Water Tight Technologies, LLC
P.O. Box 899, Payson, AZ 85547
SECTION 1 ?PRODUCT IDENTIFICATION
Product Name: Manufacturer's Name:
SEBS Rust Inhibitor Water Tight Technologies, LLC
Item Number: Manufacturer's Address:
BRITE-n-EZ -- SEBSRI P.O. Box 899, Payson, AZ 85547
24 Hour Emergency Telephone Number: HMIS Acute Hazard Rating:
CHEMTREC ?United States 800-424-9300 ; Health __, Flammability __, Reactivity __
International 202-483-7616 (collect)
Chemical Name/Synonyms: Chemical Family:
N/A Mixture
SECTION 2 ?CHEMICAL COMPOSITION
Ingredient Components (chemical names) Common Names Case No. OSHA ACGIH
Hazardous components 1% or greater PEL-TWA TLV-TWA
%
Carcinogens 0.1% or greater
5 mg / m3 5 mg / m3
Titanium Dioxide* 1343-67-7
5 mg / m3 5 mg / m3
Calcium Carbonate 1317-65-3
Silicon Dioxide (Amorphous) 112945-52-5 20 mppcf 5 mg / m3
Aromatic Solvent 64742-95-6 100 ppm 100 ppm
Styrene Butylene Block Copolymer .1 - .2% 66070-58-4 N/A N/A
Zinc Dibutyldithiocarbamate 12-13% 136-23-2 N/A N/A
Polyalicyclic Resin 69430-35-9 N/A N/A
Zinc Chromate 1 ?2% 37300-23-5 N/A N/A
* Indicates toxic chemical subject to reporting requirements of sections 313 of Title III of 40 CFR 372.
SECTION 3 ?PHYSICAL & CHEMICAL CHARACTERISTICS
Appearance/Odor: Physical State: Solubility in Water:
Yellow Liquid with Solvent Odor Liquid Negligible
Boiling Point: Specific Gravity (H睴=1) Melting Point:
313?F - 572?F 1.1 N/A
Vapor Pressure: Vapor Density: Freezing Point:
2.7 mm Hg @ 68篎 Heavier than air Not Established
VOC: Other Information: Reactivity in Water:
3.84 lb/gal. (460g/L) Evaporation rate ?Slower than ether N/A
BRITE-n-EZTM SEBS Rust Inhibitor ?Page 1 of 4
January 19, 2009
Water Tight Technologies, LLC
P.O. Box 899, Payson, AZ 85547
SECTION 4- FIRE & EXPLOSION HAZARD DATA
Flash Point: Flammable Limits (in air):
114?F LEL: 0.5% ; UEL: 6.0%
Extinguishing Media: Fire Fighting Procedures:
Positive pressure self-contained breathing apparatus
Water fog, carbon dioxide, foam or dry chemical (scba) and structural fighting protective clothing will
extinguisher. provide limited protection.
Special Fire & Explosion Hazards:
Hazardous Decomposition Products:
Flammable/combustible material; may be ignited by heat,
sparks or flames. Vapors may travel to a source of
Fire may produce irritating or poisonous gases.
ignition and flash back. Containers may explode in heat
of fire. Vapor explosion hazard indoors, outdoors or in
sewers. Runoff to sewer may create fire or explosion
hazard.
Method Used: Auto-Ignition Temperature:
PMCC N/A
SECTION- 5 HEALTH HAZARD DATA
Signs and Symptoms of Exposure:
Effects of Overexposure:
Excessive inhalation of vapors can cause nasal and
Excessive inhalation of vapors can cause nasal and
respiratory irritation, dizziness, fatigue, nausea,
respiratory irritation, dizziness, fatigue, nausea, headache
headache and possible unconsciousness. Eye contact can
and possible unconsciousness. Prolonged or repeated
cause redness, tearing & blurred vision. Ingestion can
contact with skin can cause moderate irritation, defatting
cause gastrointestinal irritation, nausea, vomiting and
and dermatitis.
diarrhea.
