MSDS No.: 268
Revision No.: 010
Revision Date: 06/25/07
? Page: 1 of 2
MATERIAL SAFETY DATA SHEET
Product name: CP 672 Speed Spray
Fire rated mastic for construction joints
Description:
Hilti, Inc. P.O. Box 21148, Tulsa, OK 74121
Supplier:
1 800 424 9300 (USA, PR, Virgin Islands, Canada); 001 703 527 3887 (other countries)
Emergency # (Chem-Trec.):
INGREDIENTS AND EXPOSURE LIMITS
TLV: mg/m3 PEL: mg/m3 STEL: mg/m3
Ingredients: CAS Number:
Acrylic polymer Mixture NE NE NE
Aluminum hydroxide 21645-51-2 NE NE NE
Calcium carbonate 1317-65-3 10 15 (T); 5 (R) NE
Calcined kaolin 66402-68-4 NA NA NE
Diisononyl phthalate 68515-48-0 NE NE NE
Ethylene glycol 107-21-1 NE NE C: 100
Pigments:
1309-37-11
? 5 (R) 10 (fume) NE
Red iron oxide
2
? 1317-61-9 NE NE NE
Black iron oxide
2,3
? 13463-67-7 10 15 (T) NE
Titanium dioxide
1 2 3
CP672 red CP672 grey CP672 white
Abbreviations: PEL = OSHA Permissible Exposure Limit. TLV = ACGIH Threshold Limit Value. STEL = Short Term Exposure
Limit. C = Ceiling. NE = None Established. T = Total dust. R = Respirable dust
PHYSICAL DATA
Red, grey, or white sprayable Mild odor
Appearance: Odor:
paste
Not applicable Not determined
Vapor Density: (air = 1) Vapor Pressure:
Not determined 0.0 g/L
Boiling Point: VOC Content:
Not determined Soluble
Evaporation Rate: Solubility in Water:
1.3 8.5 - 9.5
Specific Gravity: pH:
FIRE AND EXPLOSION HAZARD DATA
None Not applicable
Flash Point: Flammable Limits:
As appropriate for surrounding fire (e.g. Water, Carbon Dioxide, Dry Chemical, Foam)
Extinguishing Media:
Wear full protective clothing. A NIOSH-approved self-contained breathing apparatus (SCBA)
Special Fire Fighting
should be worn when fighting fires involving chemicals.
Procedures:
None known. Thermal decomposition products such as oxides of carbon and nitrogen can be
Unusual Fire and Explosion
produced under fire conditions. See below.
Hazards:
REACTIVITY DATA
Stable. Will not occur.
Stability: Hazardous Polymerization:
Metal salts will coagulate this product
Incompatibility:
Thermal decomposition can yield oxides of carbon and nitrogen.
Decomposition Products:
Avoid temperature extremes which could shorten the shelf-life of this product; i.e. below 40?and
Conditions to Avoid:
above 77?F. (See handling and storage requirements).
HEALTH HAZARD DATA
Known Hazards: Acute: No effects expected; irritation is possible. Chronic: None known
Signs and Symptoms of Eyes: Can cause irritation or watering but injury is unlikely. Skin: Irritation is possible with some
Exposure: individuals. Inhalation: No effects expected. Ingestion: Effects of ingestion have not been
determined. Considered to have a low acute oral toxicity.
Contact.
Routes of Exposure:
HILTI ?is a registered trademark of Hilti Corp.
No ingredients are classified as a carcinogen by IARC, NTP or OSHA.
Carcinogenicity:
None known
Medical Conditions
Aggravated by Exposure:
EMERGENCY AND FIRST AID PROCEDURES
Flush with plenty of water. Contact a Physician if symptoms occur.
Eyes:
Wash with soap and water. Seek medical attention if any effects persist.
Skin:
Move victim to fresh air. Contact a Physician if symptoms occur.
Inhalation:
Do not induce vomiting unless directed by a Physician. Contact a Physician immediately.
Ingestion:
Referral to a Physician is recommended if there is any question about the seriousness of the
Other:
injury/exposure.
CONTROL MEASURES AND PERSONAL PROTECTIVE EQUIPMENT
General (natural or mechanically induced fresh air movements).
Ventilation:
While spraying, chemical goggles are recommended. As a minimum, wear safety glasses with
Eye Protection:
side shields.
Impermeable (neoprene or rubber) gloves recommended.
Skin Protection:
None normally required.
Respiratory Protection:
PRECAUTIONS FOR SAFE HANDLING AND USE
Store in a cool dry area. Keep from freezing. Store between 40?and 77?F. For industrial use
Handling and Storing
only. Keep out of reach of children. Use with adequate ventilation. Keep container closed when
Precautions:
not in use. Do not get into the eyes. Avoid prolonged or repeated contact with the skin. Practice
good hygiene; i.e. wash after using and before eating or smoking.
Wipe away spilled material before it hardens. Place in a container for proper disposal in
Spill Procedures:
accordance with all applicable local, state, or federal requirements.
REGULATORY INFORMATION
This MSDS has been prepared in accordance with the federal OSHA Hazard Communication
Hazard Communication:
Standard. 29 CFR 1910.1200.
Health 1, Flammability 0, Reactivity 0, PPE B (Glasses, Gloves)
HMIS Codes:
Not regulated.
DOT Shipping Name:
Not regulated.
IATA / ICAO Shipping Name:
Chemical components listed on TSCA inventory.
TSCA Inventory Status:
This product contains 1 ?2.5% ethylene glycol (CAS 107-21-1) which is subject to reporting
SARA Title III, Section 313:
under Section 313 of SARA Title III (40 CFR Part 372).
Not regulated by EPA as a hazardous waste
EPA Waste Code(s):
Consult with regulatory agencies or your corporate personnel for disposal methods that comply
Waste Disposal Methods:
with local, state, and federal safety, health and environmental regulations.
CONTACTS
1 800 879 8000 1 800 879 8000
Customer Service: Technical Service:
1 800 879 6000 Jerry Metcalf (x6704)
Health / Safety:
1 800 424 9300 (USA, PR, Virgin Islands, Canada); 001 703 527 3887 (other countries)
Emergency # (Chem-Trec):
The information and recommendations contained herein are based upon data believed to be correct; however, no guarantee or
warranty of any kind expressed or implied is made with respect to the information provided.
MSDS 268, Page 2 of 2
|