MATERIAL SAFETY DATA SHEET
Enamel LocTM Self-Etching Light Cured Pit and Fissure Sealant
Revision B EU acc. To ISO 11014
Last revised: 11-January-2007
Approved for use: 12-September-2006
1. Chemical Product and Company Identification
Product Name: Enamel LocTM Self-Etching Light Cured Pit and Fissure Sealant
Manufacturer:
Premier Dental Products Company
1710 Romano Drive
Plymouth Meeting, PA 19462
PH: 610-239-6000; FAX: 610-239-6171
2. Composition/Information of Hazardous Ingredients
Hazardous Ingredients CAS # Hazard Identification & Risk
Phases
Urethandimethacrylate oligomer 72869-86-4 Xi, R36/37/38
Triethyleneglycoldimethacrylate 109-16-0 Xi
Methacrylated phosphoric acid esters 32435-46-4 Xi, R/36/38-43
4-methacryloxyethyltrimellitic acid 70293-55-9 Xn; Xi; R22-36/38-43
Photo initiators 10287-53-3 Xi, R36/37/38
TiO2 13463-67-7 Xi R36/37/38
Fumed Silica 7631-86-9 Xi R36/37/38
Additional information: For the wording of the listed risk phrases refer to section 16.
3. Hazard Identification Xi irritant
Acute Health Hazards: May cause eye, respiratory and skin irritation
Chronic Health Hazards: Material is not known to cause significant health problems
Signs and Symptoms of Exposure: High concentrations can cause eye and respiratory
irritation. Prolonged skin exposure can cause dryness
Primary Routes of Exposure: Inhalation, skin contact, eye contact
Carcinogenicity: NTP ?no, OSHA ?no, IARC ?no
4. First Aid Measures
Inhalation: if irritation occurs, take victim to open air.
Skin contact: wash with soap and water.
Eye contact: Flush with large quantities of water for 15 minutes. Consult a physician.
In case of ingestion: Consult a physician.
5. Fire-Fighting Measures
Flashpoint: N/A
Extinguishing Media: Carbon dioxide, water spray, foam or dry chemical
Special Fire Fighting Procedures: Avoid a direct jet of water
Unusual Fire and Explosion Hazards: None
Page 1 of 4
6. Accidental Release Measures
Environmental Precautions: Avoid seepage into sewers and water supplies.
Clean-Up Procedure: Contain spill and pick up material with a suitable
absorbent material. Place absorbent into a container for later disposal. Clean
spill area with detergent and water.
7. Handling and Storage
Handling: No special measures necessary if handled according to instructions.
Storage: Keep container tightly closed when not in use. Store in a cool, dry
location. Keep material in original packaging.
8. Exposure Controls/ Personal Protection
Exposure Controls: Use only in well ventilated areas.
Hand and Skin Protection: Avoid unnecessary skin contact. Wear latex gloves when
handling.
Hygiene Measures: Remove spilled material from skin and clothing. Do not
eat or drink when handling this material.
9. Physical and Chemical Properties
Appearance: White paste
Odor: Specific odor
Boling Point/ Range: N/A
Evaporation Bate (water = 1): N/A
Vapor Density (Air = 1): N/A
Solubility in Water: Insoluble
10. Stability and Reactivity
Stability: This material is stable.
Hazardous Reactions: None if handled according to directions
Hazardous Polymerization: May occur
Conditions to Avoid: Heat; UV-light
Incompatibility: Free radicals, reducing agents, heavy metal ions.
Hazardous Decomposition Products: Carbon dioxide, carbon monoxide,
acrylic decomposition products, depending on conditions of heating and
burning.
11. Toxicological Information
Acute oral toxicity: LD50 (rat) > 5000 mg/kg
Irritation of Skin: Dryness and irritation possible upon prolonged exposure.
Allergic Effects: Methacrylate-sensitive individuals may exhibit an allergic
reaction.
12. Ecological Information
Environmental persistence and degradability: No data available
Ecotoxicity: No data available
Do not discharge into sewers or water supplies.
Page 2 of 4
13. Disposal Considerations
May be disposed of in landfill or incinerator in accordance with local, state
and federal regulations.
14. Transport Information
14.1 Transport at land ADR RID
UN number Kemler Number
Packing group
Proper shipping name
14.2 Transport at sea ADNR IMDG
UN number MFAG
EMS Packing Group
Proper shipping name
14.3 Air transport ICAO / IATA-DGR
UN number
Proper shipping name
Subsidiary risk
Labels
Packing group
U.S. DOT: Shipping Name: Not Regulated
U.S. DOT: Hazard Class: None U.N/ N.A.
Number: None
U.S. Dot Packing Group: None
Other: Not considered hazardous cargo
15. Regulatory Information
This product requires classification according to the criteria of EC.
The product is a medical device according to the EC-directive 93/42.
15.1 UN Number ---
15.2 National regulations
15.3 EU number
15.4 Hazard symbols Xi
15.5 Hazard designation Xi: Irritant. Contains 4-Methacryloxyethyltrimellitic acid.
15.6 Risk phrases R: 22, 36, 37/38, 43
22 Harmful if swallowed.
36 Irritating to eyes.
37/38 Irritating to respiratory system and skin.
Page 3 of 4
43 May cause sensitization by skin contact.
15.7 Safety phrases S: 2, 9, 16, 23, 26, 28, 24/25, 37/39
2 Keep out of the reach of children.
9 Keep container in a well-ventilated place.
16 Keep away from sources of ignition - No smoking.
23 Do not breathe vapor.
26 In case of contact with eyes, rinse immediately with
plenty of water and seek medical advise.
28 After contact with skin, wash immediately with
plenty of water and soap.
24/25 Avoid contact with skin and eyes.
37/39 Wear suitable gloves and eye/face protection.
U.S. ?O.S.H.A. Status: This material is not hazardous under the criteria of
the U.S. Federal Hazard Communication Standard.
16. Other Information
These data are based on our present knowledge; however, they shall not constitute a guarantee
for any specific product features and shall establish a legally valid contractual relationship.
Relevant R-phrases
22 Harmful if swallowed.
36 Irritating to eyes.
37/38 Irritating to respiratory system and skin.
43 May cause sensitization by skin contact.
Xn Harmful.
Material should be maintained in original containers. Empty containers should not be re-used.
AN SI / NFPA 704 DATA
Fire = 1
Health = 1
Reactivity = 1 Specific
This information is based on data considered accurate; however, no warranty is expressed or implied regarding the accuracy
of these data, or the results to be obtained from use thereof. In no event will the manufacturer or distributor be responsible
for damages of any nature whatsoever resulting from the use of, or reliance upon this information. General properties
described herein are to be regarded as guides and are not guaranteed for all samples.
010726 Rev2
Page 4 of 4
|