MATERIAL SAFETY DATA SHEET
VETMEC ANTIPARASITIC CATTLE INJECTION
Version: Feb 2005 (Prepared by Chemwatch 5028-75) Page 1 of 6
------------------------------------------------------------------------------------------------------
COMPANY DETAILS
Company Chemvet Australia Pty Ltd
Address: 1 / 8 Rocklea Drive, Port Melbourne, VIC 3207
Phone No: 1800 243683
Web: www.chemvet.com.au
STATEMENT OF HAZARDOUS NATURE
HAZARDOUS ACCORDING TO WORKSAFE AUSTRALIA CRITERIA
IDENTIFICATION
CAS RN No(s): None
UN Number: None
Dangerous Goods Class: None
Subsidiary Risk: None
Hazchem Code: None
Poisons Schedule Number: S5
USE Subcutaneously administered Cattle endectocide
PHYSICAL DESCRIPTION / PROPERTIES
APPEARANCE Clear colourless slightly viscous non-aqueous liquid. No
odour. Mixes with water.
Boiling Point (deg C): Not available
Melting Point (deg C): Not available
Vapour Pressure (kPa): Not available
Specific Gravity: 1.054 @ 20 C.
Flash Point (deg C): 101 (CC)
Lower Explosive Limit (%): Not available
Upper Explosive Limit (%): Not available
Solubility in Water (g/L): Miscible
CHEMVET AUSTRALIA PTY LTD 1800 243 683
MATERIAL SAFETY DATA SHEET
VETMEC ANTIPARASITIC CATTLE INJECTION
Version: Feb 2005 (Prepared by Chemwatch 5028-75) Page 2 of 6
------------------------------------------------------------------------------------------------------
INGREDIENTS
Name CAS RN %
Excipient Carrier- Non hazardous 99
Abamectin 71751-41-2 10.0 g/L
NOTE: Manufacturer has supplied full ingredient information to allow
CHEMWATCH assessment.
HEALTH HAZARD
ACUTE HEALTH EFFECTS
SWALLOWED
Considered an unlikely route of entry in commercial/industrial environments.
The liquid is mildly discomforting if swallowed and may be harmful if swallowed in
large quantity.
Abamectin and analogues have been used therapeutically at low dose rates.
EYE
The liquid may produce eye discomfort causing transient smarting, blinking.
SKIN
Not considered to cause discomfort through normal use.
The liquid is mildly discomforting and may even cause skin reactions if contact is
prolonged and it is absorbed by skin.
Open cuts, abraded or irritated skin should not be exposed to this material.
INHALED
Not normally a hazard due to non-volatile nature of product.
CHRONIC HEALTH EFFECTS
Primary route of exposure is usually by skin contact with the material.
As with any chemical product, contact with unprotected bare skin; inhalation of
vapour, mist or dust in work place atmosphere; or ingestion in any form, should be
avoided by observing good occupational work practice.
The low concentration of abamectin in the product means general low risk resulting
from exposure. Needle stick injury presents low risk but accidental injection requires
medical attention.
Overexposure to abamectin may result in decreased activity, slow rate of breathing,
dilation of the pupils, muscle tremors and incoordination.
CHEMVET AUSTRALIA PTY LTD 1800 243 683
MATERIAL SAFETY DATA SHEET
VETMEC ANTIPARASITIC CATTLE INJECTION
Version: Feb 2005 (Prepared by Chemwatch 5028-75) Page 3 of 6
------------------------------------------------------------------------------------------------------
FIRST AID
SWALLOWED
If poisoning occurs, contact a doctor or Poisons Information Centre.
If swallowed, and if more than 15 minutes from a hospital:
1. INDUCE vomiting with IPECAC SYRUP, or fingers down the back of the throat,
ONLY IF CONSCIOUS. Lean patient forward or place on left side (head-down
position, if possible) to maintain open airway and prevent aspiration. NOTE: Wear
a protective glove when inducing vomiting by mechanical means.
2. REFER FOR MEDICAL ATTENTION WITHOUT DELAY.
3. In the mean time, qualified first-aid personnel should treat the patient following
observation and employing supportive measures as indicated by the patient's
condition.
4. If the services of a medical officer or medical doctor are readily available, the
patient should be placed in his/her care and a copy of the MSDS should be
provided. Further action will be the responsibility of the medical specialist.
5. If medical attention is not available on the worksite or surroundings send the
patient to a hospital together with a copy of the MSDS.
EYE
If this product comes in contact with the eyes:
1. Immediately hold the eyes open and wash with fresh running water.
2. Ensure complete irrigation of the eye by keeping eyelids apart and away from eye
and moving the eyelids by occasionally lifting the upper and lower lids.
3. If pain persists or recurs seek medical attention.
4. Removal of contact lenses after an eye injury should only be undertaken by skilled
personnel.
