Product Name: MOBILGREASE XHP 222
Revision Date: 24Jan2006
Page 1 of 8
______________________________________________________________________________________________________________________
MATERIAL SAFETY DATA SHEET
SECTION 1 PRODUCT AND COMPANY IDENTIFICATION
PRODUCT
Product Name: MOBILGREASE XHP 222
Product Description: Base Oil and Additives
MSDS Number: 17515
Intended Use: Grease
COMPANY IDENTIFICATION
Supplier: Imperial Oil Products Division
111 St. Clair Avenue West
Toronto, ONT. M5W 1K3 Canada
24 Hour Environmental / Health Emergency 519-339-2145
Telephone
Transportation Emergency Phone Number 519-339-2145
Product Technical Information 1-800-268-3183
Supplier General Contact 1-800-567-3776
SECTION 2 COMPOSITION / INFORMATION ON INGREDIENTS
No Reportable Hazardous Substance(s) or Complex Substance(s).
SECTION 3 HAZARDS IDENTIFICATION
This material is not considered to be hazardous according to regulatory guidelines see Section 15.
HEALTH EFFECTS
Low order of toxicity. Excessive exposure may result in eye, skin, or respiratory irritation. High-pressure
injection under skin may cause serious damage.
NFPA Hazard ID: Health: 0 Flammability: 1 Reactivity: 0
HMIS Hazard ID: Health: 0 Flammability: 1 Reactivity: 0
Note: This material should not be used for any other purpose than the intended use in Section 1 without expert advice.
Health studies have shown that chemical exposure may cause potential human health risks which may vary from
person to person.
SECTION 4 FIRST AID MEASURES
INHALATION
At ambient/normal handling temperatures, minimal or no irritation due to inhalation of vapour/mist is expected.
SKIN CONTACT
Wash contact areas with soap and water. If product is injected into or under the skin, or into any part of the
Product Name: MOBILGREASE XHP 222
Revision Date: 24Jan2006
Page 2 of 8
______________________________________________________________________________________________________________________
body, regardless of the appearance of the wound or its size, the individual should be evaluated immediately by
a physician as a surgical emergency. Even though initial symptoms from high pressure injection may be
minimal or absent, early surgical treatment within the first few hours may significantly reduce the ultimate extent
of injury.
EYE CONTACT
Flush thoroughly with water. If irritation occurs, get medical assistance.
INGESTION
First aid is normally not required. Seek medical attention if discomfort occurs.
SECTION 5 FIRE FIGHTING MEASURES
EXTINGUISHING MEDIA
Appropriate Extinguishing Media: Use water fog, foam, dry chemical or carbon dioxide (CO2) to extinguish
flames.
Inappropriate Extinguishing Media: Straight streams of water
FIRE FIGHTING
Fire Fighting Instructions: Evacuate area. Prevent run-off from fire control or dilution from entering streams,
sewers or drinking water supply. Fire-fighters should use standard protective equipment and in enclosed
spaces, self-contained breathing apparatus (SCBA). Use water spray to cool fire exposed surfaces and to
protect personnel.
Hazardous Combustion Products: Sulphur Oxides, Smoke, Fume, Aldehydes, Incomplete combustion
products, Oxides of carbon
FLAMMABILITY PROPERTIES
Flash Point [Method]: >204?(400?[ EST. FOR OIL, ASTM D-92 (COC)]
C F)
Flammable Limits (Approximate volume % in air): LEL: N/D UEL: N/D
Autoignition Temperature: N/D
SECTION 6 ACCIDENTAL RELEASE MEASURES
NOTIFICATION PROCEDURES
In the event of a spill or accidental release, notify relevant authorities in accordance with all applicable
regulations.
SPILL MANAGEMENT
Land Spill: Allow spilled material to solidify and shovel it up into a suitable container for recycle or disposal.
Scrape up spilled material with shovels into a suitable container for recycle or disposal.
