MATERIAL SAFETY DATA SHEET
#1 NETWORK
COLOR CHANGE ONE
COLOR CHANGE SYSTEM
1. CHEMICAL PRODUCT AND COMPANY IDENTIFICATION
Manufacturer: Optima, LLC Phone Number: 1-800-521-4042 Emergency Phone: 1-800-424-9300
Product Name: COLOR CHANGE - STEP 1 Product Number: 23864
Prepared By: MSDS Author 3 Date Prepared: 12/12/2003
2. COMPOSITION/INFORMATION ON INGREDIENTS
Chemical Name CAS OHSA PEL ACGIH TLV Weight %
ALIPHATIC HYDROCARBON 64742-88-7 100 ppm 100 ppm 50-70
*AROMATIC HYDROCARBON 64742-94-5 N.E. N.E. 5-10
PROPYL ETHER BLEND MIXTURE N.E. N.E. 5-10
*Indicates toxic chemical(s) subject to the reporting requirements of Section 313 of Title III and of 40 CFR 372.
COLOR CHANGE ONE ?STEP 1 CONTAINS < 1 % 1, 2, 4-TRIMETHYLBENZENE Cas# 95-63-6 and < 1%
NAPTHALENE Cas # 91-20-3 by weight which are a components of the PETROLEUM NAPHTHA mixture.
Manufacturer recommends 100mg/m?TWA
3. HAZARDOUS IDENTIFICATION
Emergency Overview: Contains Petroleum Distillates! Harmful or fatal if swallowed. May cause lung damage.
POTENTIAL HEALTH EFFECTS
Eye Contact: May cause moderate to severe irritation.
Inhalation: Gas or vapor in high concentrations may irritate respiratory tract. Solvent vapors are hazardous and may
cause nausea, sickness, vomiting and headaches or other signs of central nervous system depression with
overexposure.
Ingestion: Swallowing can cause gastrointestinal irritation, nausea, vomiting, and diarrhea and possible damage to vital
organs. Aspiration of materials into the lungs can case chemical pneumonitis.
Skin Contact: May cause irritation and allergic skin reaction. Prolonged or repeated contact leads to drying of skin.
Signs And Symptoms Of Exposure: Eye irritation, respiratory irritation, dermatitis, difficulty breathing, nausea,
vomiting, headaches, skin irritation, mucus membrane irritation, or intoxication.
4. FIRST AID MEASURES
Eye Contact: Immediately flush eyes with plenty of water for at least 15 minutes. Get immediate medical attention.
Inhalation: Remove to fresh air. If not breathing, give artificial respiration. If breathing is difficult, give oxygen. Get
medical attention immediately.
Ingestion: If swallowed, DO NOT induce vomiting. give large quantities of water. Call a physician or poison control
center.
Skin Contact: Wash skin with soap and water. Wash contaminated clothing before re -use. Get medical attention if
irritation or allergic reaction develops.
Aggravated Medical Conditions: Allergies, chronic asthma may be exacerbated by fumes from this product.
Supplemental Health Information: None of the components in this product is listed by IARC, NTP, or OSHA
as carcinogen.
5. FIRE FIGHTING MEASURES
Flash Point: 142篎 Flash Point Method: T.C.C. Auto ignition: N.E.
LEL: 1.0 UEL: 6.0
Extinguishing Media: Alcohol resistant foam, dry chemicals, sand, dolomite, etc.
Special Fire -Fighting Procedures: treat as a petroleum fire. Water spray may be ineffective on fire but may protect fire-
fighters and cool closed containers. Use fog nozzles if water is used. Containers close to the fire should be removed or
cooled with water. Do not get water inside container. Let small fires burn unless the leak can be stopped immediately
and safely. Do not enter confined fire-space without full bunker gear. (Helmet with face shield, bunker coats, gloves
and rubber boots). Use NIOSH approved positive-pressure self-contained breathing apparatus.
Unusual Fire And Explosion Hazards: COMBUSTIBLE! Keep container tightly closed. Isolate from oxidizers, heat,
and open flames. Closed containers may explode if exposed to extreme heat.
Combustion Products: Carbon dioxide and carbon monoxide.
6. ACCIDENTAL RELEASE MEASURES
Steps To Be Taken In Case Material Is Spilled Or Released: Review fire and explosion hazards and safety precautions
before proceeding with cleanup. Use appropriate personal protective equipment. Avoid contact with skin and eyes. stop
leak if possible without risk. Extinguish all ignition sources. Avoid sparks, flames, heat, and smoking. Use spark proof
tools. Ventilate. Stop the spillage. Dike the spill. Prevent liquid from entering sewers, waterways or low areas. Absorb
spillage in inert material. Soak up with sawdust, sand, or other absorbent material. Remove non-usable solid material
and/or contaminated soil for disposal in an approved and permitted landfill. Discharge to sewer requires approval of
permitting authority and may require pre-treatment. Contaminated surfaces should be cleaned using water.
7. HANDLING AND STORAGE
Precautions To Be Taken In Handling And Storage: Keep away from heat, sparks, and open flame. Static electricity and
formation of sparks must be prevented. Keep in cool, dry, ventilated Class II liquid storage and closed containers.
