804838PM Page 1 of 6
10-28-2009
MATERIAL SAFETY DATA SHEET
__________________________________________________________________________________________
REVISION DATE: 04-17-2007 04-10-2007
SUPERSEDES:
SECTION 1: CHEMICAL PRODUCT AND COMPANY IDENTIFICATION
COMPANY INFORMATION
H.B. Fuller Company
1200 Willow Lake Boulevard
Vadnais Heights, MN 55110
Phone: 888-423-8553
Medical Emergency Phone Number (24 Hours): 1-888-853-1758
Transport Emergency Phone Number (CHEMTREC): 1-800-424-9300
PRODUCT INFORMATION
PRODUCT IDENTIFIER: 804838PM
PRODUCT NUMBER: SC0628
PRODUCT DESCRIPTION: Solvent adhesive
SECTION 2: COMPOSITION/INFORMATION ON INGREDIENTS
Unlisted ingredients are not 'hazardous' per the Occupational Safety and Health Administration Hazard
Communication Standard (29 CFR 1910.1200) and/or are not found on the Canadian Workplace Hazardous
Materials Information System ingredient disclosure list. See Section 8 for exposure limit guidelines.
Chemical Name CAS # PERCENT OSHA PEL
Hexane, n 110-54-3 30 - 50 TWA 50ppm
Oil, petroleum 10 - 30 TWA * Mist 5MG/M3
Wood rosin 8050-09-7 5 - 10 Not established
Methylcyclopentane 96-37-7 5 - 10 Not established
Calcium carbonate 471-34-1 1-5 TWA (Total dust) 15MG/M3
TWA (Respirable dust) 5MG/M3
Heptane 142-82-5 1-5 TWA 400ppm
STEL 500ppm
*These exposure limits are for mineral oil mist, a related material.
SECTION 3: HAZARDS IDENTIFICATION
EMERGENCY OVERVIEW
Extremely flammable.
Can cause eye irritation.
Can cause skin irritation. May cause allergic skin reaction. May cause an allergic respiratory reaction.
Harmful if swallowed.
HMIS RATING: HEALTH -- 1 FLAMMABILITY -- 3 REACTIVITY -- 0
804838PM Page 2 of 6
10-28-2009
MATERIAL SAFETY DATA SHEET
__________________________________________________________________________________________
See SECTION 8: EXPOSURE CONTROLS/PERSONAL PROTECTION for personal protective equipment
recommendations.
POTENTIAL HEALTH EFFECTS BY ROUTE OF ENTRY
EYE: Can cause irritation.
SKIN: Can cause skin irritation. May cause sensitization.
INHALATION: Can cause minor respiratory irritation. Long term overexposure to some resin acids (colophony)
fumes may lead to respiratory sensitization.
Inhalation of dusts produced during cutting, grinding or sanding of this product may cause irritation of the
respiratory tract.
Inhalation of vapors may cause loss of feeling and weakness in the hands and feet and loss of manual dexterity.
Inhalation of high concentrations may result in central nervous system (CNS) effects such as dizziness, weakness,
fatigue, nausea, headache, and lack of coordination.
This product contains one or more materials that may be hazardous when present as an airborne dust. During normal
handling of the product, the material is encapsulated within the product and will not present an exposure risk. Once
the product has reached its final state and is abraded or disturbed, dusting and exposure may occur.
INGESTION: Ingestion is not an anticipated route of exposure. Harmful if swallowed. Irritating to mouth, throat,
and stomach.
LONG-TERM (CHRONIC) HEALTH EFFECTS
TARGET ORGAN(S): Central nervous system Peripheral nervous system Lungs Skin
REGULATED CARCINOGEN STATUS:
Unless noted below, this product does not contain regulated levels of NTP, IARC, ACGIH, or OSHA listed
carcinogens.
EXISTING HEALTH CONDITIONS AFFECTED BY EXPOSURE: Lung disease; Skin disease including eczema
and sensitization
SECTION 4: FIRST AID MEASURES
IF IN EYES: Use an eye wash to remove a chemical from your eye regardless of the level of hazard. Flush the
affected eye for at least twenty minutes. Tilt the head to prevent chemical from transferring to the uncontaminated
eye. Seek medical advice after flushing.
IF ON SKIN: Wash with soap and water. Get medical attention if irritation develops or persists.
IF VAPORS INHALED: Remove to fresh air. Call a physician if symptoms persist.
