---------------------------------------------------------------------------
SECTION 1 - CHEMICAL PRODUCT AND COMPANY IDENTIFICATION
---------------------------------------------------------------------------
CHEMICAL PRODUCT IDENTIFICATION:
PRODUCT ID . . . . . . . . . . : 80-WHT/BSE/CLR
PRODUCT CLASS . . . . . . . . . : PAINT, WATER BASE
TRADE NAME . . . . . . . . . . : RUST SCAT ACRYLIC GLOSS ENAMEL
FORMULA ID . . . . . . . . . . : 80-WHT/BSE/CLR
MSDS PREPARATION DATE . . . . . . : 09/12/2005
MANUFACTURER IDENTIFICATION:
NAME . . . . . . . . . . . . . : INSL-X PRODUCTS CORPORATION
ADDRESS . . . . . . . . . . . . : 308 OLD COUNTY ROAD
EDGEWATER FL 32132
TELEPHONE . . . . . . . . . . . : 386-428-6461
EMERGENCY CONTACT . . . . . . . : CHEMTREC
EMERGENCY TELEPHONE . . . . . . : (800) 424-9300
---------------------------------------------------------------------------
SECTION 2 - COMPOSITION/INFORMATION ON HAZARDOUS INGREDIENTS
---------------------------------------------------------------------------
1 2-(2-ETHOXYETHOXY)ETHANOL
CAS# 111-90-0
DIETHYLENE GLYCOL MONOETHYL ETHER
PCT BY WT: 3.1920 VAPOR PRESSURE: .080 MMHG @ 68F
EXPOSURE LIMIT:
LC50: Inhalation (Rat)- > 200 mg/1/1 Hrs
LD50: Oral (Rat)- 10,502 mg/kg
---------------------------------------------------------------------------
2
CAS# 13463-67-7
TITANIUM DIOXIDE
PCT BY WT: 20 - 25
EXPOSURE LIMIT:
ACGIH TLV/TWA: 10 mg/cu m(Total Dust) - TWA
OSHA PEL/TWA: 10 mg/cu m(Total Dust) - TWA
LD50: Oral (Rat)- >7500 mg/kg (TiO2)
---------------------------------------------------------------------------
3 HYDROUS KAOLIN
CAS# 1332-58-7
ALUMINUM SILICATE
PCT BY WT: .5 - 5
EXPOSURE LIMIT:
ACGIH TLV/TWA: 2 mg/cu m - TWA
OSHA PEL/TWA: 10 mg/cu m (Total dust) - TWA
---------------------------------------------------------------------------
***************************************************************************
This product contains no reported carcinogens or suspected carcinogens
according to the information provided in Section 3 of this MSDS.
***************************************************************************
***************************************************************************
This product contains pigments, which may become a dust nuisance when
removed by abrasive blasting, sanding, or grinding.
***************************************************************************
---------------------------------------------------------------------------
INSL-X PRODUCTS CORPORATION
MATERIAL SAFETY DATA SHEET
80-WHT/BSE/CLR 1
---------------------------------------------------------------------------
---------------------------------------------------------------------------
SECTION 3 - HAZARDS IDENTIFICATION
---------------------------------------------------------------------------
POTENTIAL HEALTH EFFECTS
EYES: Primary irritant.
SKIN: May irritate skin.
INHALATION: With poor ventilation, vapor or spray mist may irritate
respiratory mucous membranes, causing headache & nausea.
INGESTION: N/A
ROUTE(S) OF EXPOSURE
Exposure may be inhalation and/or skin or eye contact, depending on
conditions of use.
CARCINOGENICITY
No ingredient in this product is an IARC, NTP or OSHA listed
carcinogen.
CHRONIC EFFECTS:
None recognized.
---------------------------------------------------------------------------
SECTION 4 - FIRST AID MEASURES
---------------------------------------------------------------------------
EMERGENCY FIRST AID:
EYE CONTACT: Flush at once with large amounts of lukewarm water for at
least 15 minutes and get medical attention.
SKIN CONTACT: Remove from skin with soap and water. Remove drenched
clothing. If irritation persists, consult a physician.
INHALATION: If affected by inhalation of vapor or spray mist, remove to
fresh air. If necessary, restore breathing; in this case
contact physician at once.
INGESTION: If victim is conscious, give 2 glasses of water to dilute.
Do not induce vomiting. Consult physician or poison control
center at once.
NOTE TO PHYSICIAN:
Not Applicable.
