MSDS Number: 108 WATER BASED CLEAR WOOD FINISH SEMI-... Printing Date: 04/21/2006 Page 1 of 4
Material Safety Data Sheet
For Coatings, Resins and Related Materials
NOTE: CHEMTREC, CANUTEC and National Response Center emergency numbers to be used only in the event of
chemical emergencies involving a spill, leak, fire, exposure or accident involving chemicals
24 Hour Emergency: 1-800-123-4567 CHEMTREC: 1-800-424-9300
National Response in Canada CANUTEC: 613-996-6666
Outside U.S. and Canada Chemtrec: 202-483-7616
Section 1 - Chemical Product / Company Information
WATER BASED CLEAR WOOD FINISH
Product Name: Revision Date: 11/04/2005
SEMI-GLOSS
Rockler SKU: 39171
Identification Number: 108 Print Date: 04/21/2006
Product Use/Class: LACQUER
Manufacturer: Deft, Inc. (CAGE CODE 33461) Information Phone: (949) 474-0400
17451 Von Karman Ave Emergency Phone: (800) 424-9300
Irvine, Ca. 92614
Section 2 - Hazards Identification
*** Emergency Overview ***: Harmful by inhalation, in contact with skin, and if swallowed. Translucent liquid with slight
ammonia odor. Contact with eyes or skin causes irritation.
Effects Of Overexposure - Eye Contact: Direct eye contact may cause irritation. Exposure to liquid, aerosol, or vapors may
cause irritation, tearing, redness, and swelling accompanied by a stinging sensation.
Effects Of Overexposure - Skin Contact: Direct skin contact may cause irritation. Symptoms may include swelling,
redness, and rash. Prolonged and repeated skin contact may cause dermatitis, drying, and defatting due to the solvent
properties.
Effects Of Overexposure - Inhalation: Inhalation may cause headaches, difficult breathing, and loss of consciousness.
Inhalation may cause irritation to the respiratory tract (nose, mouth, mucous membranes) & acute nervous system
depression characterized by the following progressive steps: headache, dizziness, staggering gait, confusion,
unconsciousness, or coma.
Effects Of Overexposure - Ingestion: May result in possible corrosive action in the mouth, stomach tissue and digestive
tract. Vomiting may cause aspiration of the solvent, resulting in chemical pneumonitis. Ingestion may cause gastrointestinal
irritation, abdominal pain, nausea, vomiting and diarrhea.
Effects Of Overexposure - Chronic Hazards: Prolonged contact will cause drying and cracking of the skin, due to defatting
action. Skin sensitization, asthma or other allergic responses may develop. Listed as a Carcinogen: NTP? : No, IARC
Monographs? : No, OSHA regulated? : No.
Primary Route(s) Of Entry: Skin Contact, Inhalation, Eye Contact
Section 3 - Composition / Information On Ingredients
Component CAS Number Weight % Reporting Ranges
DOWANOL DPNB GLYCOL ETHER 29911-28-2 3-7
DIPROPYLENE GLYCOL MONOMETHYL ETHER 34590-94-8 3-7
N-METHYLPYRROLIDONE 872-50-4 1-5
AMMONIUM HYDROXIDE 1336-21-6 0.1-1.0
THE ABOVE LISTED PRODUCTS ARE ON THE TSCA INVENTORY LIST. ALSO ANY UNLISTED INGREDIENTS.
Section 4 - First Aid Measures
First Aid - Eye Contact: Hold eyelids open to rinse out the entire eye. If material gets into eyes, flush with water
immediately for 15 minutes. Consult a physician.
First Aid - Skin Contact: In case of contact, immediately flush skin with plenty of water and wash affected areas
thoroughly with soap and water. Remove contaminated clothing and shoes.
First Aid - Inhalation: In the case of inhalation of aerosol/mist consult a physician, if necessary. Move to fresh air in case of
accidental inhalation of vapors. Asthmatic type symptoms may develop and maybe immediate or delayed by several hours.
First Aid - Ingestion: Do not induce vomiting. Do not give anything to an unconscious person. Obtain medical help.
Section 5 - Fire Fighting Measures
Flash Point (癋): > 212 SETAFLASH LOWER EXPLOSIVE LIMIT (%): 1.1UPPER EXPLOSIVE LIMIT (%): N.D.
