PARABOND M-266
Extremely Flammable
Reducer/Cleaner
WARRANTY:
DESCRIPTION: Para-Chem's only obligation shall be to replace or pay for
Reducer -Cleaner. any adhesive proved defective when authorized in writing
by the company. Beyond the purchase price of materials
DIRECTIONS: supplied by us we assume no liability for any damages of
1. To restore normal consistency of Parabond M-250 and any kind and the user accepts the product "as is" and
M-256 Contact Adhesives. without warranties, expressed or implied. The suitability of
2. If these products should thicken due to exposure to the product for an intended use shall be solely up to the
air, minimum amounts may be added to restore user.
consistency.
3. To clean brushes, r llers, tools and spray guns or
o 11-25-02
systems used with Parabond M-250 and M-256
PHYSICAL PROPERTIES:
Weight per gallon: 6.0 pounds
DANGER! EXTREMELY FLAMMABLE, DO
NOT USE NEAR FIRE OR FLAME. PUT
OUT ALL PILOT LIGHTS AND ALL
IGNITION SOURCES. THIS INCLUDES
ELECTRIC PILOT LIGHTS, SPARK
IGNITION SYSTEMS OR INTERMITTENT
IGNITION DEVICES. THESE ARE
ELECTRIC PILOT LIGHTS FOR GAS
APPLIANCES SUCH AS FURNACES, STOVES
AND WATER HEATERS. THEREFORE, IT
IS IMPERATIVE THAT THE GAS SUPPLY
AND ALSO THE ELECTRIC SUPPLY TO
THESE APPLIANCES BE SHUT DOWN OR
DISCONNECTED FROM THE APPLIANCE
ITSELF.
FOR MORE INFORMATION READ
MATERIAL SAFETY DATA SHEET
KEEP OUT OF REACH OF CHILDREN
ISO 9001 Certified
Corporate Address: PO Box 127 ?Simpsonville, SC 29681-0127 ?800-763-7272 ?Fax: 864-228-1491
Manufacturing Facilities: Simpsonville, SC ?Philadelphia, PA ?Dalton, GA ?Mansfield, TX ?Adelanto, CA
www.parabond.com
MATERIAL SAFETY DATA SHEET Page 1
?br>
Para-Chem , PO Box 127, Simpsonville, SC 29681
24-Hour Emergency Telephone: (803) 967-7691
SECTION 1. PRODUCT IDENTIFICATION
?br>
PRODUCT NAME: PARABOND M-266
CHEMICAL FAMILY: Thinner Cleaner
SECTION 2. HAZARDOUS INGREDIENTS AND EXPOSURE LIMITS
CAS % by
Chemical Name Number Weight ACGIH TLV OSHA PEL
Toluene 108-88-3 10% 100 ppm 100 ppm
Methyl Ethyl Ketone 78-93-3 30% 200 ppm 200 ppm
Hexane 110-54-3 60% 50 ppm 500 ppm
SECTION 3. HAZARDS IDENTIFICATION
PRIMARY ROUTES OF ENTRY: Eyes, skin, and respiratory system.
MEDICAL CONDITIONS AGGRAVATED BY EXPOSURE: Respiratory problems.
POTENTIAL HEALTH EFFECTS:
EYE CONTACT: Can cause severe irritation. Vapors can cause slight to moderate irritation.
SKIN CONTACT: Can cause moderate irritation, de-fatting, and dermatitis.
INGESTION: Can cause gastrointestinal irritation, nausea, vomiting, and diarrhea
INHALATION: Can cause nasal and respiratory irritation, dizziness, weakness, fatigue, nausea, headache,
possible unconsciousness, and even asphyxiation.
CHRONIC: None known.
CARCINOGENICITY: This product contains no ingredient listed as a carcinogen by IARC, NTP,
or OSHA.
SECTION 4. FIRST AID MEASURES
EYE CONTACT: Flush with water for 15 minutes. Call physician if irritation occurs.
SKIN CONTACT: Wash with soap and water. Call physician if irritation occurs.
INGESTION: To conscious person, give two glasses of water. Do not induce vomiting and call physician
immediately.
INHALATION: Move person to fresh air. If breathing stops, administer artificial respiration and call
physician immediately.
MATERIAL SAFETY DATA SHEET Page 2
SECTION 5. FIRE-FIGHTING MEASURES
FLASH POINT (o)F: Less than 20, TOC
LOWER FLAMMABLE LIMIT: 1.2
UPPER FLAMMABLE LIMIT: 11.5
FIRE-FIGHTING INSTRUCTIONS: Alcohol foam, CO2, and dry chemical. Use protective clothing and self-
contained breathing apparatus. Eliminate sources of ignition because vapors may travel along the ground or be
moved by ventilation.