Water Spill: Stop leak if you can do so without risk. Confine the spill immediately with booms. Skim from
surface
Water spill and land spill recommendations are based on the most likely spill scenario for this material;
however, geographic conditions, wind, temperature, (and in the case of a water spill) wave and current direction
Product Name: MOBILGREASE XHP 222
Revision Date: 24Jan2006
Page 3 of 8
______________________________________________________________________________________________________________________
and speed may greatly influence the appropriate action to be taken. For this reason, local experts should be
consulted. Note: Local regulations may prescribe or limit action to be taken.
ENVIRONMENTAL PRECAUTIONS
Prevent entry into waterways, sewers, basements or confined areas.
SECTION 7 HANDLING AND STORAGE
HANDLING
Prevent small spills and leakage to avoid slip hazard.
Static Accumulator: This material is not a static accumulator.
STORAGE
Do not store in open or unlabelled containers.
SECTION 8 EXPOSURE CONTROLS / PERSONAL PROTECTION
NOTE: Limits/standards shown for guidance only. Follow applicable regulations.
ENGINEERING CONTROLS
The level of protection and types of controls necessary will vary depending upon potential exposure conditions.
Control measures to consider:
No special requirements under ordinary conditions of use and with adequate ventilation.
PERSONAL PROTECTION
Personal protective equipment selections vary based on potential exposure conditions such as applications,
handling practices, concentration and ventilation. Information on the selection of protective equipment for use
with this material, as provided below, is based upon intended, normal usage.
Respiratory Protection: If engineering controls do not maintain airborne contaminant concentrations at a
level which is adequate to protect worker health, an approved respirator may be appropriate. Respirator
selection, use, and maintenance must be in accordance with regulatory requirements, if applicable. Types of
respirators to be considered for this material include:
No protection is ordinarily required under normal conditions of use and with adequate ventilation.
For high airborne concentrations, use an approved supplied-air respirator, operated in positive pressure mode.
Supplied air respirators with an escape bottle may be appropriate when oxygen levels are inadequate,
gas/vapour warning properties are poor, or if air purifying filter capacity/rating may be exceeded.
Hand Protection: Any specific glove information provided is based on published literature and glove
manufacturer data. Work conditions can greatly effect glove durability; inspect and replace worn or damaged
gloves. The types of gloves to be considered for this material include:
No protection is ordinarily required under normal conditions of use.
Eye Protection: If contact is likely, safety glasses with side shields are recommended.
Product Name: MOBILGREASE XHP 222
Revision Date: 24Jan2006
Page 4 of 8
______________________________________________________________________________________________________________________
Skin and Body Protection: Any specific clothing information provided is based on published literature or
manufacturer data. The types of clothing to be considered for this material include:
No skin protection is ordinarily required under normal conditions of use. In accordance with good
industrial hygiene practices, precautions should be taken to avoid skin contact.
Specific Hygiene Measures: Always observe good personal hygiene measures, such as washing after
handling the material and before eating, drinking, and/or smoking. Routinely wash work clothing and protective
equipment to remove contaminants. Discard contaminated clothing and footwear that cannot be cleaned.
Practise good housekeeping.
ENVIRONMENTAL CONTROLS
See Sections 6, 7, 12, 13.
SECTION 9 PHYSICAL AND CHEMICAL PROPERTIES
Typical physical and chemical properties are given below. Consult the Supplier in Section 1 for additional data.
GENERAL INFORMATION
Physical State: Solid
Form: semi-fluid
Colour: dark blue
Odour: Characteristic
Odour Threshold: N/D
IMPORTANT HEALTH, SAFETY, AND ENVIRONMENTAL INFORMATION
Relative Density (at 15 癈): 0.91
Flash Point [Method]: >204癈 (400?[ EST. FOR OIL, ASTM D-92 (COC)]
F)
Flammable Limits (Approximate volume % in air): LEL: N/D UEL: N/D
Autoignition Temperature: N/D
Boiling Point / Range: > 316?(600?br>
C F)
Vapour Density (Air = 1): N/D
Vapour Pressure: < 0.013 kPa (0.1 mm Hg) at 20篊
Evaporation Rate (N-Butyl Acetate = 1): N/D
pH: N/A
Log Pow (n-Octanol/Water Partition Coefficient): > 3.5
Solubility in Water: Negligible
Viscosity: 220 cSt (220 mm?sec) at 40篊 | >16 cSt (16 mm?sec) at 100癈
Oxidizing properties: See Sections 3, 15, 16.
