Material Safety Data Sheet
SECTION 1: PRODUCT & COMPANY IDENTIFICATION
Product Name: C-2565
Chemical Family: Mixture
Manufacturer/ Supplier: Chrysan Industries
14707 Keel Street
Plymouth, MI 48170
Emergency Phone Number: 1-734-451-5411 x 555
Technical Information: 1-734-451-5411 x 213
MSDS Document #: 1 Effective Date: 6/30/2008
SECTION 2: COMPOSITION INFORMATION
Component CAS# Max %
Hydrotreated heavy distillate petroleum 64742-52-5 <70
2,2',2-Nitrilotriethanol 102-71-6 <5
1-Amino-2-hydroxyethane 141-43-5 <5
2,2',2"-(Hexahydro-1,3,5-triazine-1,3,5-triyl)triethanol 4719-04-4 <3
Iodopropynyl Butylcarbamate 55406-53-6 <1
Proprietary Mixture Balance
SECTION 3: HAZARD IDENTIFICATION
Emergency Overview : No unusual safety, fire or spill hazards. Consult following MSDS section for further information
Potential Health Effects
Inhalation: Exposure to oil mists, vapors, or fumes may cause respiratory tract irritation. Heating this product may
release harmful vapors. Inhalation of mists, vapors or fumes generated by heating this product may cause
respiratory tract irritation, with throat discomfort, coughing and difficult breathing.
Eyes: Mild Irritant Skin: Mild Irritant Ingestion: Mild Irritant
Medical Repeated exposure may aggravate existing liver or kidney disease. Personnel with pre-existing skin disorders
should avoid contact with this product. Exposure to liquids, vapors, mists or fumes should be minimized to
Conditions
Aggravated avoid any potential health risks.
by Exposure:
Chronic: None
Cancer None Known
Information:
SECTION 4: FIRST AID MEASURES
Inhalation: Vapor inhalation under ambient conditions is normally not a problem. Vapors or mist, in excess of the
permissible concentrations, or in unusually high concentrations generated from spraying, heating the material
or from poorly ventilated areas may cause irritation of the nose and throat, headache, nausea or drowsiness.
Eyes: May cause minimal irritation, experienced as temporary discomfort. Flush with water for 15 minutes,
occasionally lifting the upper and lower lids. Seek medical attention if eye irritation develops or persists.
Page 1 of 4
CHRYSAN INDUSTRIES 14707 KEEL ST. PHONE: (734) 451-5411
www.chrysanindustries.com PLYMOUTH, MI 48170 FAX: (734) 862-4053
Material Safety Data Sheet
Wash with soap and water immediately. Remove contaminated clothing and launder before reuse. Seek
Skin:
medical attention if irritation develops.
Other Note to Physician: Treat Symptomatically
Measures:
SECTION 5: FIRE FIGHTING MEASURES
Flash Point: Method:
> 300癋 COC
Upper Flammable Limit: Lower Flammable Limit: Not Available
Not Available
Auto Ignition Temperature: Not Available
Hazardous Combustion Products: Not Available
Extinguishing Media: Carbon dioxide, dry chemical or foam
NFPA 704 HAZARD IDENTIFICATION: This information is intended solely for the use of individuals trained in this
system.
Health Hazard: 1
Fire Hazard: 1
Reactivity: 0
Firefighters should be equipped with self-contained breathing apparatus and turn out gear.
Fire Fighting Instructions:
Fire & Explosive Hazard: There are no known unusual fire or explosion hazards.
SECTION 6: ACCIDENTAL RELEASE MEASURES
Extinguish open flames and remove heat sources. Personal Protective Equipment must be worn. Ventilate areas if spilled in
confined space or other poorly ventilated area. Prevent entry into sewers or other ground water sources. Collect all free
ground liquid using inert absorbent material and collect for disposal according to local, state and federal regulations.
SECTION 7: HANDLING AND STORAGE
Wash prior to eating, drinking, smoking or use of restroom and when leaving work. Do not dispose of material or empty
containers to the environment. Heating of non-vented container may cause container to rupture.
Shipping Storage: Do not store near heat or open flames. Keep container dry and in a cool, well-ventilated area.
Keep container tightly closed.
Other Precautions Rotate stock. Do not reuse empty containers.
SECTION 8: WASTE DISPOSAL
Used Product: Disposal procedures must comply with local, county, state and federal regulations.