DECOMPOSITION PRODUCTS: Material may produce CO, CO2, H2O, and materials listed in Section II.
SECTION 6. ACCIDENTAL RELEASE MEASURES
STEPS TO BE TAKEN IF MATERIAL IS RELEASED OR SPILLED: Eliminate all ignition sources. Dike and
pump liquid to waste containers. Dispense sand, sawdust, or vermiculite. Shovel into closed waste containers.
SECTION 7. HANDLING AND STORAGE
HANDLING: Store in well ventilated area. Use good hygienic practices. (Wash hands before eating, using
washroom, or smoking.) Keep closure tight and container upright to prevent leakage. Keep out of the reach of
children. Drums of this material should be grounded and bonded when pouring. Do not puncture, drag, or slide
container. Prevent prolonged or repeated breathing of vapor or mist. Do not weld or flame cut an empty drum.
Reports have associated repeated and prolonged overexposure to solvents with permanent brain and nervous
system damage. Intentional misuse by deliberately concentrating and inhaling the contents may be harmful or fatal.
This product as supplied is a liquid, and there are no dust hazards from the powders in it. When the product is
processed, the powders should be encapsulated. The user must determine if there is a dust hazards because of
the process used or the end use of the dried material.
STORAGE: Store above 40oF or below 100oF. Do not store or use near heat, sparks, or flame.
SECTION 8. EXPOSURE CONTROLS/PERSONAL PROTECTION
PERSONAL PROTECTIVE EQUIPMENT:
EYE/FACE PROTECTION: Wear splash goggles if contact with liquid is likely.
SKIN PROTECTION: Wear gloves if contact with liquid is likely.
RESPIRATORY PROTECTION: If PEL or TLV is exceeded, use a NIOSH/MSHA approved respirator.
ENGINEERING CONTROLS: Use sufficient ventilation, in volume and pattern, to keep air contaminant
concentration below PEL or TLV.
MATERIAL SAFETY DATA SHEET Page 3
SECTION 9. PHYSICAL AND CHEMICAL PROPERTIES
BOILING POINT (oF): 175-232
VAPOR PRESSURE: 116
VAPOR DENSITY (air=1): 3.1
SPECIFIC GRAVITY (water=1): 0.72
% VOLATILE BY WEIGHT: 100
APPEARANCE AND ODOR: Clear liquid with Ketone odor.
GRAMS VOLATILE ORGANIC COMPOUNDS/LITER OF COATING: Not Applicable
GRAMS VOLATILE ORGANIC COMPOUNDS/LITER OF MATERIAL: Not Applicable
SECTION 10. STABILITY AND REACTIVITY
CHEMICAL STABILITY: Stable.
POLYMERIZATION: Will not occur.
CONDITIONS TO AVOID: None known.
HAZARDOUS DECOMPOSITION PRODUCTS: None.
SECTION 11. TOXICOLOGICAL INFORMATION
No information available.
SECTION 12. ECOLOGICAL INFORMATION
No information available.
SECTION 13. DISPOSAL CONSIDERATIONS
Disposed of in accordance with Federal, State and Local regulations.
SECTION 14. TRANSPORT INFORMATION
DOT CLASSIFICATION:
Proper Shipping Name: Flammable Liquid, NOS, 3 (Hexane and Methyl Ethyl Ketone)
ID Number: UN 1993, PG II
Label: Flammable
MATERIAL SAFETY DATA SHEET Page 4
SECTION 15. REGULATORY INFORMATION
TSCA: All Ingredients listed.
CERCLA:
Chemical Name RQ
Toluene 1,000 lbs.
Methyl Ethyl Ketone 5,000 lbs.
Hexane 5,000 lbs.
SARA TITLE III:
Section 311 and 312 Health and Physical Hazards:
Immediate Delayed Fire Pressure Reactivity
[X] [] [X] [] []
Section 313 Chemicals:
Chemical Name CAS# % by Weight
Toluene 108-88-3 10%
Methyl Ethyl Ketone 78-93-3 30%
Hexane 000110-54-3 60%
CALIFORNIA PROPOSITION 65:
This product contains: Known to the State of California to cause:
Toluene Reproductive Toxicity
SECTION 16. OTHER INFORMATION
HMIS RATINGS: Health = 3 Flammability = 3
Reactivity = 0 Personal Protective Equipment = H
Hazard rating scale: 0=Minimal, 1=Slight, 2=Moderate, 3=Serious, 4=Severe
Para-Chem believes the statements, technical information and recommendations contained herein are reliable.
They are given without warranty or guarantee of any kind, expressed or implied.
DATE ISSUED: February 3, 2004 PREPARED BY: S. Worthy
|