MATERIAL SAFETY DATA SHEET 8500
09-15-03
INTERNATIONAL EPOXIES & SEALERS
30241 Commerce Drive, San Antonio, FL 33576
24 Hour Emergency call Infotrac : 1-800-535-5053
Information Phone: 1-800451-7206
PRODUCT IDENTIFICATION
Product Name: 8500A Acrylic Structural Adhesive
Product Type: Structural Acrylic
1. COMPOSITION
Ingredients Cas # %
Polyurethane methacrylate resin Trade secret 20-30
High boiling acrylate 7534-94-3 20-25
Hydroxyalkyl methacrylate 868-77-9 40-60
METHACRYLIC ACID 79-41-4 5-10
Modified silicone dioxide 11295-52-5 1-5
tert-BUTYL PEROXYBENZOATE 614-45-9 0.1-1.0
MALEIC ACID 110-16-7 0.1-1.0
SACCHARIN 81-07-2 0.1-1.0
2. CHEMICAL AND PHYSICAL PROPERTIES
Vapor Pressure: Less than 10mm @ 80癋
Vapor Density: Not available
Solubility in Water: Slight
Specific Gravity: 1.08 @ 80癋
Boiling Point: More than 300癋
Volatile Organic Compound 0%
Evaporation Rate (Ether = 1) Not available
pH: Does not apply
Appearance: Translucent amber tan paste
Odor: Sharp, irritating
3. FLAMMABILITY AND EXPLOSIVE PROPERTIES
Flash Point: 200癋 Method: (PMCC)
Estimated NFPA Code:
Health Hazard: 2
Fire Hazard: 1
Reactivity Hazard: 1
Specific Hazard: Does not apply
Estimated HMIS Code:
Health Hazard: 2
Flammability Hazard: 1
Reactivity Hazard: 1
Personal Protection: See Section 9
Explosive Limits:
(% by volume in air) Lower Not available
(% by volume in air) Upper Not available
Recommended Extinguishing Agents: Carbon dioxide, foam, dry chemical
Hazardous Products Formed by Fire
or Thermal Decomposition: Irritating organic vapors & oxides of carbon & nitrogen
Unusual Fire or Explosion Hazards: None
Compressed Gases: None
Pressure at Room Temp.: Does not apply
Page 1 of 6
MATERIAL SAFETY DATA SHEET 8500
09-15-03
4. SPILL OR LEAK AND DISPOSAL PROCEDURES
Steps to be taken in case of spill or leak: Remove sources of ignition. Maintain adequate ventilation.
Soak up with an inert absorbent. Store in a partly filled, closed container until disposal.
Recommended methods of disposal: Incinerate following EPA and local regulations.
5. STORAGE AND HANDLING PROCEDURES
Storage: Store at or below 100OF to preserve shelf life.
Handling: Avoid prolonged breathing of vapors. Keep away from eyes. Avoid prolonged skin
contact. Keep away from sources of ignition.
6. SHIPPING REGULATIONS
DOT and IATA Hazard Classification: Not Restricted Article
Proper DOT Shipping Name: Unrestricted
Identification Number: DOT - None IATA ?None
7. REACTIVITY DATA
Stability: Stable
Hazardous Polymerization: Will not occur.
Hazardous Decomposition Products
(non-thermal): None
Incompatibility: None
8. EMERGENCY TREATMENT PROCEDURES
Ingestion: Do not induce vomiting. Keep individual calm. Obtain
medical attention.
Inhalation: Remove to fresh air. If symptoms persist, obtain medical
attention.
Skin Contact: Wash with soap and water.
Eye Contact: Flush with water for at least 15 minutes. Obtain medical
attention.
9. PERSONAL PROTECTION
Eyes: Safety glasses or goggles.
Skin: Rubber of plastic gloves.
Ventilation: Sufficient to maintain vapor concentration below TLV.