IF SWALLOWED: Do not induce vomiting. Seek medical attention immediately. Drink two glasses of water or
milk to dilute. Do not give anything by mouth to an unconscious person. Induced vomiting may lead to aspiration of
the material into the lungs potentially causing chemical pneumonitis that may be fatal.
SECTION 5: FIRE FIGHTING MEASURES
FLASH POINT: -18C; 0F TCC
AUTOIGNITION TEMPERATURE: Not established
LOWER EXPLOSIVE LIMIT (% in air): Not established
UPPER EXPLOSIVE LIMIT (% in air): Not established
EXTINGUISHING MEDIA: Use water spray, foam, dry chemical or carbon dioxide.
UNUSUAL FIRE AND EXPLOSION HAZARDS: Vapors are heavier than air and can travel to a source of ignition
and flash back.
SPECIAL FIRE FIGHTING INSTRUCTIONS: Persons exposed to products of combustion should wear self-
contained breathing apparatus and full protective equipment.
HAZARDOUS COMBUSTION PRODUCTS: Carbon dioxide, Carbon monoxide
804838PM Page 3 of 6
10-28-2009
MATERIAL SAFETY DATA SHEET
__________________________________________________________________________________________
SECTION 6: ACCIDENTAL RELEASE MEASURES
SPECIAL PROTECTION: No health effects expected from the cleanup of this material if contact can be
avoided. Follow personal protective equipment recommendations found in
Section 8 of this MSDS. Evaporation of volatile substances can lead to the
displacement of air creating an environment that can cause asphyxiation.
CLEAN-UP: Dike if necessary, contain spill with inert absorbent and transfer to containers
for disposal. Keep spilled product out of sewers, watersheds, or water
systems.
Shut off ignition sources; including electrical equipment and flames. Do not
allow smoking in the area.
Transport Emergency Phone Number (CHEMTREC): 1-800-424-9300
SECTION 7: HANDLING AND STORAGE
Handling: Mildly irritating material. Avoid unnecessary exposure.
Keep away from heat, sparks and flame.
Wash thoroughly after handling.
Keep container closed.
Emptied container retains vapor and product residue.
Observe all labeled precautions until container is cleaned.
Drums of this material should be grounded when pouring.
DO NOT CUT OR WELD ON OR NEAR THIS CONTAINER.
Storage: Store in a cool, dry, ventilated location. Keep away from heat, sparks, flame and other
sources of ignition. Keep container closed.
Consult the Technical Data Sheet for specific storage instructions.
SECTION 8: EXPOSURE CONTROLS/PERSONAL PROTECTION
EYE PROTECTION: Wear safety glasses when handling this product.
SKIN PROTECTION: Avoid skin contact by wearing chemically resistant gloves. Skin
absorption may potentially contribute to the overall exposure to this
material. Appropriate measures should be taken to prevent
absorption so that the TLV is not invalidated.
GLOVES: Nitrile
RESPIRATORY PROTECTION: Respiratory protection may be required to avoid overexposure when
handling this product. Use a respirator if general room ventilation is
not available or sufficient to eliminate symptoms. NIOSH approved
air purifying respirator with organic vapor cartridge.
Respirators should be selected by and used following requirements
found in OSHA's respirator standard (29 CFR 1910.134).
VENTILATION: Use local exhaust ventilation or other engineering controls to
minimize exposures.
EXPOSURE LIMITS:
Chemical Name ACGIH EXPOSURE LIMITS AIHA WEEL
Hexane, n TWA 50ppm Not established
Skin absorption may potentially contribute to
the overall exposure to this material.
Oil, petroleum TWA * Mist 5MG/M3 Not established
804838PM Page 4 of 6
10-28-2009
MATERIAL SAFETY DATA SHEET
__________________________________________________________________________________________
Wood rosin TWA Exposure should be minimized to its full Not established
extent.
Methylcyclopentane Not established Not established
Calcium carbonate TWA 10MG/M3 Not established
Heptane TWA 400ppm Not established
STEL 500ppm
*These exposure limits are for mineral oil mist, a related material.
SECTION 9: PHYSICAL AND CHEMICAL PROPERTIES
PHYSICAL STATE: Liquid
COLOR: Amber
ODOR: Solvent
ODOR THRESHOLD: Not established
WEIGHT PER GALLON (lbs.): 7.3
SPECIFIC GRAVITY: 0.88
SOLIDS (% by weight): 62.0
pH: Not established
BOILING POINT (deg. C): Not established
FREEZING/MELTING POINT (deg. C): Not established
VAPOR PRESSURE (mm Hg): Not established
VAPOR DENSITY: Not established
EVAPORATION RATE: Not established
OCTANOL/WATER COEFFICIENT: Not established
SECTION 10: STABILITY AND REACTIVITY
STABILITY: Stable under normal conditions.
