SYN-FLO 90 MSDS
Syn-Flo Oil Corporation
Material Safety Data Sheet
Effective Date 01/01/10
Syn-Flo Oil Corporation ur ges each recipient of this MSDS to study it car efully to become aware of and understand the hazards
associated with the product. The reader should consider consulting reference works or individuals that ar e experts in ventilation,
toxicology, and fir e prevention, as necessary or appropriate to use and understand the data contained in this MSDS. T o promote safe
handling, each customer or recipient should: (1) notify its employees the data contained in this MSDS; (2) fur nish this same infor mation
to each of its customers for the product; and (3) request its customers to notify their employers, customers, and other users of the
product this infor mation.
I. IDENTIFICATION
Product Name: Syn-Flo 90 (Synthetic compressor oil)
Chemical Name: Diisotridecyl adipate/2stg-hydrotreat parraffinic hydr ocarbon (compounded)
Formula: CH-3-CO-O-CH2-CH3 - Plus additives
Synonyms: None
CAS# and Name: 68515-47-9 Diisotridecyl-adipate
8042475 Hydrotreated White Oil
9003-29-6 Poly-butene
122-39-4 diphenylamine
68411-46-1 benzenamine
68937-41-7 phenol-isopropylate/phosphate
II. PHYSICAL DATA (Determined on typical material)
Boiling Point, 760mm Hg. Decomposes > 300 C
Specific Gravity (H20=1) .961 at 20/20 C
Pour Point < -35 F
Vapor Pressure at 20癈: < 0.01 mm/Hg
Flash Point 249 C (480 F) COC method
Emergency Phone Number: 800-874-8993 After Hours: Chemtrec 800-424-9300
Syn-Flo Oil Company
P.O. Box 22588
Louisville, KY 40252
Vapor Density (Air = 1) >1
Evaporation Rate (Butyl Acetate = 1) Nil
Solubility in W ater by wt: < 0.1
Appearance: Pale yellow to light tan
Odor: Mild
Physical State: Liquid
Product Name: Syn-Flo 90 Lubricant Page 2
III. Ingredients
% Material CAS Exposure Limit
> 75 Diisotridecyl Adipate 68515-47-9 Not Established
< 20 Hydrotreat White Oil 8042475
< 10 Poly-butene 9003-29-6
< 05 Additive 68411-46-1 Not Established
6825-36-9
122-39-4
All other additives are less than .5% by volume and are not considered to be hazardous chemicals
under the OSHA Hazard Communications Standar d (29 CFR 1910.1200)
IV. Fire and Explosion Hazard Data
Flash Point: 480 F (249 C)
ASTM D 92 Cleveland Open Cup
Flammable Limits in Air: Lower: Not Determined
Upper: Not Determined
% by volume
Special Fire Fighting Procedures: Do not direct a solid stream of water or foam into hot, bur ning pools;
this may cause frothing and incr ease fire intensity.
Use self-contained breathing apparatus and pr otective clothing.
Extinguishing Media: Apply alcohol-type or all-purpose type foam by manufactur er's
recommended techniques for large fires.
Use carbon dioxide or dry chemical media for small fir es.
Unusual Fire and Explosion Hazards: This material may pr oduce a floating fir e hazard in extreme fire conditions.
See "Other precautions" in Section IX.
V. Health Hazard Data
Exposure Limit(s): None established by OSHA or ACGIH.
Effects of Single Overexposure:
Swallowing: No evidence of harmful effects from available infor mation.
Skin Absorption: No evidence of harmful effects from available infor mation.
Inhalation: Short-term harmful health effects are not expected from
vapor generated at ambient temperature.
Skin Contact: Brief contact is not irritating.
Prolonged contact may cause reddening, itchiness, a burning sensation,
and possible drying and flaking of the skin.
Eye Contact: May cause irritation, experience as stinging with excess
blinking and tear pr oduction.
Excess redness of the conjunctiva may occur.
Effects of Repeated Overexposure: No adverse effects anticipated from available infor mation.
Medical Conditions Aggravated by Over exposure: Skin contact may aggravate an existing der matitis.
Significant Laboratory Data with Possible Relevance to
Human Health Hazar d Evaluation: None Currently known.
Product Name: Syn-Flo 90 Lubricant Page 3
Other Effects of Overexposure: Overexposure to vapor, aerosol or mist generated at high
temperatures may result in eye and respiratory tract irritation,
dizziness, nausea and the inhalation of har mful amounts of material.
Emergency and First Aid Procedures:
Swallowing: No emergency care anticipated.
Skin: Wash skin with soapy water.
Inhalation: Remove to fresh air.
Eyes: Immediately flush eyes with water and continue washing for several minutes.
Remove contact lenses if worn. Obtain medical attention.
Notes to Physician: There is no specific antidote. Treatment of overexposure should be directed
at the control of symptoms and the clinical condition of the patient.
VI. Reactivity Data
Stability: Stable
Conditions to Avoid: None
Incompatibility (materials to avoid)
Normally unr eactive; however, avoid strong bases at high temperatures, strong
acids, strong oxidizing agents and materials r eactive with hydroxyl compounds.
