MATERIAL SAFETY DATA SHEET
CONTACT CEMENT
SECTION 1: CHEMICAL PRODUCT AND COMPANY IDENTIFICATION
Supplier: Harris Paints Barbados (2003) Limited
Wildey
St. Michael
Barbados
(246) 429-4840
Product Code and Name: G-8120 Contact Cement
Manufacturer: Harris Paints Barbados (2003) Limited
Wildey
St. Michael
Barbados
MSDS Prepared For: Technical Department Tel: (246) 429-4840
Harris Paints Barbados (2003) Limited Fax: (246) 436-9544 E-Mail: technical@harris.bb
Product Use: Adhesives & Bonding Agents - Building Product
Date of Preparation: May 24, 2004 Revision #: 1
SECTION 2: HAZARDOUS COMPOSITION OF INGREDIENTS AND INFORMATION
INGREDIENTS NAMES COMPOSITION %
(Wt /Gal.)
Common Name Chemical Name CAS No. G-8120
Toluene Methylbenzene, phenylmethane 108-88-3 40 ?50
Hexane Hexane (mixed isomers) 110-54-3 15 ?20
Acetone Propan-2-one, propanone 67-64-1 1?
SECTION 3: HAZARDS IDENTIFICATION
Physical State and
Appearance Liquid
Emergency Overview Strong adhesive properties
Primary Routes of Exposure Skin contact, Inhalation, Eye contact, Ingestion
Possible Effects to Overexposure
Skin contact:- Irritation of skin. May aggravate pre-existing skin conditions.
Inhalation :- Irritation of respiratory tract. Prolonged inhalation may lead to
mucous membrane irritation, dizziness and/or light-headedness,
headache, nausea, asphyxiation.
Eye contact :- Irritation of eyes. Prolonged or repeated contact may cause
conjunctivitis.
Ingestion :- Ingestion may cause mouth and throat irritation, gastro-intestinal
disturbances.
Medical condition aggravated by exposure: Eye, skin, respiratory disorders, kidney disorders, central nervous
system depression.
Overexposure Signs/ Symptoms: Poses a serious health threat if inhaled and harmful on acute
Exposure.
SECTION 4: FIRST-AID MEASURES
Skin Contact: Remove contaminated clothing. Flush skin with water. Then wash thoroughly with soap.
Wash contaminated clothing before re-use.
Inhalation: Remove to fresh air. Restore and support continued breathing. Get emergency medical attention.
Have trained person give oxygen if necessary. Get medical help for any breathing difficulty.
Remove to fresh air if inhalation caused eye watering, headaches, dizziness or other discomfort.
Eye Contact: Flush immediately with large amounts of water, especially under lids for at least 15 minutes. If
Page 1
Contact Cement
SECTION 4: FIRST-AID MEASURES CONT'D
irritation or other effects persist, do not use eyewash or ointment of any kind but obtain eye
specialist treatment.
Ingestion: Flush out mouth. If swallowed, do not induce vomiting. If victim is conscious give liquid paraffin to
drink. Obtain medical treatment immediately.
SECTION 5: FIRE-FIGHTING MEASURES
Flammability of the product: Lower Explosive Limit: Not Known
Upper Explosive Limit: Not Known
Auto-Ignition Temperature: Not known
< 21 oC
Flash Points:
Fire Extinguishing Media: Use dry chemical, foam or fog, carbon dioxide. Do not use water.
Products of Combustion: Carbon dioxide, carbon monoxide, hydrochloric acid, other irritating gases
Unusual Fire and Explosion Hazards: Material only burns if dry
Explosive Hazard in Presence
of Various Substances:
Special Remarks on Fire Easily catches fire if exposed to ignition source.
Hazards:
Special Remarks on
Explosion Hazards:
SECTION 6: ACCIDENTAL RELEASE MEASURES
Small Spill and Leak: Comply with all applicable health and environmental regulations.
Eliminate all sources of ignition. Ventilate area. Spills may be collected with absorbent
materials such as earth and sand. Place collected material in an appropriate container.
Complete personal protective equipment must be used during cleanup.
Large Spills and Leaks: Shut off leak if safe to do so. Dike and contain spill. Pump to storage or salvage
vessel. Use absorbent to collect excess residue.
SECTION 7: HANDLING AND STORAGE
Handling: Store cool at a constant temperature. Keep away from heat, direct exposure to
sunlight, sparks and open flames.
Minimum: 1oC Maximum: 40oC.
Storage: Steel tins. Avoid accumulationg electrostatic charge. Use a safety electric system.
