Distributed by:
www.Jameco.com 1-800-831-4242
The content and copyrights of the attached
material are the property of its owner.
Jameco Part Number 525835
CHEMTRONICS MSDS #0704
SECTION 1: CHEMICAL PRODUCT AND COMPANY INFORMATION
Company Address:
8125 Cobb Center Drive
Kennesaw, GA 30152
Product Information: 800-TECH-401 Emergency: (Chemtrec) 800-424-9300
Customer Service: 800-645-5244 Revision Date: August 23, 2004
Product Identification
CHEMASK
Product Code: CM1, CM5, CM8, CM1C, CM5C, CM8C
SECTION 2: COMPOSITION/INFORMATION ON INGREDIENTS
Product Ingredient Information CAS# Wt. % Range
Polyisoprene emulsion (latex) 9003-31-0 90.0-95.0
Zinc dibutyldithiocarbamate 136-23-2 1.0-5.0
Acrylic polymer, sodium salt 7446-81-3 1.0-5.0
Deionized water 7732-18-5 1.0-5.0
Methanol 67-56-1 1.0-3.8
Titanium dioxide 13463-67-7 0.1-1.0
Trimethyl quinoline homopolymer 26780-96-1 0.1-1.0
Ammonium hydroxide 1336-21-6 0.1-1.0
SECTION 3: HAZARD IDENTIFICATION
Emergency Overview: Opaque, pink, viscous mild ammoniacal odor. This product is nonflammable. Liquid will irritate eyes and skin under repeated or prolonged
exposure. Breathing high concentrations of product vapor may produce drowsiness and a headache.
Potential Health Effects:
Eyes: Ammonia vapors of this product are irritating and can cause pain, tearing, reddening and swelling accompanied by a stinging sensation.
Skin: Contact causes skin irritation.
Ingestion: Harmful if swallowed. Irritating to mouth, throat and stomach. Latex may solidify in intestinal tract.
Inhalation: Harmful if inhaled. High concentrations of vapors in immediate area can displace oxygen and can cause irritation of mouth, nose, throat and mucus
membranes. Keep people away from such vapors without self-contained breathing apparatus.
Pre-Existing Medical Conditions Aggravated by Exposure: Lung, skin, eye.
SECTION 4: FIRST AID MEASURES
Eyes: Immediately flush with plenty of water. After initial flushing, remove any contact lenses and continue flushing for at least 15 minutes. Have eyes examined
and tested by medical personnel if irritation develops or persists.
Skin: Wash skin with soap and water. Remove contaminated clothing. Get medical attention if irritation develops or persist. Wash clothing separately before reuse.
Ingestion: If swallowed, do not induce vomiting. Get medical attention IMMEDIATELY. Keep head below knees to minimize chance of aspirating material into the
lungs. Never give anything by mouth to an unconscious person.
Inhalation: Remove to fresh air. If not breathing, give artificial respiration. If breathing is difficult, give oxygen. Get medical attention.
SECTION 5: FIRE FIGHTING MEASURES
Flash Point: None to boiling (TCC) LEL/UEL: Not established (% by volume in air)
Extinguishing Media: Use alcohol foam, carbon dioxide, or water spray when fighting fires involving this material.
Fire Fighting Instructions: As in any fire, wear self-contained breathing apparatus (pressure-demand, MSHA/NIOSH approved or equivalent) and full protective gear.
SECTION 6: ACCIDENTAL RELEASE MEASURES
Large Spills: Shut off leak if possible and safe to do so. Wear self-contained breathing apparatus and appropriate personal protective equipment. Allow latex to dry,
scrape up and place in a chemical waste container for proper disposal. Do not flush to sewer. Avoid runoff into storm sewers and ditches which lead to waterways.
Small Spills: Scrape up dried latex, then place in a chemical waste container for proper disposal.
SECTION 7: HANDLING AND STORAGE
Avoid prolonged or repeated contact with eyes, skin, and clothing. Wash hands before eating. Use with adequate ventilation. Avoid breathing product vapor or mist.
Do not reuse this container. Store in a cool dry place away from heat, sparks and flame. Keep container closed when not in use. Do not store in direct sunlight.
KEEP OUT OF REACH OF CHILDREN.
