MATERIAL SAFETY DATA SHEET
Product Code: B092137 MAJESTA 707
SECTION 1: MANUFACTURER IDENTIFICATION
1
Manufaturer's Name: Day International Chemical Products Div.
Address: 130 West Second Street, Suite 1700 1
Dayton, Ohio 45402
0
Emergency Phone: Information Phone:
800-424-9300 CHEMTREC? 800-336-8276
Name of Preparer: Date Printed: 9/10/2007
Day Chemical Prod. Div
09/04/2007
Date Revised:
SECTION 2: HAZARDOUS INGREDIENTS / SARA III INFORMATION
Vapor Pressure
mm Hg @ Temp
Component CAS Number Weight Percent
*Ethylene Glycol 107-21-1 0.12 68癋 5%
OSHA PEL: n/e, ACGIH?TLV? TWA: 100mg/M3 Ceiling as Mist. Hazardous Air Pollutant
* Indicates toxic chemical(s) subject to the reporting requirements of Section 313 of SARA Title III and of 40 CFR 372.
All ingredients are listed on the EPA TSCA Inventory
SECTION 3: PHYSICAL / CHEMICAL CHARACTERISTICS
>212癋
BOILING POINT / RANGE:
Heavier than air.
VAPOR DENSITY:
Slower than water.
EVAPORATION RATE:
0.9
V.O.C. (EPA METHOD 24) lb/gl:
Not Applicable.
VAPOR PRESSURE:
100%
SOLUBILITY IN WATER:
Green Liquid - Mild Odor
APPEARANCE AND ODOR:
1.08
SPECIFIC GRAVITY (H20=1):
SECTION 4: FIRE AND EXPLOSION HAZARD DATA
None.
FLASH POINT:
TAG CC
METHOD USED:
None. Aqueous product.
FLAMMABLE LIMITS IN AIR BY VOLUME:
Use any fire extinguishing media.
EXTINGUISHING MEDIA:
Under normal conditions this product does not support combustion.
SPECIAL FIREFIGHTING PROCEDURES:
However, as in any fire, wear self-contained breathing apparatus
(MSHA/NIOSH approved) and full protective (bunker) gear.
None Known.
UNUSUAL FIRE AND EXPLOSION HAZARDS:
Page 2 of 3
Product Code: B092137 MAJESTA 707
SECTION 5: REACTIVITY DATA
STABILITY:
Stable
CONDITIONS TO AVOID:
Avoid conditions of excess heat to prolong shelf life.
INCOMPATIBILITY (MATERIALS TO AVOID):
Avoid mixing with strong oxidizing agents.
HAZARDOUS DECOMPOSITION OR BYPRODUCTS:
None known.
HAZARDOUS POLYMERIZATION:
Will Not Occur.
SECTION 6: HEALTH HAZARD DATA
INHALATION HEALTH RISKS AND SYMPTOMS OF EXPOSURE:
Not an inhalation hazard in normal industrial use.
SKIN AND EYE CONTACT HEALTH RISKS AND SYMPTOMS OF EXPOSURE:
Skin and eye contact may cause mild to moderate irritation.
SKIN ABSORPTION HEALTH RISKS AND SYMPTOMS OF EXPOSURE:
Skin contact will result in absorption and potentially contribute to the overall exposure to the chemical 2-Butoxy ethanol.
Ethylene glycol can be absorbed through the skin. Skin absorption may contribute to the overall exposure to ethylene glycol.
INGESTION HEALTH RISKS AND SYMPTOMS OF EXPOSURE:
Ingredients in this product are toxic. Ingestion may cause nausea, moderate gastro-intestinal irritation, diarrhea and possible
damage to vital organs. Follow first aid procedures.
HEALTH HAZARDS (ACUTE AND CHRONIC):
This product may cause mild to moderate irritation upon contact with eyes and mild irritation to skin. Ethylene glycol has been
identified as a probable birth defect hazard based on laboratory animal data.
No
CARCINOGENICITY NTP CARCINOGEN:
No
IARC CARCINOGEN:
No
OSHA CARCINOGEN:
MEDICAL CONDITIONS GENERALY AGGRAVATED BY EXPOSURE:
Skin contact may aggravate pre-existing dermatitis.
EMERGENCY AND FIRST AID PROCEDURES:
EYES: Hold eyelids open and flush with water for 15 minutes. Contact physician if irritation persists. SKIN: Wash with soap and
water. INGESTION: If victim is fully conscious, induce vomiting as directed by medical personnel. Seek medical attention
immediately. INHALATION: Move victim to fresh air. Give oxygen if breathing is labored.
SECTION 7: PRECAUTIONS FOR SAFE HANDLING AND USE
STEPS TO BE TAKEN IN CASE MATERIAL IS RELEASES OR SPILLED:
Clean up small spills with soap water and a mop. Large spills should be diked and kept from entering the sewer. Soak up
large spills with absorbent or transfer liquid into a closed container for later disposal.
WASTE DISPOSAL METHOD:
Page 3 of 3
Product Code: B092137 MAJESTA 707
Product may meet the sewer disposal guidelines in many municipalities. Sewer disposal is governed by EPA Regulations
(Clean Water Act) which controls local sewer authorities (POTW). Sewer disposal of spent product may be restricted by
discharge limits for specific chemicals set by the POTW and end of pipe chemical levels of the individual user. Check with
the local POTW before sewer disposing.
PRECAUTIONS TO BE TAKEN IN HANDLING AND STORAGE:
Store in a cool dry area away from sunlight and excess heat. Protect from freezing. When using or transferring this product,
wear proper personal protective equipment.
OTHER PRECAUTIONS/DOT INFORMATION::
DOT Proper Shipping Name: Not Regulated, Hazard Class: N/A, ID No.: N/A, Packing Group: N/A
SECTION 8: CONTROL MEASURES
RESPIRATORY PROTECTION:
No special protection is required under normal conditions of use.
VENTILATION:
No special ventilation required.
PROTECTIVE GLOVES:
Wear solvent resistant gloves made of butyl or nitrile rubber.
EYE PROTECTION:
Wear safety glasses with side shields.
OTHER PROTECTIVE CLOTHING OR EQUIPMENT:
A personal protective rating of X means you must see your supervisor for guidance. OSHA regulations (29CFR Part 1910,
Subpart I) require employers to evaluate Personal Protective Equipment requirements in the workplace.
WORK/HYGIENIC PRACTICES:
Wash with soap and water after product contact with skin.
SECTION 9: DISCLAIMER
The information on this MSDS is believed to be accurate as of the date shown in SECTION 1. Since the use of this product is
not under the control of the manufacturer, it is the user's responsibility to determine what constitutes safe usage for a
particular product. This form may be reproduced in quantities necessary to meet your requirements.