MATERIAL SAFETY DATA SHEET
Date Printed: 09/15/2008 Page: 1
Product Code(s): 4663
________________________________________________________________________________
1. CHEMICAL PRODUCT AND COMPANY INFORMATION
Product Name: TRIM GLOSS BLACK
Product Code(s): 4663
Manufacturer/Supplier: TRANSTAR AUTOBODY TECHNOLOGIES
2040 Heiserman Dr.
Brighton, MI, 48114, USA
24 Hour Emergency Phone(s): 800-424-9300 (CHEMTREC), 613-996-6666 (CANUTEC)
Business Phone: 810-220-3000
Product Use: Adhesive
MSDS Prepared By: K. Oman
________________________________________________________________________________
2. COMPOSITION/INFORMATION ON INGREDIENTS
Ingredient(s) CAS Number % by Weight
---------------------------------------------------------------------------
Acetone 67-64-1 25- 40%
* Methylbenzene; Toluene 108-88-3 15- 25%
Propane 74-98-6 12.5
n-Butane 106-97-8 12.5
* Methyl Ethyl Ketone (MEK) 78-93-3 0 - 5%
n-Butyl Acetate 123-86-4 0 - 5%
Isobutyl Acetate 110-19-0 0 - 5%
* Propylene Glycol Monomethyl Ether Acetate108-65-6 0 - 5%
Carbon Black Pigment 1333-86-4 0 - 5%
Ethyl Benzene 100-41-4 0 - 5%
See Section 15. Regulatory Information for code descriptions
Weight percent (%) of 0.0 means chemical is in trace amounts.
________________________________________________________________________________
3. HAZARDS IDENTIFICATION
DANGER: EXTREMELY FLAMMABLE. CONTENTS UNDER PRESSURE. Aerosol cans
produce flammable vapors which can travel to a source of ignition and flash
back. IRRITANT.
HMIS Hazard Ratings: Health =2*, Flammability =3, Chemical Reactivity =0
Note: HMIS ratings involve data and interpretations that may vary
from company to company. They are intended only for rapid, general
identification of the magnitude of the specific hazard. To deal
adequately with the safe handling of this material, all the
information contained in this MSDS must be considered.
Potential Health Effects
Eyes: Moderate irritation to the eyes.
MATERIAL SAFETY DATA SHEET
Date Printed: 09/15/2008 Page: 2
Product Code(s): 4663
________________________________________________________________________________
Skin: Moderate irritation to the skin.
Inhalation: Moderate irritation to the respiratory system. May be harmful
if inhaled. High concentrations may be fatal.
Ingestion: Moderate irritation to the digestive tract.
________________________________________________________________________________
4. FIRST AID MEASURES
Seek professional medical attention for all over-exposures and/or
persistent problems.
Eyes Contact: Flush eyes with clean water for a minimum of 15 minutes.
Seek medical attention.
Skin Contact: Wash exposed area thoroughly with soap and water.
Inhalation: Remove person from area to fresh air. If breathing
difficulty persists, seek medical attention.
Ingestion: DO NOT INDUCE VOMITTING. Seek immediate medical attention.
________________________________________________________________________________
5. FIRE FIGHTING MEASURES
Flammable Properties
Flash Point: -156 Deg F, -104 Deg CMethod: TCC
Upper Explosive Limit (UEL): 12.8
Lower Explosive Limit (LEL): 0.8
Autoignition Temperature: No data
Extinguishing Media: Foam, Alcohol Foam, CO2, Dry Chemical, Water Fog,
Other.
Special Firefighting Procedures: Full fire fighter equipment including
SCBA should be worn to avoid skin contact and inhalation of
concentrated vapors. Minimize skin exposure. Highly toxic fumes may
be generated by thermal decomposition.
Hazardous Combustion Products: Carbon monoxide, carbon dioxide, oxides
of nitrogen.
Unusual Fire and Explosion Hazards: Vapors can travel to a source of
ignition and flash back. Aerosol cans contain flammable, pressurized
propellant. Cans will explode when exposed to flame, high heat and
temperatures. Combustion generates toxic fumes.
________________________________________________________________________________
6. ACCIDENTAL RELEASE MEASURES
For large spills or transportation accidents involving release of this
product, contact the Emergency Response Center: 800-424-9300.
Eliminate all sources of ignition, provide adequate ventilation, dike
spill area and add absorbent earth or sawdust to spilled liquid. Sweep
MATERIAL SAFETY DATA SHEET
Date Printed: 09/15/2008 Page: 3
Product Code(s): 4663
________________________________________________________________________________
up and dispose of in appropriate containers in accordance with
Federal, State and/or Local regulations.
