G28 Penetrating Foam
Material Safety Data Sheet
1. Chemical Product and Company Information
Product Name: emzone G28 Penetrating Foam.
Product Item Numbers: # 44028 ?15.7 oz / 445 g
Product Manufacturer: Empack, a Division of EMU Polishes Inc.
Address: 98 Walker Drive
Brampton, Ontario, Canada L6T 4H6
Telephone: (905) 792 ?6571
Emergency Telephone: Empack: (905) 792-6571 (8:00 am ?4:00 pm ET)
CANUTEC: (613) 996-6666 collect (24 Hours)
Product Use: Non-drip Foam penetrates rust, loosens tight parts.
A, B5, D1B
WHMIS Classification:
AEROSOLS, Class 2.1, UN1950
TDG Classification:
Under the Clear Language Regulations: refer to Section 1.17
for Limited Quantity Shipping Information, if shipping under this
exemption.
Prepared By: Empack Regulatory Department
Preparation Date: September 2008
2. Composition / Information on Ingredients
Hazardous Ingredients CAS Number Weight % TLV (ppm)
Aromatics 100 Fluid 64742-95-6 30-60 50
Oleic acid 112-80-1 10-30 N/Av
Methyl isobutyl carbinol 108-11-2 10-30 N/Av
Propane 74-98-6 10-30 2500
Isobutane 75-28-5 10-30 800
2-butoxyethanol 111-76-2 7-13 50
1336-21-6
Ammonium Hydroxide 1-5 25
3. Hazards Identification
Emergency overview:
High vapour concentrations may cause drowsiness. Gas reduces oxygen available for breathing.
Contents under pressure. Can decompose at high temperatures forming toxic gases.
Potential Health Effects:
Inhalation: Breathing small amounts is not likely to cause harmful effects. Breathing large
amounts may be harmful.
Skin Contact: Can cause skin irritation. Prolonged or repeated contact may dry the skin.
Eye Contact: The liquid of this material can produce chilling sensation and discomfort. This
product causes irritation, redness and pain.
Ingestion: Ingestion is not a likely route of exposure.
Carcinogenicity of Material: No Carcinogenic material is available.
Page 1 of 4
G28 Penetrating Foam
4. First Aid Measures
Inhalation: Move victim to fresh air. If not breathing, give artificial respiration. If breathing is
difficult, give oxygen. Get medical attention. Do not give adrenaline, epinephrine or similar drugs
following exposure to this products.
Skin Contact: Wash thoroughly with soap and lukewarm water. Treat frostbite by immediately
immersing affected areas in warm water until the skin has warmed up and turned pink. Obtain
medical attention IMMEDIATELY.
Eye Contact: Immediately flush eyes with plenty of water. Get medical attention if irritation
persists.
Ingestion: Not likely to happen-product is spray mist. If happen, do not induce vomiting contact
poison center immediately.
Note to Physicians: Treat symptomatically.
5. Fire Fighting Measures
Flammability Class: Flammable
Flash Point (Propellant): -104癈
Flash Point (TCC deg. C)(Liquid): N/Av
Autoignition Temperature: 450 癈
Flammability Limits in Air (%): LEL: 2.1, UEL:9.5
Aerosol Flame Projection Classified as: < 45 cm
Flashback: No
Extinguishing Media: Carbon dioxide, dry chemicals, foam or water fog.
Fire and Explosion Hazards: May decompose on contact with flames or extremely hot metal
surfaces to produce toxic and corrosive products. Thermal decomposition products are Carbon
oxides (CO, CO2).
Sensitivity to Mechanical Impact: Not expected to be sensitive.
Sensitivity to Static Discharge: Not expected to be sensitive
6. Accidental Release Measure
Spill and Leak: Large spill or leak is unlikely in aerosol containers. If happens, ventilate enclosed
spaces and disperse gas with floor-level forced-air ventilation. Exhaust vapors outdoors. Do not
smoke or operate internal combustion engines. Remove flames and heating elements.
