MATERIAL SAFETY DATA SHEET
HAZARD RATING HEALTH 2
VEXCON NO. VW107
4=EXTREME
3=HIGH
FLAMMABILITY 2
2=MODERATE
1=SLIGHT
0=INSIGNIFICANT
REACTIVITY 0
The road to better performance TM
7240 STATE RD ?PHILADELPHIA, PA 19135
VOICE: 215.332.7709 ?FAX: 215.332.9997
TOLL FREE: 888-VEXCON-1
WEBSITE ADDRESS: www.vexcon.com
---------------------------------------------------------------------- VAPOR PRESSURE: 200 mm Hg 680 F
SPECIFIC GRAVITY 1.48
GENERAL INFORMATION VAPOR DENSITY (AIR=1): APPROX. 5
---------------------------------------------------------------------- SOLUBILITY IN H20 % BY WT: SOLUBLE
CERTI-VEX ?BLOCK FILL VOC
PRODUCT IDENTIFICATION: % VOLATILES BY VOL: 25% PH (AS IS) 8.5-9.5 PH (1% SOLN.) N/A
VOC CONTENT: 398 GR/LITER OR 3.32 #/GAL. EVAPORATION RATE (BUAC=1): 0.1
CATEGORY: CONCRETE PROTECTIVE COATING APPEARANCE AND ODOR: VERY THICK PAINT,VARIOUS COLORS,
COMMON NAME: TEXTURED HIGH BUILD PAINT SLIGHTLY SWEET PETROLEUM ODOR
------------------------------------------------------------------------
DOT SHIPPING NAME: IN CONTAINERS LESS THAN 119 GALS.:
CERTI-VEX BLOCK FILL VOC (NON-REGULATED) IN CONTAINERS SECTION IV FIRE AND EXPLOSION DATA
GREATER THAN 119 GALS: RQ, RESIN SOLUTION, FLAMMABLE, 3,
------------------------------------------------------------------------
UN 1866, III
FLASH POINT: (TEST METHOD): 1060 F TCC
HEALTH AND SAFETY: THIS IS A SOLVENT BASED PRODUCT: USE
AUTOIGNITION TEMPERATURE: 473 LOWER: 0.7 UPPER: 6.0
ONLY WITH ADEQUATE VENTIALTION; IF SWALLOWED, DO NOT INDUCE
FLAMMABLE LIMITS IN AIR: % BY VOL:
VOMITING; USE OF SOLVENT RESISTANT GLOVES, GOGGLES AND
EXTINGUISHING MEDIA: EXCLUDE AIR-USE FOAM CO2, STEAM, WATER,
OTHER PROTECTIVE CLOTHING IS ADVISED WHEN HANDLING THIS
FOG, DRY CHEMICALS.
PRODUCT.
--------------------------------------------------------------------------- SPECIAL FIRE FIGHTING PROCEDURES: THE USE OF SELF CONTAINED
BREATHING APPARATUS IS RECOMMENDED FOR FIRE FIGHTERS. SEE
SECTION I
--------------------------------------------------------------------------- ALSO SECTION IX.
MANUFACTURER: VEXCON CHEMICALS UNUSUAL FIRE AND EXPLOSION HAZARD: NO UNUSUAL HAZARDS ?br>
EMERGENCY NO: 1-800-858-2828
KEEP WORK AREAS FREE OF HOT METAL AND OTHER SOURCES OF
CHEMTREC NO: 1-880-424-9300
TELEPHONE NO: 1-215-332-7709 IGNITION.
ADDRESS: 7240 STATE RD.PHILA., PA 19135
GENERAL HAZARD: COMBUSTIBLE LIQUID, CAN FORM COMBUSTIBLE
PREPARED: MARCH 1998
MIXTURES AT TEMPERATURES AT OR ABOVE THE FLASH POINT.STATIC
UPDATED: SEPTEMBER 13, 1999
PREPARED BY : DARRYL F. MANUEL DISCHARGE, MATERIAL CAN ACCUMULATE STATIC CHARGES WHICH
--------------------------------------------------------------- CAN CAUSE AN INCENDIARY ELECTRICAL DISCHARGE. "EMPTY"
SECTION II HAZARDOUS INGREDIENTS CONTAINERS RETAIN PRODUCT RESIDUE (LIQUID AND/OR VAPOR) AND
--------------------------------------------------------------- CAN BE DANGEROUS. DO NOT PRESSURIZE, CUT WELD, BRAZE,
MATERIAL OR COMPONENTS CAS# % HAZARD DATA UN#
SOLDER DRILL GRIND, OR EXPOSE SUCH CONTAINERS TO HEAT,
STYRENE ACRYLATE POLYMER 25085-34-1 8% ND
PIGMENTS: FLAME, SPARKS, STATIC ELECTRICITY, OR OTHER SOURCES OF
1. TITANIUM DIOXIDE 13463-67-7 3% RESPIRABLE DUST
IGNITION: THEY MAY EXPLODE AND CAUSE INJURY OR DEATH. EMPTY
5 mg/M3 TLV 5 mg/M3
TOTAL DUST 15 mg/M3 TLV 10 mg/M3
DRUMS SHOULD BE COMPLETELY DRAINED, PROPERLY BUNGED AND
2. CALCIUM CARBONATE 1317-65-3 16% SAME AS ABOVE
STODDARD SOLVENT 8052-41-3 10% TLV 100 ppm PROMPTLY RETURNED TO A DRUM RECONDITIONER ,OR PROPERLY
AR-100 SOLVENT 64742-95-6 10% 50 ppm
DISPOSED OF.