Protect from light, including direct sun rays. Ground container and transfer equipment to eliminate static electric sparks.
Store isolated from oxidizing materials. Continue all label precautions.
Other Precautions: Empty containers retain product residue and can be dangerous. Do not pressurize, cut weld, braze,
solder, drill, grind, or expose such containers to heat, flame, sparks static electricity, or other sources of ignition.
8. EXPOSURE CONTROL / PERSONAL PROTECTION
PERSONAL PROTECTIVE EQUIPMENT
Respiratory Protection: Provide adequate general and local exhaust ventilation.
Ventilation: No specific recommendation made, but respiratory protection must be used if level exceeds the PEL. Use a
respirator with organic vapor cartridges.
Protective Gloves: Impervious gloves recommended made of nitrile or butyl rubber.
Eye Protection: Safety glasses with side shields (or goggles) or goggles and splash shield.
Other Protective Clothing or Equipment: Rubber or plastic apron.
Work/Hygienic Practices: Use good personal hygiene when handling this product. Wash hands after use, before
smoking, or using the toilet.
Engineering Controls: Facilities storing or utilizing this material should be equipped with an eyewash facility and
a safety shower. Use engineering controls to reduce air contamination to permissible exposure levels.
Exposure Guidelines: Use vapor, mist gas mask within use limits, or ventilate to keep vapors of this material below
15 ppm. If over, TLV, in accordance with 29 CFR 1910.134, use NIOSH approved positive-pressure self-
contained breathing apparatus.
9. PHYSICAL AND CHEMICAL PROPERTIES
Appearance And Odor: Clear pale yellow slightly viscous liquid with slight amine odor.
Solubility In Water: Emulsible Boiling Point: 355?F-390?F Vapor Pressure: N.E.
Specific Gravity: 0.82 Melting Point: Not applicable Freezing Point: < 15?C
Percent Volatile: 92.57 Evaporation Rate: (n Butyl = 1) < 1 Vapor Density: (air =1) > 1
Ph: Not applicable Molecular Weight: Not applicable Pounds Per Gallon: 6.9
V.O.C. is 710 gm/L, or 86 %, or 5.9 lb/gal.
10. STABILITY AND REACTIVITY
Stability: Stable
Conditions To Avoid: Isolate from sparks, heat, flame and other sources of ignition.
Incompatibility: Isolate fromstrong oxidizers.
Hazardous Decomposition Or By Products: Carbon dioxide and carbon monoxide and dense smoke.
Hazardous Polymerization: Will Not Occur
11. TOXICOLOGICAL INFORMATION
12. ECOLOGICAL INFORMATION
13. DISPOSAL CONSIDERATIONS
Discharge, treatment or disposal may be subject to Federal, State (provincial in Canada) or local laws. Incinerate in
suitable combustion chamber.
14. TRANSPORT INFORMATION
This material is regulated by the U.S. Department of Transportation (DOT) only when transported in bulk container
shipments of greater than 119 gallon capacity. Reference 49.CFR 172.504(f) (2). However, pursuant to 49 CFR
173.150(b), "limited-quantities" offered for transport via aircraft may be subject to DOT regulation.
For non-bulk shipments less than 119 gallons: For Bulk shipments greater than 119 gallons:
DOT Class: NOT REGULATED DOT Shipping Name: COMBUSTIBLE LIQUID, N.O.S.
Hazard Class: NOT APPLICABLE (Contains: Petroleum Distillates)
UN No.: NOT APPLICABLE Hazard Class: 3
Packing Group: UN No.: 1268
Guide No: Packing Group: III
Guide No.: 128
15. REGULATORY INFORMATION
TSCA: All ingredients in this finished product are listed on the EPA TSCA INVENTORY.
SARA TITLE III: Diethanolamine (Cas # 111-42-2) is a component in this product and is listed under Section 313.
CALIF. PROP. 65: This product contains a mixture which includes Naphthalene Cas # 91-20-3 and 1, 2, 4
Trimethylbenzene Cas # 95-63-6. The following information is required by the State of California's Safe Drinking
Water and Toxic Enforcement Act of 1986, or Proposition 65. This regulation does not address di minimus levels;
therefore, even trace amounts of the chemicals included on Proposition 65's list of chemicals known to the State of
California to cause cancer or reproductive toxicity must be noted with the "Safe Harbor" wording. WARNING: This
product contains benzene and toluene in the above components, and they are known to cause birth defects or other
reproductive harm.
CARCINOGENICITY: NONE OF THE COMPONENTS IN THIS CHEMICAL IS ABOVE THE MINIMUM
AMOUNT LISTED BY IARC, NTP, OR OSHA AS A CARCINOGEN.
16. OTHER INFORMATION (HMIS)
Health: 1
Flammability: 2
Reactivity: 0
Protective: B
OTHER ADDITIONAL INFORMATION: The information contained herein is based on the data available to us and is
believed to be accurate. However, no warranty is expressed or implied regarding the accuracy of this data or the results
to be obtained from the use thereof. We assume no responsibility for the injuries from the use of the product described
herein
|