|-------------------------------------------------------|
| MATERIAL SAFETY DATA SHEET |
|-------------------------------------------------------|
|-------------------------------------------------------------------------|
| SECTION 1 - CHEMICAL PRODUCT AND COMPANY IDENTIFICATION |
|-------------------------------------------------------------------------|
THIS MATERIAL SAFETY DATA SHEET IS AVAILABLE IN SPANISH UPON REQUEST.
LOS DATOS DE SEGURIDAD DEL PRODUCTO PUEDEN OBTENERSE EN ESPANOL SI LO
REQUIERE.
PRODUCT NAME : CONTACT CEMENT
UPC NUMBER : 00102, 00107, 00127
PRODUCT USE/CLASS : Contact Adhesive
MANUFACTURER: 24 HOUR EMERGENCY:
DAP INC. TRANSPORTATION: 1-800-535-5053 (352-323-3500)
2400 BOSTON STREET MEDICAL : 1-800-327-3874 (513-558-5111)
BALTIMORE, MD 21224
PREPARE DATE : 05/08/1996 GENERAL INFORMATION:
REVISION NO. : 10 DAP INC. : 1-888-DAP-TIPS (1-888-327-8477)
REVISION DATE: 08/13/2001
|-------------------------------------------------------------------------|
| SECTION 2 - COMPOSITION/INFORMATION ON INGREDIENTS |
|-------------------------------------------------------------------------|
WT/WT %
ITEM ------------ CHEMICAL NAME ------------- CAS NUMBER RANGE
---------------------------------------------------------------------------
01 Toluene 108-88-3 15.0-20.0 %
02 N-Hexane 110-54-3 10.0-15.0 %
03 Acetone 67-64-1 15.0-20.0 %
04 Aliphatic Petroleum Distillate 64742-89-8 30.0-35.0 %
---------------------- EXPOSURE LIMITS --------------------
ACGIH OSHA COMPANY
ITEM TLV-TWA TLV-STEL PEL-TWA PEL-CEILING TLV-TWA SKIN
---------------------------------------------------------------------------
01 50 ppm. N.E. 100 ppm. N.E. N.E. YES
02 50 ppm N.E. 50 ppm N.E. N.E. NO
03 750 ppm 1000 ppm 750 ppm N.E. N.E. NO
04 400 ppm N.E. 400 ppm N.E. N.E. NO
(See Section 16 for abbreviation legend)
Remaining ingredients are not considered hazardous per the OSHA Hazard
Communication Standard.
(Continued on Page 2)
--------------------------------------------------------------------------
Product Name: CONTACT CEMENT
Revision Date: 08/13/2001 Page 2
|-------------------------------------------------------------------------|
| SECTION 2 - COMPOSITION/INFORMATION ON INGREDIENTS |
|-------------------------------------------------------------------------|
Listed Permissible Exposure Levels (PEL) are from the U.S. Dept. of Labor
OSHA Final Rule Limits (CFR 29 1910.1000); limits may vary between states.
|-------------------------------------------------------------------------|
| SECTION 3 - HAZARDS IDENTIFICATION |
|-------------------------------------------------------------------------|
EMERGENCY OVERVIEW: DANGER! Extremely flammable liquid and vapor. Vapor
harmful. Vapors may cause flash fire or explosion. Aspiration hazard if
swallowed - can enter lungs and cause damage. Harmful if inhaled.
POTENTIAL HEALTH EFFECTS:
EFFECTS OF OVEREXPOSURE - EYE CONTACT: May cause eye irritation.
EFFECTS OF OVEREXPOSURE - SKIN CONTACT: May irritate skin. Prolonged
or repeated contact can result in defatting and drying of the skin which
may result in skin irritation and dermatitis (rash).
EFFECTS OF OVEREXPOSURE - INHALATION: Vapor harmful if inhaled. Vapor
may irritate nose and upper respiratory tract. Vapor inhalation may affect
the brain or nervous system causing dizziness, headache or nausea.
EFFECTS OF OVEREXPOSURE - INGESTION: Aspiration of material into the lungs
due to vomiting can cause chemical pneumonitis which can be fatal. If
ingested, this product may cause vomiting, diarrhea, and depressed
respiration.