7. Handling And Storage
Do not breathe vapour or mist. Avoid contact with eyes, skin and clothing. Keep container
closed. Use only with adequate ventilation. Do not enter confined spaces unless adequately
ventilated.
Page 2 of 4
G28 Penetrating Foam
8. Exposure Controls/Personal Protection
Engineering Controls: Local exhaust ventilation required to maintain the point of use below the
Threshold Limit Value if unprotected personnel are involved.
Respiratory Protection: Not required on a short-term basis or if exhaust ventilation is provided.
Use approved NIOSH respirators for emergencies.
Eye Protection: Use chemical safety glasses.
Skin Protection: Use gloves & protective clothing against cold temperature made from viton,
butyl rubber, PVC, neoprene or nitrile.
9. Physical And Chemical Properties
Physical State: Aerosol
Appearance: Clear- yellow mist
Odour: Hydrocarbons
Odour Threshold: Not Available
100 癈
Boiling Point ( liquid):
% Weight Volatile: 65
Vapour Density (Air = 1): <1
Specific Gravity (Liquid): 0.87 @ 25癈
Specific Gravity (Aerosol): 0.73 @ 25癈
Vapour Pressure (psig): 55 @ 20癈
Evaporation Rate: <1 (n-Butyl Acetate = 1)
pH: Not Applicable
Solubility in Water: Miscible
10. Stability And Reactivity
Chemical Stability: Stable under the recommended storage and handling conditions.
Conditions of Reactivity: Avoid sources of heat and flame, and electrostatic charge.
Incompatible Materials: Strong oxidizing agent.
Hazardous Products of Decomposition: May form carbon dioxide and carbon monoxide,
various hydrocarbons.
Hazardous Polymerization: Will not occur.
11. Toxicological Information
Carcinogenicity: Not classified as carcinogenic by ACGIH, IARC, OSHA or NTP.
Reproductivity: No adverse reproductive effects are anticipated..
Teratogenicity: Prolong exposure may lead to the damage of organ systems.
Mutagenicity: No adverse mutagenic effects are anticipated.
Respiratory / Skin Sensitization Data: Not available.
Synergistic Materials: None known.
Page 3 of 4
G28 Penetrating Foam
12. Ecological Information
Liquid release is only expected to cause localized, non-persistent environmental damage, such
as freezing.
13. Disposal Considerations
Dispose of in accordance with local, provincial and federal regulations.
14. Transport Information
Ground: Consumer Commodity, ORM-D.
Air: Cannot be shipped by air.
Sea: AEROSOLS, UN# 1950, Class 2.1.
15. Regulatory Information
CANADA
WHMIS Classification: A: Compressed gas, B5: Flammable Aerosol, D1B: Material causing very
toxic effects. D2B:Material causing other toxic Materials.
USA
Environmental Protection Act: Constituents of this product are included on the TSCA inventory.
OSHA (29CFR 1910.1200) Classification: Compressed Gas.
HMIS: 3 Health, 4 Fire, 1 Reactivity.
16. Other Information
Abbreviations:
ACGIH American Conference of Governmental Industrial Hygienists
CAS Chemical Abstract Service
NIOSH National Institute for Occupational Safety and Health
OSHA Occupational Safety and Health Administration, USA
TSCA Toxic Substances Control Act 1976, USA
PEL Permissible Exposure Limit
TLV Threshold Limit Value
WHIMIS Workplace Hazardous Materials Information System
Disclaimer:
This product has been classified in accordance with the hazard criteria of the CPR and the MSDS
contains all the information required by the CPR. This MSDS is valid for three years.
The information contained herein is based on data considered accurate. No warranty is
expressed or implied regarding the accuracy of this data or the results obtained from the
use thereof. Empack assumes no responsibility for personal injury or property damage to
vendees or users or third parties, caused by the material. Such vendees or users assume
all risks with the use of the material.
Page 4 of 4
|