10. HEALTH HAZARD DATA
Toxicity: Eye and skin irritant. Estimated oral LD50 more than 5,000
mg/kg. Estimated dermal LD50 more than 2,000 mg/kg.
Primary Routes of Entry: None known
Signs and Symptoms of Exposure: May cause dermatitis on prolonged contact in sensitive
individuals.
Existing Conditions Aggravated
By Exposure: None known.
Exposure Limits (TWA) ACGIH OSHA OTHER
Ingredients (TLV) (TLV)
High boiling acrylate None None 5 ppm
Hydroxyalkyl methacrylate None None 3 ppm
METHACRYLIC ACID 20 ppm skin 20 ppm skin None
Modified Silicone Dioxide 10 mg/m? 6 mg/m? 3 mg/m?br>
Page 2 of 6
MATERIAL SAFETY DATA SHEET 8500
09-15-03
Exposure Limits (STEL) ACGIH OSHA
Ingredients 6(TLV) (PEL)
Ingredients for which no Exposure Limits have been established are not listed above.
Literature Referenced Carcinogen
Ingredients Target Organ and Other Health Effects NTP IARC OSHA
Polyurethane methacrylate resin No Data NO NO NO
High boiling acrylate No Data NO NO NO
Hydroxyalkyl methacrylate No Data NO NO NO
METHACRYLIC ACID IRR NO NO NO
Modified silicone dioxide No Data NO NO NO
MUT NO NO NO
Tert-BUTYL PEROXYBENZOATE
MALEIC ACID IRR NO NO NO
SACCHARIN MUT YES 2B NO
Abbreviations
2B Possibly carcinogenic to humans IRR Irritant
MUT Mutagen
DISCLAIMER
THE INFORMATION AND RECOMMENDATIONS PROVIDED HEREIN ARE BELIEVED TO BE
ACCURATE AS OF THE DATE HEREOF. HOWEVER, SUCH INFORMATION AND RECOMMENDATIONS
ARE PROVIDED WITHOUT WARRANTY OF ANY KIND AND INTERNATIONAL EPOXIES & SEALERS,
DISCLAIMS ANY AND ALL LIABILITY OR LEGAL RESPONSIBLITY
FOR USE OR RELIANCE UPON SAME.
Page 3 of 6
MATERIAL SAFETY DATA SHEET 8500
09-15-03
INTERNATIONAL EPOXIES & SEALERS
30241 Commerce Drive, San Antonio, FL 33576
24 Hour Emergency call Infotrac : 800-535-5053
Information Phone: 800-451-7206
PRODUCT IDENTIFICATION
Product Name: 8500P Activator / Primer
Product Type: Activator
1. COMPOSITION
Ingredients: Cas # %
Acetone 67-64-1 70-85
Aldehyde-amine condensation Proprietary 5-25
Adhesion Promotion Agent Proprietary 1-5
2. CHEMICAL AND PHYSICAL PROPERTIES
Vapor pressure: Not Defined
Vapor density: 2.0
Solubility in water: High
Specific gravity: 0.815
Boiling point: 56 C
Volatile Organic Compound NA
Evaporation rate: (Ether = 1) Not Available
pH: Does not apply
Appearance: Amber liquid
Odor: Acetone
3. FLAMMABILITY AND EXPLOSIVE PROPERTIES
Flash point: Approximately 0癋 Method: TCC
Estimated NFPA Code:
Health hazard: 2
Fire hazard: 3
Reactivity hazard: 0
Specific hazard: Does not apply
Estimated HMIS Code:
Health hazard: 2
Flammability hazard: 3
Reactivity hazard 0
Personal Protection See Section 9
Recommended extinguishing agents: Carbon dioxide, dry chemical, foam
Hazardous products formed by
fire/thermal decomposition: Irritating organic vapors
Compressed gases: None
Pressure at room temperature: Does not apply
4. SPILL OR LEAK AND DISPOSAL PRODUCERS
Steps to be taken in case of spill or leak: Avoid flame and sparks. Maintain adequate ventilation. Soak
up in an inert absorbent and store in a closed container until
disposal.
