Material Safety Data Sheet U.S. Department of Labor
May be used to comply with OSHA's Hazard Occupational Safety and Health Administration
Communication Standard, 29 CFR 1910 1200. Standard (Non-Mandatory Form)
must be consulted for specific requirements. Form Approved
OMB No. 1218-0072
IDENTITY (as Used on Label and List) Note: Blank spaces are not permitted. If any item is not
applicable or no information is available, the space
RodoTrak
must be marked to indicate that.
fluorescent agent, CAS# 7128-64-5
Section I
Manufacturer's name Emergency Telephone Number
RodoTrak 1-800 424-9300
Address (Number, Street, City, State and ZIP Code) Telephone Number for Information
1-866-763-6875
Date Prepared
PO Box 735 01/29/2008
Signature of Preparer (optional)
Redding, CT 06896
Section II--Hazardous Ingredients/Identity Information
Hazardous Components Specific Chemical Identity, Common Other Limits
Name(s) OSHA PEL ACGIH TLV Recommended % (optional)
None Known
Not Not
Trade secret None
Established Established
Section III--Physical/Chemical Characteristics
Boiling Point Specific Gravity (H20 = 1)
Not Applicable 1.26
Vapor Pressure (mm Hg) Freezing/Melting Point
~2 x 10(-10) mmHg @ 20C 196-203C (385-397F)
Vapor Density (AIR = 1) Evaporation Rate (Butyl Acetate = 1)
Not Applicable Not Applicable
Solubility in Water
<0.01 % at 20C (68F)
Appearance and Odor
Yellow/white Crystalline Powder; Odorless
Section IV--Fire and Explosion Hazard Data
Flash Point (Method Used)
>662F (> 350C) (Marcusson)
Extinguishing Media
Carbon Dioxide, dry chemical, foam, water mist.
Unusual Fire and Explosion Hazards
The product can form an explosive dust/air mixture. Avoid dust formation and control
ignition sources. Employ grounding, venting and explosion relief provisions in accord with accepted engineering
practices in process operations capable of generating dust and/or static electricity.
Fire Fighting Instructions
Use self-contained breathing apparatus.
Section V--Reactivity Data
Chemical Stability
Stable
Incompatibility (Materials to Avoid)
Strong oxidizing agents
Hazardous Decomposition or Byproducts
Thermal decomposition and burning may produce carbon monoxide, carbon
dioxide, nitrogen oxides, sulfur oxides, and other toxic compounds.
Hazardous Polymerization Will not occur
Copyright RodoTrak
* Some items on this MSDS may be designated as Trade Secrets. Bonafide requests for disclosure of Trade Secret
information must be made in accordance with the provisions contained in 29 CFR 1910.1200 I 1-13.
Section VI--Health Hazard Data
Route(s) of Entry
Dermal, inhalation, ingestion
Health Hazards (Acute and Chronic)
This product presents little or no immediate hazard to people if spilled or released.
Carcinogenicity NTP? OSHA Regulated?
None Non toxic No
Signs and Symptoms of Exposure
None known
Medical Conditions Generally Aggravated by Exposure
None known
Emergency and First Aid Procedures
Swallowing:
If swallowed, give at least 3-4 glasses of water, but do NOT induce vomiting. Do not give anything by
mouth to an unconscious or convulsing person.
Skin:
Following skin contact, wipe away excess material with a dry towel. Then wash affected areas with plenty of
water and soap, if available, for several minutes. Get medical attention if irritation occurs.
Inhalation:
If inhaled, remove from area to fresh air. Get medical attention if irritation develops or if breathing
becomes difficult.
Eye:
Following eye contact, flush eyes with plenty of water for several minutes. Get medical attention if irritation
occurs.
Section VII--Precautions for Safe Handling and Use
Steps to Be Taken in Case Material Is Released or Spilled
(The following applies to the chemical in bulk use only. The
RodoTrak stations use very small quantities.) Sweep or shovel spilled material and place in a sealable
container. Pre-wet the material to prevent dust buildup. Dispose in accordance with federal, state and local
regulations. This product is not a hazardous waste under RCRA and presents little or no immediate hazard to
people if spilled or released.
Waste Disposal Method
Dispose in accordance with federal, state and local regulations.
Precautions to Be Taken in Handling and Storing
In accordance with good industrial practice, handle with care and avoid
unnecessary personal contact. Avoid contact with eyes and prolonged or repeated skin contact. Avoid
continuous or repetitive breathing of dust. Use only with adequate ventilation. Wash thoroughly after handling
and before eating, drinking or using tobacco products. Keep containers closed when not in use and during
transport.
Section VII--Control Measures
Respiratory Protection (Specify Type)
Very small quantities used. Not applicable.
Local Exhaust
Ventilation Special
Very small quantities used. Not Very small quantities used. Not applicable.
applicable.
Mechanical (General) Other
Very small quantities used. Not Very small quantities used. Not applicable.
applicable.
Protective Gloves Eye Protection
Very small quantities used. Not applicable. Very small quantities used. Not applicable.
Other Protective Clothing or Equipment
Very small quantities used. Not applicable.
Work/Hygienic Practices
Very small quantities used. Not applicable.
Copyright RodoTrak
* Some items on this MSDS may be designated as Trade Secrets. Bonafide requests for disclosure of Trade Secret
information must be made in accordance with the provisions contained in 29 CFR 1910.1200 I 1-13.
|