EB-MSDSC-0105
Page 1 of 2
MATERIAL SAFETY DATA SHEET Effective Date: 03/31/01
SECTION I - PRODUCT IDENTIFICATION AND PREPARATION INFORMATION
Product Name: CELdek, CELdek with Mi-T-edg, Mi-T-Cool, Mi-T-edg
Description: Cellulose paper impregnated with insoluble anti-rot salts and rigidifying saturants.
Manufacturer Name and Address: MSDS Prepared by:
The Munters Corporation Dell Tech Laboratories Ltd.
108 Sixth Street Southeast UWO Research Park
Fort Myers, Florida 33907 100 Collip Circle
London, Ontario N6G 4X8
(519) 858-5021
Emergency Phone: (941) 936-1555
SECTION II - INFORMATION ON INGREDIENTS
Ingredients CAS # Wt% ACGIH-TLV OSHA-PEL LC50 LD50
1 mg/m3 TWA 1 mg/m3 TWA
Copper, elemental 7440-50-8 <0.1 Not available 1.2 mg/kg oral, rat
316 mg/m3 4 h, rat 317 mg/kg oral, rat
Phenol 108-95-2 <0.1 5 ppm Skin 5 ppm Skin
Formaldehyde 50-00-0 <0.1 0.3 ppm Ceiling 0.75 ppm TWA 590 ppm 4 h, rat 800 mg/kg oral, rat
Acrylic monomer Not available <0.1 Not available Not available Not available Not available
SECTION III - PHYSICAL DATA
Boiling Point (deg C): Not applicable Specific Gravity: >1.0
Vapour Pressure (mm Hg): Not applicable Percent Volatile (Wt %): Not applicable
Vapour Density (Air = 1): Not applicable Evaporation Rate (Water = 1): Not applicable
Solubility in Water: Not applicable pH (as supplied): Not applicable
Physical State: Solid Viscosity: Not applicable
Appearance; Odour: Tan Kraft paper and rubber; odourless Odour Threshold (ppm): Not available
SECTION IV - FIRE AND EXPLOSION DATA
Flammability: Edge coating not flammable according to WHMIS criteria (no self-sustained flame). Corrugated paper
not flammable according to WHMIS criteria (ignites at a rate of 0.13 cm/s under laboratory conditions). Will sustain
combustion in the presence of an external source of ignition.
0
Flash Point of Liquid ( C, TCC): None LEL: Not applicable UEL: Not applicable
Hazardous Combustion Products: May include and are not limited to oxides of carbon, oxides of nitrogen, organic
acids, aldehydes, hydrogen chloride.
Means of Extinction: Water spray, carbon dioxide.
Special Fire Hazards: Firefighters should wear self-contained breathing apparatus. Avoid breathing smoke.
SECTION V - REACTIVITY DATA
Conditions for Chemical Instability: Stable.
Incompatible Materials: None known to The Munters Corporation at this time.
Hazardous Decomposition Products: May include and are not limited to oxides of carbon, oxides of nitrogen,
organic acids, aldehydes, hydrogen chloride when heated to decomposition.
EB-MSDSC-0105
Page 2 of 2
CELdek, CELdek with Mi-T-edg, Mi-T-Cool, Mi-T-edg
SECTION VI - TOXICOLOGICAL PROPERTIES
Route of Entry: Skin contact, Inhalation
Effects of Acute Exposure:
Inhalation: Nuisance dust may be created when sawing.
Effects of Chronic Exposure:
None known to The Munters Corporation at this time.
Irritancy: Non hazardous by WHMIS criteria.
Respiratory Tract Sensitization: No data available.
Carcinogenicity: Non hazardous by WHMIS criteria.
Teratogenicity, Reproduction, Mutagenicity: No data available.
Synergistic Materials: Not available.
SECTION VII - PREVENTATIVE MEASURES
Gloves: Not normally required.
Eye Protection: Safety glasses recommended to avoid possible contact with eyes when sawing.
Respiratory Protection: Not normally required. Dust mask recommended when sawing.
Other Protective Equipment: As required by employer code.
Engineering Controls: General ventilation normally adequate.
Leak and Spill Procedure: Special precautions not required.
Waste Disposal: Review federal, provincial/state and local government requirements prior to disposal.
Storage and Handling Requirements: Keep away from open flame.
SECTION VIII - FIRST AID
Eye Contact (dust): Immediately flush with cool water. Remove contact lenses, if applicable, and continue flushing.
Obtain medical attention if irritation persists.
Skin Contact (dust): Flush with water. Wash with soap and water. If irritation persists obtain medical attention.
Inhalation: Not a normal route of exposure. If symptoms develop move victim to fresh air. If symptoms persist, obtain
medical attention.
Ingestion: Not a normal route of exposure. Do not induce vomiting. Rinse mouth with water then drink one or two
glasses of water. Obtain medical attention. Never give anything by mouth if victim is unconscious, or is
convulsing.
SECTION IX - REGULATORY INFORMATION
Occupational Health and Safety Regulations:
WHMIS Class: Not a controlled product under WHMIS (Manufactured article).
OSHA & WHMIS: MSDS prepared pursuant to the Hazard Communication Standard (CFR29 1910.1200) and
Canadian WHMIS regulations (Controlled Products Regulations under the Hazardous Products Act).
Environmental Regulatory Lists:
SARA - Section 313 (Toxic Chemical Release Reporting) 40 CFR 372 - Exempt from reporting any component.
Toxic Substances Control Act (TSCA) - All the ingredients are listed on the Chemical Substance Inventory.
Canadian Domestic Substance List (DSL) - Exempt from the requirements of The New Substance Notification
Regulation of the Canadian Environmental Protection Act.
T.D.G./D.O.T. Classification: Not regulated
Disclaimer
Information for this material safety data sheet was obtained from sources considered technically accurate and reliable. While every effort
has been made to ensure full disclosure of product hazards, in some cases data is not available and is so stated. Since conditions of actual product
use are beyond control of the supplier, it is assumed that users of this material have been fully trained according to the mandatory requirements
of WHMIS. No warranty, expressed or implied, is made and supplier will not be liable for any losses, injuries or consequential damages which may
result from the use of or reliance on any information contained in this form. If user requires independent information on ingredients in this or any
other material, we recommend contact with the Canadian Centre for Occupational Health and Safety (CCOHS) in Hamilton, Ontario (1-800-263-
8446) or CSST in Montreal, Quebec (514-873-3990).
|