MATERIAL SAFETY DATA SHEET
Date Revised: July 2005
Information on this form is furnished solely for the purpose of compliance with the Occupational Safety and Health Act and shall not be used for any other
purpose. T. Christy Enterprises, Inc. urges the customers receiving this Material Safety Data Sheet to study it carefully to become aware of the hazards, if any,
of the product involved. In the interest of safety, you should notify your employees, agents and contractors of the information on this sheet.
SECTION I
MANUFACTURER'S NAME: Transportation Emergencies:
T. Christy Enterprises, Inc. INFOTRAC: (800) 535-5053
ADDRESS: Medical Emergencies: (800) 451-8346
655 East Ball Road, Anaheim, CA 92805-5910
(714) 507-3300 FAX:(714) 507-3310
CHEMICAL NAME and FAMILY TRADE NAME: Christy'sTM Plastics Cleaner
Ethanol (denatured)
FORMULA: Proprietary
Oxygenated Hydrocarbon Mixture
SECTION II - HAZARDOUS INGREDIENTS
None of the ingredients below are listed as
carcinogens by IARC, NTP or OSHA CAS# APPROX % ACGIH-TLV ACGIH-STEL OSHA-PEL OSHA-STEL
Denatured Alcohol 64-17-5 >90 1000PPM 1000 PPM
All of the constituents of Christy's adhesive products are listed onthe TSCA inventory of chemical substances maintained by the US EPA, or are exempt from that listing.
Note to Physicians: Contains Methanol (less than 4% by volume). Methanol is metabolized to formaldehyde and formic acid. This in turn may cause metabolic
acidosis, visual disturbances and blindness. Because metabolism must occur before the toxic effects, the onset of toxic symptoms may be delayed from 6 to 30 hours
following ingestion. Ethanol competes for the same metabolic pathway and has been used as an antidote.
COMMENTS: Reports have associated repeated and prolonged occupational overexposure to solvents with permanent brain and nervous system damage (sometimes
referred to as solvent or painters' syndrome).
**Title III Section 313 Supplier Notification; This product contains toxic chemicals subject to the reporting requirements of Section 313 of the Emergency Planning
and Community Right-to-Know Act of 1986 and of 40CFR372. This information must be included in all MSDS'S that are copied and distributed for this material.
SPECIAL HAZARD DESIGNATIONS
SHIPPING INFORMATION FOR GALLON CONTAINERS OR ABOVE
DOT Shipping Name: Alcohols, n.o.s. HMIS NFPA HAZARD RATING
(Denatured Alcohol
DOT Hazard Class: 3 2 1
HEALTH: 0-MINIMAL
Identification Number: UN 1987 FLAMMABILITY: 3 3 1-SLIGHT
REACTIVITY:
Packaging Group: II 0 0 2-MODERATE
PROTECTIVE 3-SERIOUS
Label Required : Flammable Liquid
EQUIPMENT: H 4-SEVERE
SHIPPING INFORMATION FOR CONTAINERS LESS THAN ONE GALLON
DOT Shipping Name: Consumer Commodity
H=Eye, Hand/Skin & respiratory protection plus Impervious
DOT Hazard Class: ORM-D
Apron
SECTION III - PHYSICAL DATA
BOILING POINT (癋)
APPEARANCE ODOR
Blue, thin liquid Ethereal, vinous odor 165?176癋 (74癈-81癈)
PERCENT VOLATILE BY VOLUME(%)
VAPOR PRESSURE (mm Hg.)
SPECIFIC GRAVITY@73?3.6癋
Approx: 90-95%
Typical 0.815 ?0.040 57 mm Hg.@68癋 (20癈)
EVAPORATION RATE (BUAC = 1) SOLUBILITY IN WATER
VAPOR DENSITY (Air =1)
1.9 100%
1.59
VOC STATEMENT:This product contains 800 grams of VOC per liter as manufactured.
SECTION IV - FIRE AND EXPLOSION HAZARD DATA
LEL UEL
FLASH POINT FLAMMABLE LIMITS
(PERCENT BY VOLUME) 3 19
57癋 (14癈) T.C.C.
FIRE EXTINGUISHING MEDIA
Carbon dioxide, dry chemical or a universal type foam.
SPECIAL FIRE FIGHTING PROCEDURES
Use self-contained breathing apparatus, positive pressure hose masks or airline masks. Water spray may be useful in minimizing vapors and cooling
containers exposed to heat and flame. Avoid spreading burning liquid with water used for cooling purposes.
UNUSUAL FIRE AND EXPLOSION HAZARDS
Dangerous when exposed to heat or flame - can react vigorously with oxidizing materials.
SECTION V - HEALTH HAZARD DATA
PRIMARY ROUTES
Ingestion
x Inhalation x Skin Contact Eye Contact
OF ENTRY:
EFFECT OF OVEREXPOSURE
ACUTE: Inhalation: Breathing high concentrations of vapors or mists may cause irritation of nose and throat, signs of nervous system depression
(drowsiness, dizziness, loss of coordination, fatigue). and pulmonary edema (accumulation of fluid in lungs). Prolonged or repeated exposure may
causse visual disturbances (including blindness), blood disorders (anemia).