EFFECTS OF OVEREXPOSURE - CHRONIC HAZARDS: Reports have associated
permanent brain and nervous system damage with prolonged and repeated
occupational overexposure to solvents. Overexposure or misuse of toluene
can cause liver, kidney, and brain damage as well as cardiac abnormalities.
Hexane exposure can cause nerve damage to arms and legs which may
permanent. Symptoms include: loss of memory, loss of intellectual ability,
and loss of coordination.
MEDICAL CONDITIONS WHICH MAY BE AGGRAVATED BY CONTACT: None known.
PRIMARY ROUTE(S) OF ENTRY: SKIN CONTACT INHALATION
|-------------------------------------------------------------------------|
| SECTION 4 - FIRST AID MEASURES |
|-------------------------------------------------------------------------|
EYE CONTACT: Flush with large quantities of water until irritation
subsides.
SKIN CONTACT: Wash with soap and water.
INHALATION: Remove to fresh air. If not breathing, give artificial
respiration. If breathing is difficult, give oxygen.
(Continued on Page 3)
--------------------------------------------------------------------------
Product Name: CONTACT CEMENT
Revision Date: 08/13/2001 Page 3
|-------------------------------------------------------------------------|
| SECTION 4 - FIRST AID MEASURES |
|-------------------------------------------------------------------------|
|-------------------------------------------------------------------------|
| SECTION 4 - FIRST AID MEASURES |
|-------------------------------------------------------------------------|
INGESTION: DO NOT INDUCE VOMITING.
COMMENTS: Call Medical in Section 1 if irritation or complications arise
from any of the above routes of exposure.
|-------------------------------------------------------------------------|
| SECTION 5 - FIRE FIGHTING MEASURES |
|-------------------------------------------------------------------------|
FLASH POINT: -50 F LOWER EXPLOSIVE LIMIT: N.A.
(SETAFLASH CLOSED CUP) UPPER EXPLOSIVE LIMIT: N.A.
AUTOIGNITION TEMPERATURE: N.E.
EXTINGUISHING MEDIA: CO2 DRY CHEMICAL FOAM
UNUSUAL FIRE AND EXPLOSION HAZARDS: Extremely flammable. Material will
readily ignite at room temperature. Vapors may form an explosive mixture
with air. Vapors can travel back to a source of ignition and flashback.
Containers may explode if exposed to extreme heat. Eliminate sources of
ignition: heat, electrical equipment, sparks, and flames. Do not put in
contact with oxidizing or caustic materials.
SPECIAL FIREFIGHTING PROCEDURES: Full protective equipment, including
self-contained breathing apparatus, is recommended to protect from
combustion products. Cool exposed containers with water.
|-------------------------------------------------------------------------|
| SECTION 6 - ACCIDENTAL RELEASE MEASURES |
|-------------------------------------------------------------------------|
SPILL OR LEAK PROCEDURES: Dike spill area. Immediately eliminate sources
of ignition. Use absorbent material or scrape up dried material and place
into containers.
|-------------------------------------------------------------------------|
| SECTION 7 - HANDLING AND STORAGE |
|-------------------------------------------------------------------------|
HANDLING INFORMATION: KEEP OUT OF REACH OF CHILDREN. Avoid skin and eye
contact. Avoid breathing vapors. Use only in a well ventilated area.
STORAGE INFORMATION: Store away from caustics and oxidizers. Keep away
from heat, spark, and flame. Keep containers tightly closed when not in
use. Keep containers from excessive heat and freezing. Do not store at
temperatures above 120 degrees F.
(Continued on Page 4)
--------------------------------------------------------------------------
Product Name: CONTACT CEMENT
Revision Date: 08/13/2001 Page 4
|-------------------------------------------------------------------------|
| SECTION 7 - HANDLING AND STORAGE |
|-------------------------------------------------------------------------|
OTHER PRECAUTIONS: Intentional misuse by deliberately concentrating and
inhaling vapors may be harmful or fatal. Do not take internally.
Construction and repair activities can adversely affect indoor air quality.
