Carter's?Neat-FloTM Stamp Pad Inker
Consumer Information Sheet #92
Date Issued: 2/92
Date Revised: 11/06
Page Number: One of One
_________________________________________________________________________________________
_
Consumer Information Sheet for Carter's?Neat-FloTM Stamp Pad Inker (Black, Red)
This product is labeled in accordance with the chronic hazard labeling standard, ASTM D4236 and is
considered nonhazardous as defined by 29 CFR Part 1910.1200 (c). This product has been evaluated in a
program of toxicological evaluation by a medical expert and certified to be nontoxic. This product does not
contain sufficient quantities of materials to be toxic or injurious to humans or to cause acute or chronic health
problems when used for its normal and intended purpose.
Manufacturer:
Avery Dennison
Office Products North America
Writing Instruments
50 Pointe Drive
Brea, CA 92821
Phone: 1-800-462-8379 (7 am ?7 pm CST M-F)
_________________________________________________________________________________________
_
Hazard Information: The normal and intended use of this product is as a stamping ink and does not include
consumption or skin contact. Adequate ventilation should be provided when using product for extended periods
of time in enclosed areas to avoid breathing any nuisance odors. Hazardous combustion products may be
generated if product is burned; smoke may contain toxic and/or irritating compounds: carbon monoxide,
carbon dioxide, amines, oxides of nitrogen, sulfur oxides.
_________________________________________________________________________________________
_
Storage and Disposal Information: Product should be retained in original, unopened package if being stored
for long periods of time. Product is stable when stored as recommended and will not decompose under normal
conditions. Clean ink spills with absorbent material and dispose of as solid waste in accordance with all federal,
state, and local regulations.
_________________________________________________________________________________________
_
Technical Information: For detailed toxicological and/or ecological data on the individual ink components
contained in this product, write or call the address or phone number shown above.
_________________________________________________________________________________________
_
Disclaimer of Liability: The information contained herein is, to the best of our knowledge and belief, accurate.
However, since the conditions of handling and use are beyond our control, we make no guarantee of results,
and assume no liability for damages incurred by use of this material. All chemicals may present unknown health
hazards and should be used with caution. Although certain hazards are described herein, we cannot guarantee
that these are the only hazards which exist. Final determination of suitability of this material is the sole
responsibility of the user. No representations or warranties, either expressed or implied, of
MERCHANTABILITY, fitness for a particular purpose or any other nature are made hereunder with respect to
the information contained herein or the material to which the information refers. It is the responsibility of the
user to comply with all applicable federal, state, and local laws and regulations.
_________________________________________________________________________________________
_
Consumer Information Sheet #23
Date Prepared: 11/01/94
Last Revision Date: 02/21/92
Office Products North America
Markers and Adhesives
20955 Pathfinder Road
Diamond Bar, CA 91765
Phone: 615-456-8219 (8 am-5 pm CDT M-F)
_________________________________________________________________________________________________________________________
SECTION I PRODUCT IDENTIFICATION
Avery Dennison Product: Stamp Pad Ink
_________________________________________________________________________________________________________________________
SECTION II HAZARDOUS INGREDIENT/IDENTITY INFORMATION
Material Name: CAS #: OSHA PEL (ppm): ACGIH TLV (ppm):
Ethylene Glycol 107-21-1 50 50
All of the chemicals listed above are in compliance with OSHA, CFR, 1910.1200. A finished stamp pad contains a substantially lower percentage by weight
of each chemical and has the ink held within an absorbent material.
_________________________________________________________________________________________________________________________
SECTION III PHYSICAL DATA
o
Boiling Point: 365 F Appearance: Liquid, colored
o
Specific Gravity: 1.04 @ 20 C Odor: Mild odor
o
Vapor Pressure (mmHg): 0.22 @ 20 C Water Solubility: Complete
Vapor Density (Air=1): N/AP Evaporation Rate (Butyl Acetate=1): < 0.01
Melting Point: N/AP
_________________________________________________________________________________________________________________________
SECTION IV FIRE AND EXPLOSION HAZARD DATA
o
Flash Point: 225 F (method used - PMCC) Flammable Limits: N/AP
Extinguishing Media: Foam, carbon dioxide, dry chemical Unusual Hazards: None
Fire Fighting Procedure: Wear self-contained breathing apparatus, use water spray to cool nearby containers
_________________________________________________________________________________________________________________________
SECTION V REACTIVITY DATA
Stability: Yes Conditions to Avoid: N/AP
Incompatibility: Strong oxidizing agents Hazardous Polymerization: Will not occur
Hazardous Decomposition: May form toxic materials, carbon dioxide or carbon monoxide
_________________________________________________________________________________________________________________________
SECTION VI HEALTH HAZARD DATA
Symptoms of Overexposure for each Potential Route of Exposure -
Inhaled: No symptoms expected
Eye Contact: May cause eye irritation
Absorbed through Skin: No evidence of harmful effects
Ingestion: May cause abdominal discomfort or pain, nausea, vomiting, dizziness, drowsiness, central nervous system effects
Health Effects or Risks from Exposure -
Medical Conditions Aggravated by Exposure: Chronic - No Carcinogenic: No
This product contains materials that are listed on the following lists: NTP: No IARC: No OSHA: No
S.A.R.A. Information: This product is not reportable under SARA Title III, Section 313
Toxic Information: Non-toxic per ASTM D-4236
Emergency First Aid Procedures -
Eye Contact: Flush with large amounts of water, if eye irritation occurs, get medical attention
Skin Contact: Thoroughly wash with soap and water
Inhaled: Remove to fresh air, obtain medical attention if symptoms persist
Ingestion: If conscious, give two glasses of water, induce vomiting, and obtain medical attention without delay
_________________________________________________________________________________________________________________________
SECTION VII PRECAUTIONS FOR SAFE HANDLING AND USE
Spill or Leak Procedures: Absorb liquid on paper or other absorbent material, flush with water
Waste Disposal: Dispose of in accordance with local, state, federal regulations
Storage: N/AP
_________________________________________________________________________________________________________________________
SECTION VIII CONTROL MEASURES
Work Practices: Observe ordinary measures of personal hygiene
_________________________________________________________________________________________________________________________
To the best of our knowledge this information is accurate; however, we do not, and cannot, warrant or guarantee its accuracy and cannot be liable for any
damages, consequential or actual which might result from any reliance therein. This MSDS was prepared to comply with the OSHA Hazard Communication
Standard (29 CFR 1910.1200).
N/AP: Not applicable N/E: Not established
|