________________________________________________________________________________
7. HANDLING AND STORAGE
Aerosol cans contain pressurized, flammable propellent. Cans will
burst if exposed to extreme heat or temperatures. Keep spray nozzle
pointed away from face and do not direct nozzle spray towards people
or animals. Avoid hot surfaces. Use in cool, well-ventilated areas.
Keep aerosol can capped when not in use. Keep away from excessive
heat and open flames. Follow all MSDS/label precautions even after
container is emptied because they may retain product residues. Store
in a cool area away from heat and flames. Do not reuse container when
empty.
________________________________________________________________________________
8. EXPOSURE CONTROLS/PERSONAL PROTECTION
Exposure Guidelines
Chemical Name/Exposure Limits CAS Number
---------------------------------------------------------------------------
Acetone 67-64-1
OSHA PEL: 750 ppm, ACGIH TLV: 750 ppm, OTHER: SETL1000pm
* Methylbenzene; Toluene 108-88-3
OSHA PEL: 200 ppm, 300 ppm ceiling
ACGIH TLV: 50 ppm (skin)
IDLH: 500 ppm
Propane 74-98-6
OTHER: TWA1000ppm
n-Butane 106-97-8
OTHER: TWA 800ppm
* Methyl Ethyl Ketone (MEK) 78-93-3
OSHA PEL: 200 ppm, ACGIH TLV: 200 ppm, OTHER: STEL 300 ppm
n-Butyl Acetate 123-86-4
OSHA PEL: 150, ACGIH TLV: 150, OTHER: STEL200ppm
Isobutyl Acetate 110-19-0
ACGIH TLV: 150 ppm
* Propylene Glycol Monomethyl Ether Acetate 108-65-6
OSHA PEL: N/A, ACGIH TLV: N/A, OTHER: N/A
Carbon Black Pigment 1333-86-4
OSHA PEL: 3.5 mg/m3, ACGIH TLV: 3.5mg/m3
Ethyl Benzene 100-41-4
OSHA PEL: 100 ppm, ACGIH TLV: 100 ppm, STEL 125ppm
NIOSH: 100ppm STEL 125ppm, IDLH: 800 ppm
Engineering Controls: General mechanical ventilation or local exhaust
should be utilized to keep vapor concentrations below exposure limits
(PEL & TLV). Ventilation equipment must be explosion proof.
Respiratory Protection: Utilize engineering controls to reduce
emission levels below the time weighted exposure limits (ACGIH TLV &
OSHA PEL). Wear an approved respirator if exposure limits are above
the exposure limits listed above.
Eye Protection: Use safety glasses or splash goggles.
MATERIAL SAFETY DATA SHEET
Date Printed: 09/15/2008 Page: 4
Product Code(s): 4663
________________________________________________________________________________
Skin Protection: Use chemical resistant gloves.
Safe Work Practices: Eye washes and safety showers in the workplace
are recommended. Avoid contact with skin and eyes. Avoid breathing
vapors. Wash hands thoroughly after using and before eating, drinking
or smoking. Employee education and training in the safe use and
handling of this product is required under the OSHA Hazard
Communication Standard 29CFR1200. When spraying an aerosol can, use
ventilation to minimize vapors. Smoking in area where this material
is used should be strictly prohibited. Always use protective clothing
and equipment. Remove all contaminated clothing and wash thoroughly
when finished working. Keep food and drink away from material and
from area where material is being used.
________________________________________________________________________________
9. PHYSICAL AND CHEMICAL PROPERTIES
Physical Form: Homogeneous mixture
Physical State: Liquid
Color: White
Odor: Organic solvent
Odor Threshold: No Data
Specific Gravity (water=1) 0.74
Vapor Pressure: No data
Vapor Density: Heavier than air
MIR: 1.42
% VOC: 53.7%
Evaporation Rate: Faster than Butyl Acetate
Boiling Point: -44鳩
Melting Point: No data
Freezing Point: No data
Viscosity at Ambient Temperature: No data
Solubility in Water: Insoluble
Octanol/Water Partition Coefficient: No data
pH: No data
________________________________________________________________________________
10. STABILITY AND REACTIVITY
Stability: Stable
Incompatibility: Strong acids, strong bases and strong oxidizing
agents.
Hazardous Polymerization: Will not occur.
________________________________________________________________________________
11. TOXICOLOGICAL INFORMATION
Effects of Exposure:
ACUTE:
INHALATION - Dizziness, breathing difficulty, headaches, & loss of
coordination.
