Distributed By: MSDS 013
Invensys Foxboro Foxboro Rev Date: April 2007
Foxboro, MA 02035 U.S.A. Part Number T0103RK
1-866-746-6477 Page 1 of 7
Material Safety Data Sheet
sec-BUTYLBENZENE
February 28, 2002
MSDS #: 47160
Revision #: 1
PHONE NUMBERS
CHEVRON PHILLIPS CHEMICAL COMPANY LP HEALTH:
10001 Six Pines Drive Chevron Phillips Emergency
The Woodlands, TX 77380 Information Center 866.442.9628
(North America) and
1.832.813.4984(International)
TRANSPORTATION:
North America: CHEMTREC 800.424.9300
or 703.527.3887
ASIA: 1.703.527.3887
EUROPE: BIG .32.14.584545 (phone)
or .32.14.583516 (telefax)
SOUTH AMERICA SOS-Cotec
Inside Brazil: 0800.111.767
Outside Brazil: 55.19.3467.1600
Technical Services: (832) 813-4862
For Additional MSDSs: (800) 852-5530
A. Product Identification
Synonyms: 2-Phenylbutane, secondary-Butylbenzene
Chemical Name: Benzene, (1-methylpropyl)-
Chemical Family: Aromatic hydrocarbon
Chemical Formula: C10H14
CAS Reg. No.: 135-98-8
Product No.: A66400
Product and/or Components Entered on EPA's TSCA Inventory: YES
This product is in U.S. commerce, and is listed in the Toxic Substances
Control Act (TSCA) Inventory of Chemicals; hence, it may be subject to
applicable TSCA provisions and restrictions.
B. Components
MSDS 013
Part Number T0103RK
Page 2 of 7
CAS % OSHA ACGIH
Ingredients Number By Wt. PEL TLV
sec-Butylbenzene 135-98-8 100 NE NE
C. Personal Protection Information
Ventilation: Use adequate ventilation.
Respiratory Protection: Not generally required unless needed to prevent
respiratory irritation. In case of spill or leak
resulting in unknown concentration, use NIOSH
approved supplied air respirator.
Eye Protection: Use safety glasses with side shields and face
shield for splash protection.
Skin Protection: Use protective garments to prevent skin contact.
NOTE: Personal protection information shown in Section C is based upon
general information as to normal uses and conditions. Where special or
unusual uses or conditions exist, it is suggested that the expert
assistance of an industrial hygienist or other qualified professional
be sought.
D. Handling and Storage Precautions
Do not swallow, may be aspirated into lungs. Avoid contact with eyes,
skin or clothing. Avoid breathing vapors, mist, fume or dust. Wear
protective equipment and/or garments described in Section C if exposure
conditions warrant. Wash thoroughly after handling. Launder
contaminated clothing before reuse. Use with adequate ventilation.
Keep away from heat, sparks, and flames. Store in well-ventilated area.
Store in closed container. Bond and ground during transfer.
E. Reactivity Data
Stability: Stable
Conditions to Avoid: Not Applicable
Incompatibility (Materials to Avoid): Oxygen and strong oxidizing
agents
Hazardous Polymerization: Will Not Occur
Conditions to Avoid: Not Applicable
Hazardous Decomposition Products: Carbon oxides formed when burned.
MSDS 013
Part Number T0103RK
Page 3 of 7
F. Health Hazard Data
Recommended Exposure Limits:
Not Established.
Acute Effects of Overexposure:
Eye: May cause mild irritation to the eyes.
Skin: May cause mild to moderate irritation to skin. Prolonged or
repeated contact with the liquid may cause defatting of the skin
resulting in drying, redness, and possibly blistering.
LD50 (rabbit) > 13 g/kg.
Inhalation: May cause slight to moderate upper airway irritatancy, with
higher exposures causing central nervous system depression,
headache, and dizziness.
Ingestion: May be slightly irritating to the gastrointestinal tract. If
swallowed, may be aspirated resulting in inflammation and
possible fluid accumulation in the lungs.
LD50 (rat) > 1.9 g/kg.
Subchronic and Chronic Effects of Overexposure:
No known applicable information.
Other Health Effects:
No known applicable information.
Health Hazard Categories:
Animal Human Animal Human
Known Carcinogen ___ ___ Toxic ___ ___
Suspect Carcinogen ___ ___ Corrosive ___ ___
Mutagen ___ ___ Irritant ___ ___
Teratogen ___ ___ Target Organ Toxin _X_ _X_
Allergic Sensitizer ___ ___ Specify - Lung - Aspiration Hazard
Highly Toxic ___ ___
First Aid and Emergency Procedures:
MSDS 013
Part Number T0103RK
Page 4 of 7
Eye: Flush eyes with running water for at least fifteen minutes. If
irritation or adverse symptoms develop, seek medical attention.
Skin: Wash skin with soap and water for at least fifteen minutes. If
irritation or adverse symptoms develop, seek medical attention.
Inhalation: Remove from exposure. If breathing is difficult, give oxygen.