1255
WHICH CONTAINS OSHA HAZARD COMBUSTIBLE
ELECTROSTATIC ACCUMULATION HAZARD: USE PROPER GROUNDING
HYDROCARBONS NOT ESTABLISHED
---------------------------------------------------------------------------
1,2,4 TRIMETHYBENZENE
BALANCE INERT RESINS AND FILLERS
SECTION V REACTIVITY DATA
THE FOLLOWING PORTION CONTAINS THE SECTION 313 REPORTABLE
INGREDIENTS.
----------------------------------------------------------------------------
COMPONENT CAS NO MAXIMUM %
CONDITIONS CONTRIBUTING TO INSTABILITY: PRODUCT IS STABLE
TRIMETHLBENZENE 95-63-6 2%
INCOMPATIBILITY: THIS PRODUCT IS INCOMPATIBLE WITH STRONG
-------------------------------------------------------------------------
OXIDIZING AGENTS. STRONG ACIDS OR BASES AND SELECTED AMINES.
SECTION III PHYSICAL/CHEMICAL CHARACTERISTICS
HAZARDOUS DECOMPOSITION PRODUCTS: THERMAL DECOMPOSITION
--------------------------------------------------------------------------
IN THE PRESENCE OF AIR MAY YIELD CARBON MONOXIDE AND
BOILING POINT: 310-4950 F MELTING POINT: N/A
UNIDENTIFIED ORGANICS.
CONDITIONS CONTRIBUTING TO HAZARD POLYMERIZATION: N/A WILL EYES: CHEMICAL GOGGLES AND/OR FACE SHIELD ARE RECOMMENDED
NOT OCCUR. TO SAFEGUARD AGAINST POTENTIAL EYE CONTACT, IRRITATION, OR
--------------------------------------------------------------- INJURY.
SECTION VI HEALTH HAZARD INFORMATION GLOVES: IMPERVIOUS GLOVES, (CHEMICAL RESISTANT) SUCH AS
--------------------------------------------------------------- NEOPRENE, LATEX OR PVA.
HEALTH HAZARD DATA HAZARRD CLASSIFICATION BASIS FOR OTHER CLOTHING AND EQUIPMENT:TO PREVENT BODY CONTACT,
CLASSIFICATION IMPERVIOUS CLOTHING AND BOOTS ARE RECOMMENDED. IMPERVIOUS
ROUTES OF EXPOSURE: THIS PRODUCT MAY CREATE BREATHING APRONS ARE RECOMMENDED WHEN WORKING WITH THIS PRODUCT.
DIFFICULTIES, DIZZINESS, LIGHT HEADEDNESS WHEN WORKING IN AREAS THE AVAILABILITY OF EYE WASHES AND SAFETY SHOWERS IN WORK
WITH HIGH VAPOR CONCENTRATION. MINERAL SPIRITS COMPONENTS. AREAS ARE RECOMMENDED.
-------------------------------------------------------------
SKIN CONTACT: THIS PRODUCT MAY CAUSE SKIN IRRITATION UPON
SECTION IX SPECIAL PRECAUTIONS
PROLONGED OR REPEATED CONTACT.
-------------------------------------------------------------
SKIN ABSORPTION SEE ABOVE
EYE CONTACT: THIS PRODUCT MAY BE AN EYE IRRITANT. MINERAL PRECAUTIONARY STATEMENTS:
SPIRITS COMPONENT. PERSONNEL SHOULD AVOID INHALATION OF VAPORS. PERSONAL
EFFECTS OF OVEREXPOSURE TLV - 100 PPM CONTACT WITH THE PRODUCT SHOULD BE AVOIDED. SHOULD
ACUTE OVEREXPOSURE: CONTACT
ANESTHESIA, HEADACHE, NAUSEA, DIZZINESS: MODERATE IRRITATION BE MADE, REMOVE SATURATED APPAREL AND FLUSH AFFECTED BODY
BY LIQUID TO SKIN AND EYES. AREAS WITH WATER. CLOTHING MUST BE WASHED AND DRIED BEFORE
EMERGENCY AND FIRST AID PROCEDURES: RE-USE. CONTAINERS OF THIS MATERIAL MAY BE HAZARDOUS WHEN
EYES: FLUSH WITH PLENTY OF WATER FOR AT LEAST 15 MINUTES EMPTIED, SINCE EMPTIED CONTAINERS RETAIN PRODUCT RESIDUE
CONSULT A PHYSICIAN. (VAPOR, LIQUID AND/OR SOLID). ALL HAZARD PRECAUTIONS GIVEN IN
SKIN: IMMEDIATELY WASH SKIN WITH SOAP AND PLENTY OF THIS DATA SHEET MUST BE OBSERVED.
