MATERIAL SAFETY DATA SHEET
AZ KWIK STRIP REMOVER 340-0020
Substance key: BBG703W REVISION DATE: 06/07/2005
Version 1 PRINT DATE 11/30/2005
Section 01 - Product Information
AZ Electronic Materials USA Corp.
Identification of the
70 Meister Avenue
company:
Somerville, NJ 08876
Telephone No.: 800-515-4164
Information on the substance/preparation
Product Safety: 908-429-3562
Emergency Tel. number: 800-424-9300 CHEMTREC
Trade name: AZ KWIK STRIP REMOVER 340-0020
18451123170
Material No.:
Section 02 - Composition information
Hazardous ingredients:
Chemical Name CAS-no. (Trade Concentration [%]
secret no.)
Dipropylene glycol monomethyl ether 34590-94-8 59,00 - 0,00
Tetrahydrothiophene-1,1-dioxide 126-33-0 34,00
Polyglycol ether 67829000004- 2,00 - 0,00
5718P
Section 03 - Hazardous identification
May produce systemic or organ effects with repeated or
Emergency overview:
excessive exposure., Clear, yellow liquid., Solvent odor.,
Irritating on contact or inhalation., Water soluble.
Expected route of entry
Contact with liquid and mist.
Skin contact:
no
Ingestion:
Inhalation of mist.
Inhalation:
yes
Skin absorption:
Health effects of
exposure:
Component information:
1/7
MATERIAL SAFETY DATA SHEET
AZ KWIK STRIP REMOVER 340-0020
Substance key: BBG703W REVISION DATE: 06/07/2005
Version 1 PRINT DATE 11/30/2005
Dipropylene glycol monomethyl ether (34590-94-8)
Dipropylene glycol monomethyl ether is a slight eye irritant. Overexposure of animals to DPGME produces
minor liver and kidney effects. In vitro mutagenicity tests have been negative.
Tetrahydrothiophene-1,1-dioxide (126-33-0)
Tetrahydrothiophene-1,1-dioxide is a moderate skin and eye irritant. Prolonged or excessive contact may
result in severe skin irritation and nervous system effects. Inhalation of excessive mists (aerosols) containing
sulfolane may lead to tremors and convulsions. Shows neurotoxicity in animals at high exposures;
aggressive behavior, brain, and visual effects are also manifested.
Polyglycol ether (24938-91-8)
Polyglycol ether may cause skin, eye, and respiratory irritation.
Preexisting skin, eye, and respiratory conditions may be
Known effects on other
aggravated.
illnesses:
IARC: NO NTP: NO OSHA: NO
Listed carcinogen:
HMIS:
Health: 2 Flammability: 1 Reactivity: 0 Personal protection: X
NFPA:
Health: 2 Flammability: 1 Reactivity: 0 Special notice: NONE
Section 04 - First aid measures
Remove victim to fresh air.
After inhalation:
Consult physician if irritation occurs.
Consult physician if exposure is extensive or if irritation occurs.
After contact with skin:
Immediately remove contaminated clothing and wash affected
area thoroughly with soap and water.
Flush thoroughly with water for 15 minutes. Get immediate
After contact with eyes:
medical help.
If person is conscious, give water or milk to dilute stomach
After ingestion:
contents.
Never give anything by mouth to an unconscious person.
Consult physician.
Administer oxygen if there is difficulty in breathing.
Advice to doctor /
Treatement:
2/7
MATERIAL SAFETY DATA SHEET
AZ KWIK STRIP REMOVER 340-0020
Substance key: BBG703W REVISION DATE: 06/07/2005
Version 1 PRINT DATE 11/30/2005
Section 05 - Fire fighting measures
236 癋
Flash point:
Method: closed cup
Thermal decomposition may generate carbon dioxide, carbon
Hazardous
monoxide, and oxides of sulfur.
decomposition products:
Carbon dioxide, water, alcohol resistant foam, dry chemical.
Suitable extinguishing
media:
Use self-contained breathing apparatus and full protective
Special fire fighting
clothing. Use water spray to cool drums in fire area.
procedure:
Thermal decomposition may generate carbon dioxide, carbon
Specific hazards during
monoxide, and oxides of sulfur.
fire fighting:
Solvent vapors., Emits toxic fumes under fire conditions.
Unusual fire and
explosion hazards:
Section 06 - Accidental release measures
Wearing appropriate personal protective equipment, contain
Steps to be taken in case
spill, ventilate area of spill or leak, remove all sparking devices
of spill or leak:
or ignition sources, collect onto inert absorbent, and place in a
suitable container. Rinse residual with water.
Section 07 - Handling and Storage
Advice on safe handling:
Avoid breathing vapors and contact with skin, eyes, and clothing.
Use only with adequate ventilation and proper protective eyewear, gloves, and clothing.
Wash thoroughly after handling.
Keep container closed.
Further information for storage conditions:
Store at appropriate temperature. See label for details.
Store in original container.
Transport and store under dry conditions tightly closed.
Section 08 - Exposion Control / personal protection
When heating this material, use engineering controls to provide
Respiratory protection:
3/7
MATERIAL SAFETY DATA SHEET
AZ KWIK STRIP REMOVER 340-0020
Substance key: BBG703W REVISION DATE: 06/07/2005
Version 1 PRINT DATE 11/30/2005
adequate exhaust ventilation or a NIOSH approved respirator.
Where mist is present, provide local ventilation or a respirator
certified for mist by NIOSH.
Safety eyewear to protect against splashes.
Eye protection:
Clothing suitable to prevent skin contact.
