?br>
ITW CHEMTRONICS MSDS #-0719
0SECTION 1: CHEMICAL PRODUCT AND COMPANY INFORMATION
Company Address:
8125 Cobb Center Drive
Kennesaw, GA 30152
Product Information: 800-TECH-401 Emergency: (Chemtrec) 800-424-9300
Customer Service: 800-645-5244 Revision Date: February 17, 2010
Product Identification
Chemask NA Non-Ammoniated Temporary Spot Mask
Product Code: CNA8, CNA1
SECTION 2: COMPOSITION/INFORMATION ON INGREDIENTS
Product Ingredient Information CAS# Wt. % Range
Deionized water 7732-18-5 45.0-55.0
Acrylic polymer mixture 35.0-45.0
Polyurethane resin mixture 1.0-5.0
diethylene glycol dibenzoate 120-55-8 1.0-5.0
dipropylene glycol dibenzoate 27138-31-4 1.0-5.0
titanium dioxide 13463-67-7 0.1-1.0
SECTION 3: HAZARD IDENTIFICATION
Emergency Overview: Viscous, opaque green liquid. This product is not flammable. Liquid may irritate eyes and skin under repeated or prolonged exposure.
Potential Health Effects:
Eyes: Liquid and vapors of this product are irritating and can cause pain, tearing, reddening and swelling accompanied by a stinging sensation.
Skin: Contact causes skin irritation. Sensitizer - may cause allergic skin reaction.
Ingestion: Harmful if swallowed. Irritating to mouth, throat and stomach. May cause nausea, vomiting, and diarrhea.
Inhalation: High concentrations of vapors may cause headaches, nausea, dizziness, and respiratory irritation if inhaled.
Pre-Existing Medical Conditions Aggravated by Exposure: Lung, eye, skin
SECTION 4: FIRST AID MEASURES
Eyes: Immediately flush with large amounts of water. After initial flushing, remove any contact lenses and continue flushing for at least 15 minutes. Have eyes
examined and tested by medical personnel if irritation develops or persists.
Skin: Wash skin with soap and water. Remove contaminated clothing. Get medical attention if irritation develops or persists. Wash clothing separately before reuse.
Ingestion: If swallowed, seek medical attention immediately.
Inhalation: In case of exposure to high concentrations of vapor, remove to fresh air. If breathing is difficult, give oxygen and get medical attention.
SECTION 5: FIRE FIGHTING MEASURES
Flash Point: None to boiling (TCC) LEL/UEL: NA (% by volume in air)
Extinguishing Media: Use alcohol foam, carbon dioxide, or water spray when fighting fires involving this material.
Fire Fighting Instructions: As in any fire, wear self-contained breathing apparatus (pressure-demand, MSHA/NIOSH approved or equivalent) and full protective gear.
SECTION 6: ACCIDENTAL RELEASE MEASURES
Large Spills: Shut off leak if possible and safe to do so. Wear self-contained breathing apparatus and appropriate personal protective equipment. Absorb spill with
inert absorbant material, then place in a chemical waste container for proper disposal. Do not flush to sewer. Avoid runoff into storm sewers and ditches which lead
to waterways.
Small Spills: Absorb spill with absorbent material, then place in a chemical waste container for proper disposal.
SECTION 7: HANDLING AND STORAGE
Avoid prolonged or repeated contact with eyes, skin, and clothing. Wash hands before eating. Use with adequate ventilation. Avoid breathing product vapor.
Do not reuse this container. Store in a cool dry place away from heat, sparks and flame. Keep container closed when not in use. Do not store in direct sunlight.
KEEP OUT OF REACH OF CHILDREN.
SECTION 8: EXPOSURE CONTROLS/PERSONAL PROTECTION
Exposure Guidelines:
CHEMICAL NAME ACGIH TLV OSHA PEL ACGIH STEL
Acrylic polymer NA NA NA
Polyurethane resin NA NA NA
diethylene glycol dibenzoate NA NA NA
dipropylene glycol dibenzoate NA NA NA
Work/Hygienic Practices: Good general ventilation should be sufficient to control airborne levels. Wear safety glasses with side shields (or goggles) and rubber or
other chemically resistant gloves when handling this material.
NFPA and HMIS Codes: NFPA HMIS
Health 1 1
Flammability 0 0
Reactivity 0 0
Personal Protection - B
Page 1 of 2
?br>
ITW CHEMTRONICS MSDS #-0719
SECTION 9: PHYSICAL AND CHEMICAL PROPERTIES
Physical State: Opaque, viscous material Solubility in Water: Dispersible
Odor: None Specific Gravity: 1.06
Vapor Pressure: NA Evaporation Rate: >1
Vapor Density: NA (Butyl Alcohol= 1)
Color: Light green Viscosity: NA
Boiling Range: >212癋 Percent Volatile: <0.5
pH: 6.0-8.0
SECTION 10: STABILITY AND CHEMICAL PROPERTIES
Stability - Stable.
Conditions to Avoid: Storage above 120?F, exposure to light, loss of polymerization inhibitor, contamination with incompatible materials.
Incompatibility: Do not mix with powdered alkali and alkaline earth metals or strong oxidizing agents.
Products of Decomposition: Thermal decomposition may release carbon monoxide, carbon dioxide, HCN, and hydrocarbons.
Hazardous Polymerization: Will not occur
SECTION 11: TOXICOLOGICAL INFORMATION
Inhalation: Not available
Ingestion: Not available
Skin: Not available
Cancer Information: No ingredients listed as human carcinogens by NTP or IARC
Reproductive effects: none Teratogenic effects: none Mutagenic effects: none
SECTION 12: ECOLOGICAL INFORMATION
Environmental Impact Information
Avoid runoff into storm sewers and ditches which lead to waterways. Water runoff can cause environmental damage.
REPORTING
US regulations require reporting spills of this material that could reach any surface waters. The toll free number for
the US Coast Guard National Response Center is:
1-800-424-8802
SECTION 13: DISPOSAL CONSIDERATIONS
Dispose of in accordance with all federal, state and local regulations. Water runoff can cause environmental damage.
SECTION 14: TRANSPORTATION INFORMATION
Air: Coating Compound, Not Regulated
Ground: Coating Compound, Not Regulated
SECTION 15: REGULATORY INFORMATION
SECTION 313 SUPPLIER NOTIFICATION
This product contains the following toxic chemicals subject to the reporting requirements of Section 313 of the Emergency Planning and Community Right-To-Know
Act of 1986 (40 CFR 372).
None
This information should be included on all MSDSs copied and distributed for this material.
TOXIC SUBSTANCES CONTROL ACT (TSCA).
All ingredients of this product are listed on the TSCA Inventory.
CALIFORNIA PROPOSITION 65: WARNING: This product contains formaldehyde, a chemical known to the state of California to cause cancer.
WHMIS: Class D2B
This product has been classified according to the hazard criteria of the CPR and the MSDS contains all of the information required by the CPR.
SECTION 16: OTHER INFORMATION
Normal ventilation for standard manufacturing practices is usually adequate.
To the best of our knowledge, the information contained herein is accurate. However, all materials may present unknown hazards and should be used with caution. In
particular, improper use of our products and their inappropriate combination with other products and substances may produce harmful results which cannot be
anticipated. Final determination of the suitability of any material is the sole responsibility of the user. Although certain hazards are described herein, we cannot
guarantee that these are the only hazards that may exist.
Page 2 of 2
|