SECTION 8: EXPOSURE CONTROLS/PERSONAL PROTECTION
Exposure Guidelines:
CHEMICAL NAME ACGIH TLV OSHA PEL ACGIH STEL
Polyisoprene emulsion NA NA NA
Methanol 200 ppm 200 ppm 250 ppm
Ammonium hydroxide 25 ppm NA 50 ppm
10 mg/m3 15 mg/m3
Titanium dioxide NA
Work/Hygienic Practices: Good general ventilation should be sufficient to control airborne levels. Local exhaust ventilation may be necessary to control any air
contaminants to within their TLVs during the use of this product. If vapor concentration exceeds TLV, use NIOSH approved organic vapor cartridge respirator. Wear
safety glasses with side shields (or goggles) and rubber or other chemically resistant gloves when handling this material.
NFPA and HMIS Codes: NFPA HMIS
Health 1 1
Flammability 0 0
Reactivity 0 0
Personal Protection - B
Page 1 of 2
CHEMTRONICS MSDS #0704
SECTION 9: PHYSICAL AND CHEMICAL PROPERTIES
Physical State: Opaque, pink liquid Solubility in Water: Dispersible
Odor: Mild ammonical Specific Gravity: .90 (Water =1)
Vapor Pressure: 760 mm Hg @ 100C Evaporation Rate: >1
Vapor Density: 0.63 (Butyl acetate=1): 1
(Air =1) Color: Pink
Boiling Point: (癋) 100 initial Viscosity: 15,000 cps (Approx.)
Percent Volatile: 5% by weight Melting Point: NA
SECTION 10: STABILITY AND CHEMICAL PROPERTIES
Stability - This product is stable. Conditions to Avoid: Do not spray near open flames, red hot surfaces or other sources of ignition.
Incompatibility: Do not mix with powdered alkali and alkaline earth metals or strong oxidizing agents.
Products of Decomposition: Thermal decomposition may release carbon monoxide, carbon dioxide and incompletely burned hydrocarbons.
Hazardous Polymerization: Will not occur Conditions to Avoid: NA
SECTION 11: TOXICOLOGICAL INFORMATION
Inhalation: Ingestion:
Methanol LC50/rats 64,000ppm/4hrs Methanol LD50 5,628 mg/kg
Cancer Information: No ingredients listed as human carcinogens by NTP or IARC
Reproductive effects: none Teratogenic effects: none Mutagenic effects: none
SECTION 12: ECOLOGICAL INFORMATION
Environmental Impact Information
Avoid runoff into storm sewers and ditches which lead to waterways. Water runoff can cause environmental damage.
REPORTING
US regulations require reporting spills of this material that could reach any surface waters. The toll free number for the US Coast Guard National Response Center is:
1-800-424-8802
SECTION 13: DISPOSAL CONSIDERATIONS
Dispose of in accordance with all federal, state and local regulations. Water runoff can cause environmental damage.
SECTION 14: TRANSPORTATION INFORMATION
Air: Cleaning Compound Not Regulated
Ground: Cleaning Compound Not Regulated
SECTION 15: REGULATORY INFORMATION
SECTION 313 SUPPLIER NOTIFICATION
This product contains the following toxic chemicals subject to the reporting requirements of Section 313 of the Emergency Planning and Community Right-To-Know
Act of 1986 (40 CFR 372).
Chemical Name CAS# Wt. % Range
Methanol 67-56-1 1.0-3.8
This information should be included on all MSDSs copied and distributed for this material.
TOXIC SUBSTANCES CONTROL ACT (TSCA).
All ingredients of this product are listed on the TSCA Inventory.
WHMIS: Class D2B
This product has been classified according to the hazard criteria of the CPR and the MSDS contains all of the information required by the CPR.
SECTION 16: OTHER INFORMATION
Normal ventilation for standard manufacturing practices is usually adequate. Local exhaust should be used when large amounts are released.
To the best of our knowledge, the information contained herein is accurate. However, all materials may present unknown hazards and should be used with caution. In
particular, improper use of our products and their inappropriate combination with other products and substances may produce harmful results which cannot be
anticipated. Final determination of the suitability of any material is the sole responsibility of the user. Although certain hazards are described herein, we cannot
guarantee that these are the only hazards that may exist.
Page 2 of 2
|