Page 1 of 2
MATERIAL SAFETY DATA SHEET
Manufacturer's Name: Transportation Emergencies: NPCA Hazardous Materials Identification System
Rating Identification
Call Chemtrec 4=EXTREME HEALTH 2
1-800-424-9300 3=HIGH FLAMMABILITY 0
Masterchem庐Industries, Inc. 2=MODERATE REACTIVITY 0
Emergency Telephone No.
3135 Old Hwy M 1-SLIGHT CHRONIC HEALTH See Section V
1-800-325-3552 0=MINIMAL
Imperial, MO 63052
Medical Emergencies:
1-866-303-6951
Section I - Product Identification
Hammerite庐 Galvanized & Aluminum Primer
PRODUCT NAME:
PRODUCT NUMBER: 48301
PRODUCT CLASS: Water Reducible Coating
___________________________________________________________________________________________________________________________
SECTION II A-HAZARDOUS INGREDIENTS
CAS %W CHEMICAL NAME(S) OCCUPATIONAL VAPOR PRESSURE LISTED AS A
REGISTRY EXPOSURE LIMITS CARCINOGEN
NO.
TLV PEL
107-21-1 2.73 Ethylene Glycol 50 ppm 50 ppm No
0.12 mm Hg @ 25掳 C
112-34-5 2.75 Diethylene Glycol N.E N.E - No
Monobutyl Ether
SECTION II B 鈥? OTHER INGREDIENTS
25586-20-3 50-60 Styrene/Acrylate Dispersion - - - No
7732-18-5 5-15 Water - - - No
13463-67-7 5-15 Titanium Dioxide - - - No
1314-13-2 1-5 Zinc Oxide - - - No
1313-27-5 1-5 Zinc Phosphate - - - No
SECTION III - PHYSICAL DATA
APPEARANCE: Grey, Medium Viscosity Liquid ODOR: Mild, Sweet Acrylic
VAPOR DENSITY: 鈱? HEAVIER " LIGHTER THAN AIR
BOILING RANGE: 212掳 F
EVAPORATION RATE: " FASTER 鈱? SLOWER THAN ETHER 57.05% VOLATILE VOLUME: 10.72 POUNDS WT/GAL
SECTION IV - FIRE AND EXPLOSION HAZARD DATA
FLAMMABILITY CLASSIFICATION: None FLASH POINT: N/A LEL: N/A DOT: Not Required
EXTINGUISHING MEDIA:
DRY CHEMICAL 鈱? ALCOHOL FOAM 鈱? WATER FOG 鈱? FOAM 鈱? CO2 鈱? OTHER "
UNUSUAL FIRE AND EXPLOSION HAZARDS: This product will not burn, however dried primer film will support combustion.
SPECIAL FIREFIGHTING PROCEDURES: Firefighters and others exposed to products of combustion should wear self-contained breathing
apparatus and full protective clothing. Use water to keep fire-exposed containers cool to reduce pressure.
SECTION V - HEALTH HAZARD DATA
EFFECTS OF OVEREXPOSURE: Inhalation: May cause irritation to upper respiratory tract. Splash (Eyes): Can cause irritation, burning and
redness. Splash (Skin): Prolonged or repeated may cause minor irritation. Ingestion: Gastrointestinal distress, vomiting and diarrhea may result.
Galvanized & Aluminum Primer.doc
Page 2 of 2
PRIMARY ROUTE(S) OF ENTRY:
DERMAL 鈱? INHALATION 鈱? INGESTION 鈱?
EMERGENCY AND FIRST AID PROCEDURES: Inhalation: Remove to fresh air. Restore breathing. Treat symptomatically. Consult a physician.
Splash (eyes): Flush immediately with large amounts of water for at least 15 minutes. Take to physician for medical treatment. Splash (skin); Wash
affected areas with soap and water. Remove contaminated clothing. Consult a physician if irritation persists. Ingestion: Drink 1 or 2 glasses of water to
dilute. Do not induce vomiting. Consult physician or poison control center immediately. Treat symptomatically.
