MATERIAL SAFETY DATA SHEET

                                                  ISSUE DATE: 10/24/01

                                                 REVISED DATE: 05/02/09

                                     Supercedes: Any Previous M.S.D.S. On This Product

                                EMERGENCY PHONE NUMBER: CHEM-TEL INC. 1-800-255-3924



I. IDENTIFICATION

                    PIPE & FITTING PRESS ON GASKET

PRODUCT NAME:                                                                                 DUCTMATE INDUSTRIES, INC.

                                                                                              1502 Industrial Drive

PRODUCT CLASS: Crosslinked Polyethylene Foam                                                  Monongahela, PA 15063





II. HAZARDOUS INGREDIENTS

                                                                                                OSHA               ACGIH

MATERIAL:              CAS NUMBER                    WEIGHT                                     PEL                TLV

NONE AS DEFINED BY OSHA COMMUNICATION (29 CFR 1910.1200).



III. PHYSICAL DATA

APPEARANCE: Cellular Plastics Foam

SOLUBILITY IN WATER: Insoluble

SPECIFIC GRAVITY: Density 29.7 ?36.3g/1

EVAPORATION RATE: None



IV. HEALTH HAZARD DATA

SKIN: Essentially non-irritating to skin.

INHALATION: Dust/fumes generated during thermal forming or slicing. It may cause eye and respiratory irritation.

INGESTION: Ingestion is unlikely due to physical state.

                  Physical injury only, may cause choking if swallowed.



V. EMERGENCY AND FIRST AID PROCEDURES

INHALATION: Remove to fresh air.

EYE CONTACT: Wash with flowing water for a minimum of five minutes.

INGESTION: No adverse effects anticipated by this route of exposure incidental to proper industrial handling. In the event this does

occur induce vomiting and promptly call physician.

SKIN CONTACT: Wash with soap and water.



VI. FIRE AND EXPLOSION HAZARD DATA

FLASH POINT: N/A

EXTINGUISHING MEDIA: Water or N2 gas.

SPECIAL PROCEDURES: No unusual fire or explosion hazards. It is required avoidance of possible ignition sources.



VII. SPILL OR LEAK PROCEDURES

WASTE DISPOSAL METHOD: Destruction by fire.





VIII. SPECIAL PROTECTION

VENTILATION: Provide general and/or local exhaust ventilation to control airborne levels.

SKIN PROTECTION: No skin protection should be needed.

EYE PROTECTION: No eye protection should be needed.



IX. REACTION DATA

CONDITIONS TO AVOID: Avoid fire and temperature over 625°F, 329°C.

INCOMPATIBILITY (Materials to avoid): Gasoline, Cyclohexane, Ether, Ketone, Parrafin, Xylene.

HAZARDOUS DECOMPOSITION PRODUCT: Combustion conditions may release fumes hydrogen bormide and/or other toxic

vapors.

HAZARDOUS POLYMERIZATION: Will not occur.

X. SPECIAL PRECAUTIONS

HANDLING AND STORAGE: Avoid breathing vapors during thermal forming or sliding. Store in dry area protected from external

source of heat and direct sunlight.



This information is taken from sources or based upon data believed to be reliable; however, DUCTMATE INDUSTRIES, INC. makes no

warranty as to the absolute correctness or sufficiency of any of the foregoing or that additional or other measures may not be required under

particular conditions.









                                                                                                                                  123/5-09