Waterlox Coatings Corporation
9808 Meech Avenue 鈥? Cleveland, OH 44105
Phone: 216.641.4877 鈥? Fax: 216.641.7213
www.waterlox.com
Waterlox Original
Marine Finish
(Exterior Grade)
Description Coverage
Waterlox Original Marine Finish is a clear, high One gallon of Waterlox Original Marine Finish covers 400
gloss finish coat, which penetrates wood square feet per gallon per coat. Thinning is not necessary.
enabling it to resist moisture, the harmful UV rays
of the sun, salt and fresh water exposure, and Recoatability
heat and cold. Once the gloss level of the film begins to fade it is time to re-coat
the surface. Sanding down to bare wood is not necessary. Simply
Uses clean the surface and recoat with more Waterlox Original Marine
Waterlox Original Marine Finish is recommended Finish and allow to dry.
for all exterior wood surfaces as a finish coat,
such as marine furniture, paneling, all boat Dry Time
woodwork, exterior furniture, doors, railings, fences and decks. After each coat has been applied, allow to air dry for 6-24 hours, or
When used in combination with Waterlox Original Sealer/Finish, until tack-free. Dry time depends on temperature, ventilation and
Waterlox Original Marine Finish renders a hand-rubbed humidity. For best results apply when temperatures are over 60掳F,
appearance in a high gloss sheen. and when humidity is relatively low. Dry time will increase due to
low temperatures or high humidity.
Preparation of Surfaces
Apply to a small test area and allow to dry prior to applying to the Clean Up/Storage
entire surface. Final color effect is always influenced by the grain, Use mineral spirits or turpentine to clean tools, equipment,
texture, porosity, species of wood, number of coats and by method applicators and spills. Then wash with warm soapy water.
of application.
Transfer unused Waterlox Original Marine Finish to smaller tightly
Strip previously finished surfaces to bare wood. Where not possible sealed jars or raise the level in the original container by adding
to strip all wood, Waterlox Original Sealer/Finish can be used as a clean marbles or stones. This is to prevent the potential jelling of
primer/tie-coat. If the previous finish is a urethane or unknown, the contents due to air exposure within the can.
finish must be abraded before application. Sand the surface well
and wipe clean with a tack cloth or cloth dampened with paint Cautions
thinner. Do not use over wax. To avoid spontaneous combustion during
temporary storage, soak soiled rags and waste immediately after
Application use in a water-filled, closed metal container. For MSDS
Application methods include lambswool, brush, roller, or cloth. information, visit our website at www.waterlox.com.
Sanding between coats is not necessary for adhesion purposes, for
aesthetic reasons, you can perform a light sanding with fine
sandpaper, steel wool (0000) or buff with a 3M庐 white pad.
Staining with Waterlox
Stain can be added to your first coat of Waterlox Original
Sealer/Finish. You can add up to 1 quart of oil-based stain to 1 DANGER! CONTAINS MINERAL SPIRITS. COMBUSTIBLE LIQUID
gallon of Waterlox Original Sealer/Finish. We recommend you use AND VAPOR. HARMFUL OR FATAL IF SWALLOWED. USE WITH
ADEQUATE VENTILATION. KEEP OUT OF REACH OF CHILDREN.
an old-fashioned oil-based stain (without additives such as
urethane).
Waterlox Tung Oil Penetrates 路 No Sanding Necessary for Adhesion 路 Great for use with Exotics 路
Protects against moisture, heat/cold, household chemicals 路 Very easy to apply, maintain & re-coat
Visit us on the web at www.waterlox.com for more information
|