If breathing ceases, administer artificial respiration followed
by oxygen. Seek immediate medical attention.
Ingestion: Do not induce vomiting. Seek immediate medical attention.
Note to Physician: Gastric lavage using a cuffed endotracheal tube may be
performed at your discretion.
MSDS 013
Part Number T0103RK
Page 5 of 7
G. Physical Data
Appearance: Colorless liquid
Odor: Acrid
Boiling Point: 344F (173C)
Vapor Pressure: 0.2 psia @ 130F (54C)
Vapor Density (Air = 1): 4.6
Solubility in Water: Negligible
Specific Gravity (H2O = 1): 0.866 @ 60/60F 16/16C
Percent Volatile by Volume: 100
Evaporation Rate (Ethyl Ether = 1):
H. Fire and Explosion Data
Flash Point (Method Used): 126F (52C) (TOC, ASTM D 1310)
Flammable Limits (% by Volume in Air): LEL - 0.8
UEL - 6.9
Fire Extinguishing Media: Dry chemical, foam or carbon dioxide
(CO2)
Special Fire Fighting Procedures: Evacuate area of all unnecessary
personnel. Shut off source if
possible. Use NIOSH approved
self-contained breathing apparatus and
other protective equipment and/or
garments described in Section C if
conditions warrant. Water fog or
spray may be used to cool exposed
containers and equipment. Do not
spray water directly on fire product
will float and could be reignited on
surface of water.
Fire and Explosion Hazards: Carbon oxides formed when burned.
Highly flammable vapors which are
heavier than air may accumulate in low
areas and/or spread along ground away
from handling site.
I. Spill, Leak and Disposal Procedures
Precautions Required if Material is Released or Spilled:
Evacuate area of all unnecessary personnel. Wear protective equipment
and/or garments described in Section C if exposure conditions warrant.
Shut off source, if possible and contain spill. Protect from ignition.
Keep out of water sources and sewers. Absorb in a dry, inert material
(sand, clay, etc). Transfer to disposal drums using non-sparking
equipment.
MSDS 013
Part Number T0103RK
Page 6 of 7
Waste Disposal (Insure Conformity with all Applicable Disposal Regulations):
Incinerate or place in permitted waste management facility.
J. DOT Transportation
Shipping Name: Butyl benzenes
Hazard Class: 3
ID Number: UN 2709
Packing Group: III
Marking: Butyl benzenes, UN 2709
Label: Flammable Liquid
Placard: Flammable/2709
Hazardous Substance/RQ: Not Applicable
Shipping Description: Butyl benzenes, 3, UN 2709,PG III
Packaging References: 49 CFR 173.150, 173.203, 173.241
K. RCRA Classification - Unadulterated Product
as a Waste
Ignitable (D001)
Prior to disposal, consult your environmental contact to determine if
TCLP (Toxicity Characteristic Leaching Procedure, EPA Test Method
1311) is required. Reference 40 CFR Part 261.
L. Protection Required for Work on Contaminated
Equipment
Contact immediate supervisor for specific instructions before work is
initiated. Wear protective equipment and/or garments described in
Section C if exposure conditions warrant.
M. Hazard Classification
___ This product meets the following hazard definition(s) as defined by
the Occupational Safety and Health Hazard Communication Standard (29
CFR Section 1910.1200):
_X_ Combustible Liquid ___ Flammable Aerosol ___ Oxidizer
___ Compressed Gas ___ Explosive ___ Pyrophoric
___ Flammable Gas _X_ Health Hazard (Section F) ___ Unstable
___ Flammable Liquid ___ Organic Peroxide ___ Water Reactive
___ Flammable Solid
MSDS 013
Part Number T0103RK
Page 7 of 7
___ Based on information presently available, this product does not meet
any of the hazard definitions of 29 CFR Section 1910.1200.
N. Additional Comments
REVISION STATEMENT:
This revision updates Section J.
SARA 313
As of the preparation date, this product did not contain a chemical or
chemicals subject to the reporting requirements of Section 313 of Title
III of the Superfund Amendments and Reauthorization Act of 1986 and 40
CFR Part 372.
NFPA 704 Hazard Codes - - - - - - - - Signals
Least - 0
Health : 0 Slight - 1
Flammability: 2 Moderate - 2
Reactivity : 0 High - 3
Special Haz.: - Extreme - 4
Prepared according to the OSHA Hazard Communication Standard (29 CFR 1910.1200) and the
ANSI MSDS Standard (Z400.1) by EHS Product Stewardship Group, Chevron Phillips Chemical
Company LP, 10001 Six Pines Drive, The Woodlands, TX 77380
The above information is based on the data of which we are aware and is believed to be correct as
of the date hereof. Since this information may be applied under conditions beyond our control and
with which we may be unfamiliar and since data made available subsequent to the date hereof may
suggest modifications of the information, we do not assume any responsibility for the results of its
use. This information is furnished upon condition that the person receiving it shall make his own
determination of the suitability of the material for his particular purpose.
|