HMIS
H =1
MATERIAL SAFETY DATA SHEET F =0
R =0
PPE = See Section 8
VOC: 200 grams per liter or less
Section I
Manufacturer: Siplast, an Icopal Group Company
(800) 643-1591 or (800) 922-8800
Address: 1000 E. Rochelle Blvd., Irving, TX 75062-3940
Emergency Phone No.: CHEMTREC, (800) 424-9300 (U.S.), (703) 527-3887 (outside of U.S.)
Product Class: Self-adhered Product Primer
Trade Name: Siplast TA-119 Primer
Section II - Ingredients
NTP/IRAC Percent ACGIH OSHA
Ingredient OSHA CARC. TLV PEL
Mist, 100 mg/m3
Ethylene Glycol Not Available 6-8 50 ppm
CAS #107-21-1 Ceiling Ceiling
Hexahydro-1, 3, 5 - Not Available < 0.2 0.75 ppm
triethyl-s-triazine
CAS #7779-27-3
Section III - Physical Data Section V - Health Hazard Data
Appearance: Pale blue liquid
Odor: Typical latex odor Summary of Risks: May cause moderate irritation to
pH: Slight basic eyes. May be harmful if swallowed. Read and
Physical State: Liquid understand all health and safety information on the
Boiling Range: 214癋 to 215癋 product label and Material Safety Data Sheet before
Vapor Density (Air = 1): < air use.
% Volatile by Volume: 60 - 70 Target Organs: Skin, Inhalation, Eye, Ingestion
Sp. Gr.: 1 Effects of Overexposure:
Solubility in H2O: Miscible with water SKIN: May cause mild skin irritation on prolonged or
Vapor Pressure: 17 mm Hg @ 20癈 repeated contact.
Volatile Organic Content: 200 g/liter EYES: May cause eye irritation if wiped or rubbed into
eyes.
Section IV - Fire and Explosion Data INHALATION: Vapor and mist may cause respiratory
irritation, dizziness and/or nausea, tightness of chest,
shortness of breath, headache. Ethylene glycol is
DOT Category: Not flammable, other regulated
very toxic in particular form upon inhalation.
substances, liquid (contains ethylene glycol).
INGESTION: Ingestion of large quantity may cause
Flash Point: 232癋
initial central nervous system stimulation, followed by
LEL %: N/A UEL %: N/A
depression.
Autoignition Temperature: 752癋
MEDICAL CONDITION AGGRAVATED BY EXPOSURE:
Extinguishing Media: CO2, foam, dry chemical, or
Prolonged exposure to vapors could aggravate pre-
water spray.
existing disorders in lungs, kidney, and liver.
Special Procedures: Firemen must wear full-face air-
supplied masks and full protective clothing.
Unusual Hazards: None known.
Hazardous Combustion By-Products: CO, CO2,
unburned hydrocarbons. Emits acrid fumes.
Trade Name: Siplast TA-119 Primer
Page Two
Emergency and First Aid Procedures: Section VIII - Special Protection Information
SKIN: Wipe off and wash skin with soap and water.
Promptly remove contaminated clothing and wash Respirator: Provide adequate ventilation to maintain
before reuse. vapors below PEL/TWA. If vapor levels are
EYES: Flush with water for 15 minutes. Get medical exceeded, use NIOSH approved respirator, both
attention immediately. during and immediately after application, until vapor
INHALATION: Remove to fresh air. If breathing has levels are below limits.
stopped, start artificial respiration. Oxygen may be Ventilation: Provide local exhaust or area ventilation
administered. Consult physician immediately. to maintain concentration of vapors below PEL/TWA.
INGESTION: Do not induce vomiting unless directed to Protective Gloves: Use protective rubber gloves.
do so by a physician. Consult a physician Eye/Face Protection: Wear safety goggles. Contact
immediately. lenses should not be worn.
NOTES TO PHYSICIAN: This product contains ethylene Other: Source of clean water should be available in
glycol, Hexahydro-1, 3, 5-triethyl-s-triazine. the work area for flushing eyes and skin. Wash
thoroughly with soap and water after use and before
Section VI - Reactivity Data eating.
Stability: Stable X Unstable ______ Section IX - Special Precautions
Conditions to Avoid: Avoid extreme heat, fire, and
temperature. Handling: Avoid prolonged contact with skin. Use
Materials to Avoid: Avoid strong acids, and strong protective gloves. Avoid rubbing eyes while handling.
oxidizers. Storage: Store in dry, cool environment. Keep
Hazardous Decomposition Products: containers closed when not in use.
Hazardous Polymerization: Empty Container Warnings:
May occur Will not occur X Drums: Drums may be reused after wash.
Plastic: Plastic containers may be reused after wash.
Section VII - Spill or Leak Procedures
Steps to be Taken: Evacuate non-essential
personnel to safe areas. Clean-up responders
should wear proper protective clothing and gloves
before entering the affected area.
Regulatory Notifications: Certain component of this
product is defined as hazardous according to U.S.
EPA. Spill reporting requirements and reportable
quantities vary by region. Consult all applicable state
and local regulations. For Canada, observe all
precautions noted above.
Waste Disposal Method: Dispose of in accordance
with local, state, and federal EPA regulation.
Regulator Information: Consult all regulations
(federal, state, provincial, local, etc.) or a qualified
waste disposal firm when characterizing waste for
disposal.
Waste Management: Prevent product from entering
drinking water supplies or streams. Observe above
precautions, collect liquid with inert, noncombustible
material and remove for disposal.
The information and recommendations contained herein are, to the best of Siplast's knowledge and belief, accurate and reliable as of the date
issued. Siplast does not warrant or guarantee their accuracy or reliability, and should not be liable for any loss or damage arising out of the use
thereof. User should satisfy himself that he has all current data relevant to his particular use.
Rev 10/07
|