MATERIAL SAFETY DATA SHEET
PRODUCT NAME: Flamedxx Fire Retardant Coating DATE REVISED: 12-01-07
FLAMEDXX, LLC HMIS HAZARD RATINGS
P. O. Box 280448 LEAST 0 HEALTH HAZARD 1
Nashville, TN 37228 SLIGHT 1 FLAMMABILITY HAZARD 0
MODERATE 2 REACTIVITY HAZARD 0
PHONE: (615) 297.2000 HIGH 3 MAXIMUM PERSONAL
EXTREME 4 PROTECTION B
SECTION I ?PRODUCT IDENTIFICATION
PRODUCT NAME: FLAMEDXX FR Coating D.O.T. HAZARD CLASS: None
D.O.T. Shipping Name: Cold Water Paint
PRODUCT CLASS: Latex Fire Retardant Coating D.O.T. UN Number:
SECTION II ?PHYSICAL DATA
APPEARANCE AND ODOR: Orange viscous liquid, slight odor
BOILING POINT (at 760 mm Hg): 220-240?F SPECIFIC GRAVITY (water = 1): 1.3
VAPOR PRESSURE (at 20C or 68F) nil WEIGHT PER GALLON (lbs): 11
EVAPORATION RATE (ether = 1): much slower PERCENT VOLATILES BY VOLUEM: 56
VAPOR DENSITY (air = 1) 0.6 SOLUBILITY IN WATER: Very
SECTION III ?HAZARDOUS COMPONENTS
TRADE NAME CAS # % Volume OSHA PEL ACGIH TLV
15 mg/m3 10 mg/m3
Titanium Dioxide 13463-67-7 25%
5 mg/m3 5mg/m3
(total dust)
(respirable dust)
15mg/m3 10 mg/m3
DOT (Polybor) 12280-03-4 1%
5mg/m3
(total dust)
(respirable dust)
* Indicates toxic chemicals subject to the reporting requirements of Section 313 of Title III and of 40 CFR 372. Hazard for this material is as a
dust only. This hazard is eliminated in liquid paints. Dust hazard is applicable if dried coating is subjected to grinding and/or sanding operations.
FLAMMABILITY LIMITS LEL: Not applicable UEL: Not applicable
EXTINGUISING MEDIA: Non-flammable (aqueous emulsion). After water evaporates, remaining material will
burn. Use alcohol type or all-purpose foam for large fires. Use CO2 or dry chemical media for small fires.
SPECIAL FIRE FIGHTING PROCEDURES: Wet product will not burn but will smoke and spatter if exposed to
flames. Firefighters must use self-contained breathing apparatus.
1
HF13 REV: Original 12/07
PRODUCT NAME: FLAMEDXX FR Coating
UNUSUAL FIRE AND EXPLOSION HAZARDS: Sealed containers may rupture if overheated. Cool with water
spray.
HAZARDOUS DECOMPOSITION PRODUCTS: Thermal oxidative decomposition can produce toxic gases,
including oxides of nitrogen and carbon monoxide.
SECTION V ?REACTIVITY DATA
STABILITY: STABLE
CONDITIONS TO AVOID: Not applicable
INCOMPATIBILITY (MATERIALS TO AVOID): Strong Oxidizers, Strong Bases
HAZARDOUS POLYMERIZATION: Will Not Occur
SECTION VI ?HEALTH HAZARD DATA
EFFECTS OF OVEREXPOSURE:
Eyes: Direct contact with product may result in eye irritation.
Skin: Prolonged or repeated contact with product may cause skin irritation.
Breathing: Excessive inhalation can cause irritation of the mucous membranes of the
nose, throat, and respiratory tract, headache and nausea.
Swallowing: Excessive exposure may cause central nervous system effects, cardio-
pulmonary effects, and kidney failure.
FIRST AID PROCEDURES:
If in Eyes: Flush with flowing water immediately and continuously for 15 minutes.
Consult medical personnel.
If on Skin: Thoroughly wash exposed area with soap and water. Remove and wash
contaminated clothing before reuse.
If Swallowed: If conscious, give two glasses of water to drink. Get immediate medical
attention.
SECTION VII ?SPILL OR LEAK PROCEDURES
STEPS TO BE TAKEN IF MATERIAL IS RELEASED OR SPILLED: Keep unnecessary people away. Contain
spill with inert material (sand, earth, etc.) and transfer the material to containers for recovery or disposal. Keep spill
out of sewers and open bodies of water. Floors may be slippery; care should be exercised to avoid spills.
SECTION VIII- SPECIAL PROTECTION INFORMATION
VENTILATION TYPE: Mechanical local exhaust at point of mist release is preferred.
RESPIRATORY PROTECTION: None required if good ventilation is maintained. Otherwise wear OSHA/NIOSH
approved respirator suitable for vapor, mist, or dust concentrations encountered.
2
HF13 REV: Original 12/07
PRODUCT NAME: FLAMEDXX FR Coating
SECTION IX ?SPECIAL PRECAUTIONS
PRECAUTIONS TO BE TAKEN IN HANDLING AND STORAGE: Use only with adequate ventilation. Prevent
prolonged breathing of vapor or mist. Prevent contact with eyes. Do not take internally. Keep out of reach of
children.
STORAGE TEMPERATURE: MAX 100?F MIN 32?F
OTHER PRECATIONS:
The information and recommendations contained herein are based upon data believed to be correct.
However, no guarantee or warranty of any kind, express or implied, is made with respect to the information
contained herein. It is the user's responsibility to determine the suitability of this information for the
adoption of the necessary safety precautions. We reserve the right to revise Material Safety Data Sheets
periodically as new information becomes available.