Recommended methods of disposal: Follow EPA and local regulations.
Page 4 of 6
MATERIAL SAFETY DATA SHEET 8500
09-15-03
5. STORAGE AND HANDLING PROCEDURES
Storage: Store away from flames and sparks. Store below 80癋 to preserve shelf life.
Handling: Avoid prolonged breathing of vapors. Avoid prolonged skin contact. Keep away from
eyes.
6. SHIPPING REGULATIONS
DOT (49 CFR 172)
Proper shipping name Ground: Consumer Commodity (Not more than one quart);
Air: Consumer Commodity (Not more than one quart);
Acetone solution (More than 1 quart).
Hazard class of division Ground: ORM-D (Not more than one quart);
Flammable liquid (More than one quart)
Air: ORM-D (Not more than one quart);
Flammable liquid (More than one quart)
Identification number None (Not more than one quart)
UN 1090 (More than one quart)
Proper shipping name Acetone solution
Class or division Class 3, Packing Group II
UN or ID number UN 1090
IMO
Substance Not available
Marine Pollutant Status Not available
Class Not available
Subsidiary Risk Label Not available
IMDG Code Page Not available
UN Number Not available
7. REACTIVITY DATA
Stability: Stable Hazardous polymerization: Will not occur
Hazardous decomposition products (non-thermal) None
Incompatibility: Strong oxidizers
8. EMERGENCY TREATMENT PROCEDURES
Ingestion: Do not induce vomiting. Keep individual calm. Obtain medical attention.
Inhalation: Remove to fresh air. If symptoms persist, obtain medical attention.
Skin contact: Wash with soap and water.
Eye contact: Flush at least 15 minutes with water. Obtain medical attention.
9. PERSONAL PROTECTION
Eyes: Safety glasses or goggles
Skin: Rubber or plastic gloves
Ventilation: Sufficient to maintain vapor concentration below TLV.
10. HEALTH HAZARD DATA
Toxicity: Possible eye irritant. Moderately toxic by ingestion.
Estimated dermal LD50 greater than 2000 mg/kg.
Primary Routes of Entry: Inhalation, ingestion, contact.
Signs & Symptoms of Exposure: Vapors irritate eyes, nose and throat. Liquid is an eye irritant and may
irritate skin.
Page 5 of 6
MATERIAL SAFETY DATA SHEET 8500
09-15-03
Existing Conditions Aggravated by Exposure: Eye disorders from aldehyde-amine condensation.
Exposure Limits (TWA) ACGIH OSHA OTHER
Ingredients (TLV) (PEL)
Acetone 750 ppm TWA 1000 ppm TWA None
1780 mg/m? 2400 mg/m?br>
Aldehyde-amine condensation None None None
Adhesion Promotion agent None None None
Literature Referenced Carcinogen
Ingredients Target Organ and Other Health Effects NTP IARC OSHA
Acetone IRR KID LIV MET NER NO NO NO
Aldehyde-amine Irritant NO NO NO
Condensation
Adhesion Promotion Irritant NO NO NO
Abbreviations
N/A Not Applicable NER Nervous System IRR Irritant
KID Kidney LIV Liver MET Metabolic
DISCLAIMER
THE INFORMATION AND RECOMMENDATIONS PROVIDED HEREIN ARE BELIEVED TO BE
ACCURATE AS OF THE DATE HEREOF. HOWEVER, SUCH INFORMATION AND
RECOMMENDATIONS ARE PROVIDED WITHOUT WARRANTY OF ANY KIND AND INTERNATIONAL
EPOXIES & SEALERS, DISCLAIMS ANY AND ALL LIABILITY OR LEGAL RESPONSIBLITY
FOR USE OR RELIANCE UPON SAME.
Page 6 of 6
|