Skin Contact: Repeated or prolonged exposure may cause moderate irritation or other dermatological symptoms.
Eye Contact: Eye irritant. Direct contact with the liquid or exposure to its vapors or mists may cause burning, tearing, redness and swelling.
Ingestion: Moderately toxic, may result in irritation of the digestive tract, signs of nervous system depression, vomiting, drunkenness, stupor, visual
disturbances (including blindness).
CHRONIC: Long term ingestion of large quantities of Ethanol has also been associated with liver damage, irreversible changes in the genetic material (DNA)
of a cell and adverse effects on the reproductive system and/or developing fetus
Reproductive Effects Teratogenicity Mutagenicity Embryotoxicity Sensitization to Product Synergistic Products
Yes N. AP Yes Yes N.AP Some
MEDICAL CONDITIONS AGGRAVATED BY EXPOSURE: Breathing of vapor and/or mist may aggravate respiratory symptoms associated with pre-
existing inflammatory or fibrotic pulmonary diseases (asthma, emphysema, etc.) and blood disorders.
EMERGENCY AND FIRST AID PROCEDURES
Inhalation: If overcome by vapors, remove to fresh air and if breathing stopped, give artificial respiration. If breathing is difficult, give oxygen. Call doctor.
Eye Contact: Flush eyes with plenty of water for 15 minutes and call a doctor.
Skin Contact: Wash skin thoroughly with soap and water for at least 15 minutes and get medical attention.
Ingestion: If swallowed, DO NOT INDUCE VOMITING. Call physician or poison control center immediately.
SECTION VI - REACTIVITY
CONDITIONS TO AVOID
STABILITY UNSTABLE
Keep away from heat, sparks, open flame and other sources of ignition. Can react vigorously with oxidizing material.
X
STABLE
INCOMPATIBILITY
(MATERIALS TO AVOID) Incompatible with strong acids, strong bases and strong alkalies. Can react vigorously with oxidizing material.
HAZARDOUS DECOMPOSITION PRODUCTS
Thermal decomposition may yield acrid fumes, carbon monoxide and/or carbon dioxide.
CONDITIONS TO AVOID
MAY OCCUR
HAZARDOUS
N/A
X
POLYMERIZATION WILL NOT OCCUR
SECTION VII - SPILL OR LEAK PROCEDURES
STEPS TO BE TAKEN IN CASE MATERIAL IS RELEASED OR SPILLED
Eliminate all ignition sources. Avoid breathing of vapors. Keep liquid out of eyes. Flush with large amount of water. Contain liquid with sand or earth.
Absorb with sand or non-flammable absorbent material and transfer into steel drums for recovery or disposal. Prevent liquid from entering drains.
WASTE DISPOSAL METHOD
Follow local, State and Federal regulations. Consult disposal expert. Can be disposed of by incineration. Excessive quantities should not be permitted
to enter drains. Empty containers should be air dried before disposing. Hazardous Waste Code: 214
SECTION VIII - SPECIAL PROTECTION INFORMATION
RESPIRATORY PROTECTION (Specify type)
Atmospheric levels should be maintained below established exposure limits contained in Section II. If airborne concentrations exceed those limits, use of a
NIOSH-approved organic vapor cartridge respirator with full face-piece is recommended. The effectiveness of an air purifying respirator is limited. Use it
only for a single short-term exposure. For emergency and other conditions where short term exposure guidelines may be exceeded, use an approved positive
pressure self-contained breathing apparatus.
VENTILATION
Use only with adequate ventilation. Provide sufficient ventilation in volume and pattern to keep contaminants below applicable exposure limits set forth in
Section II. Use only explosion proof ventilation equipment.
EYE PROTECTION
PROTECTIVE GLOVES
Butyl, Latex or Nitrile Rubber Splashproof chemical goggles/face shield/safety glasses with brow guard.
OTHER PROTECTIVE EQUIPMENT AND HYGENIC PRACTICES
Impervious apron and a source of running water to flush or wash the eyes and skin in case of contact.
SECTION IX - SPECIAL PRECAUTIONS
PRECAUTIONS TO BE TAKEN IN HANDLING AND STORING
Store in the shade between 40癋 - 110癋. Keep away from heat, sparks, open flame and other sources of ignition. Avoid prolonged breathing of vapor. Use
with adequate ventilation. Avoid contact with eyes, skin and clothing. Train employees on all special handling procedures before they work with this product.
OTHER PRECAUTIONS
Follow all precautionary information given on container label, product bulletins and our solvent cementing literature. All handling equipment should be
electrically grounded.
The information contained herein is based on data considered accurate. However, no warranty is expressed or implied regarding the accuracy of
this data or the results to be obtained from the use thereof. It is the responsibility of the user to investigate and understand the ramifications of
using this product, and to comply with all use and disposal laws and procedures.
|