Hazardous Combustion or Decomposition Products:
Combustion may pr oduce the following products:
Carbon monoxide and/or carbon dioxide.
See Section V, "Other Effects of Overexposure."
Carbon monoxide is highly toxic if inhaled; carbon dioxide in
sufficient concentrations can act as an asphyxiate.
Hazardous Polymerization: Will not occur .
Conditions to Avoid: None
VII. Spill or Leak Procedures
Steps to be taken if material is Released or Spilled:
Wear suitable protective equipment, especially eye protection.
See Section VIII
Small spills can be flushed with lar ge amounts of water;
larger spills should be collected for disposal.
See section IX, "Other Pr cautions."
e
Waste Disposal Method: Incinerate in a fur nace or otherwise dispose of in accordance with
applicable Federal, State and local requirements.
VIII. Special Protection Information
Respiratory Protection (specify type): None required for use at low temperatures.
Ventilation: General (mechanical) room ventilation is satisfactory for use at low temperatur es.
If used at high temperatures, special local ventilation is r ecommended
at points where vapors can be expected to escape the workplace air .
Protective Gloves: Polyvinyl Chloride coated
Eye Protection: Monogoggles
Product Name: Syn-Flo 90 Lubricant Page 4
Other Protective Equipment: Eye Bath, Safety Shower
IX. Special Precautions
Precautions to be Taken in Handling and Storage:
WARNING!
Causes Eye and Skin Irritation.
Vapor, Aerosol or Mist of the product and thermal degradation products
generated at high temperatures can be irritating and har mful if inhaled.
Avoid contact with eyes, skin, and clothing.
Avoid breathing vapor, aerosol and mist.
Keep container closed.
Use adequate ventilation.
Wash thoroughly after handling.
FOR INDUSTR USE ONL
Y Y
Other Precautions:
SPILLS: This pr duct has very low solubility in water and will float on the
o
surface. Avoid drainage of large spills to sewers or to neutral waters.
ADDITIONAL INFORMA TION: Additional product safety information can
be obtained by calling Syn-Flo Oil Company 1-800-874-8933.
Ask for our brochure, which will afford you more specific information.
PROCESS HAZARD: Sudden r lease of hot organic chemical vapors or mists fr om process
e
equipment operating at elevated temperature and pressure, or sudden ingress of air into hot
equipment under a vacuum, may r esult in ignitions without the pr esence of obvious ignition
sources. Published "autoignition" or "ignition" temperature values cannot be treated as safe
operating temperatures in chemical processes without analysis of the actual process conditions.
Any use of this product in elevated-temperature processes should be thoroughly evaluated to
establish and maintain safe operating conditions. Further infor mation is available in a technical
bulletin entitled "Ignition Hazar ds of Organic Chemical Vapors."
X. Regulatory Information
Status on Substance Lists:
The concentrations shown are maximum or ceiling levels (weight %) to be used for calculations for r egulations.
Trade Secrets are indicated by "TS".
FEDERAL EP A
Comprehensive Environmental Response Compensation, and Liability Act of 1980 (CERCLA) r equires notification
of the National Response Center of Release of quantities of Haza rdous Substances equal to or greater than the
reportable quantities (RQs) in 40 CFR 302.4
Components present in this product at a level, which could require reporting under the statute, are:
***NONE***
Superfund Amendments and Reauthorization Act of 1986 (SARA) Title III
Requires emergency planning based on Threshold Planning Quantities (TPQs) and release reporting based on Reportable
Quantities (RQs) in 40 CFR 355 (Used for SARA 302,304,311 and 312).
Components present in this product at a level, which could require reporting under the statute, are:
***NONE***
Product Name: Syn-Flo 80 FG Lubricant Page 5
Superfund Amendments and Reauthorization Act of 1986 (SARA) Title III
Requires submission of annual r eports of release of toxic chemicals that appear in 40 CFR 372 (for SARA 313). This
information must be included in all MSDSs that ar e copies and distributed for this material.
Components present in this product at a level, which could require reporting under the statute, are:
UPPER BOUND
CHEMICAL CAS Number Concentration %
This product does not contain toxic chemicals at levels,
which require reporting under the statute.
Toxic Substances Control Act (TSCA) Status:
All components of this product are on the TSCA Inventory or are exempt from TSCA Inventory requirements.
State Right-To-Know
CALIFORNIA Pr position 65
o
This product contains no listed substances known to the State of Califor nia to cause cancer, birth
defects or other reproductive harm, at levels which would require a warning under the statute.
MASSACHUSETTES Right-T o-Know, Substances List (MSL) Hazar dous Substances and Extraordinarily Hazar dous
Substances on the MSL must be identified when present in products.
Components present in this product at a level, which could require reporting under the statute, are:
***NONE***
PENNSYL VANIA Right-T o-Know, Hazardous Substances List Hazardous Substances and Special Hazardous Substances
on the List must be identified when present in products.
Components present in this product at a level, which could require reporting under the statute, are:
***NONE***
CALIFORNIA SCAQMD RULE 443.1 VOC's:
***Not determined***
|