MATERIAL SAFETY DATA SHEET
INNERBOND 420 Paintable Silicone Latex Sealant
SECTION I ?PRODUCT AND COMPANY IDENTIFICATION
October 2, 2007
DATE:
INLAND, INC.
MANUFACTURER'S NAME:
P. O. BOX 644 (42702)
ADDRESS:
209 PETERSON DRIVE
ELIZABETHTOWN, KY 42701
270-737-6757
TELEPHONE NUMBER:
CHEMTREC 800-424-9300
EMERGENCY CONTACT:
NFPA = NATIONAL FIRE PROTECTION ASSOCIATION
1 0 0
HEALTH (NFPA): FLAMMABILITY (NFPA): REACTIVITY (NFPA):
MIXTURE
CAS NO:
NOT USED
INLAND, INC. WARNING CODE:
SEALANT
GENERIC DESCRIPTION:
SECTION II - HAZARDOUS COMPONENTS
CAS Number Substance Wt. %
85-68-7 Butyl benzyl phthalate 5 ?10%
107-21-1 1,2-Ethanediol 1 ?5%
8052-41-3 Stoddard solvent 1 ?5%
The above components are hazardous as defined in 29 CFR 1910.1200.
SECTION III ?HAZARDS IDENTIFICATION
Ingestion:
May be harmful if swallowed. May irritate the mouth, throat and stomach. May cause kidney damage. May
cause headache, dizziness, nausea, vomiting, gastrointestinal irritation and central nervous system depression.
Skin:
May be absorbed through the skin and produce effects as listed under "Ingestion". Can cause irritation and
reddening of the skin.
Inhalation:
Symptoms of overexposure may be headache, dizziness, tiredness, nausea and vomiting. Can irritate mucous
membranes and respiratory tract with coughing and shortness of breath. Avoid inhalation of vapor and mist.
Eyes:
Contact can cause irritation, redness and swelling.
Medical Conditions Aggravated:
Central nervous system disorders, pre-existing skin diseases, respiratory diseases, and kidney disorders may be
aggravated.
Subchronic (Target Organ):
Respiratory system, kidney, and the central nervous system may be targeted.
Chronic Effects / Carcinogenicity:
This product and its ingredients (present at 0.1% or more) are not listed as a carcinogen or suspected
carcinogen by NTP, IARC, or OSHA.
Page 1 of 4
MATERIAL SAFETY DATA SHEET
INNERBOND 420 Paintable Silicone Latex Sealant
SECTION IV - FIRST AID MEASURES
Ingestion:
Do not induce vomiting. Immediate medical attention is required. If victim is conscious, give 2 ?4 glasses of
water.
Skin:
Wipe off and wash with soap and water. Remove contaminated clothing and launder before re-use. Get medical
attention if irritation or symptoms of section III develop. Flush skin with large amounts of water for at least 15
minutes until no evidence of chemical remains.
Inhalation:
Get medical attention if irritation or symptoms from Section III develop. If not breathing, begin artificial
respiration using a barrier device. Because of chemical properties, do not use mouth ?to ?mouth contact.
Remove to fresh air.
Eyes:
In case of contact, immediately flush eyes with plenty of water for at least 15 minutes and get medical attention if
irritation persists.
SECTION V - FIRE FIGHTING MEASURES
Unknown
Flash Point (Method Used):
Unknown
Ignition Temperature:
Unknown
Flammable limits in air:
No
Sensitivity to mechanical impact:
All standard extinguishing agents are suitable.
Extinguishing Media:
Firefighters must wear NIOSH/MSHA approved positive pressure self-
Special Fire Fighting Procedures:
contained breathing apparatus with full face mask and full protective
clothing.
SECTION VI - ACCIDENTAL RELEASE MEASURES
Wipe, scrape or soak up in an inert material and put in a container for disposal. Wash walking surfaces with
detergent and water to reduce slipping hazard. Wear proper protective equipment as specified in the protective
equipment section. Keep out of water supplies and sewers.
SECTION VII - HANDLING AND STORAGE
Avoid contact with skin and eyes. Remove and wash contaminated clothing before re-use. Keep away from
children. Keep container tightly closed. Keep container dry. Do not inhale vapors. Avoid accidental ingestion
of this material. Wash hands and face before eating, drinking, smoking, using toilet facilities, or applying
cosmetics. Store between 40癋 and 120癋. Product releases formaldehyde during curing.