OTHER INFORMATION
Freezing Point: N/D
Melting Point: >260癈 (500?F)
DMSO Extract (mineral oil only), IP-346: < 3 %wt
Note: Most physical properties above are for the oil component in the material.
SECTION 10 STABILITY AND REACTIVITY
STABILITY: Material is stable under normal conditions.
Product Name: MOBILGREASE XHP 222
Revision Date: 24Jan2006
Page 5 of 8
______________________________________________________________________________________________________________________
CONDITIONS TO AVOID: Excessive heat. High energy sources of ignition.
MATERIALS TO AVOID: Strong oxidizers
HAZARDOUS DECOMPOSITION PRODUCTS: Material does not decompose at ambient temperatures.
HAZARDOUS POLYMERIZATION: Will not occur.
SECTION 11 TOXICOLOGICAL INFORMATION
Acute Toxicity
Route of Exposure Conclusion / Remarks
INHALATION
Toxicity (Rat): LC50 > 5000 mg/m? Minimally Toxic. Based on assessment of the components.
Irritation: No end point data. Not determined.
INGESTION
Toxicity (Rat): LD50 > 2000 mg/kg Minimally Toxic. Based on test data for structurally similar
materials.
Skin
Toxicity (Rabbit): LD50 > 2000 mg/kg Minimally Toxic. Based on test data for structurally similar
materials.
Irritation (Rabbit): Data available. Negligible irritation to skin at ambient temperatures. Based on
assessment of the components.
Eye
Irritation (Rabbit): Data available. May cause mild, short-lasting discomfort to eyes. Based on
assessment of the components.
CHRONIC/OTHER EFFECTS
Contains:
Base oil severely refined: Not carcinogenic in animal studies. Representative material passes IP-346, Modified
Ames test, and/or other screening tests. Dermal and inhalation studies showed minimal effects; lung non-
specific infiltration of immune cells, oil deposition and minimal granuloma formation. Not sensitising in test
animals. C.I. Solvent blue: Positive in the Ames and Mouse Lymphoma mutagenicity assay.
Additional information is available by request.
CMR Status:
Chemical Name CAS Number List Citations
HYDROTREATED LIGHT 64742-53-6 1
NAPHTHENIC DISTILLATE
(PETROLEUM)
Phosphorus 7723-14-0 4
--REGULATORY LISTS SEARCHED--
1 = IARC 1 3 = IARC 2B 5 = ACGIH A1
2 = IARC 2A 4 = ACGIH ALL 6 = ACGIH A2
SECTION 12 ECOLOGICAL INFORMATION
Product Name: MOBILGREASE XHP 222
Revision Date: 24Jan2006
Page 6 of 8
______________________________________________________________________________________________________________________
The information given is based on data available for the material, the components of the material, and similar materials.
ECOTOXICITY
Material -- Not expected to be harmful to aquatic organisms.
MOBILITY
Base oil component -- Low solubility and floats and is expected to migrate from water to the land. Expected to
partition to sediment and wastewater solids.
PERSISTENCE AND DEGRADABILITY
Biodegradation:
Base oil component -- Expected to be inherently biodegradable
BIOACCUMULATION POTENTIAL
Base oil component -- Has the potential to bioaccumulate, however metabolism or physical properties may
reduce the bioconcentration or limit bioavailability.
