Wednesday, February 27, 2008
Page 1 of 5
MSDS - Material Safety Data Sheet
Product Name: ACRA SEAL PLASTIC SPRAY & IGNITION SEALER
MSDS No.: M406
I. Basic Information:
Manufacturer: RADIATOR SPECIALTY COMPANY Contact: Robert Geer
Address: 600 RADIATOR ROAD Information Telephone Number: 704-684-1811
City, ST Zip: INDIAN TRAIL, NC 28079 Emergency Contact: Rocky Mountain Poision Control Center
Country: Emergency Telephone Number: 303-623-5716
Emergency Restrictions:
Product Name: ACRA SEAL PLASTIC SPRAY & IGNITION SEALER
MSDS No.: M406
Issue Date: 02/27/2008
Supersedes Date: 07/12/2007
II. Hazards Identification:
EMERGENCY OVERVIEW
Danger: Extremely Flammable, Harmful or Fatal if Swallowed, Vapor Harmful, Eye and Skin Irritant, Contents Under Pressure.
Level 3 Aerosol
OSHA Regulatory Status
This material is considered hazardous by the OSHA Hazard Communication Standard (29 CFR 1910.1200).
Potential Health Effects
Route(s) of Entry:
Absorption, Inhalation, and Ingestion.
Health Hazards (Acute and Chronic):
See signs and symptoms below
Signs and Symptoms:
Eye Contace: Irritant. Prolonged contact may cause conjunctivitis.
Skin Contact: Irritant. Defatting of tissue, dermatitis may occur.
Inhalation: Irritant to mucous membranes. Repeated exposure may cause narcosis, headache, and nausea.
Ingestion: HARMFUL OR FATAL IF SWALLOWED. Material is a aspiration hazard.
Medical Conditions Generally Aggravated by Exposure:
Preexisting disorders of the following organs may be aggravated by exposure to this material: skin, lungs, kidneys, auditory system. Individuals
with preexisting heart disorders may be susceptible to arrhythmia's if exposed.
Other Health Warnings:
None Known
Potential Environmental Effects
Not Available
III. Composition/Information on Ingredients:
Chemical Name CAS No. % Range Trade Secret
Diacetone alcohol 123-42-2 1.0 - 5.0
Isopropyl alcohol (mfg-strong acid process) 67-63-0 15.0 - 40.0
Methane, oxybis- 115-10-6 30.0-60.0
N-Methyl-2-pyrrolidone 872-50-4 1.0 - 5.0
Toluene 108-88-3 15.0-40.0
IV. First Aid Measures:
Emergency and First Aid Procedures:
Wednesday, February 27, 2008
Page 2 of 5
MSDS - Material Safety Data Sheet
Product Name: ACRA SEAL PLASTIC SPRAY & IGNITION SEALER
MSDS No.: M406
Eye Contact: Flush eyes with clean water for 15 minutes while lifting eyelids. Get prompt medical attention.
Skin Contact: Wash with soap and water thoroughly. If adverse effects persist, get prompt medical attention. Launder contaminated clothing
before reuse.
Inhalation: Remove to fresh air. If breathing becomes difficult give oxygen and get prompt medical attention. If breathing stops, give artificial
respiration and get prompt medical attention.
Ingestion: DO NOT INDUCE VOMITING! Call Poison Control Center, physician, or hospital emergency room immediately. Aspiration of vomitus
into the lungs can cause pneumonitis, which can be fatal.
Note to Physicians:
N/D
V. Fire Fighting Measures:
Suitable Extinguishing Media:
Water Fog, Foam, Carbon Dioxide, Dry Chemical
Unsuitable Extinguishing Media:
Do not use forced water stream as this could cause the fire to spread. Use shield to protect from rupturing and venting containers.
Products of Combustion:
Carbon Dioxide, Carbon Monoxide, and Hydrocarbons.
Protection of Firefighters:
Wear self-contained positive pressure breathing apparatus and protective clothes. Use shield to protect from rupturing and venting containers. At
elevated temperatures containers may vent, rupture or burst, even violently
VI. Accidental Release Measures:
Personal Precautions:
Persons not wearing protective equipment should be excluded from area of spill until clean-up has been completed.
Environmental Precautions:
Prevent run-off to sewers, streams, or other bodies of water. If run-off occurs, notify proper authorities as required that a spill has occurred. Run off
to sewer may create fire or explosion hazard.
Methods for Containment:
Dike or contain spill and absorb with inert materials (sand, sawdust, absorbent sweeping compounds, rags, etc).
Methods for Cleanup:
Using a non-metalic scoop, place contaminated material into an approved chemical waste container. Where possible, vacuum spilled liquid using
an explosion proof vacuum to recover material.
Other Information:
All equipment used with handling the concentrate must be grounded. If run-off occurs, notify proper authorities as required that a spill has occurred.
VII. Handling and Storage:
Handling Precautions:
Use with adequate ventilation and proper protective equipment.
Contact lenses may cause further damage in case of splash into eye. KEEP AWAY FROM CHILDREN AND ANIMALS! Do not puncture or
incinerate container. Exposure to temperatures above 120?may cause container to vent, rupture, or burst.
