Fox Industries Inc.
Material Safety Data Sheet
OSHA's Hazard Communication Standard,
29 CFR 1910.1200.
IDENTITY: FX-70-9 Hydro-Ester Coating (Gray) "A" Component
SECTION I
Manufacturer: Fox Industries, Inc. Emergency Number: 1-800-424-9300 CHEMTREC
Address: 3100 Falls Cliff Road Telephone Number: (410) 243-8856
Baltimore, MD 21211 Date Prepared: 7/2009
SECTION II - HAZARDOUS INGREDIENTS/IDENTITY INFORMATION
Hazardous Components CAS # OSHA PEL Hazard Limits %
Epoxy Resin 025085-99-8 N/E
Silicon Dioxid 14808-60-7 10 mg/m_
Titanium Dioxide 13463-67-7 10 mg/m_
NOTE: It is very unlikely that normal work operations with FX-70-9 "A" Component could produce concentrations that
are harmful to humans.
HMIS Hazard Code Health : 1 Flammability : 1 Reactivity : 0
SECTION III - PHYSICAL/CHEMICAL CHARACTERISTICS
Boiling Point: N/A Specific Gravity (H20 =1): 1.2
Vapor Pressure (mm Hg.): N/A Melting Point: N/A
Vapor Density (AIR = 1): N/A Evaporation Rate: N/A
Solubility in Water: Slight (Butyl Acetate = 1)
Appearance and Odor: Gray liquid, mild odor
SECTION IV - FIRE AND EXPLOSION HAZARD DATA
Flash Point (Method Used): 480?F (PMCC)
Flammable Limits: LEL N/D UEL N/D
Extinguishing Media: Foam, dry chemical, CO2
Special Fire Fighting Procedures: Wear positive pressure, self-contained breathing apparatus.
Unusual Fire and Explosion Hazards: None
SECTION V - REACTIVITY DATA
Stability: Stable Conditions to Avoid: None known
Incompatibility: Oxidizing agents
Hazardous Decomposition or Byproducts: Carbon monoxide
Hazardous Polymerization: Will Not Occur Conditions to Avoid: None known
(OVER)
FX-70-9 Gray "A" comp.
SECTION VI - HEALTH HAZARD DATA
Route(s) of Entry: Inhalation: No Skin: Yes Ingestion: Yes
Health Hazards (Acute and Chronic): May cause eye irritation. Can cause allergic skin response. No hazards
anticipated from ingestion incidental to industrial exposure.
Carcinogenicity: NTP: Not Listed IARC Monographs: Not Listed OSHA Regulated: Not Regulated
Signs and Symptoms of Exposure: Skin or eye irritation or sensitization.
Medical Conditions Generally Aggravated by Exposure: None known
Emergency and First Aid Procedures: Skin - Flush with soap and water. Eyes - Flush with water for at least 15
minutes.
SECTION VII - PRECAUTIONS FOR SAFE HANDLING AND USE
Steps to Be Taken in Case Material Is Released or Spilled: Soak up with absorbent materials, such as sand,
and collect in suitable containers.
Waste Disposal Method: Burn in approved incinerator in compliance with Federal, State, and Local regulations.
Precautions to Be Taken in Handling and Storing: Keep containers closed. Keep in cool area.
Other Precautions: Avoid breathing vapors of heated materials.
SECTION VIII - CONTROL MEASURES
Respiratory Protection: None normally needed.
Ventilation: Mechanical (General) Good general ventilation.
Other Protective Clothing or Equipment: Clean work clothing.
Work/Hygienic Practices: Follow practices of good industrial hygiene.
N/A = Not Applicable N/D = Not Determined N/E = Not Established
Fox Industries Inc.
Material Safety Data Sheet
OSHA's Hazard Communication Standard,
29 CFR 1910.1200.
Flash Point (Method Used): 220?F (PMCC)
Flammable Limits: LEL N/D UEL N/D
Extinguishing Media: Foam, dry chemical, CO2
Special Fire Fighting Procedures: Self-contained breathing apparatus should be worn in confined areas.
Unusual Fire and Explosion Hazards: Toxic fumes will be evolved when this material is involved in a fire.
SECTION V - REACTIVITY DATA
Stability: Stable Conditions to Avoid: None known
Incompatibility: Strong oxidizing agents
Hazardous Decomposition or Byproducts: CO_, CO, Oxides of nitrogen
Hazardous Polymerization: Will Not Occur Conditions to Avoid: None known
(OVER)
FX-70-9 Gray "B" comp
SECTION VI - HEALTH HAZARD DATA
Route(s) of Entry: Inhalation: Yes Skin: Yes Ingestion: Yes
Health Hazards (Acute and Chronic): May cause burns to skin and eyes. High concentrations of vapor can cause
severe irritation of eyes and respiratory tract. Prolonged exposure may cause asthma and skin sensitization or other
allergic response.
Carcinogenicity: NTP: Not Listed IARC Monographs: Not Listed OSHA Regulated: Not Regulated
Signs and Symptoms of Exposure: Skin irritation.
Medical Conditions Generally Aggravated by Exposure: Not known.
Emergency and First Aid Procedures: Skin - Flush with soap and water. Eyes - Flush with water for at least 15
minutes. Seek medical attention. Ingestion - Do not induce vomiting. Get prompt medical attention.
SECTION VII - PRECAUTIONS FOR SAFE HANDLING AND USE
Steps to Be Taken in Case Material Is Released or Spilled: Avoid contact. Stop spill at source. For small
amounts, react with "A" Component to harden. For larger amounts, contain with absorbent and scoop up to disposal
container.
Waste Disposal Method: Burn in approved incinerator in compliance with Federal, State, and Local regulations.
Precautions to Be Taken in Handling and Storing: Keep containers closed. Keep in cool area.
Other Precautions: Prevent all skin and eye contact. Avoid breathing vapors.
SECTION VIII - CONTROL MEASURES
Respiratory Protection: NIOSH approved organic respirator in confined areas.
Ventilation: Mechanical (General) Good general ventilation.