---------------------------------------------------------------------------
SECTION 5 - FIRE FIGHTING MEASURES
---------------------------------------------------------------------------
FIRE AND EXPLOSIVE PROPERTIES OF THE CHEMICAL:
Flammability Classification . . . . . : N/A
Flashpoint . . . . . . . . . . . . . : N/A
Explosion Level . . . . . . . . . . . : Low - .6
High - 23.5
EXTINGUISHING MEDIA
---------------------------------------------------------------------------
INSL-X PRODUCTS CORPORATION
MATERIAL SAFETY DATA SHEET
80-WHT/BSE/CLR 1
---------------------------------------------------------------------------
Use extinguishing media appropriate for surrounding fire. After
water evaporates, remaining material will burn; use CO2, dry chemical
or foam (National Fire Protection Association Class B extinguisher).
FIRE-FIGHTING PROCEDURES AND EQUIPMENT
Full protective equipment including self-contained breathing
apparatus should be used. Water spray may be ineffective. If water
is used, fog nozzles are preferable.
UNUSUAL FIRE AND EXPLOSION HAZARDS
Closed containers may explode when exposed to extreme heat; use
water spray to cool. Product in open containers may spatter when the
temperature exceeds boiling point of water.
---------------------------------------------------------------------------
SECTION 6 - ACCIDENTAL RELEASE MEASURES
---------------------------------------------------------------------------
STEPS TO BE TAKEN IN CASE MATERIAL IS RELEASED OR SPILLED
Ventilate as described in Section 8. Avoid unnecessary skin
contact. Stop and/or contain spill if it can be done safely.
Avoid discharge into drains, sewers or waterways.
CLEAN-UP
Collect by absorption, shovel and/or wet moping.
---------------------------------------------------------------------------
SECTION 7 - HANDLING AND STORAGE
---------------------------------------------------------------------------
HANDLING
Transfer only to approved containers with complete & appropriate
labeling. Do not take internally. Keep out of the reach of children.
STORAGE
Do not store above 120 Degrees F. Close container after each use.
SPECIAL COMMENTS
Do not take internally. Wash with soap and water before eating,
drinking, smoking or using toilet. Avoid FREEZING this product.
---------------------------------------------------------------------------
SECTION 8 - EXPOSURE CONTROLS, PERSONAL PROTECTION
---------------------------------------------------------------------------
VENTILATION
Local exhaust preferable. General exhaust acceptable if the
exposure to chemicals in Section 2 is maintained below applicable
exposure limits.
RESPIRATORY PROTECTION
Where exposures are below the PEL, no respiratory protection is
required. Where exposures exceed the PEL, use a respirator approved by
NIOSH or a full protective suit with air supply appropriate for the
---------------------------------------------------------------------------
INSL-X PRODUCTS CORPORATION
MATERIAL SAFETY DATA SHEET
80-WHT/BSE/CLR 1
---------------------------------------------------------------------------
chemical(s) and level of exposure.
EYE PROTECTION
Wear safety spectacles with unperforated side shields.
PROTECTIVE GLOVES
None required for normal application of limited duration is expected.
For long or repeated contact, wear chemical resistant gloves.
---------------------------------------------------------------------------
SECTION 9 - PHYSICAL AND CHEMICAL PROPERTIES
---------------------------------------------------------------------------
Vapor Density . . . . . . . . . . . . : N/A
Vapor Pressure . . . . . . . . . . . : 17mmHg@ 68 Degrees F (water)
Physical State . . . . . . . . . . . .: LIQUID
Boiling Point Range . . . . . . . . . : Lower - 212.0 癋
Higher - 401.0 癋
Specific Gravity . . . . . . . . . . : 1.243
Weight per Volume . . . . . . . . . . : 10.3434 LB/GL
VOC - Total (lbs./gal). . . . . . . . : 1.845
Evaporation Rate . . . . . . . . . . .: .020 (n-Butyl Acetate = 1)
Volatile by Weight . . . . . . . . . : 51.3236
Volatile by Volume . . . . . . . . . : 64.0556
---------------------------------------------------------------------------
SECTION 10 - STABILITY AND REACTIVITY
---------------------------------------------------------------------------
STABILITY
This product is stable.
INCOMPATIBILITIES (Materials to Avoid)
None known.
HAZARDOUS POLYMERIZATION
Will not occur.
CONDITIONS TO AVOID
High temperatures.
HAZARDOUS PRODUCTS OF DECOMPOSITION
Heating to decomposition, as in a fire or welding, may produce
hazardous fumes. Fumes may contain carbon monoxide, carbon dioxide
and oxides of nitrogen.