SECTION 13 DISPOSAL CONSIDERATIONS
Disposal recommendations based on material as supplied. Disposal must be in accordance with current applicable
laws and regulations, and material characteristics at time of disposal.
DISPOSAL RECOMMENDATIONS
Product is suitable for burning in an enclosed controlled burner for fuel value or disposal by supervised
incineration at very high temperatures to prevent formation of undesirable combustion products.
REGULATORY DISPOSAL INFORMATION
Empty Container Warning (where applicable): Empty containers may retain residue and can be dangerous.
DO NOT PRESSURISE, CUT, WELD, BRAZE, SOLDER, DRILL, GRIND OR EXPOSE SUCH CONTAINERS
TO HEAT, FLAME, SPARKS, STATIC ELECTRICITY, OR OTHER SOURCES OF IGNITION; THEY MAY
EXPLODE AND CAUSE INJURY OR DEATH. Do not attempt to refill or clean container since residue is difficult
to remove. Empty drums should be completely drained, properly bunged and promptly returned to a drum
reconditioner. All containers should be disposed of in an environmentally safe manner and in accordance with
governmental regulations.
SECTION 14 TRANSPORT INFORMATION
LAND (TDG) : Not Regulated for Land Transport
LAND (DOT) : Not Regulated for Land Transport
SEA (IMDG) : Not Regulated for Sea Transport according to IMDG-Code
AIR (IATA) : Not Regulated for Air Transport
Product Name: MOBILGREASE XHP 222
Revision Date: 24Jan2006
Page 7 of 8
______________________________________________________________________________________________________________________
SECTION 15 REGULATORY INFORMATION
WHMIS Classification: Not controlled
This product has been classified in accordance with hazard criteria of the Controlled Products Regulations and the
(M)SDS contains all the information required by the Controlled Products Regulations.
CEPA: All components of this material are either on the Canadian Domestic Substances List (DSL), exempt, or have
been notified under CEPA.
NATIONAL CHEMICAL INVENTORY LISTING: AICS, EINECS, TSCA
Special Cases:
Inventory Status
NDSL Restrictions Apply
The Following Ingredients are Cited on the Lists Below:
Chemical Name CAS Number List Citations
DIPHENYLAMINE 122-39-4 1, 5
XYLENES 1330-20-7 1, 5
--REGULATORY LISTS SEARCHED--
1 = TSCA 4 3 = TSCA 5e 5 = TSCA 12b
2 = TSCA 5a2 4 = TSCA 6 6 = NPRI
SECTION 16 OTHER INFORMATION
N/D = Not determined, N/A = Not applicable
THIS SAFETY DATA SHEET CONTAINS THE FOLLOWING REVISIONS:
No revision information is available.
-----------------------------------------------------------------------------------------------------------------------------------------------------
WHMIS Classification: Not controlled
-----------------------------------------------------------------------------------------------------------------------------------------------------
The information and recommendations contained herein are, to the best of Imperial Oil's knowledge and belief, accurate
and reliable as of the date issued. Imperial Oil assumes no responsibility for accuracy of information unless the
document is the most current available from an official Imperial Oil distribution system. The information and
recommendations are offered for the user's consideration and examination, and it is the user's responsibility to satisfy
itself that they are suitable and complete for its particular use. If buyer repackages this product, legal counsel should be
consulted to insure proper health, safety and other necessary information is included on the container. Appropriate
warnings and safe-handling procedures should be provided to handlers and users. Alteration of this document is strictly
prohibited. Except to the extent required by law, republication or retransmission of this document, in whole or in part, is
not permitted.
-----------------------------------------------------------------------------------------------------------------------------------------------------
Product Name: MOBILGREASE XHP 222
Revision Date: 24Jan2006
Page 8 of 8
______________________________________________________________________________________________________________________
DGN: 5016072 (1010818)
-----------------------------------------------------------------------------------------------------------------------------------------------------
Copyright 2002 Imperial Oil Limited, All rights reserved
Prepared By: Imperial Oil Limited, IH and Product Safety
|