Acute: Chemical Listed as a Carcinogen (or Potential Carcinogen):
Headache, dizziness, nausea and irritation
National Toxicology Program: None
Chronic:
I.A.R.C. Monographs: None
Loss of appetite, nose bleeds. OSHA: None
Symptoms of poisoning may even occur after several hours, therefore medical observation
Emergency & First Aid Procedures:
for at least 48 hours after the accident should occur.
Eye Contact:
Flush with water and call physician
Skin Contact:
Immediately wash with soap and water and rinse thoroughly.
Inhalation:
Remove to fresh air. Administer oxygen or artificial respiration, if necessary.
Ingestion:
Seek medical treatment.
Primary Route of Entry:
Inhalation, skin, eyes, ingestion.
BRITE-n-EZTM SEBS Rust Inhibitor ?Page 2 of 4
January 19, 2009
Water Tight Technologies, LLC
P.O. Box 899, Payson, AZ 85547
SECTION 6 ?REACTIVITY DATA
Stability: Incompatibility:
Stable. Isolate from oxidizers, heat and open flame.
Hazardous Decomposition Products: Hazardous Polymerization:
Fire may produce irritating or poisonous gases.
Will not occur.
Conditions to Avoid:
Extreme heat, open flames.
SECTION 7 - SPILL OR LEAK PROCEDURES
Steps to be taken in case material is released or spilled:
Small spill:
Ventilate confined spaces. Keep product out of watercourses by diking. Take up with sand or other noncombustible
absorbent material and place into container for later disposal.
Large Spill:
Same as small spill. Dike far ahead of liquid spill for later disposal. Stop leak if you can without risk.
Waste Disposal Method:
Incinerate under safe conditions or dispose of in accordance with local, federal and state laws and regulations.
SECTION 8 ?SPECIAL PROTECTION
Respiratory Protection: Eye Protection:
Use respirator in confined areas. Splash goggles recommended or safety glasses with side
shields are acceptable.
Protective Gloves: Other Protective Equipment:
Impervious gloves are recommended to prevent skin Protective work clothing.
contact.
Ventilation:
Local exhaust recommended.
BRITE-n-EZTM SEBS Rust Inhibitor ?Page 3 of 4
January 19, 2009
Water Tight Technologies, LLC
P.O. Box 899, Payson, AZ 85547
SECTION 9 ?SPECIAL PRECAUTIONS OR OTHER COMMENTS
Storage/Handling:
Store in cool, dry, well ventilated facility. Store and use away from all sources of direct heat, sunlight and open
flames. DO NOT FREEZE. Keep containers closed when not in use.
Other Precautions:
Provide adequate ventilation and avoid prolonged or repeated contact with the skin. Wash with soap and water after
contact.
Work/Hygienic Practices:
Maintain good personal hygiene practices. Wash contaminated clothing before reuse. Do not eat, drink, or smoke in
work areas. Wash exposed skin before eating, drinking, smoking, or applying cosmetics.
SECTION 10 - TRANSPORTATION
Regulatory Agency: Identification Number:
N/A
Labels Required:
Proper Shipping Name:
N/A N/A
Hazard Classification: Other Requirements:
N/A N/A
Packing Group:
N/A
SECTION 11 ?MISCELLANEOUS INFORMATION
Additional Comments:
Date of Previous MSDS:
Changes Since Previous MSDS:
Telephone Number for Additional Information:
(888) 269-2122
DISCLAIMER
The information contained herein is based on data considered accurate which has been obtained from other
companies and organizations. However, no warranty or representation is expressed or implied that the information
is accurate, complete, or representative. Water Tight Technologies, LLC assumes no responsibility for injury to the
buyer, the buyer's employees, or any third persons if reasonable safety procedures are not followed.
BRITE-n-EZTM SEBS Rust Inhibitor ?Page 4 of 4
January 19, 2009
|