MATERIAL SAFETY DATA SHEET
Item Number: 841 - Solar Version 4 Effective Date: 07-31-02
Originally prepared by: Sue Heiser Section(s) Revised: IX Supercedes 06-15-02
IDENTITY (As on labels and lists): Stainless Steel Polish
EMERGENCY MEDICAL SECTION VI - HEALTH HAZARD DATA
Telephone #: 1-800-228-5635 x 009 (24 hrs) Route(s) of Entry - Inhalation: X Eyes: X Skin: X Ingestion:
Outside of the USA call 651-632-9275 Signs of Symptoms of Exposure: High vapor concentrations may result
in central nervous system depression and evidenced by giddiness,
PRODUCT HAZARD RATINGS (HMIS):
headache and nausea. Ingestion may result in vomiting. Prolonged or
repeated skin contact can result in drying and defatting of skin. Moderate
Health=2 Fire=4
eye irritant.
Reactivity=0 Protective Equipment=B
Medical Conditions Generally Aggravated by Exposure: Preexisting
(Rating Legend: 4=Extreme, 3=Serious, 2=Moderate,
skin or eye disorders may be aggravated by exposure to this product.
1=Slight, 0=Minimal, *=Chronic Hazard)
Emergency and First Aid Procedures: Eye contact: Flush eyes with
SECTION 1 plenty of water for 15 minutes while holding eyelids open. Get medical
attention if irritation persists. Skin Contact: Remove contaminated
Dalco Telephone # for information: 1-800-950-1975
clothing. Flush skin with water, followed by washing with soap and water.
300 5th Ave NW Date Printed: 10/10/03
If irritation persists, get medical attention. Do not reuse clothing until
New Brighton, MN 55112 Name of Preparer: Regulatory Compliance
cleaned. Inhalation: Remove victim to fresh air and provide oxygen if
SECTION II - HAZARDOUS INGREDIENTS / IDENTITY INFORMATION breathing is difficult. Give artificial respiration if not breathing. Get medical
attention. Ingestion: Get medical attention. (Breathing of vomitus into
SARA
lungs must be avoided as even small quantity may result in aspiration
Title III ACGIH
Chemical Names CAS# SEC 313 TLV/TWA OSHA PEL % by Wt. pneumonitis).
Mineral spirits 64741-65-7 No 177 ppm* 177 ppm* 20-30 CARCINOGENICITY: No regulated ingredients.
Isoparaffinic Solvent64741-66-8 No NE 400 ppm** 40-50 TOXICITY INFORMATION: No data available.
Mineral oil 8042-47-5 No NE NE 10-20
SECTION VII - PRECAUTIONS FOR SAFE HANDLING AND USE
Propane 68476-85-7 No 2500 ppm 1000 ppm 10-20
*ExxonMobil recommendation **Exxon recommendation Released or Spilled: Remove all sources of ignition and ventilate area.
Balance of ingredients are non-hazardous or below reportable levels. Soak up spill with an inert absorbent and place into a designated disposal
container. Consult local regulatory agency for proper disposition of
SECTION III - PYSICAL CHARACTERISTICS
material.
Boiling Points: NA Vapor Pressure (psig): 60@130F Waste Disposal Method: Do not puncture or incinerate containers.
Specific Gravity (H2O=1): <1.0 Solubility/Water: Negligible When contents are depleted continue to depress button until all gas is
Vapor Density (AIR=1): >1 Evaporation Rate (Ether=1): <1 expelled. Dispose of container in accordance with local, state, and federal
Appearance and Odor: Clear with Hydrocarbon Odor regulations.
Handling and Storing: avoid breathing vapor. Keep away from heat and
SECTION IV - FIRE AND EXPLOSION HAZARD DATA
flame. Use with adequate ventilation. Do not puncture or incinerate
Aerosol Flammability: Product is to be labeled as flammable as containers. Do not expose to direct sunlight or store at temperatures
described in 16 CFR 1500.3 and 1500.45. above 130F (54C). Store as Level 3 Aerosol (NFPA 30B).
Flashpoint: <0F (Propellant); >80F (Concentrate)
SECTION VIII - EMPLOYEE PROTECTION
Flammable Limits - % Volume in Air (Propellant): LEL: 2.2 UEL: 9.5
Extinguishing Media: Carbon dioxide, foam and/or dry chemical may be Respiratory Protection (Type): None required if good ventilation is
used. maintained. If exposure exceeds occupational exposure limits (Sec. II),
Special Firefighting procedures: Containers should be cooled with water use a NODSH approved respirator to prevent overexposure.
to prevent vapor pressure build up. Use equipment or shielding, as Ventilation: General ventilation is adequate under normal conditions,
required, to protect personnel from bursting, rupturing or venting mechanical ventilation is optional.
containers. Protective Gloves: Chemical resistant gloves are recommended -
Unusual Fire and Explosion Hazards: At elevated temperatures (over consult glove manufacturer to determine the proper type for specific
54C-130F) containers exposed to direct flame or heat contact should be operation.
cooled with water to prevent weakening of container structure. Eye Protection: Chemical safety glasses are recommended.
Other Protective Clothing or Equipment: Wear impervious clothing to
SECTION V - REACTIVITY DATA
prevent skin contact.
Stability: Stable Hazardous Polymerization: NA Work/Hygienic Practices: Ensure strict sanitary conditions are
Incompatibility (Materials to Avoid): Oxidizing agents conformed to when working around chemicals. Protective clothing and
Hazardous Decomposition Products: Carbon Monoxide and additional equipment should be in accordance with 29 CFR 1910.132 and CFR
hazardous materials may be formed in small amounts. 1910.133.
Conditions to avoid: Do no store above 54C-130F. Keep away from heat,
SECTION IX - OTHER REGULATORY CONTROLS
direct sunlight, open flames or sparks. Dropping of containers may cause
bursting. FEDERAL: Toxic Substance Control Act (TSCA): Ingredients of this
product are listed on the EPA/TSCA Inventory of Chemical Substances.
STATE RIGHT-TO-KNOW: Pennsylvania/New Jersey Right-To-Know
(Chemical and CAS No.):
Mineral spirits 64741-65-7
Isoparaffinic Solvent 64741-66-8
Mineral oil 8042-47-5
N-Methylpyrrolidinone 872-50-4
Propane 68476-85-7
Shipping Name: Consumer Commodity Hazard Class: ORM-D
While the information set forth herein is believed to be accurate as of the data
hereof, the Company makes no warranty or guarantee, express or implied, and
disclaims all liability arising out of the use of this information.
Effective Date: 07-31-02 Supercedes 06-15-02
Originally prepared by: Sue Heiser
|