WATER. IF IRRITATION PERSISTS, CONSULT A PHYSICIAN. OTHER HANDLING AND STORAGE REQUIREMENTS:
INHALATION: MOVE TO LOCATION FREE FROM VAPORS. IF BREATHING STORE IN WELL VENTILATED AREA. KEEP CONTAINER TIGHTLY CLOSED.
STOPS, BEGIN ARTIFICIAL RESPIRATION ANDSEEK IMMEDIATE DO NOT STORE WITH INCOMPATIBLE MATERIALS. STORE IN
MEDICAL ATTENTION. ACCORDANCE WITH FEDERAL REGULATIONS. DO NOT STORE OR
INGESTION: DO NOT INDUCE VOMITING, SEEK PROMPT MEDICAL CONSUME FOOD, DRINK OR TOBACCO IN AREA WHERE THEY MAY
ATTENTION. BECOME CONTAMINATED WITH THIS MATERIAL. KEEP AWAY FROM HIGH
--------------------------------------------------------------- TEMPERATURES, OPEN FLAMES,SPARKS ETC. USE WITH EXPLOSION
SECTION VII PRECAUTIONS FOR SAFE PROOF EQUIPMENT IS HIGHLY ADVISABLE.
HANDLING AND USE HMIS HAZARD RATINGS:
------------------------------------------------------------------ NPCA-HMIS NFPA 704 KEY
AQUATIC TOXICITY (E.G. 96 HR. TLM): HEALTH 2 2 4=SEVERE
WASTE DISPOSAL METHOD: IF POSSIBLE, PUMP TO CONTROLLED FLAMMABILITY 2 2 3=SERIOUS
CONTAINMENT AREA. ABSORB ON CLAY OR SAND. DISPOSE OF IN REACTIVITY 0 0 2=MODERATE
COMPLIANCE WITH EPA, STATE, AND LOCAL REGULATIONS. 1=SLIGHT
STEPS TO BE TAKEN IF MATERIAL IS RELEASED OR 0=MINIMAL
SPILLED: IF POSSIBLE PUMP TO CONTROLLED CONTAINMENT AREA. ADDITIONAL REGULATORY CONCERNS: (FEDERAL, FDA, USDA, CPSC,
ELIMINATE ALL IGNITION SOURCES (FLARES, FLAMES, INCLUDING STATE, OTHER)
PILOT LIGHTS, ELECTRICAL SPARKS). PERSONS NOT WEARING FEDERAL:
PROTECTIVE EQUIPMENT SHOULD BE EXCLUDED FROM AREA OF FDA:
SPILL UNTIL CLEAN-UP IS COMPLETE. STOP SPILL AT SOURCE. DIKE USDA:
SPILL AREA TO PREVENT SPREADING. PUMP LIQUID TO SALVAGE TSCA: IS THIS PRODUCT, OR ALL IT'S INGREDIENTS, BEING CERTIFIED
TANK. REMAINING LIQUID CAN BE TAKEN UP ON SAND, EARTH, FLOOR FOR INCLUSION ON THE TOXIC SUBSTANCES CONTROL ACT INVENTORY
ABSORBENT, OR OTHER ABSORBENT MATERIAL AND SHOVEL INTO OF CHEMICAL SUBSTANCES? YES
CONTAINERS.
------------------------------------------------------------ PREPARED BY: DARRYL MANUEL
TITLE: PRESIDENT
SECTION VIII CONTROL MEASURES COMPANY: VEXCON CHEMICALS
------------------------------------------------------------- ADDRESS: 7240 STATE RD., PHILA., PA 19135
THE INFORMATION PROVIDED IN THIS MATERIAL
VENTILATION REQUIREMENTS:
SAFETY DATA SHEET HAS BEEN OBTAINED FROM SOURCES
LOCAL MECHANICAL VENTILATION MAY BE SUFFICIENT TO
BELIEVED TO BE RELIABLE. VEXCON PROVIDES NO
KEEP PRODUCT VAPOR CONCENTRATIONS WITHIN SPECIFIED TIME-
WARRANTIES, EXPRESS OR IMPLIED, AND ASSUMES NO
WEIGHTED TLV RANGES. IF LOCAL VENTILATION PROVES
RESPONSIBILITY FOR THE ACCURACY OR COMPLETMENT OF
INADEQUATE TO MAINTAIN SAFE VAPOR CONCENTRATIONS,
THE INFORMATION CONTAINED HEREIN
SUPPLEMENTAL LOCAL EXHAUST MAY BE REQUIRED. OTHER
SPECIAL PRECAUTIONS SUCH AS RESPIRATORY MASKS OR
ENVIRONMENTAL CONTAINMENT DEVICES MAY BE REQUIRED IN
EXTREME CASES.
RESPIRATORY(SPECIFY IN DETAIL): CHEMICAL CARTRIDGE RESPIRATOR;
HALF MASK ORGANIC VAPOR CARTRIDGE IF EYE PROTECTION IS
NEEDED.
|