Storage Precautions:
Do not used in confined area without proper ventilation. Do not use or store near fire, sparks, or open flame.
VIII. Exposure Controls/Personal Protection:
Wednesday, February 27, 2008
Page 3 of 5
MSDS - Material Safety Data Sheet
Product Name: ACRA SEAL PLASTIC SPRAY & IGNITION SEALER
MSDS No.: M406
Chemical Name OSHA PEL ACGIH TLV Other Limits
Toluene 100 PPM 100 PPM Not Available
Methane, oxybis- Not Available Not Available Not Available
N-Methyl-2-pyrrolidone N/E N/E Not Available
Diacetone alcohol 50 ppm 50 ppm Not Available
Isopropyl alcohol (mfg-strong acid process) 400 ppm 400 ppm Not Available
Engineering Controls:
See Section 2 for applicable exposure limits. Maintain adequate ventilation.
Avoid breathing vapors. In restricted areas, use approved chemical/mechanical filters designed to remove a combination of particles and vapor. In
confined areas, use approved air line type respirator or hood. A self-contained breathing apparatus is required for vapor concentrations above TLV
limits.
Personal Protective Equipment:
See Section 2 for applicable exposure limits. For prolonged exposure wear protective safety glasses, gloves, and apron.
IX. Physical and Chemical Properties:
Boiling Point: 82 F Melting Point: N/D
Boiling Range: N/D Freezing Point: N/D
Solubility In Water: Nil Evaporation Rate (Butyl Acetate = 1): > 1.0
Flash Point: - 10 F Flash Point Method: TCC
Odor Threshold: N/D Appearance and Odor: Clear Liquid with characteristic aromatic
odor.
Vapor Density (AIR = 1): N/D Vapor Pressure (mm Hg.): N/D
pH Range: N/A N/D
Partition Coefficient:
Decomposition Temp: N/D Auto-Ignition Temp: N/D
Lower Explosive Limit: 1% Upper Explosive Limit: 12.2%
Specific Gravity (H20 = 1): 0.91
Other Information: Container pressure: 45-50 psig @ 25癈
X. Stability and Reactivity:
Stability:
Stable
Conditions to Avoid:
See Incompatible Materials below.
Incompatible Materials:
Avoid contact with strong oxidizers.
Hazardous Decomposition Products:
Carbon Dioxide, Carbon Monoxide, and Hydrocarbons.
Possibility of Hazardous Reactions:
Will not occur
XI. Toxicological Information:
N/D
Wednesday, February 27, 2008
Page 4 of 5
MSDS - Material Safety Data Sheet
Product Name: ACRA SEAL PLASTIC SPRAY & IGNITION SEALER
MSDS No.: M406
XII. Ecological Information:
N/D
XIII. Disposal Considerations:
DISPOSAL: This container may be recycled in aerosol recycling centers when empty. Before offering for recycling, empty the can by using the
product according to the label. DO NOT PUNCTURE! If recycling is not available, wrap the container and discard in the trash. Dispose of unused
product in accordance with all local, state government and federal laws and regulations.
XIV. Transport Information:
Shipping Name: Not Available
DOT Hazard Class: Not Available DOT Subsidiary Hazard Class: Not Available
UN/NA#: Not Available Not Available
Packing Group:
Transportation Information:
DOT Hazard Class: ORM-D
Shipping Name: Consumer Commodity
The DOT description is provided to assist in the proper shipping classification of this product and may not be suitable for international and air
shipping purposes.
ICAO/IATA (US)
Shipping Name: Aerosols
Class: 2.1
UN number: UN1950
International:
ICAO/IATA
UN number: UN1950
Shipping Name: Aerosols
Class: 2.1
IMDG
UN number: UN1950
Shipping Name: Aerosols
Class: 2.1
EmS: F-D, S-U
XV. Regulatory Information:
See Section 2 for SARA Reportable Chemicals.
USA TSCA: All components of this material are listed on the US TSCA Inventory.
Warning: This product contains a chemical known to the State of California to cause reproductive toxicity.
XVI. Other Information:
Liquid Gas Solid
Chemical State: X
Pure Mixture
Chemical Type: 4
X
Hazard Category: 2 0
Acute Chronic Fire
X X X
Pressure Reactive
X
Wednesday, February 27, 2008
Page 5 of 5
MSDS - Material Safety Data Sheet
Product Name: ACRA SEAL PLASTIC SPRAY & IGNITION SEALER
MSDS No.: M406
Additional Manufacturer Warnings:
Do not used in confined area without proper ventilation. Contact lenses 2
may cause further damage in case of splash into eye. KEEP AWAY FROM
4
CHILDREN AND ANIMALS!
0
N/E: Not Established
N/D: Not Determined B
N/A: Not Applicable
N/AV: Not Available
Additional Product Information:
While Radiator Specialty Company believes this data is accurate as of the revision date, we make no warranty with respect to the
data and we expressly disclaim all liability for reliance thereon. The data is offered solel y for information, investigation, and
verification. Various government agencies may have specific regulations regarding the transportation, handling, storage, use, or
disposal of this product which may not be covered by this MSDS. The user is responsible for full compliance.
|