SECTION VI - REACTIVITY DATA
UNSTABLE " STABLE 鈱?
STABILITY:
MAY OCCUR " WILL NOT OCCUR 鈱?
HAZARDOUS POLYMERIZATION:
HAZARDOUS DECOMPOSITION PRODUTS: May produce fumes when heated to decomposition, as in welding or fire. Fumes may contain:
carbon monoxide, carbon dioxide, hydrocarbons and other products of combustion.
CONDITIONS TO AVOID: Temperature extremes.
INCOMPATIBILITY: (MATERIALS TO AVOID) Water-reactive materials.
SECTION VII - SPILL OR LEAK PROCEDURES
STEPS TO BE TAKEN IN CASE MATERIAL IS RELEASED OR SPILLED: Limit spread of spill or leak. Ventilate area. Soak up with inert
absorbent material and transfer to closed containers. See Section VIII for required protective measures. Keep material out of sewers and/or drains.
WASTE DISPOSAL METHOD: Dispose of in accordance with all local, state and federal regulations. Dry product and empty containers may be
landfilled. Full or partially full containers should be dried or coagulated with the liquid portion poured off. Coagulated material should be dried before
landfilling. Product may also be incinerated.
SECTION VIII-SAFE HANDLING AND USE INFORMATION
RESPIRATORY PROTECTION: If you experience eye watering, headaches or dizziness, increase fresh air or wear respiratory protection
(NIOSH/MSHA TC 23C or Equivalent) or leave the area.
VENTILATION: Ventilation of sufficient volume and pattern should be provided to keep air contaminant concentrations below occupational exposure.
Local exhaust ventilation required when applying in a confined area.
PROTECTIVE GLOVES: Required, rubber or neoprene to prevent skin contact.
EYE PROTECTION: Use safety eyewear including splash guards or side shields.
OTHER PROTECTIVE EQUIPMENT: Wear protective clothing. Remove and wash contaminated clothing before re-use.
HYGIENIC PRACTICES: Wash hands before eating or using the washroom. Smoke in smoking areas only.
SECTION IX - SPECIAL PRECAUTIONS
PRECAUTIONS TO BE TAKEN IN HANDLING AND STORING: Store in accordance with OSHA 1910.106. Store in a cool, dry, well ventilated
area. Protect from freezing. Frozen product may coagulate and become unusable.
OTHER PRECAUTIONS: DO NOT TAKE INTERNALLY. Avoid prolonged contact with skin. Keep closure tight and container upright to prevent
leakage. Do not store near heat, sparks, or open flame. Keep out of eyes. Do not breathe spray mist. Avoid contact with or breathing of vapors released
during curing process. Never use welding or cutting torch on or near drum (even empty). Keep out of reach of children.
DISCLAIMER OF EXPRESSED AND IMPLIED WARRANTIES
The information contained herein is based on data considered accurate. However, no warranty is expressed or implied regarding the accuracy
of this data or the results to be obtained from the use thereof. The product is no more hazardous than its component parts pursuant to 29CFR
1910.1200 (D). The technical information on this MSDS sheet is based upon information submitted by manufacturers and additional
information furnished by distributor's chemical suppliers and manufacturers. Vendor assumes no responsibility for injury to vendee or third
persons proximately caused by the material if reasonable safety procedures are not adhered to as stipulated in the data sheet. Additionally,
vendor assumes no responsibility for injury to vendee or third persons proximately caused by abnormal use of the material even if reasonable
safety procedures are followed. Furthermore, vendee assumes the risk in his use of the material.
PREPARED BY: Mr. William R. Benton DATE PREPARED: May 7, 2003
NAME AND TITLE: W.R. Benton, MSDS Coordinator SUPERSEDES: August 18, 1999 Grey G&AP
(Signature Available upon Request)
Galvanized & Aluminum Primer.doc
|