HMIS Rating NFPA Rating
MATERIAL SAFETY DATA SHEET
0
Health Health
(Complies with OSHA Communication Standard 29 CFR 1910.1200 Dept. of Labor)
1
Flammability Flammability
Form approved OMB No. 1218-0072
OSHA 174 - Sept. 1985
0
Reactivity Reactivity
Personal Protection B Special
White Grease
Section I - Product Identification
74104
Marketer鈥檚 Name Must Appear Below DOT Shipping and Hazard Classification
Consumer Commodity ORM-D
1-800-255-3924
Manufactured For: Emergency Telephone Number
IBS Maintenance Magic
(253) 804-8666
Address: Telephone Number for Information
740 Clay St. N.W.
Auburn, WA 98001 Date Prepared April 11, 2000
Section II - Hazardous Ingredients/Identity Information
Hazardous Components (Specific Chemical Identity, CAS Number) OSHA PEL ACGIH TLV STEL % Wt. (Approx.)
White Cote HTP 1314-13-2 N/E N/E 20-40
Liquified Petroleum Gas 68476-85-7 1000 ppm 1000 ppm 60-80
All chemical compounds marked with an Asterisk (*) are toxic chemicals subject to the reporting requirements of Section 313 of Title III of the
Superfund Amendments and Reauthorization Act (SARA) of 1986 and 40 CFR Part 372. You must notify each person to whom this mixture or
trade name is sold. This statement must remain a part of this Material Safety Data Sheet.
Section III - Physical/Chemical Characteristics
Boiling Point: Specific Gravity (H2O=1): Melting Point:
N/D @75掳F 0.898 N/A
Vapor Pressure PSIG @ 70掳F: Vapor Density (Air=1): Evaporation Rate (Butyl Acetate=1):
40-45 >1
Solubility in Water: Appearance: Odor:
slight white cream none
Section IV - Fire and Explosion Hazard Data
Flash Point (Method Used): Flammable Limits: LEL UEL
None Extremely flammable spray
Extinguishing Media:
Use foam, CO2, dry media
Special Fire Fighting Procedures: Wear self-contained breathing apparatus & protective clothing. Cool fire exposed
containers to prevent rupturing
Unusual Fire and Explosion Hazards:
Exposure to temperature above 120掳F may cause bursting
The information contained herein is based on data considered accurate. However, no warranty is expressed or implied regarding the accuracy of
these data or the results to be obtained from the use thereof. Vendor assumes no responsibility for injury to vendee or third persons proximately
caused by the material if reasonable safety procedures are not adhered to as stipulated in this MSDS. Additionally, vendor assumes no responsibility
for injury to vendee or third persons proximately caused by abnormal use of the material even if reasonable safety procedures are followed.
Furthermore, vendee assumes the risk in his use of the material.
Section V - Reactivity Data
STABILITY: Unstable Conditions to Avoid:
X High temperatures.
Stable
Incompatibility (Materials To Avoid):
Avoid contact with strong oxidizing agents
Hazardous Decomposition or By-products:
Carbon Dioxide, Carbon Monoxide
Hazardous May Occur Conditions to Avoid:
none known
X Will Not Occur
Polymerization
Section VI - Health Hazard Data
Routes of Entry: Inhalation Yes Ingestion Yes Yes Yes
Skin Absorption Eye
Carcinogenicity: NTP? IARC Monograph? OSHA Regulated?
Health Hazards (Acute and Chronic):
Abusive and excessive inhalation may cause irritation to the upper respiratory tract, dizziness, nausea,
and other central nervous system effects.
Aspiration of material into lungs can cause chemical pneumonitis. Minimal toxicity.
Signs and Symptoms of Exposure
Irritation of nasal & respiratory passages.
Inhalation:
Gastrointestinal irritation, nausea, vomiting and diarrhea.
Ingestion:
Skin Contact: Frequent & prolonged contact may cause irritation.
May cause slight irritation but does not injure eye tissue.
Eye Contact:
Medical Conditions Aggravated by Exposure:
Emergency First Aid Procedures
Remove to fresh air. Give oxygen. Resuscitate if necessary. Get medical help.
Inhalation:
DO NOT INDUCE VOMITING. Seek medical attentin immediately.
Ingestion:
Skin Contact: Wash with soap and water. If irritation persists, seek medical attention.
Flush with water for 15 minutes. If irritation persists, see a physician immediately.
Eye Contact:
Section VII - Precautions for Safe Handling and Use
Steps to be Taken in Case Allow propellant to evaporate. Maintain local exhaust & adequate ventilation. No
smoking. Do not expose to heat, sparks or open flame. Cover with aborbent material
Material is Released or Spilled:
& sweep up. Dispose of material in accordance with State & Federal laws.
Dispose as hazardous waste in accordance with EPA RCRA.
Waste Disposal Method:
Precautions to be Taken in Keep away from heat, sparks or open flame. Store at temperatures below 120掳F.
Handling and Storing:
When spraying more than one half can continuously or more than one can consecu-
Other Precautions:
tively, use NIOSH approved respirator. Keep out of reach of children.
Section VIII - Control Measures
Protective Equipment Types
None needed unless it is anticipated that splash back will occur. Wear safety goggles.
Eyes:
Respiratory: None needed if used in accordance with label directions.
Gloves: None needed if used according to label directions. Use chemical resistant gloves for contact.
Other: Local exhaust to keep TLV of Section II ingredients below acceptable limits.
Ventilation: General Mechanical Local Exhaust Yes Other
Work/Hygienic Practises: Do not smoke while using. Wash hands after use.
|