Skin and body protection:
Use local exhaust ventilation.
Advice on system design:
Section 09 - Physical and chemical properties
Liquid
Form:
Clear, yellow
Color:
Solvent odor.
Odor:
soluble
Water solubility:
1,06 g/cm3
Density:
180 癈
Starts to boil:
Reference substance: n-butyl acetate
Evaporation number:
<
4 Torr
Vapor pressure:
>1
Relative vapor density:
100 %
Loss on drying:
Section 10 - Stability and reactivity
Stable.
Hazardous reactions:
Will not occur.
Hazardous polymerization:
Avoid contact with oxidizing agents.
Conditions to avoid:
Section 11 - Toxiclogical information
Dipropylene glycol monomethyl ether (34590-94-8)
LD50 rat
Acute oral toxicity:
5.400 mg/kg
4/7
MATERIAL SAFETY DATA SHEET
AZ KWIK STRIP REMOVER 340-0020
Substance key: BBG703W REVISION DATE: 06/07/2005
Version 1 PRINT DATE 11/30/2005
Tetrahydrothiophene-1,1-dioxide (126-33-0)
LD50 rat
Acute oral toxicity:
1.540 mg/kg
Tetrahydrothiophene-1,1-dioxide (126-33-0)
LC50 rat
Acute inhalation toxicity
Exposure time: 4 h
Dipropylene glycol monomethyl ether (34590-94-8)
LD50 rabbit
Acute dermal toxicity:
Tetrahydrothiophene-1,1-dioxide (126-33-0)
LD50 rabbit
Acute dermal toxicity:
4.009 mg/kg
Section 12 - Ecological information
Additional ecological
Do not allow to enter soil, waterways or waste water
information:
Dipropylene glycol monomethyl ether (34590-94-8)
(carp)
Toxicity to fish:
Section 13 - Disposal considerations
Consult local, state, and federal regulations.
Product:
Section 14 - Transport information
Section 15 - Regulatory information
All components of this product are listed on the TSCA
TSCA Status:
Inventory.
Reactive hazard: no
SARA (section 311/312):
Pressure hazard: no
Fire hazard: no
Immediate/acute: yes
Delayed/chronic: yes
This product is not subject to SARA Title III Section 313
SARA 313 information:
reporting requirements under 40 CFR 372.
5/7
MATERIAL SAFETY DATA SHEET
AZ KWIK STRIP REMOVER 340-0020
Substance key: BBG703W REVISION DATE: 06/07/2005
Version 1 PRINT DATE 11/30/2005
Content VOC (g/l): 625 g/l
Volatile organic
Method: calculated
compounds:
Section 16 - Other information
US State regulatory information
Under the notification requirements of the state of California, this product may be found to contain
one or more of the listed chemicals covered by Proposition 65. These are not intentionally included,
but can be naturally occurring contaminants and/or raw materials used to produce the product. While
we do not analyze expressly for Proposition 65 substances, the possibility of their presence in trace
quantities exists. In order to comply with the California law we are therefore providing the following
statement: Warning: This product contains chemicals known to the state of California to cause cancer
and/or birth defects or other reproductive harm., Ethylene oxide, 1,4-Dioxane
Label information
CAUTION!
Harmful if inhaled, swallowed, or on contact. Contains material that can cause skin, eye, and
respiratory irritation; prolonged or repeated overexposure may cause liver, kidney, and central
nervous system effects. Based on animal tests, exposure to aerosols of this material may cause
aggressive behavior, blood and liver changes, convulsions, and lung effects.
Keep away from heat and flame. Avoid breathing vapor. Avoid contact with skin, eyes, and clothing.
Use only with adequate ventilation, and proper protective eyewear, gloves, and clothing. Wash
thoroughly after handling. Keep container closed.
In case of contact, flush eyes with plenty of water for 15 minutes. Get medical attention immediately.
Flush affected skin areas with water, and wash with mild soap and water. Remove contaminated
clothing. If INHALED, remove individual to fresh air. If breathing is difficult, give oxygen. If ingested,
give water or milk to dilute stomach contents. Never give anything by mouth to an unconscious
person. Get medical attention immediately for ingestion or breathing problems or if skin contact is
extensive.
In case of fire, use water, alcohol resistant foam, dry chemical, or CO2.
If spilled, wear protective clothing, remove ignition sources, prevent sparks, and ventilate area.
Absorb with inert material, collect, and place in a chemical waste container.
Keep sealed in original container. Protect from heat and light. Store in a cool, dry place. Empty
container may contain harmful residue.
The solvent in this product is not photochemically reactive per Rule 102 of the California South Coast
Air Quality Management District.
6/7
MATERIAL SAFETY DATA SHEET
AZ KWIK STRIP REMOVER 340-0020
Substance key: BBG703W REVISION DATE: 06/07/2005
Version 1 PRINT DATE 11/30/2005
This information is supplied under the OSHA Hazard Communication Standard, 29 CFR
1910.1200, and is offered in good faith based on data available to us that we believe to be true and
accurate. The recommended industrial hygiene and safe handling procedures are believed to be
generally applicable to the material. However, each user should review these recommendations in
the specific context of the intended use and determine whether they are appropriate for that use.
No warranty, express or implied, is made regarding the accuracy of this data, the hazards
connected with the use of the material, or the results to be obtained from the use thereof. We
assume no responsibility for damage or injury from the use of the product described herein. Data
provided here are typical and not intended for use as product specifications. (R) and TM indicate
trademarks of AZ Electronic Materials USA Corp., its business partners and suppliers.
7/7
|