SKIN
If product comes in contact with the skin:
1. Wash affected areas thoroughly with water (and soap if available).
2. Seek medical attention in event of irritation.
INHALED
1. If fumes or combustion products are inhaled: Remove to fresh air.
2. Lay patient down. Keep warm and rested.
3. If breathing is shallow or has stopped, ensure clear airway and apply resuscitation,
preferably with a demand valve resuscitator, bag-valve mask device, or pocket
mask as trained. Perform CPR if necessary.
4. Transport to hospital, or doctor.
ADVICE TO DOCTOR
Treat symptomatically.
CHEMVET AUSTRALIA PTY LTD 1800 243 683
MATERIAL SAFETY DATA SHEET
VETMEC ANTIPARASITIC CATTLE INJECTION
Version: Feb 2005 (Prepared by Chemwatch 5028-75) Page 4 of 6
------------------------------------------------------------------------------------------------------
PRECAUTIONS FOR USE
EXPOSURE STANDARDS
None assigned. Refer to individual constituents.
Abamectin:
CEL TWA: 0.4 mg/m3
The recommended exposure standard and a wipe test criteria of 0.4 mg/cm2
were obtained using a derived acceptable daily intake (ADI) of 0.4 mg/day.
ENGINEERING CONTROLS
None required when handling small quantities.
PERSONAL PROTECTION
EYE
Safety glasses with side shields; or as required, Chemical goggles.
Contact lenses pose a special hazard; soft lenses may absorb irritants and
all lenses concentrate them.
HANDS/FEET
Wear chemical protective gloves. eg. PVC gloves with barrier cream
Wear safety footwear.
OTHER
1. Overalls.
2. Eyewash unit.
RESPIRATOR
None Required
SAFE HANDLING
STORAGE AND TRANSPORT
SUITABLE CONTAINER
100 ml, 250 ml and 500 ml HDPE pillow packs in a cardboard outer.
STORAGE INCOMPATIBILITY
CHEMVET AUSTRALIA PTY LTD 1800 243 683
MATERIAL SAFETY DATA SHEET
VETMEC ANTIPARASITIC CATTLE INJECTION
Version: Feb 2005 (Prepared by Chemwatch 5028-75) Page 5 of 6
------------------------------------------------------------------------------------------------------
Avoid contamination of water, foodstuffs, feed or seed. Keep out of reach of children.
and avoid storage with oxidisers.
STORAGE REQUIREMENT
Protect from light. Store below 30 deg. C.
1. Store in original containers.
2. Keep containers securely sealed.
3. Store in a cool, dry, well-ventilated area.
4. Store away from incompatible materials and foodstuff containers.
5. Protect containers against physical damage and check regularly for leaks.
6. Observe manufacturer's storing and handling recommendations.
TRANSPORTATION
No restrictions.
SPILLS AND DISPOSAL
MINOR SPILLS
Clean up all spills immediately. Avoid contact with skin and eyes.
Wipe up and absorb small quantities with vermiculite or other absorbent
material. Place in suitable containers for disposal.
MAJOR SPILLS
1. Clean up all spills immediately.
2. Secure load if safe to do so.
3. Bundle/collect recoverable product.
4. Collect remaining material in containers with covers for disposal. Prevent by any
means spillage from entering drains or water-courses. Wipe up and absorb small
quantities with vermiculite or other absorbent material. Place in suitable
containers for disposal.
DISPOSAL
Recycle wherever possible. Consult manufacturer for recycling options. Incinerate
residue at an approved site. Or Dispose of empty container by wrapping with paper
and dispose in garbage. Discarded needles should be immediately placed in
designated and labelled " Sharps " disposal container.
FIRE/EXPLOSION HAZARD
1. The material is not readily combustible under normal conditions.
2. However, it will breakdown under fire conditions and the organic component may
burn.
3. Not considered to be a significant fire risk.
4. Heating may cause expansion and violent bursting - rupture of containers.
5. In fire may emit acrid smoke, i.e. acrolein. Other combustion products include
carbon dioxide (CO2), carbon monoxide (CO).
CHEMVET AUSTRALIA PTY LTD 1800 243 683
MATERIAL SAFETY DATA SHEET
VETMEC ANTIPARASITIC CATTLE INJECTION
Version: Feb 2005 (Prepared by Chemwatch 5028-75) Page 6 of 6
------------------------------------------------------------------------------------------------------
CONTACT POINTS
AUSTRALIAN POISONS INFORMATION CENTRE
24 HOUR SERVICE 13 11 26
POLICE OR FIRE BRIGADE :- 000 (exchange):-1100
NEW ZEALAND POISONS INFORMATION CENTRE
Dunedin (03)479 1200 (Normal Hours) (03)474 0999 (Emergency)
CHEMVET AUSTRALIA PTY LTD 1800 243 683
|