Route(s) of Entry: Inhalation? Yes , Skin? Yes , Eyes? Yes , Ingestion? Yes
Potential Health Effects (Acute and Chronic)
Carcinogenicity: NTP? No , IARC Monographs? No , OSHA Regulated? No
Carcinogenicity/Other Information
Recommended Exposure Limits: Pyrethrins: 5 mg/m3 ACGIH TWA
LD 50/LC 50: Oral LD50 > 1500 mg/kg in rats
Signs and Symptoms Of Exposure
SKIN CONTACT: Irritation immediately after direct contact is not expected. However, skin contact should be avoided.
EYE CONTACT: Irritation may occur following direct contact. Symptoms might include redness, swelling or
discharge.
INHALATION: Mist or vapor is not expected to be toxic. However, inhalation should be avoided.
INGESTION: Toxicity following ingestion is not expected. However, ingestion should be avoided.
Medical Conditions Generally Aggravated By Exposure
None known.
SECTION 4. First Aid Measures
Adams Flea & Tick Mist
Emergency and First Aid Procedures
SKIN CONTACT: Remove contaminated clothing and wash exposed area with soap and water. Obtain medical
assistance if irritation or other unusual symptoms occur.
EYE CONTACT: Wash eyes continuously with water for at least 15 minutes and obtain medical attention. NOTE TO
PHYSICIAN: Consider further flushing of eyes with large amounts of water or saline.
INHALATION: Move exposed subject to fresh air. Refer to a physician if subject experiences difficulty breathing. IF
BREATHING HAS STOPPED, START BASIC LIFE SUPPORT AND SEEK IMMEDIATE MEDICAL
ASSISTANCE.
INGESTION: In the event of swallowing this material, do not induce vomiting. Treat Subject symptomatically and
supportively. Get immediate medical assistance.
NOTE TO PHYSICIAN: This material contains pyrethrin insecticides. In cases of overexposure, consult a poison
control center for detailed information concerning pyrethrin poisoning and treatment.
ANTIDOTES: No specific antidote known.
Note to Physician
SECTION 5. Fire Fighting Measures
Adams Flea & Tick Mist
Flash Pt: 65.00 F Method Used: No data.
Explosive Limits: LEL: 2 UEL: 12
Autoignition Pt: 460.00 F Extinguishing Media
This material supports combustion. Carbon dioxide, dry chemical or foam extinguishers are recommended. Water jets
may intensify the fire or be ineffective. Toxic or corrosive gases are expected during a fire or heating of this material.
Fire Fighting Instructions
Toxic or corrosive gases are expected in fires involving this mixture. Self-contained breathing apparatus and full
protective equipment are recommended for firefighters. Move containers from fire area if possible without increased
personal risk. Dike area if possible to contain water for later disposal.
Flammable Properties and Hazards
Flammable liquid. Vapors are heavier than air and may travel to a flame or point of ignition.
Hazardous Combustion Products
Steps To Be Taken In Case Material Is Released Or Spilled
For large spills, isolate the spill area, restrict access and post the area for hazards present (flammable liquid, eye irritant)
and necessary precautions. Extinguish open flames and shut off sources of ignition. Wear apropriate protective
equipment to avoid skin contact and eye contact. Avoid sparks and open flames. Mix with sand or absorbent material
and scoop or shovel into a suitable, properly labeled container for recovery or disposal.
SECTION 7. Handling and Storage
Adams Flea & Tick Mist
Hazard Label Information:
Store away from incompatible material
Rubber or neoprene gloves
Precautions To Be Taken in Handling
STORAGE: Store in a cool, dry place away from heat, open flames and other containers of food or feed. Do not
transfer to other containers.
HANDLING: Do not use this material near sources of ignition. Use with adequate ventilation.
Precautions To Be Taken in Storing
Other Precautions
Personal exposure to this material should be avoided. Enclosure or local exhaust ventilation at the source of the
material release should be used to routinely control exposure. If local exhaust ventilation is not appropriate, respirators
supplied for the identified hazard must be worn.
Protective clothing should be worn if contact is possible.
Respiratory Equipment (Specify Type)
An appropriate respirator should be used if respiratory discomfort occurs. For U.S. operations, OSHA 29 CFR
1910.134 must be followed if respirator use is employed in the workplace. For non U.D. operations, review pertinent
local regulations.
Eye Protection
Glasses or goggles are recommended if eye contact is possible.
Protective Gloves
Avoid skin contact or wear impervious gloves when handling this material.
Other Protective Clothing
Wear clothing with long sleeves to avoid skin contact.
Engineering Controls (Ventilation etc.)
Work/Hygienic/Maintenance Practices
Wash hands and arms thoroughly after handling this material. Clean up spills immediately.
SECTION 9. Physical and Chemical Properties
Adams Flea & Tick Mist
[ ] Gas , [ X ] Liquid , [ ] Solid
Physical States:
82.00 C
Boiling Point:
-88.00 C
Melting Point:
.804
Specific Gravity (Water = 1):
No data.
Density:
32mmHG at 23.0 C
Vapor Pressure (vs. Air or mm Hg):
2.07
Vapor Density (vs. Air = 1):
2.06
Evaporation Rate (vs Butyl Acetate=1):
No data.
Solubility in Water:
components are soluble in water
Other Solubility Notes:
N.A.
Percent Volatile:
No data.
Saturated Vapor Concentration:
No data.
Viscosity:
7
pH:
Appearance and Odor
A yellow liquid with an alcohol odor
SECTION 10. Stability and Reactivity
Adams Flea & Tick Mist
Stability: Unstable [ ] Stable [ X ]
Conditions To Avoid - Instability
Avoid direct sunlight, conditions that might generate heat and sources of ignition.
Incompatibility - Materials To Avoid
Incompatible with strong oxidizing agents such as household bleach, anhydrides, isocyanates and organometallics.
Hazardous Decomposition Or Byproducts
Hazardous Polymerization: Will occur [ ] Will not occur [ X ]
Conditions To Avoid - Hazardous Polymerization
SECTION 11. Toxicological Information
Adams Flea & Tick Mist
Waste Disposal Method
DECONTAMINATION PROCEDURES: NONE
DISPOSAL CONSIDERATIONS: Do not reuse empty containers. Observe all federal, State and local regulations when
disposing of this material.
SECTION 14. Transport Information
Adams Flea & Tick Mist
DOT Proper Shipping Name
DOT Hazard Class: ORM-D
DOT Hazard Label: None
UN/NA Number: No dat
Additional Transport Information
SECTION 15. Regulatory Information
Adams Flea & Tick Mist
SECTION 16. Other Information
Adams Flea & Tick Mist
Supercedes Revision 04/03/2003
ECOLOGICAL INFORMATION
ACUTE AQUATIC EFFECTS: This mixture is toxic to fish. Do not add directly to water. Do not apply where runoff is
likely to occur.
The information and data herein are believed to be accurate and have been compiled from sources believed to be
reliable. It is offered for your consideration, investigation and verification.