Extinguishing Media: Alcohol Foam, Carbon Dioxide, Dry Chemical, Foam, Water Fog
Unusual Fire And Explosion Hazards: Fire or intense heat may cause violent rupture of packages. Remove all sources of
ignition. Keep containers tightly closed. Isolate from heat, sparks, electrical equipment and open flame. Application to hot
RTD20000336AA
MSDS Number: 108 WATER BASED CLEAR WOOD FINISH SEMI-... Printing Date: 04/21/2006 Page 2 of 4
surfaces requires special precautions. Toxic gases may form when product burns.
Special Firefighting Procedures: Cool fire-exposed containers using water spray. In the event of fire, wear self-contained
breathing apparatus. Firefighters should wear full protective clothing.
Section 6 ?Accidental Release Measures
Steps To Be Taken If Material Is Released Or Spilled: Evacuate all non-essential personnel. Remove all sources of ignition.
Ventilate area. Contain and remove spilled material with inert absorbent and non-sparking tools. Use personal protective
equipment as necessary.
Section 7 - Handling and Storage
Handling: Use only in ventilated areas. Open doors and windows. Handle in accordance with good industrial hygiene and
safety practice. Keep product and empty containers away from heat, hot surfaces, open flame, and other sources of ignition.
Storage: Keep containers upright to prevent leakage and tightly closed in a dry, cool and well-ventilated place. Avoid
storing near high temperatures, fire, open flames, and spark sources. Store in buildings designed to comply with OSHA
1910.106.
Section 8 - Exposure Controls / Personal Protection
Component ACGIH TLV ACGIH STEL OSHA PEL OSHA STEL
DOWANOL DPNB GLYCOL ETHER N.E. N.E. N.E. N.E.
DIPROPYLENE GLYCOL 100 ppm 150 ppm 100 ppm 150 ppm
MONOMETHYL ETHER
N-METHYLPYRROLIDONE N.E. N.E. N.E. N.E.
AMMONIUM HYDROXIDE 25 ppm N.E. 25 ppm N.E.
Notes
DIPROPYLENE GLYCOL MONOMETHYL ETHER CAS# 34590-94-8 has been shown to cause minor effects in the liver and kidneys of animals.
N-METHYLPYRROLIDONE, CAS # 872-50-4, estimated TLV TWA 100 ppm. (Per GAF Corporation)
Engineering Controls: Local ventilation of emission sources may be necessary to maintain ambient concentrations below
permissible OSHA exposure limits. Remove all ignition sources (heat, sparks, flame, and hot surfaces).
Respiratory Protection: A respirator that is recommended or approved for use in an organic vapor environment (air
purifying or fresh air supplied) is necessary. Observe OSHA regulations for respirator use. Ventilation should be provided
to keep exposure levels below the OSHA permissible limits.
Skin Protection: Chemical-resistant gloves (cotton, neoprene, rubber, polyethylene) should be used to prevent skin contact.
Eye Protection: Wear safety eyewear (safety glasses, safety glasses with side-shields, chemical goggles, or face shields) to
prevent eye contact.
Other protective equipment: Long sleeve and long leg clothing is recommended. Remove and wash contaminated clothing
before reuse or discard.
Hygienic Practices: Wash hands before breaks, eating, smoking, and at the end of the workday.
Section 9 - Physical and Chemical Properties
Boiling Range (癋): 212 - N.D. Vapor Density: Heavier than air
Odor: Slight ammonia odor Odor Threshold: N.D.
Appearance: Translucent liquid Evaporation Rate: 0.0 x n-Butyl Acetate
Solubility in H2O: Soluble
Freeze Point: N.D. Specific Gravity: 1.033
Vapor Pressure: N.D. PH: N.D.
Physical State: Liquid Viscosity: Thin liquid to heavy
viscous material
(See section 16 for abbreviation legend)
Section 10 - Stability and Reactivity
Conditions To Avoid: Avoid high temperatures, sparks, or open flames. Do not breathe vapors or spray mist.
Incompatibility: Incompatible with oxidizing agents.
Hazardous Decomposition: Thermal decomposition can lead to the generation and release of gases and vapors including
carbon monoxide, carbon dioxide, oxides of nitrogen, and hydrocarbons.
