Material Safety Data Sheet
Revision A : 11-17-04
Page 1 of 3
PRODUCT IDENTITIES
HITAK Polyurethane TapeTM ; Non-Metallic Frame
HT3935-7
SECTION I. MANUFACTURER鈥橲 INFORMATION
Av-DEC - Aviation Devices &
Manufacturer鈥檚 Name Emergency Telephone Number 817-738-9161
Electronic Components, L.L.C.
1810 Mony Street Telephone Number for Information 817-738-9161
Address Facsimile Telephone Number 817-738-9163
Fort Worth, TX 76102
SECTION II. HAZARDOUS INGREDIENTS IDENTIFICATION
Components OSHA PEL ACGIH TLV
1. Non-metallic Frame NA 5 mg/ m3 (as dust)
SECTION III. PHYSICAL/CHEMICAL CHARACTERISTICS
Phase Transition
> 160 潞C
Specific
Boiling Point (掳F) NA 0.97 g/ml Temp (see Section
Gravity(H2O = 1)
IX)
Vapor Pressure Vapor Density Evaporation Rate
NA NA 0
(mm Hg) (Air = 1) (Butyl Acetate = 1)
Not
Solubility in Water Appearance Plum Tint Odor No Odor
Soluble
SECTION IV. FIRE AND EXPLOSION HAZARD DATA
Special Fire Fighting Unusual Fire and
>182 潞C
Flash Point
Extinguishing Media Procedures Explosion Hazards
Carbon dioxide; Dry
LEL - NA Use self-contained Decomposition products
Flammable
chemical; Foam;
Limits UEL - NA breathing apparatus. may be toxic.
water.
Material Safety Data Sheet
Revision A : 11-17-04
Page 2 of 3
SECTION V. REACTIVITY DATA
Stability Stable Unstable Hazardous Decomposition or Byproducts
Bases, alcohols, moisture and/or Carbon dioxide, carbon monoxide,
Incompatibility
oxidizers aldehydes, nitrogen oxides and/or organics.
Hazardous
Will Not Occur Conditions to Avoid Excessive heat
May Occur
Polymerization
SECTION VI. HEALTH HAZARD DATA
Entry Routes: Inhale Low Skin Low Ingestion Low
Acute exposure may cause skin, eye and mucous membrane irritation. Acute
Health Hazard
(Acute and Chronic) and/or chronic exposure may cause allergic sensitization.
Carcinogenicity This product contains or may contain chemicals which are listed by the following
agencies as carcinogenic:
NTP: None; IARC: None; OSHA: None.
Skin, eye, mucous membrane Allergies, Pulmonary
Signs & Medical Conditions generally
Symptoms aggravated by Exposure
irritation, allergic response disorder
Emergency SKIN - flush area with water for at least 15 minutes with mild soap and water rinse.
First Aide Remove all contaminated clothing. If irritation or redness develops, consult an
occupational physician.
EYE - immediately flush eyes with water for 15 minutes. Hold eyes open while flushing.
Do not add any other solution(s) to eye except water. Contact an eye physician promptly.
INHALATION - Remove to fresh air immediately. If breathing is difficult, give oxygen.
If victim is not breathing, perform artificial respiration.
INGESTION - If victim is conscious, give water or diluted milk. Do not induce vomiting.
Keep head below hips. Repeat fluids. Call an occupational physician. Never give fluids to
an unconscious person, or someone convulsing.
SECTION VII. PRECAUTIONS FOR SAFE HANDLING AND USE
Steps to be taken in case material is Released or Spilled
Accidental release or spillage is not likely to occur due to the physical nature of this product. Avoid skin contact with
sealant. Place all waste materials in a sealable container for appropriate disposal.
Waste Disposal Method
Follow approved Federal, State and Local regulations.
Precautions to be taken in Handling and Storage
CAUTION: MAY CAUSE EYE IRRITATION. Avoid contact with skin, eyes or clothing. Do not discard to open water.
Other Precautions
Store materials in a cool, well-ventilated area.
Material Safety Data Sheet
Revision A : 11-17-04
Page 3 of 3
SECTION VIII. CONTROL MEASURES
Typically not necessary. Use only NIOSH approved respiratory protection for organic
vapors. NIOSH respiratory protection for dust may be required if the product is
Respiratory
mechanically manipulated (i.e., grinding, sawing, drilling, etc.). However, due to the
Protection
physical nature of the product, mechanical manipulation may be difficult.
Not necessary under Will be adequate for the
Local Mechanical
Ventilation
Exhaust (General)
normal use conditions. majority of user applications.
Not necessary under Not necessary under
Barrier creams
Protective Eye
normal use conditions. normal use conditions. Special
Gloves Protection suggested.
Refer to Section IX. Refer to Section IX
Additional protective clothing is not necessary under normal use conditions. Safety
Other Pro-Clo
shower/eye wash and fire extinguisher are standard safety precautions. Refer to Section
or Equipment
IX.
Good housekeeping and personal hygiene are critical. Wash face, neck, hands and arms
/Work &
Hygienic before eating, drinking, smoking or using hygiene/make-up products. Separately wash
Practices contaminated clothing before reuse.
SECTION IX. OTHER INFORMATION
The product is not conducive to an accurate measurement of boiling or melting point temperatures.
Phase Transition Temperature is the temperature at which, this product, changes from a stable, gelled
material to a material which is no longer usable in its suggested form.
Additional Control Measures: Protective gloves and other protective clothing are recommended for
persons who exhibit symptoms of skin sensitization or possible allergic reaction. Protective clothing
should be impervious to the components (e.g., polyethylene). Eye protection must be worn when the
potential for eye injury exists.
The information contained in this MSDS is based on data available to Aviation Devices and is believed to
be reliable. No guarantee is implied or expressed regarding the accuracy of this information or the use of
the product since the conditions for use are beyond Aviation Devices鈥? and the manufacturer鈥檚 control.
Nothing contained herein should be construed as a recommendation to use this product in conflict with
existing patents covering any material or its use.
|