CHEMICAL INCOMPATIBILITY: Strong oxidizing agents
HAZARDOUS POLYMERIZATION: Will not occur.
HAZARDOUS DECOMPOSITION PRODUCTS: Carbon monoxide, carbon dioxide
SECTION 11: TOXICOLOGICAL INFORMATION
CHEMICAL NAME LD50/LC50
Hexane, n Oral LD50 Rat = 28710mg/kg
Inhalation LC50 Rat = 48000ppm/4H
Oil, petroleum Not established
Wood rosin Not established
Methylcyclopentane Not established
Calcium carbonate Oral LD50 Rat = 6450mg/kg
804838PM Page 5 of 6
10-28-2009
MATERIAL SAFETY DATA SHEET
__________________________________________________________________________________________
Heptane
Inhalation LC50 Rat = 103000mg/cu m/4H
TOXICOLOGY SUMMARY: No additional health information available.
SECTION 12: ECOLOGICAL INFORMATION
OVERVIEW: No ecological information available
333 g VOC/liter of material
(VOC theoretically determined using EPA Reference method 24)
333 g VOC/liter of material, less water and exempt solvents
(VOC theoretically determined using EPA Reference method 24)
SECTION 13: DISPOSAL CONSIDERATIONS
This product meets the definition of hazardous waste under the U.S. EPA Hazardous Waste Regulations 40 CFR
261. It is ignitable waste class D001. Disposal via incineration is recommended. Consult your state, local, or
provincial authorities for more restrictive requirements.
SECTION 14: TRANSPORTATION INFORMATION
Consult Bill of Lading for transportation information.
DOT: UN1133, ADHESIVES, 3, II
IATA: UN1133, ADHESIVES, 3, II
SECTION 15: REGULATORY INFORMATION
INVENTORY STATUS
U.S. EPA TSCA: This product is in compliance with the Toxic Substances Control Act's
Inventory requirements.
CANADIAN CEPA DSL: The components of this product are included on the DSL or are exempt from
DSL requirements.
If you need more information about the inventory status of this product call 651-236-5858.
This product may contain chemical substances that are regulated for export by various government agencies (such as
the Environmental Protection Agency, the Bureau of Industry and Security, or the Drug Enforcement
Administration, among others). Before exporting this product from the USA or Canada, we recommend you contact
us at 651-236-5858 (USA) or 450-655-1306 x227 (Canada) to request an export review.
FEDERAL REPORTING
EPA SARA Title III Section 313
Unless listed below, this product does not contain toxic chemical(s) subject to the reporting requirements of section
313 of Title III of the Superfund Amendments and Reauthorization Act of 1986 (SARA) and 40 CFR part 372. EPA
has advised that when a percentage range is listed the midpoint may be used to fulfill reporting obligations.
Chemical Name CAS# %
n-Hexane 110-54-3 30 - 50
WHMIS STATUS: Unless listed below, this product is not controlled under the Canadian Workplace Hazardous
Materials Information System.
B2
D2B D2A
STATE REPORTING
This MSDS is not prepared for distribution in California.
804838PM Page 6 of 6
10-28-2009
MATERIAL SAFETY DATA SHEET
__________________________________________________________________________________________
SECTION 16: ADDITIONAL INFORMATION
This Material Safety Data Sheet is prepared to comply with the United States Occupational Safety and Health
Administration (OSHA) Hazard Communication Standard (29 CFR 1910.1200) and the Canadian Workplace
Hazardous Materials Information System (WHMIS).
Prepared by: The Global Regulatory Department
Phone: 651-236-5842
The information and recommendations set forth herein are believed to be accurate. Because some of the information
is derived from information provided to the H.B. Fuller Company from its suppliers, and because the H.B. Fuller
Company has no control over the conditions of handling and use, the H.B. Fuller Company makes no warranty,
expressed or implied, regarding the accuracy of the data or the results to be obtained from the use thereof. The
information is supplied solely for your information and consideration, and the H.B. Fuller Company assumes no
responsibility for use or reliance thereon. It is the responsibility of the user of H.B. Fuller Company products to
comply with all applicable federal, state and local laws and regulations.
|