Hazardous Polymerization: Will not occur.
Stability: Stable under recommended storage conditions.
Section 11 - Toxicological Information
Product LD50: N.E. Product LC50: N.E.
Section 12 - Ecological Information
Ecological Information: No Information.
Section 13 - Disposal Information
Disposal Information: Dispose of waste in accordance with federal, state, and local environmental regulations. Empty
MSDS Number: 108 WATER BASED CLEAR WOOD FINISH SEMI-... Printing Date: 04/21/2006 Page 3 of 4
containers will contain product residue and flammable vapors. Handle as hazardous material. Do not incinerate closed
containers. EPA Hazardous Waste Number/Code: D001, F003, F005. Hazardous Waste Characteristics: Ignitability and
Reactivity.
Section 14 - Transportation Information
DOT Proper Shipping Name: Consumer Commodity Packing Group: N.A.
DOT Technical Name: N.A. Hazard Subclass: N.A.
DOT Hazard Class: ORM-D Resp. Guide Page: N.A.
DOT UN/NA Number: N.A.
Section 15 - Regulatory Information
CERCLA ?SARA Hazard Category
This product has been reviewed according to the EPA `Hazard Categories' promulgated under Sections 311and 312 of the
Superfund Amendment and Reauthorization Act of 1986 (SARA Title III) and is considered, under applicable definitions, to
meet the following categories: IMMEDIATE HEALTH HAZARD, FIRE HAZARD
SARA Section 313:
This product contains the following substances subject to the reporting requirements of Section 313 of Title III of the
Superfund Amendment and Reauthorization Act of 1986 and 40 CFR part 372:
Component CAS Number Percent By Weight
N-METHYLPYRROLIDONE 872-50-4 1.94
AMMONIUM HYDROXIDE 1336-21-6 0.20
Toxic Substances Control Act:
This product contains the following chemical substances subject to the reporting requirements of TSCA 12(B) if exported
from the United States:
Component CAS Number
DIPROPYLENE GLYCOL MONOMETHYL ETHER 34590-94-8
N-METHYLPYRROLIDONE 872-50-4
U.S. State Regulations: As follows ?br>
New Jersey Right-to-Know:
The following materials are non-hazardous, but are among the top five components in this product.
Component CAS Number
WATER 7732-18-5
ACRYLIC COPOLYMER PROPRIETARY
Pennsylvania Right-to-Know:
The following non-hazardous ingredients are present in the product at greater than 3%.
Component CAS Number
WATER 7732-18-5
ACRYLIC COPOLYMER PROPRIETARY
California Proposition 65:
Warning: The following ingredients present in the product are known to the state of California to cause Cancer:
Component CAS Number
ACRYLIC COPOLYMER PROPRIETARY
Warning: The following ingredients present in the product are known to the state of California to cause birth defects, or
other reproductive hazards.
Component CAS Number
N-METHYLPYRROLIDONE 872-50-4
International Regulations: As follows ?br>
CANADIAN WHMIS: This MSDS has been prepared in compliance with Controlled Product Regulations except for the
use of the 16 headings.
CANADIAN WHMIS CLASS: N.A.
Section 16 - Other Information
HMIS Ratings:
Health: 2 Flammability: 1 Reactivity: 0 Personal Protection: G
VOLATILE ORGANIC COMPOUNDS, GR/LTR: 274.1
VOLATILE ORGANIC COMPOUNDS, LB/GAL: 2.3
VOLATILE ORGANIC COMPOUNDS MIXED, GR/LTR: <= N.D.
MSDS Number: 108 WATER BASED CLEAR WOOD FINISH SEMI-... Printing Date: 04/21/2006 Page 4 of 4
VOLATILE ORGANIC COMPOUNDS MIXED, LB/GAL: <= N.D.
REASON FOR REVISION: New Computer System. Information in Sections 2, 5, 7, 14, 15, and 16 have been updated.
REGULATORY CODE: 108
LAYOUT CODE: A2004R
Legend: N.A. - Not Applicable, N.E. - Not Established, N.D. - Not Determined
The information contained on this MSDS has been checked and should be accurate. However, it is the responsibility of the
user to comply with all Federal, State, and Local laws and regulations.
|