EYE CONTACT - Moderate irritation, tearing, redness, and blurred
vision.
SKIN CONTACT - Moderate irritant. Can dry and defat skin causing
MATERIAL SAFETY DATA SHEET
Date Printed: 09/15/2008 Page: 5
Product Code(s): 4663
________________________________________________________________________________
cracks, irritation, and dermatitis.
INGESTION - Can cause gastrointestinal irritation, vomiting, nausea, &
diarrhea.
CHRONIC:
May affect liver, kidney and central nervous system with repeated
exposure.
Aerosol spraying may create an oxygen deficient environment. Use
proper ventilation to remove vapors, mists and fumes.
Aerosol propellents can cause asphyxia characterized by blueness of
the skin, difficulty breathing, headaches, loss of coordination and
unconsciousness.
Acute Toxicity Data: No data.
Carcinogenicity: NTP -No, IARC -Yes, OSHA -No
This product has not been tested for carcinogenic effects. Some
chemicals in this product may be identified by NTP, IARC and/or OSHA
as carcinogenic, indicated above as "Yes". No further information
available.
Teratology: No data.
Reproduction: No data.
Mutagenicity: No data.
________________________________________________________________________________
12. ECOLOGICAL INFORMATION
No data.
________________________________________________________________________________
13. DISPOSAL CONSIDERATIONS
Subject to hazardous waste generation, treatment, storage and
disposal. Product should be disposed of in accordance with all
governmental regulations. Subject to hazardous waste generation,
treatment, storage and disposal under RCRA, 40CFR261. Product should
be disposed of in accordance with all Federal, State and local
regulations.
________________________________________________________________________________
14. TRANSPORT INFORMATION
The following transportation information is provided based on Transtar
Autobody Technologies interpretation of shipping regulations. Each
shipper is responsible for identifying, naming, marking and labeling
prior to offering for transport.
USA (DOT) Status: Consumer Commodity ORM-D
Water (IMDG) Status: UN1950, AEROSOL, 2.1, Limited Quantity
Air (ICAO,IATA) Status: Aerosol, 2, UN1950
MATERIAL SAFETY DATA SHEET
Date Printed: 09/15/2008 Page: 6
Product Code(s): 4663
________________________________________________________________________________
Canada (TDG) Status: Consumer Commodity ORM-D
________________________________________________________________________________
15. REGULATORY INFORMATION
The information listed in this section is not all inclusive of all
regulations for this product or the chemical components of this
product.
US Federal Regulations
TSCA Status: All known major components of this product are listed on
the TSCA Inventory and/or are otherwise in compliance with TSCA.
SARA 302 (EHS) Status: No EHS chemicals present.
SARA 311/312 Status: Immediate Health Hazard, Delayed Health Hazard,
Fire Hazard, Sudden Release of Pressure
SARA 313 Status: * Indicates toxic chemical(s) subject to the
reporting requirements of section 313 of Title III and of 40 CFR 372.
OSHA Status: This material meets the requirement of hazardous material
and is subject to 29CFR1910.1200.
USA State Information
California Proposition 65: This product does not contain chemical(s)
known to the State of California to cause cancer or birth defects or
other reproductive harm.
Pennsylvania RtK Status: This material contains chemical(s) subject to
notification under Pennsylvania Right to Know.
New Jersey RtK Status: This material contains chemical(s) subject to
notification under New Jersey Right to Know.
Massachusetts RtK Status: This material contains chemical(s) subject
to notification under Massachusetts Right to Know.
Rhode Island RtK Status: This material contains chemical(s) subject to
notification under Rhode Island Right to Know.
International Regulations
Canada
DSL Status: All known major components of this product are listed on
the DSL Inventory and/or are otherwise in compliance with the DSL
NDSL Status: Contains no chemicals on the NDSL
WHMIS: B2 D1A D2A D2B
EINECS Status: All components of this material are listed on the
EINECS Inventory.
________________________________________________________________________________
16. OTHER INFORMATION
To the best of our knowledge, the information contained herein is
MATERIAL SAFETY DATA SHEET
Date Printed: 09/15/2008 Page: 7
Product Code(s): 4663
________________________________________________________________________________
accurate, obtained from sources believed by Transtar Autobody
Technologies to be accurate. As with all chemicals, KEEP AWAY FROM
CHILDREN AND ANIMALS. FOR PROFESSIONAL USE ONLY. The hazard
information contained herein is offered solely for the consideration
of the user, subject to his own investigation and verification of
compliance with applicable regulations, including the safe use of the
product under every foreseeable condition.
________________________________________________________________________________
|