Other Precautions: Use only with adequate ventilation. Do not take internally. Keep out of reach of
children. Avoid contact with skin and eyes and breathing of vapours. Wash hands
thoroughly after handling, especially before eating or smoking. Keep containers tightly
closed and upright when not in use. Avoid conditions which result in formation of
inhalable particles such as spraying or sanding applied surfaces. If such conditions
cannot be avoided, use appropriate respiratory protection as directed under Exposure
Control/Personal Protection. Empty containers may contain residues.
SECTION 8: EXPOSURE CONTROLS / PERSONAL PROTECTION
Common Name CAS No. ACGHI-TLV OSHA-PEL
8-Hour TWA 8-Hour TWA
Toluene 108-88-3 50 ppm 100 ppm
Hexane 110-54-3 500 ppm NA
Acetone 67-64-1 750 ppm 1000 ppm
Personal Protection
Body Impervious clothing should be worn to eliminate possible skin irritation
Hands Impervious gloves such as neoprene or nitrile rubber gloves should be worn.
Page 2
Contact Cement
SECTION 8: EXPOSURE CONTROLS / PERSONAL PROTECTION CONT'D
Respiratory Use in a well ventilated area or provide local exhaust or ventilation to reduce
vapours build up.
Use of an appropriate NIOSH/MSHA approved or equivalent electometric sealing
surface face piece respirator outfitted with organic vapour cartridges.
Eyes Safety goggles or glasses recommended especially for over head work. Face
shield could be used to protect facial skin also.
N.B.: Keep running water sources on site in cases of emergency and for after work cleaning.
SECTION 9: PHYSICAL AND CHEMICAL PROPERTIES
Physical Sate
and Appearance: Liquid, viscous Odour: Charactistic
pH: Not available Colour: Yellow
Soluble / Insoluble: Insoluble in water Viscosity: Not available
Melting / Freezing Point: Not available Solubility: Not available
from 56 oC
Boiling / Condensation Point: Critical Temperatures: Not available
Specific Gravity: Not available Volatility: Not available
Vapour Density: >1 Vapour Pressure: Not available
Evaporation Rate: Not available
SECTION 10: STABILITY AND REACTIVITY
Stability and reactivity: This product is stable. See Section 5 Fire Fighting Measures.
Conditions to avoid: Elevated temperatures, accumulating electrostatic charge, contact with oxidising
mineral acids, sparks, open flame
Materials to avoid: Combustible materials, oxidising mineral acids.
SECTION 11: TOXICOLOGICAL INFORMATION
Supplemental Health
Information: No additional effects are anticipated besides those mentioned in Section 5 Fire Fighting
Measures.
This product has not been listed by IARC, OSHA, ACGIH, DSL, TSCA but contains
ingredients which may be irritants by ingestion, inhalation and through the skin.
SECTION 12: ECOLOGICAL INFORMATION
There is no data available on the product.
General Note: Do not allow undiluted product or large quantities of product to reach ground water,
water courses or sewage systems.
Contains n-hexane which is toxic to aquatic organisms and may cause long-term
adverse effects.
SECTION 13: DISPOSAL CONSIDERATION
Dispose of in accordance with all applicable regulations ensuring no contamination of
surrounding environment.
Page 3
Contact Cement
SECTION 14: TRANSPORTATION INFORMATION
UN ID No.:
This product is not controlled or regulated under DOT, IATA.
DOT: Classification:
IATA: Classification: Class 3
SECTION 15: REGULATORY INFORMATION
Products
As of the date of this MSDS, these products were not being regulated or controlled but
similar products are listed as follows:
SARA Title III
Section 311/312: Delayed (Chronic) Health Hazard
WHMIS: D4, B2
Product Components:
EINECS No.: Toluene ?203-777-6, Acetone ?200-662-2
DSCL (EEC)
IARC
SARA Title III
Section 311/312: Acetone - Immediate (Acute) Health Hazards, Fire Hazard
n-heaxane - Fire Hazard
Section 313: Toluene
Acetone
WHMIS: Toluene - B2, D2B
Acetone
DSL: Toluene
Acetone
TSCA: Toluene
Acetone
ATSDR:
SECTION 16: OTHER INFORMATION
The information contained herein is based on data available at the time of preparation of this data sheet and which
is believed to be reliable. However, it is the users' responsibility to ensure safe conditions for handling, storage
and disposal of the product, and to assume liability for loss, injury, damage or expense due to improper use. This
information is given in good faith, but no warranty, expressed or implied is made.
This MSDS complies with MSDS requirements for Canada, the USA and the European Union and fulfils the ISO
standards for format and content.
Page 4
|