---------------------------------------------------------------------------
SECTION 11 - TOXICOLOGICAL INFORMATION
---------------------------------------------------------------------------
No data at this time.
---------------------------------------------------------------------------
INSL-X PRODUCTS CORPORATION
MATERIAL SAFETY DATA SHEET
80-WHT/BSE/CLR 1
---------------------------------------------------------------------------
---------------------------------------------------------------------------
SECTION 12 - ECOLOGICAL INFORMATION
---------------------------------------------------------------------------
No data at this time.
---------------------------------------------------------------------------
SECTION 13 - DISPOSAL CONSIDERATIONS
---------------------------------------------------------------------------
WASTE DISPOSAL
Dispose of this product in accordance with applicable local,
county, state and federal regulations, by incinerating, or treating and
disposing in approved facility. Do not incinerate closed containers.
---------------------------------------------------------------------------
SECTION 14 - TRANSPORT INFORMATION
---------------------------------------------------------------------------
DOT HAZARD CLASS . . . . . . . . : N/A
DOT PACKAGING GROUP . . . . . . . : N/A
DOT LABEL . . . . . . . . . . . . : NONE
DOT SHIPPING NAME . . . . . . . . : PAINT
DOT PLACARD . . . . . . . . . . . : NONE
UN/NA NUMBER . . . . . . . . . . .: NONE
---------------------------------------------------------------------------
SECTION 15 - REGULATORY INFORMATION
---------------------------------------------------------------------------
U.S. FEDERAL REGULATORY INFORMATION
TSCA SECTION 8(b) - INVENTORY STATUS:
All components of this product are either listed on the U.S. Toxic
Substances Control Act (TSCA) inventory of chemicals or are otherwise
compliant with TSCA Regulations.
SARA 313 TOXIC CHEMICALS:
This product contains the following substances subject to the
reporting requirements of Section 313 of Title III of the Superfund
Amendments and Reauthorization Act of 1986 and 40 CFR Part 372:
DIETHYLENE GLYCOL MONOETHYL ETHER
CAS# 111-90-0 PCT BY WT: 3.1920
---------------------------------------------------------------------------
---------------------------------------------------------------------------
SECTION 16 - OTHER INFORMATION
---------------------------------------------------------------------------
Prepared by . . . . . . . . . . . . . :
Date of issue . . . . . . . . . . . . : 09/12/2005
Last Revision Date . . . . . . . . . : 04/16/2003
MSDS Prepared for . . . . . . . . . . :
---------------------------------------------------------------------------
INSL-X PRODUCTS CORPORATION
MATERIAL SAFETY DATA SHEET
80-WHT/BSE/CLR 1
---------------------------------------------------------------------------
MSDS Last Prepared . . . . . . . . . : NONE
HMIS Rating: Health- 1 Flammability- 0
Reactivity- 0
***************************************************************************
This Material Safety Data Sheet conforms to the Hazard Communication
Standard, 29 CFR 1910.1200(g)(4).
The above information pertains to this product as currently formulated
and is based on the information available, as of this date. Addition of
reducers or other additives to this product may substantially alter the
composition and hazards of the product. Since conditions of use are out-
side our control, we make no warranties, express or implied, and assume
no liability in connection with any use of this information.
***************************************************************************
Abbreviations used: int.- interior; ext.- exterior; MSDS - Material Safety
Data Sheet; HMIS - Hazardous Materials Information System; CAS - Chemical
Abstracts Services; pct - percent; wt - weight; mm Hg - millimeters of
mercury; F - Fahrenheit; ACGIH - American Conference of Governmental
Industrial Hygienists; TLV - Threshold Limit Value; OSHA - Occupational
Safety and Health Administration; PEL - Permissible Exposure Limit; TWA -
Time-Weighted Average; STEL- Short Term Exposure Limit; N/A- Not applicable
IARC - International Agency for Research on Cancer; NE - Not established
NTP - National Toxicological Program; CFR - Code of Federal Regulations;
OSHA - Z 29CFR 1910, Subpart Z; VOC - Volatile Organic Compounds; TCC -
Tag Closed Cup; LEL - Lower Explosive Limit; Mg/m3 or Mg/Cu M - milligram
per cubic meter; mppcf - millions of particles per cubic foot; ppm - parts
per million; NIOSH - National Institute of Occupational Safety and Health;
MSHA - Mine Safety and Health Administration; CNS - Central Nervous System.
|