Consult with the occupants or a representative(i.e. maintenance, building
manager, industrial hygienist, or safety officer) to determine ways to
minimize any impact.
|-------------------------------------------------------------------------|
| SECTION 8 - EXPOSURE CONTROLS/PERSONAL PROTECTION |
|-------------------------------------------------------------------------|
ENGINEERING CONTROLS: Provide sufficient mechanical ventilation (local or
general exhaust) to maintain exposure below PEL and TLV. Vapors are
heavier than air and will collect in low areas. Check all low areas
(basements, sumps, etc.) for vapors before entering.
RESPIRATORY PROTECTION: If 8 hour exposure limit or value is exceeded for
any component, use an approved NIOSH respirator. Consult your safety
equipment supplier and the OSHA regulation, 29 CFR 1910.134 for respirator
requirements. A respiratory protection program that meets OSHA 1910.134 and
ANSI Z88.2 requirements must be followed whenever workplace conditions
warrant a respirator's use.
EYE PROTECTION: Goggles or safety glasses with side shields.
SKIN PROTECTION: Solvent impervious gloves.
OTHER PROTECTIVE EQUIPMENT: Provide eyewash and solvent impervious apron
if body contact may occur.
HYGIENIC PRACTICES: Remove contaminated clothing and wash before reuse.
|-------------------------------------------------------------------------|
| SECTION 9 - PHYSICAL AND CHEMICAL PROPERTIES |
|-------------------------------------------------------------------------|
BOILING RANGE : 130 - 140 F VAPOR DENSITY : Is heavier than air
ODOR : Gasoline-like
APPEARANCE : Tan mobile liquidEVAPORATION RATE: Is faster than Butyl
SOLUBILITY IN H2O : Negligible Acetate
SPECIFIC GRAVITY : 0.8040
VAPOR PRESSURE : 400 mm Hg @ 100 F.
PHYSICAL STATE : Liquid
(See Section 16 for abbreviation legend)
|-------------------------------------------------------------------------|
| SECTION 10 - STABILITY AND REACTIVITY |
|-------------------------------------------------------------------------|
CONDITIONS TO AVOID: Excessive heat and freezing.
(Continued on Page 5)
--------------------------------------------------------------------------
Product Name: CONTACT CEMENT
Revision Date: 08/13/2001 Page 5
|-------------------------------------------------------------------------|
| SECTION 10 - STABILITY AND REACTIVITY |
|-------------------------------------------------------------------------|
INCOMPATIBILITY: Strong oxidizers and caustics.
HAZARDOUS DECOMPOSITION PRODUCTS: Normal decomposition products, i.e. COx,
NOx
HAZARDOUS POLYMERIZATION: Will not occur under normal conditions.
STABILITY: This product is stable under normal storage conditions.
|-------------------------------------------------------------------------|
| SECTION 11 - TOXICOLOGICAL PROPERTIES |
|-------------------------------------------------------------------------|
No product or component toxicological information is available.
|-------------------------------------------------------------------------|
| SECTION 12 - ECOLOGICAL INFORMATION |
|-------------------------------------------------------------------------|
No Information.
|-------------------------------------------------------------------------|
| SECTION 13 - DISPOSAL CONSIDERATIONS |
|-------------------------------------------------------------------------|
WASTE MANAGEMENT/DISPOSAL: Dispose of according to Federal, State, and
Local Standards. Discarded material should be incinerated at a permitted
facility. Liquids cannot be disposed of in a landfill. Do not reuse empty
container. State and Local regulations/restrictions are complex and may
differ from Federal regulations. Responsibility for proper waste disposal
is with the owner of the waste.
EPA WASTE CODE - If discarded (40 CFR 261): D001-Ignitable.
|-------------------------------------------------------------------------|
| SECTION 14 - TRANSPORTATION INFORMATION |
|-------------------------------------------------------------------------|
DOT PROPER SHIPPING NAME: Adhesive(Consumer Commodity*)
DOT HAZARD CLASS: 3(ORM-D*)
DOT UN/NA NUMBER: UN 1133(NONE*) PACKING GROUP: II(NONE*)
* For containers of 1 gallon or less.