Unused Product: This product does not meet the criteria for hazardous waste under RCRA, if discarded in its
purchased form. Under RCRA, it is the responsibility of the user of the product to determine
at the time of disposal, whether the product meets RCRA standards for hazardous waste.
Empty Containers: Do not attempt to refill or clean containers. "Empty" containers should be completely drained,
properly closed and promptly returned to a reconditioner or supplier. All containers should be
disposed of in an environmentally safe manner and in accordance with governmental
regulations.
Page 2 of 4
CHRYSAN INDUSTRIES 14707 KEEL ST. PHONE: (734) 451-5411
www.chrysanindustries.com PLYMOUTH, MI 48170 FAX: (734) 862-4053
Material Safety Data Sheet
SECTION 9: EXPOSURE CONTROL / PERSONAL PROTECTION
Normally not required if adequate ventilation is available. Any respiratory equipment worn
Respiratory Protection:
should be NIOSH/MSHA approved apparatus.
Ventilation: Use local exhaust and mechanical ventilation to capture vapor, mists or fumes.
Where spills and splashes are likely, facilities storing or using this product should be
Other Protective Equipment:
equipped with an emergency shower and eyewash, both equipped with clean water and in
the immediate work area.
Eye Protection: Safety shield or goggles recommended when handling.
Personal Hygiene: Good personal hygiene should always be followed.
Protective Gloves: Chemical resistant rubber gloves.
SECTION 10: PHYSICAL AND CHEMICAL PROPERTIES
Boiling Point: Not Available Vapor Pressure: Not Available
Specific Gravity: Not Available Melting Point: Not Available
pH (concentrate): Not Available Vapor Density: Not Available
pH (20:1 dilution): 9.0 - 10.5 Physical State: Liquid
Solubility: Water Soluble Appearance / Odor: Amber - Brown / Petroleum
Evaporation Rate: Not Available VOC: Not Available
SECTION 11: STABILITY AND REACTIVITY
Stable
Stability:
Conditions to Avoid: Strong oxidizers and sources of ignition.
Sources of ignition, heat, sparks and open flames, strong oxidizers
Materials to Avoid:
Hazardous Polymerization: Will not occur
Hazardous Decomposition In the event of complete evaporation or very high temperatures, residues may yield
decomposition products: oxides of carbons and other organics.
Products:
SECTION 12: TRANSPORTATION INFORMATION
DOT Proper Shipping Name: Not Regulated
DOT Hazard Class: Not Regulated
DOT Labels Required: Not Regulated
DOT Placards Required: Not Regulated
SECTION 13: REGULATORY & TOXICOLOGICAL INFORMATION
CERCLA: No chemicals in this product are subject to the reporting
requirements of CERCLA.
EPCRA (SARA) TITLE III (302/304): None
SARA (311, 312) HAZARDOUS CATEGORIZATION: This material would be classified under the following hazard
categories: Acute (immediate) health hazard, Chronic (delayed)
health hazard
SARA SECTION 313 Toxic Chemicals: No chemicals in this product exceed the De Minimus reporting level
established by SARA Title III Section 313
Page 3 of 4
CHRYSAN INDUSTRIES 14707 KEEL ST. PHONE: (734) 451-5411
www.chrysanindustries.com PLYMOUTH, MI 48170 FAX: (734) 862-4053
Material Safety Data Sheet
TSCA: All of the components of this product are listed on, or are exempted
from the requirements to be listed on the TSCA inventory.
TOXICOLOGICAL: Not Available
SECTION 14: SUPPLIER INFORMATION
The information presented herein, while not guaranteed, was prepared by competent technical personnel and is true and
accurate to the best of our knowledge. NO WARRANTY, OR GUARANTY, EXPRESS OR IMPLIED IS MADE REGARDING
PERFORMANCE, STABILITY, OR OTHERWISE. This information is not intended to be all inclusive as to the manner and
conditions of use, handling and storage. Other factors may involve other additional safety or performance considerations.
While our technical personnel will be happy to respond to questions regarding safe handling and use procedures, safe
handling and use remains the responsibility of the customer. No suggestions for use are intended as, and nothing herein
shall be constructed as a recommendation to infringe any existing patents or violate Federal, State or Local Laws.
Page 4 of 4
CHRYSAN INDUSTRIES 14707 KEEL ST. PHONE: (734) 451-5411
www.chrysanindustries.com PLYMOUTH, MI 48170 FAX: (734) 862-4053
|