contact, wash with soap and water. If irritation occurs, contact a physician.
MATERIAL SAFETY DATA SHEET
"ASEP-332" SELF ETCHING PRIMER Page: 3
INGESTION HEALTH RISKS AND SYMPTOMS OF EXPOSURE
Gastrointestinal distress. In the unlikely event of ingestion, call a physician immediately and have the names of all
ingredients available.
HEALTH HAZARDS (ACUTE AND CHRONIC)
ACUTE- Dizziness, irritation of the respiratory tract, weakness, nausea, or possible narcosis or even asphyxiation. be
accompanied by coughing or labored breathing.
CHRONIC- Reports have linked organic solvents with brain and nervous system damage. Misuse of this product by
deliberately concentrating and inhaling the contents may be harmful or fatal.
CARCINOGENICITY: NTP CARCINOGEN: Yes IARC MONOGRAPHS: Yes
PROPOSITION 65 STATEMENT: WARNING! This product contains a chemical known to the state of California to cause birth
defects or other reproductive harm.
OSHA REGULATED: Yes
MEDICAL CONDITIONS GENERALLY AGGRAVATED BY EXPOSURE
Do not use this product i f you have chronic lung or breathing problems.
EMERGENCY AND FIRST AID PROCEDURES
If ingestion, or any type of overexposure or symptoms of overexposure occur during the use of this product, contact a
poison control center, emergency room or physician immediately; have material safety data sheet available.
=========== SECTION VII - PRECAUTIONS FOR SAFE HANDLING AND USE ============
STEPS TO BE TAKEN IN CASE MATERIAL IS RELEASED OR SPILLED
Remove all sources of ignition (sparks, flames, and hot surfaces). Avoid breathing vapors. Ventilate area. Remove with
an inert absorbent and non-sparking tools.
WASTE DISPOSAL METHOD
Dispose in accordance with state ,federal and local regulations. Do not incinerate closed containers.
PRECAUTIONS TO BE TAKEN IN HANDLING AND STORING
Keep containers tightly closed in a cool, dry, well ventilated area away from all possible ignition sources. Store large
quanties of material in buildings designed for the storage of flammable liquids.
OTHER PRECAUTIONS
Employees should be trained in safety measures that should be taken when using this product.
===================== SECTION VIII - CONTROL MEASURES
RESPIRATORY PROTECTION
Avoid breathing vapors or spray mist. Wear a properly fitted respirator approved by NIOSH/MSHA (TC-23c) for use with
paints during application and until all vapors are exhausted. In confined areas, or where continuous spray operations are
typical, or proper respirator fit is not possible, wear a positive-pressure supplied air respirator (TC-19c). In all cases
follow respirator manufactures directions for respirator use. Do not allow anyone without protection into the painting
area.
VENTILATION
Provide sufficient ventilation to keep contaminates below applicable OSHA requirements.
PROTECTIVE GLOVES
MA T E R I A L SAFETY DATA SHEET
"ASEP-332" SELF ETCHING PRIMER Page: 4
Neoprene gloves impervious to organic solvents are recommended.
EYE PROTECTION
Use safety eyewear designed to protect against liquid splash.
OTHER PROTECTIVE CLOTHING OR EQUIPMENT
Impervious coveralls are recommended.
WORK/HYGIENIC PRACTICES
Eye wash and safety showers in the work place are recommended. Wash hands before eating and smoking.
SECTION IX - DISCLAIMER
The information contained in this material safety data sheet is information from our suppliers and other sources. It
believed to be reliable. This data is not to be taken as a warranty or representation for which this company assumes
legal responsibility.
|