MATERIAL SAFETY DATA SHEET Page 1 of 5
SECO 101
NFPA HMIS
HEALTH 3
0
FLAMMABILITY 0
3 0
REACTIVITY 0
PERSONAL PROTECTION
1. Product And Company Identification
Supplier Manufacturer
ASAS / Tysol, Inc. ASAS / Tysol, Inc.
1561 Woodlane Drive 1561 Woodlane Drive
PO Box 25098 PO Box 25098
Woodbury, MN 55125 USA Woodbury, MN 55125 USA
Company Contact: Tom Ewing Company Contact: Tom Ewing
Telephone Number: 651-730-5639 Telephone Number: 651-730-5639
FAX Number: 651-730-5107 FAX Number: 651-730-5107
E-Mail: tom@tysol.com E-Mail: tom@tysol.com
Web Site: www.tysol.com Web Site: www.tysol.com
Supplier Emergency Contacts & Phone Number Manufacturer Emergency Contacts & Phone Number
Medical Emergency Hotline: 1-800-228-5635 Medical Emergency Hotline: 1-800-228-5635
Issue Date: 06/14/2007
Product Name: SECO 101
Chemical Name: Organic acid blend
CAS Number: Not Established
Chemical Family: Acid blend
Chemical Formula: Blend
EPA Registry Number: N.E.
MSDS Number: 100
2. Composition/Information On Ingredients
Ingredient CAS Percent Of
Name Number Total Weight
OXALIC ACID 144-62-7 < 10
3. Hazards Identification
Primary Routes(s) Of Entry
Ingestion Eye Contact, Skin Contact, Inhalation of spray
Eye Hazards
Severe irritation, or burns possible.
Skin Hazards
Irritation, or burns possible with prolonged contact
Ingestion Hazards
Irritation or burns of mouth, throat or stomach.
Inhalation Hazards
Causes respiratory tract irritation.
MATERIAL SAFETY DATA SHEET Page 2 of 5
SECO 101
3. Hazards Identification - Continued
Subchronic (Target Organ Effects)
Unknown; none expected beyond acute effects.
Chronic/Carcinogenicity Effects
The product and its ingredients have not been identified as carcinogen or probable carcinogen by NTP, IARC
monographs or OSHA.
Conditions Aggravated By Exposure
Dermatitis and skin disorders.
4. First Aid Measures
Eye
In case of contact, immediately flush eyes with plenty of water. Get medical attention immediately.
Skin
In case of contact, immediately flush skin with plenty of water for at least 15 minutes. Get medical attention
immediately if irritation (redness, rash, blistering) develops and persists. Remove contaminated clothing and
shoes.
Ingestion
If victim is fully conscious, give one or two cups of water or milk to drink. Call a physician or a poison control
center immediately. DO NOT try to neutralize acid with a strong base.
Inhalation
If inhaled, remove to fresh air. Call a physician or a poison control center immediately.
5. Fire Fighting Measures
Flash Point: none 癋
Flammability Class: 0
Lower Explosive Limit: none
Upper Explosive Limit: none
Fire And Explosion Hazards
none
Extinguishing Media
Use the appropriate extinguishing media for the surrounding fire.
Fire Fighting Instructions
Firefighters should wear self-contained breathing apparatus and full protective gear.
6. Accidental Release Measures
Neutralize spill area with soda ash or lime. Use appropriate personal protective equipment (PPE). Flush spill area with
water.
7. Handling And Storage
Handling And Storage Precautions
Keep containers tightly closed. Keep out of reach of children. Wash thoroughly after handling.
Handling Precautions
Avoid contact with eyes. Avoid contact with skin and clothing. Do not taste or swallow. Use only with adequate
personal protection. Wash thoroughly after handling.
Storage Precautions
Keep from freezing. Keep container tightly closed.
MATERIAL SAFETY DATA SHEET Page 3 of 5
SECO 101
7. Handling And Storage - Continued
Work/Hygienic Practices
Wash thoroughly after handling.
8. Exposure Controls/Personal Protection
Engineering Controls
Use with adequate general and local exhaust ventilation.
Eye/Face Protection
Chemical splash goggles.
Skin Protection
Chemical-resistant gloves. Plastic or rubber apron.
Respiratory Protection
The level of respiratory protection needed should be based on the required protection factor after evaluating
chemical exposures using appropriate industrial hygiene monitoring and/or OSHA guidance.
Ingredient(s) - Exposure Limits
OXALIC ACID
OSHA PEL 1mg/m3 2mg/m3 STEL
ACGIH TLV 1mg/m3 2mg/m3 STEL
9. Physical And Chemical Properties
Appearance
Slightly hazy liquid
Odor
Mild odor
Chemical Type: Mixture
Physical State: Liquid
Melting Point: NA ?NA ?br>
F C
Boiling Point: 212 ?100 ?br>
F C
Specific Gravity: 1.37
Molecular Weight: NA
Percent Volatiles: >50
Percent VOCs: none
Packing Density: NA
Vapor Pressure: NA
Vapor Density: NA
pH Factor: 2 At a Concentration Of 100
Solubility: complete
Viscosity: like water
Evaporation Rate: like water
10. Stability And Reactivity
Stability: Avoid strong oxidizing materials and strong bases.
Hazardous Polymerization: none
Conditions To Avoid (Stability)
Avoid incompatable materials.
Incompatible Materials
Contact with metal liberates (releases) poisonous gas. Avoid strong oxidizing and reducing agents. Strong
alkaline materials, bleach, cyanides and sulfides may create toxic fumes.
MATERIAL SAFETY DATA SHEET Page 4 of 5
SECO 101
11. Toxicological Information
No Data Available...
12. Ecological Information
No Data Available...
13. Disposal Considerations
Refer to applicable federal, state, and local regulations prior to disposition of container and residual contents.
RCRA Information
Waste solutions may meet the RCRA Corrosive characteristic.
14. Transport Information
Proper Shipping Name
Corrosive liquids, NOS ( Oxalic Acid ), 8, UN 1760, III ERG#60
Hazard Class
Corrosive, 8
DOT Identification Number
UN1760
DOT Shipping Label
Corrosive liquids, NOS ( Oxalic Acid ), 8, UN 1760, III ERG#60
Freight Class
55
15. Regulatory Information
SARA Hazard Classes
Acute Health Hazard
SARA Section 313 Notification
This product does not contain any ingredients regulated under Section 313 of the Emergency Planning and
Community Right-To-Know Act of 1986 or 40 CFR 372.
16. Other Information
NFPA Rating
Health: 3
F ir e : 0
Reactivity: 0
HMIS Rating
Health: 3
F ir e : 0
Reactivity: 0
Revision/Preparer Information
MSDS Preparer: TM
MSDS Preparer Phone Number: 651-730-4923
This MSDS Supercedes A Previous MSDS Dated: 05/01/2003
Disclaimer
The above information is to the best of our knowledge, current, accurate, and complete based on information
reasonably available to us as of the date of preparation of this form. However, it is the user's responsibility to
determine the safety, toxicity and suitability for his or her own use of the product described herein. Since the
actual use by others is beyond our control, no guarantee, expressed or implied, is made by us to the effects of
MATERIAL SAFETY DATA SHEET Page 5 of 5
SECO 101
Disclaimer - Continued
such use or on the safety or toxicity of this product. Nor do we assume any liability arising out of use by others of
the product. Nor is the information herein to be construed as absolutely complete, since additional information
may be necessary or desirable when exception conditions or circumstances exist or because of applicable laws or
regulations.
ASAS / Tysol, Inc.
Printed Using MSDS GeneratorTM 2000
|