Page 1
Print Date 03/03/2009
MSDS Document
1. Chemical Product and Company Identification
Trade Name of the Product
Christy'sTM FastFix
Epoxy Repair Putty - Product Code: RH-FF4
Transportation Emergency Phone
Manufacturer
T. Christy Enterprises, Inc. INFOTRAC (800) 535-5053
655 E. Ball Rd.
Anaheim, CA 92805-5910
(714) 507-3300
Hazard Rating
Flammability
0 - Minimal
3 1 - Slight
Health
Reactivity 2 - Moderate
1
2 3 - Serious
4 - Severe
2. Composition and Information on Ingredients
CAS# APPROX% ACGIH-TLV OSHA-PEL mm HG
Glycidyl Ethers of Bisephenol A Resins 25068-38-6 8.40 N.E. N.E. 0
Tri (dimethylaminomehyl) phenol 90-72-2 1.37 N.E. N.E. 0
Crystalline Silica 14808-60-7 12.64 .1 mg/M3 0.1 mg/M3 0
Epoxy Resins Trade Secret
Title III Section 313 Supplier Notification. This product contains toxic chemicals subject to the reporting requirements of Section 313
of the Emergency Planning and Community Right -to-Know Act of 1986 and of 40CFR372. This information must be included in all
MSDS's that are copied and distributed for this material.
Respirable crystalline silica (quartz) is classified as a proable carcinogen. The crystalline silica present in this product is encapsulated
in the epoxy resin and could only be liberated by sanding or abrading and then not as pure crystalline silica. Appropriate precautions,
however, should be taken, if the product is sanded or abraded to preclude personnel from breathing the dust.
3. Hazard Identification
Ingestion
May cause mild irritation of intestional track
Skin Contact/Absorption
May cause mild irritation to sensitive skin
Inhalation
None
Eye Contact
May cause mild irritation
**NOTE: Wash with soap and water immediately after use. If sanding cured putty, wear eye protection and dust mask.
Page 2
Print Date 03/03/2009
Christy'sTM FastFix
4. First Aid Information
Eye Contact
Flush eyes with plenty of water for 15 minutes and call a doctor.
Skin Contact/Absorption
Wash exposed area with soap and water. Wash clothing before reuse.
Inhalation
N/A
Ingestion
Induce vomiting and call a doctor.
5. Fire Fighting Measures
Flash Point
None
Extinguishing Media
Water spray, foam, CO2,dry chemicals
Flammability Limits (Percent by Volume)
LEL - none UEL - none
Special Fire Fighting Procedures
None
Unusual Fire and Explosion Hazards
CO, aldehydes, acids, oxides of sulfur and nitrogen may be formed.
6. Accidental Release Measures
Steps to be Taken in Case of Spill or Release
Dispose of in normal manner; not a hazardous waste.
7. Handling and Storage
Storage
Avoid eye contact & excessive skin contact.
8. Exposure Controls and Personal Protection
Eye Protection
Keep out of eyes. Wear protective goggles where necessary.
Respiratory
None required
Ventilation
General mechanical ventilation may be sufficient to keep product vapor and/or mist concentrations within specified TLV ranges. Local
exhaust - only if heated above 100 癋 (37 癈).
Protective Gloves
Polyethylene gloves for prolonged use
Other Protective Equipment
N/A
Medical Conditions Aggravated by Exposure:
Individuals with pre-existing diseases of the eyes, skin or respiratory system may have increased susceptibility to the toxicity of exces-
sive exposures.
9. Physical and Chemical Properties
Appearance Putty
Specific Gravity(H2O =1) N/A
Vapor Density (Air= 1) Non volatile
Odor N/A
Liquid Density Heavier than water
Boiling Point (F? N/A
Evaporation Rate (BUAC = 1) 0.0 x n-butyl acetate
Weight per Gallon 16.20
Page 3
Print Date 03/03/2009
Christy'sTM FastFix
10. Stability and Reactivity
Chemical Stability
Product is stable, but keep away from heat, sparks, open flame and other sources of ignition which induce combustion or thermal
decomposition
Hazardous Polymerization
Will not occur.
Hazardous Decomposition
CO, aldehydes, acids, oxides of sulfur and nitrogen.
Materials to Avoid
None
Conditions to Avoid
N/A
11. Disposal Considerations
Waste Disposal Method
Disposal to be done in accordance with local, state and federal regulations.
12. Transportation Information
DOT Shipping Name:
Not regulated
DOT Hazard Class:
Not regulated
Identification Number:
N/A
13. Other Information
Information on this form is furnished solely for the purpose of compliance with the Occupational Safety and Health Act and
shall not be used for any other purpose. Christy's urges the customers receiving this Material Safety Data Sheet to study it carefully
to become aware of the hazards, if any, of the product involved. In the interest of safety you should notify your employees, agents,
and contractors of the information on this sheet.
The information contained is based on data considered accurate. However, no warranty is expressed or implied regarding
the accuracy of this data or the results to be obtained from the use thereof.
|