|-------------------------------------------------------------------------|
| SECTION 15 - REGULATORY INFORMATION |
|-------------------------------------------------------------------------|
(Continued on Page 6)
--------------------------------------------------------------------------
Product Name: CONTACT CEMENT
Revision Date: 08/13/2001 Page 6
|-------------------------------------------------------------------------|
| SECTION 15 - REGULATORY INFORMATION |
|-------------------------------------------------------------------------|
U.S. FEDERAL REGULATIONS: AS FOLLOWS -
OSHA: Hazardous by definition of Hazard Communication Standard (29 CFR
1910.1200)
SARA SECTION 313:
This product contains the following substances subject to the reporting
requirements of Section 313 of Title III of the Superfund Amendments and
Reauthorization Act of 1986 and 40 CFR Part 372:
----------- CHEMICAL NAME ----------- CAS NUMBER WT/WT % RANGE
Toluene 108-88-3 15.0-20.0 %
N-Hexane 110-54-3 10.0-15.0 %
TOXIC SUBSTANCES CONTROL ACT:
This product contains the following chemical substances subject to the
reporting requirements of TSCA 12(B) if exported from the United States:
----------- CHEMICAL NAME ----------- CAS NUMBER
Toluene 108-88-3
Methylcyclopentane 96-37-7
Cyclohexane 110-82-7
Cyclopentane 287-92-3
NEW JERSEY RIGHT-TO-KNOW:
The following materials are non-hazardous, but are among the top five
components in this product:
----------- CHEMICAL NAME ----------- CAS NUMBER
Polychlorinated Rubber TSRN-618608-5001P
PENNSYLVANIA RIGHT-TO-KNOW:
The following non-hazardous ingredients are present in the product at
greater than 3%:
----------- CHEMICAL NAME ----------- CAS NUMBER
Polychlorinated Rubber proprietary
Phenolic resin proprietary
Polychlorinated Rubber proprietary
CALIFORNIA PROPOSITION 65:
WARNING: The chemical(s) noted below and contained in this product, are
known to the state of California to cause birth defects or other
reproductive harm:
----------- CHEMICAL NAME ----------- CAS NUMBER
Toluene 108-88-3
INTERNATIONAL REGULATIONS: AS FOLLOWS -
(Continued on Page 7)
--------------------------------------------------------------------------
Product Name: CONTACT CEMENT
Revision Date: 08/13/2001 Page 7
|-------------------------------------------------------------------------|
| SECTION 15 - REGULATORY INFORMATION |
|-------------------------------------------------------------------------|
CANADIAN WHMIS: This MSDS has been prepared in compliance with Controlled
Product Regulations except for use of the 16 headings.
CANADIAN WHMIS CLASS: Consumer Commodity sold on retail market only.
|-------------------------------------------------------------------------|
| SECTION 16 - OTHER INFORMATION |
|-------------------------------------------------------------------------|
HMIS RATINGS - HEALTH: 2 FLAMMABILITY: 3 REACTIVITY: 0
PREVIOUS MSDS REVISION DATE: 02/01/1997
REASON FOR REVISION:
SECTION 1: Address change and new emergency contact phone numbers.
Deletion of non-applicable UPC numbers.
SECTION 2: Correction of reported percentages.
VOC less water, less exempt solvent: 600-610 gm/l(75-76%)where acetone is
exempt
VOC material: 490-500 gm/l(61-62%)
LEGEND: ACGIH - AMERICAN CONFERENCE OF GOVERNMENTAL INDUSTRIAL HYGIENISTS
N.A. - NOT APPLICABLE
N.E. - NOT ESTABLISHED
PEL - PERMISSIBLE EXPOSURE LIMIT
NTP - NATIONAL TOXICOLOGY PROGRAM
SARA - SUPERFUND AMENDMENTS AND REAUTHORIZATION ACT OF 1986
STEL - SHORT TERM EXPOSURE LIMIT
TLV - THRESHOLD LIMIT VALUE(8 HR. TIME WEIGHTED AVERAGE OR TWA)
VOC - VOLATILE ORGANIC COMPOUND
NJRTK - NEW JERSEY RIGHT TO KNOW LAW
N.D. - NOT DETERMINED
MSDS# 30202
This data is offered in good faith as typical values and not as a product
specification. No warranty either expressed or implied, is hereby made.
The recommended industrial hygiene and safe handling procedures are
believed to be generally applicable. However, each user should review the
recommendations in specific context of the intended use and determine if
they are appropriate.
---------------------------------------------------------------------------
< End OF MSDS >
|