Material Safety Data Sheet
Professional Coatings, Inc.
100 Commerce Park Drive
Cabot, AR 72023
HMIS
Date of Preparation: January 1, 2007 Health 1
Prepared By: Steven E. Mitchell Flammability 1
Telephone Number: 1-800-962-0344 Reactivity 0
SECTION 1. PRODUCT IDENTIFICATION
Product Name: PRO-COAT?PREMIUM H2 OIL
Product Class: Polyurethane Aqueous Dispersion
SECTION 2. HAZARDOUS INGREDIENTS
INGREDIENT CAS NO. % WT ACGIH-TLV OSHA-PEL VAPOR PRESSURE
Mm Hg
1-Triethylamine: 121-44-8 1-5 Not Established 100 PPM .29 @ 20 C
N-Methyl-2-Pyrrolidone 872-50-4 1-5 Not Established
Dipropylene Glycol 34590-94-8 <1 100 PPM 8 hours
Methyl Ether
SECTION 3. PHYSICAL DATA
Evaporation Rate: Slower Than Ether Boiling Range: 192-396 F
Vapor Density: Heavier Than Air
Boiling Range: 192-396 ?F
% Volatile Weight: 66
WT/GAL: 8.68 lbs.
SECTION 4. FIRE AND EXPLOSION HAZARD DATA
Flammability Classification: OSHA Combustible Liquid Class III B DOT Not Regulated
Flash Point: Over 200 F Pensky-Martens CC LEL: 1.2% (TEA)
Extinguishing Media: Carbon dioxide, dry chemical, water fog.
Unusual Fire and Explosion Hazards:
Material will not support combustion unless the water has evaporated.
SECTION 5. HEALTH HAZARD DATA
Effects of Overexposure:
Eye Contact: May cause severe irritation.
Inhalation: May cause irritation to nose, throat or lungs.
Skin: May cause irritation.
Ingestion: May be harmful if swallowed.
1
Chronic Health Effects:
Human experience has demonstrated redness, cracking and blistering of skin through repeated and prolonged
contact with N-Methyl Pyrrolidone. NMP is reported to be fetotoxic and teratogen by dermal but not inhalation
exposure.
Medical Conditions Prone to Aggravation by Exposure: None known
Primary Route(s) of Entry: Dermal, eye contact, inhalation.
Emergency and First Aid Procedures:
Eyes: Flush immediately with copious quantities of running water for a least 15 minutes. Consult
physician.
Skin: Wash affected areas with soap and water.
Ingestion: Consult physician.
Inhalation: Remove to fresh air.
Note: The health effects of this product have not been tested. This information is based on the hazards of its
components.
Rats exposed to an aerosol-vapor mixture of NMP at 1.0 mg/1 for 6 hr/days/week for 4 weeks developed excessive
mortality, focal pneumonia, bone marrow hypoplasia and atrophy of lymphoid tissue.
Toxicity:
N-Methly Pyrrolidone: May cause severe eye irritation. Prolonged exposure may cause skin
irritation. LD, oral-rat: 4200 mg/kg.
LD, skin-rabbit: 8000 mg/kg
Teratogenic effects: Male and female rats exposed orally to 500 mg/kg/day in feed for 10 weeks
before mating and throughout pregnancy, fetolethality. In earlier study, 300
mg/kg/day was a clear no effects level.
N,N-Dimethyl Ethanolamine: Primary irritant of mucous membranes and eyes.
Toxic by ingestion and skin absorption.
LD, oral-rat: 2 g/kg.
LD, skin rabbit: 1370 mg/kg.
LCLo, Inhalation-rat: 1641 ppm/4H.
Note: No constituents are listed as carcinogens by NTP, LARC or OSHA.
SECTION 6. REACTIVITY DATA
Stability: Stable
Hazardous Polymerization: Will not occur.
Hazardous Decomposition Products: Normal combustion products including carbon dioxide, carbon
monoxide, and oxides of nitrogen.
Conditions to Avoid: None known.
Incompatibility (Material to Avoid): Strong oxidizers.
2
SECTION 7. SPILL OR LEAK PROCEDURES
Steps to be Taken in Case Material is Released or Spilled:
Ventilate area. Remove sources of spark or flame. Remove with inert absorbent.
Waste Disposal:
Dispose in accordance with local, state, and federal regulations. This product is not a hazardous waste under
RCRA regulations (40 CFR 261).
SECTION 8. SAFE HANDLING AND USE INFORMATION
Respiratory Protection:
If exposed to spray mists exists, wear NOSH- approved organic vapor/particulate respirator. In case of poor
ventilation, use NOSH- approved organic vapor mask.
Ventilation:
Sufficient to keep vapor concentration below limits in Section II.
Protective Gloves:
Protective gloves required for direct contact.
Eye Protection:
Safety goggles.
Other Protective Equipment:
No special requirements.
SECTION 9. SPECIAL PRECAUTIONS
Precautions to be Taken in Handling:
Do not get in eyes.
Other Precautions:
Do not take internally. Avoid prolonged or repeated contact with skin. Avoid breathing vapors.
SECTION 10. FOR YOUR PROTECTION
Important Notice to Purchaser. The information in this publication is based on tests that we believe are reliable. Your results may vary
due to differences in test types and conditions. You must evaluate and determine whether the product is suitable for you intended
application. Professional Coatings, Inc. exclusive warranty is as follows: If Pro-Coat products are proved defective, the user's exclusive
remedy will be, at Pro-Coat's option, to replace the defective Pro-Coat product or to refund the purchase price for the defective quantity.
Except for the replacement or refund remedies, Pro-Coat is not liable for direct damages or liable for indirect, incidental or consequential
damages, regardless of the legal theory asserted, including negligence and strict liability.
3
|