SECTION VIII - EXPOSURE CONTROLS AND PERSONAL PROTECTION
Respiratory Protection:
If exposure limits are exceeded or respiratory irritation is experienced, NIOSH/MSHA approved respiratory
protection should be worn. Supplied air respirators may be required for non-routine or emergency situations.
Respiratory protection must be provided in accordance with OSHA regulations.
Protective Gloves:
Neoprene
Eye Protection:
Wear safety spectacles with sideshields.
Page 2 of 4
MATERIAL SAFETY DATA SHEET
INNERBOND 420 Paintable Silicone Latex Sealant
Exposure Guidelines
Component CAS RN Source Value
1,2Ethanediol 107211 ACGIH, Ceiling Aerosol. 100 mg/m?
Stoddard Solvent 8052413 ACGIH, TWA 100 ppm
Stoddard Solvent 8052413 OSHA Z1,PEL 500 ppm; 2,900 mg/m?
SECTION IX - PHYSICAL AND CHEMICAL PROPERTIES
Solid
Physical Form:
Trace Ammonia
Odor:
100 癈; 212 癋
Boiling Point:
Unknown
Vapor Pressure (20 C) (MM HG):
No data available
Vapor Density (Air = 1 at 77癋/25癈):
Unknown
Freezing Point:
Not available
Melting Point:
Unknown
Evaporation Rate (Butyl Acetate =1):
1.61
Specific Gravity (Water = 1):
Unknown
Density:
Ca. 8.0
pH
34.20% (m)
Volatile Organic Content (VOL):
Unknown
Solubility in Water:
60.90
VOC EXCL. H2O & Exempts (G/L)
The above information is not intended for use in preparing product specifications.
SECTION X ?STABILITY AND REACTIVITY
Chemical Stability:
Stable
Hazardous Polymerization:
Will not occur
Hazardous Thermal Decomposition / Combustion Products:
Carbon dioxide (CO2), carbon monoxide, oxides of nitrogen, toxic monomer fumes
Conditions to Avoid:
None known
Incompatibility (Materials to Avoid):
None known
SECTION XI ?TOXICOLOGICAL INFORMATION
No data available
SECTION XII ?ECOLOGICAL INFORMATION
No data available
Page 3 of 4
MATERIAL SAFETY DATA SHEET
INNERBOND 420 Paintable Silicone Latex Sealant
SECTION XIII ?DISPOSAL CONSIDERATION
Disposal should be made in accordance with federal, state and local regulations.
SECTION XIV ?TRANSPORT INFORMATION
Not regulated
US DOT & Canada TDG Surface:
Not regulated
Transport by sea IMDG-Code:
Not regulated
Air transport ICAO-TI/IATA-DGR:
SECTION XV ?REGULATORY INFORMATION
FEDERAL REGULATIONS:
TSCA inventory status and TSCA information:
All chemical substances in this material are included on or exempted from listing on the TSCA Inventory of
Chemical Substances.
TSCA 12 (b) Export Notification:
This material does not contain any TSCA 12 (b) regulated chemicals.
CERCLA Regulated Chemicals:
This material does not contain any CERCLA Regulated Chemicals.
SARA 302 EHS Chemicals:
This material does not contain any SARA extremely hazardous substances.
SARA (311, 312) Hazard Class:
Acute health hazard; chronic health hazard
SARA 313 Chemicals:
(50-00-0) formaldehyde, (79-06-1) acrylamide, (108-05-4) Vinyl Acetate
HAPS:
This material does not contain any hazardous air pollutants.
U.S. STATE REGULATIONS:
California Proposition 65:
This material contains chemicals known to the state of California to cause cancer, birth defects or other
reproductive harm. (7440-38-2) arsenic, (7439-92-1) lead, (50-00-0) formaldehyde, (140-88-5) ethyl acrylate,
(75-07-0) acetaldehyde, (79-06-1) 2-propeamide
SECTION XVI ?OTHER INFORMATION
This data is offered in good faith as typical values and not as a product specification. No warranty, either
expressed or implied, is hereby made. The recommended industrial hygiene and safe handling procedures are
believed to be generally applicable. However, each user should review these recommendations in the specific
context of the intended use and determine whether they are appropriate.
Page 4 of 4
|